Product Name: HONEY WAX 250 Revision Date: 25 MAY 2011 Page 1 of 5

Transcription

1 Page 1 of 5 1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING Product Code P52111, P52140 Product Name Honey Wax 250 Recommended Use Industrial Mold Release Manufacturer Specialty Products Co Telephone Number: California Ave. Address: info@specialtyproductsco.com Corona, CA USA Emergency Phone Number: (CHEMTREC) in the US 2. COMPOSITION/INFORMATION ON INGREDIENTS 3. HAZARDS IDENTIFICATION Components CAS-No Percent by weight Mineral Spirits HAZARDOUS IDENTIFICATION HMIS RATING/ NFPA Health: 1 Flammability: 2 Reactivity: 0 Protection: See Sec. 8 VARIABILITY AMONG INDIVIDUALS Health studies have shown that many petroleum hydrocarbons and synthetic lubricants pose potential human health risks which may vary from person to person. As a precaution, exposure to liquids, vapors, mists, or fumes should be minimized. EFFECTS OF OVEREXPOSURE (Signs and symptoms of exposure) High vapor concentrations (greater than approximately 1000 ppm) are irritating to the eyes and the respiratory tract, and may cause headaches, dizziness, anesthesia, drowsiness, unconsciousness, and other central nervous system effects, including death. PRE-EXISTING MEDICAL CONDITIONS WHICH MAY BE AGGRAVATED BY EXPOSURE Petroleum Solvents/Petroleum Hydrocarbons - Skin contact may aggravate an existing dermatitis. CAUTION: FLAMMABLE SOLID. MAY CAUSE SKIN IRRITATION. Wash thoroughly after handling. Keep away from heat and flame. Potential Health Effects Eyes: Exposure is not expected to cause significant irritation. Skin: Prolonged skin contact may cause skin irritation and/or dermatitis. High standards of skin care and personal hygiene should be exercised at all times. Inhalation: Prolonged exposure through inhalation may cause damage to health. Ingestion: Ingestion may cause gastrointestinal irritation, nausea, vomiting, and diarrhea. Effect of overexposure: (Signs and symptoms of exposure) High vapor concentrations (greater than approximately 1000 ppm) are irritating to the eyes and the respiratory tract, and may cause headaches, dizziness, anesthesia, drowsiness, unconsciousness, and other central nervous system effects, including death. 4. FIRST AID MEASURES General Advice If symptoms persist, call a physician. Show this safety data sheet to the doctor in attendance. Do not breathe vapors, mist, or gas. Eye Contact Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. If symptoms persist, call a physician. Skin Contact Wash off immediately with soap and plenty of water removing all contaminated clothes and shoes. Consult a physician if necessary. Ingestion Call a physician immediately. Do NOT induce vomiting. Aspiration hazard if swallowed can enter lungs and cause damage. Rinse mouth. Inhalation Not an expected route of exposure. Move to fresh air. Call a physician immediately. If breathing is irregular or stopped, administer artificial respiration. Avoid direct contact with skin. Use barrier to give mouth-to-mouth resuscitation. Notes to physician Treat symptomatically.

2 Page 2 of 5 Protection of First-aiders Use personal protective equipment. Remove all sources of ignition. 5. FIRE-FIGHTING MEASURES Suitable Extinguishing Media Use Foam Carbon dioxide (CO2 ) Dry chemical Cool containers with flooding quantities of water until well after fire is out. Extinguishing Media Which Must not be Used for Safety Reasons Do not use a solid water stream as it may scatter and spread fire. Special exposure hazards arising from the substance or preparation itself, combustion products, resulting gases Flammable. May be ignited by heat, sparks, or flames. In the event of fire and/or explosion do not breathe fumes. Special Protective Equipment for Fire-fighters As in any fire, wear self-contained breathing apparatus pressure demand, MSHA/NIOSH (approved or equivalent) and full protective gear. 6. ACCIDENTAL RELEASE MEASURES Environmental Precautions Prevent entry into waterways, sewers, basements or confined areas. Do not flush into surface water or sanitary sewer system. Personal Precautions Remove all sources of ignition. Use personal protective equipment. Ensure adequate ventilation. Take precautionary measures against static discharge. Methods for Cleaning Up Prevent product from entering drains. Contain spillage, and then collect with non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite) and place in container for disposal according to local / national regulations (see section 13). Other Information See Section 12 for additional information 7. HANDLING AND STORAGE Handling Keep away from open flames, hot surfaces and sources of ignition. Wash thoroughly after handling. Storage Keep container tightly closed in a cool, dry and well-ventilated place. Incompatible with oxidizing agents. Keep away from heat and sources of ignition. 8. EXPOSURE CONTROLS / PERSONAL PROTECTION EXPOSURE LIMIT FOR NAPHTHA (PETROLEUM) HYDROTREATED HEAVY 300 ppm (1800 mg/m3) for an 8-hour workday. Recommended by the manufacturer of the solvent. VENTILATION Use only with ventilation sufficient to prevent exceeding recommended exposure No smoking or use of flame or other ignition sources. PROTECTIVE GLOVES Use chemical-resistant gloves, if needed, to avoid prolonged or repeated skin contact EYE PROTECTION Use splash goggles when eye contact may occur. 9. PHYSICAL AND CHEMICAL PROPERTIES General Information Physical State Odor Appearance Solid Aromatic Tan Important Health, Safety and Environmental Information Flash Point Boiling Point/Range ph Auto-ignition Temperature Vapor Pressure VOC Content Viscosity 41 o C C Not applicable g/l

3 Page 3 of 5 Solubility Soluble in hydrocarbons Water Solubility Negligible Evaporation Rate Specific Gravity Flammability Limits in Air Other Information Melting Point/Range 90 C 10. STABILITY AND REACTIVITY Stability Conditions to Avoid Materials to Avoid Hazardous Decomposition Products Stable under normal conditions Heat, flames, and sparks. Strong oxidizing agents. None under normal use 11. TOXICOLOGICAL INFORMATION Acute Toxicity Product Information Inhalation Eye Contact Skin Contact Ingestion Chronic Toxicity Carcinogenicity No known effect based on information supplied. No known effect based on information supplied. Prolonged skin contact may de-fat the skin and produce dermatitis. Potential for aspiration if swallowed. Aspiration may cause pulmonary oedema and pneumonitis. The substance has delayed effects. Contains no ingredient listed as a carcinogen. NATURE OF HAZARD AND TOXICITY INFORMATION Prolonged or repeated skin contact with this product tends to remove skin oils, possibly leading to irritation and dermatitis; however, based on human experience and available toxicological data, this product is judged to be neither a "corrosive" nor an "irritant" by OSHA criteria. Product contacting the eyes may cause eye irritation. Product has a low order of acute oral and dermal toxicity, but minute amounts aspirated into the lungs during ingestion or vomiting may cause mild to severe pulmonary injury and possibly death. This product is judged to have an acute oral LD50 (rat) greater than 5 g/kg of body weight, and an acute dermal LD50 (rabbit) greater than 3.16 g/kg of body weight. The toxicity information is based on data available for Naphtha (Petroleum) Hydro-treated Heavy, a solvent component of the product. Data for Finished product is not available. 12. ECOLOGICAL INFORMATION Ecotoxicity Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment. Persistence and Degradability Bioaccumulative Potential Mobility Do not discharge this product into public waters or waterways. Regulatory Requirements: Follow applicable OSHA regulations (29 CFR ).

4 Page 4 of 5 OSHA PEL ACGIH TLV NIOSH REL NIOSH Ingredient TWA STEL TWA STEL TWA STEL IDLH Isoparaffinic 500 ppm 500 ppm 500 ppm 500 ppm 500 ppm 500 ppm 1100 ppm Hydrocarbons Wax Blend None est. None est. None est. None est. None est. None est. None established 13. DISPOSAL CONSIDERATIONS Disposal methods: Dispose of only in accordance with local, state, and federal regulations 14. TRANSPORT INFORMATION U.S. DOT Transported by highway or rail: Non-bulk packagings (capacity less than or equal to 119 gallons) Not regulated Transported by air or marine vessel: Bulk or non-bulk packagings, Flammable solid, n.o.s., organic, (MINERAL SPIRITS) 4.1, Ltd Quantity IMDG/IMO Proper Shipping Name Flammable solid, organic, n.o.s. EmS F-A, S-G, Flammable solid, organic, n.o.s. (Mineral Spirits), 4.1, PG, LTD QTY RID Proper Shipping Name Flammable solid, organic, n.o.s. Classification Code F1, Flammable solid, organic, n.o.s. (Mineral Spirits),4.1,,RID, LTD QTY ADR/RID-Labels 4.1 ADR Proper Shipping Name Flammable solid, organic, n.o.s. Classification Code F1, Flammable solid, organic, n.o.s. (Mineral Spirits),4.1,, LTD QTY ICAO Proper Shipping Name Flammable solid, organic, n.o.s. Flammable solid, organic, n.o.s.(mineral Spirits),4.1,,PG, LTD QTY IATA Proper Shipping Name Flammable solid, organic, n.o.s. ERG Code 3L, Flammable solid, organic, n.o.s. (Mineral Spirits),4.1, PG, LTD QTY 15. REGULATORY INFORMATION

5 Page 5 of 5 International Inventories TSCA EINECS/ELINCS DSL/NDSL PICCS ENCS IECSC AICS KECL Legend TSCA EINECS/ELINCS DSL/NDSL PICCS ENCS IECSC AICS KECL United States Toxic Substances Control Act Section 8(b) Inventory European Inventory of Existing Commercial Chemical Substances/EU List of Notified Chemical Substances Canadian Domestic Substances List/Non-Domestic Substances List Philippines Inventory of Chemicals and Chemical Substances Japan Existing and New Chemical Substances China Inventory of Existing Chemical Substances Australian Inventory of Chemical Substances Korean Existing and Evaluated Chemical Substances 16. OTHER INFORMATION Prepared By SPECIALTY PRODUCTS CO. Issuing Date 25 MAY 2011 Revision Note Not applicable Disclaimer The information provided on this SDS is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guide for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered as a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other material or in any process, unless specified in the text.