Safety Data Sheet EPI-CLENZ PLUS INSTANT HAND SANITIZERS

Transcription

1 Safety Data Sheet EPI-CLENZ PLUS INSTANT HAND SANITIZERS Section 1. Identification Product Identifier Synonyms Manufacturer Stock Numbers Recommended use Uses advised against Manufacturer Contact Address EPI-CLENZ PLUS INSTANT HAND SANITIZERS MSC97025; MSC97028 MSC97025; MSC97028 Medline Industries, Inc. One Medline Place Mundelein, IL, USA Phone Emergency Phone Fax (800) (800) (847) CHEMTREC CHEMTREC Website Section 2. Hazards Identification Classification ACUTE TOXICITY - ORAL - Category 5 EYE DAMAGE/IRRITATION - Category 2B FLAMMABLE LIQUIDS - Category 3 Signal Word Warning Pictogram Hazard Statements Causes eye irritation Flammable liquid and vapor Page 1 of 5

2 Precautionary Statements Response Prevention May be harmful if swallowed Call a poison center/doctor/... /if you feel unwell. If eye irritation persists: Get medical advice/attention. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. In case of fire: Use... to extinguish. Ground/bond container and receiving equipment. Keep away from heat. Keep container tightly closed. Take precautionary measures against static discharge. Use explosion-proof electrical/ventilating/lighting/.../equipment. Use only non-sparking tools. Wash...thoroughly after handling. Wear protective gloves/eye protection/face protection Store in a well-ventilated place. Keep cool. Storage Disposal Dispose of contents/container to... Ingredients of unknown toxicity 0% Hazards not Otherwise Classified Section 3. Ingredients CAS Ingredient Name Weight % Ethyl alcohol 70 % Occupational exposure limits, if available, are listed in Section 8. Section 4. First-Aid Measures General Advice: Eye Contact: Skin Contact: Inhalation: Ingestion: Take proper precautions to ensure your own health and safety before attempting rescue and providing first aid. Consult a physician. Show this safety data sheet to the doctor in attendance. Move out of dangerous area. Avoid rubbing eyes. Immediately flush eyes with large amounts of water, occasionally lifting upper and lower lids, until no evidence of product remains ( minimum 15 minutes is typically recommended). Remove contact lenses, if present and easy to do. Get medical attention if pain or irritation persists. If swallowed, call a physician immediately. Rinse mouth and throat thoroughly with water. Do not induce vomiting unless directed to do so by a physician. Never give anything by mouth to an unconscious person. If vomiting occurs spontaneously, keep head below hips to prevent aspiration of liquid into lungs. Page 2 of 5

3 Section 5. Fire Fighting Measures Suitable Extinguishing Media Unsuitable Extinguishing Media Special Fire Fighting Procedures: Special Fire Fighting Procedures: Unusual Fire and Explosion Hazards: In case of fire, use Carbon Dioxide (CO2) or Dry Chemical Self contained breathing apparatus and full protective clothing recommended. Keep unopened containers cool by spraying with water. Flammable liquid. Vapors are heavier than air. Vapors may settle in low or confined areas, or travel long distances along the ground or surface to an ignition source where they may ignite, flashback, or explode. Keep away from heat, sparks, flames or other sources of ignition (e.g., static electricity, pilot lights, mechanical/electrical equipment). Process hazard: Sudden release of hot organic chemical vapors or mists from process equipment operating at elevated temperature and pressure, or sudden ingress of air into hot equipment under a vacuum, may result in ignitions without the presence of obvious ignition sources. Published "autoignition" or "ignition" temperature values cannot be treated as safe operaring temperatures in chemical processes without analysis of the actual process conditions. Any use of this product in elevated-temperature processes should be throughly elevated to establish and maintain safe operating conditions. This material may produce a floating fire hazard. Section 6. Accidental Release Measures Flammable Small Spill: Flammable Large Spill: Absorb with an inert dry material and place in an appropriate waste disposal container. Flammable liquid. Keep away from heat. Keep away from sources of ignition. Stop leak if without risk. Absorb with dry earth, sand or other non-combustible material. Do not touch spilled material. Prevent entry into sewers, basements or confined areas; dike if needed. Section 7. Handling and Storage Storage Flammable: Handling Flammable: Store in a segregated and approved area. Keep container in a cool, wellventilated area. Keep container tightly closed and sealed until ready for use. Avoid all possible sources of ignition (spark or flame). Keep away from heat. Keep away from sources of ignition. Ground all equipment containing material. Do not ingest. Do not breathe gas/ fumes/ vapor/ spray. Avoid contact with eyes. Wear suitable protective clothing. In case of insufficient ventilation, wear suitable respiratory equipment. If ingested, seek medical advice immediately and show the container or the label. Keep away from incompatibles such as oxidizing agents, acids. Page 3 of 5

4 Section 8. Exposure Controls/Personal Protection Occupational Exposure Limits Personal Protective Equipment Respiratory Protection: Engineering Controls: Skin Protection: Ingredient Name Ethyl alcohol ACGIH TLV OSHA PEL STEL STEL: 1,000 ppm Note: Upper respiratory track irritation. Confirmed animal carcinogen with unknown relevance to humans. Ventilation: Local exhaust. Gloves and protective clothing is required. TWA: 1,000 ppm/1,900mg/mm3 29 CFR Table Z-1 Limits Section 9. Physical and Chemical Properties Physical State Color Clear Odor Alcohol odor Odor Threshold Solubility Complete Partition coefficient Water/n-octanol VOC% Viscosity Specific Gravity Density lbs/gal Pounds per Cubic Foot Flash Point 70 F FP Method TCC Ph Melting Point Boiling Point 176 F Boiling Range LEL 3.3 UEL 19 Evaporation Rate >1 Flammability Decomposition Temperature Auto-ignition Temperature Vapor Pressure 40 Vapor Density >1 Page 4 of 5

5 Section 10. Stability and Reactivity Stability: Conditions to avoid: Incompatibility (Materials to Avoid): Hazardous Decomposition or Byproducts: Hazardous Polymerization Stable. Keep away from heat. Strong acids. Burning may produce Carbon Monoxide, Carbon Dioxide and other hazardous components. N.D. Section 11. Toxicological Information Acute Toxicity: Skin Contact No hazard expected in normal industrial use Acute Toxicity: Eye Contact Contact may cause temporary moderate irritation Section 12. Ecological Information Section 13. Disposal Waste Disposal: Section 14. Transport Information Waste must be disposed of in accordance with federal, state and local environmental control regulations. UN Number UN Proper Shipping Name DOT Classification Packing Group IMDG: IATA: Limited Quantity Limited Quantity Section 15. Regulatory Information Section 16. Other Information Revision Date 5/29/2015 Legend - Not Applicable N.E. - Not Established N.D. - Not Determined Additional Information NFPA Page 5 of 5