CLT Continued Aircraft Operations Evaluations

Transcription

1 CLT Continued Aircraft Operations Evaluations Airport Community Roundtable Presentation August 15, 2018

2 ACR Requests of the CLT Technical Consultant Continued review of open ACR motions Increase Base Leg Altitudes on Arrival into CLT (ACR Motion 01-18/02-18) Optimized Profile Descents into CLT (ACR Motion 01-17) Delay Runway 18L Turnout on Departure (ACR Motion 00-18) 2

3 3 Increase Base Leg Altitudes on Arrival into CLT (ACR Motion 01-18/02-18)

4 36R CLT Altitude Profiles East Downwind

5 36R CLT Altitude Profiles East Downwind Downwind Portion Downwind Portion

6 CLT North Flow East Downwind 2014 Altitude Profiles North South 2nm 5nm 8nm 11nm 14nm 17nm 21nm Airport Elevation: nm 27nm 6

7 CLT North Flow East Downwind 2017 Altitude Profiles North South 2nm 5nm 8nm 11nm 14nm 17nm 21nm Airport Elevation: nm 27nm 7

8 CLT North Flow East Downwind 2014 and 2017 Altitude Profile Comparison North South Airport Elevation: 748 8

9 Findings North Flow East Downwind Altitude Analysis Downwind altitudes were higher in 2014 (pre-metroplex) than 2017 (postmetroplex) consistent with prior analysis Altitudes at the start of the downwind leg (northeast of the airport) could be increased without departure traffic conflicts No departure traffic conflicts at the middle and end of the downwind leg(abeam and southeast of the airport), however: Increasing altitudes at these locations could result in aircraft flying further southeast of the airport to meet glideslope capture as well as aircraft operator and performance requirements Could present sequencing issues during peak traffic periods 9

10 10 Optimized Profile Descents into CLT (ACR Motion 01-17)

11 CDA Analysis Methodology Proposed Procedure Development Selected 2017 north flow east downwind operations for evaluation of a Continuous Descent Approach (CDA) Runway 36R Potential area for development of a Required Navigation Performance (RNP) approach procedure Generated model flight track of average lateral and vertical profiles for selected operations to represent exiting conditions Derived from 9,268 flight tracks Average vertical profile included aircraft level segment at 6,000 ft. above Mean Sea Level (MSL) on downwind Developed proposed RNP approach with continuous 3-degree descent profile from start of downwind leg to the runway 11

12 Runway 36R Continuous Descent Approach (CDA) Model Flight Track Development 6,000 MSL Level Segment 12

13 CDA Analysis Methodology Noise Modeling Modeled and compared noise results for two most common arrival aircraft types at CLT Airbus A321 Canadair Regional Jet 900 (CRJ9) Existing condition model track and proposed RNP approach Generated and compared Sound Exposure Level (SEL) Contours for modeled operations Calculated and compared Maximum Sound Exposure Level (Lmax) at selected community location near Runway 36R east downwind (SouthPark Mall) 13

14 14 A Existing Condition (left) and Proposed RNP CDA (right) SEL Contours

15 15 CRJ Existing Condition (left) and Proposed RNP CDA (right) SEL Contours

16 Findings CDA Analysis Proposed RNP CDA SEL Contours for both aircraft types are smaller than those for existing conditions Result of reduced aircraft thrust and higher altitudes on downwind leg SEL Contours converge as aircraft approach airport due to glideslope and descent requirements Proposed RNP CDA Lmax values at SouthPark Mall for both aircraft types are 3-4 db less than existing conditions A321 Existing conditions: 57.0 db Proposed RNP CDA: 52.9 db CRJ9 Existing conditions: 54.4 db Proposed RNP CDA: 51.4 db Implementation of the RNP CDA as proposed could negatively impact arrival sequencing during peak traffic periods due to limited altitude flexibility for air traffic controllers 16

17 17 Delay Runway 18L Turnout on Departure (ACR Motion 00-18)

18 18L and 18C Departure Turn Gate Analysis To analyze altitude conflicts, we developed two analysis gates Southeast of CLT in the area where 18L departures turn East Southwest of CLT in the area where 18C departures turn West

19 Departure Gate Analysis (SE) 2014 Northeast Southwest 19

20 Departure Gate Analysis (SE) 2017 Northeast Southwest 20

21 Departure Gate Analysis (SE) 2014 Compared to 2017 Northeast Southwest Northeast Southwest

22 Departure Gate Analysis (SW) 2014 Southeast Northwest 22

23 Departure Gate Analysis (SW) 2017 Southeast Northwest 23

24 Departure Gate Analysis (SW) 2014 Compared to 2017 Southeast Northwest Southeast Northwest

25 Findings 18L and 18C Departure Turn Analysis Delaying left (southeast) Runway 18L and right (southwest) Runway 18C departure turns would result in potential traffic conflicts with south flow downwind arrivals Turning aircraft later would not result in higher aircraft altitudes due to need to keep departures vertically separated below arrivals Could result in potential extended level flight segments Potential to increase aircraft noise Delaying Runway 18L and 18C departure turns could potentially be accomplished by increasing south flow east and west downwind altitudes 25

26 Discussion CLT Technical Consultant to the ACR 26