Enewall Acrylic Render

Transcription

1 MATERIAL SAFETY DATA SHEET 1. Identification of the Substance / Preparation and Company / Undertaking Product Expected use Product Codes Company name ENEWALL ACRYLIC RENDER Plaster for External Wall Insulation System EWAR1517 Enewall Limited. 4 Netherton Road, Wishaw, North Lanarkshire, Scotland. ML2 0EQ Tel Fax Composition / Information on Ingredients This mixture does not contain any substances presenting a health or environmental hazard within the meaning of the Dangerous Substances Directive 67/548/EEC or Regulation (EC) No.1272/2008, assigned a Community workplace exposure limit, classified as PBT/vPvB or included in the Candidate List. 3. Hazard Identification This mixture is not classified as dangerous according to EC Directive 1999/45/EC. 4. First Aid Measures Inhalation Get the patient into fresh air and keep warm. Avoid exertion. If the patient breathes irregular or doesn t breathe, give artificial breathing. Do not give food or drinks. If the patient is unconscious put him/her into comfortable stable position and contact a doctor. Skin Take Contaminated clothing off. Wash skin thoroughly with soap and water or a proprietary skin cleanser. DO NOT use solvents or thinners. Eye Remove contact lenses, rinse thoroughly with running water while holding eyelids apart for at least 10 minutes and seek medical attention. Ingestion If accidentally swallowed obtain immediate medical attention. Keep at rest. Do not induce vomiting. General Advice When in doubt or symptoms persist, seek medical attention. Never try to get someone unconscious to take something. Place unconscious patient in the recovery position and seek medical advice. Protection for aid assistance Not applicable.

2 5. Fire Fighting Measures Suitable extinguishing media Powders, foam, CO2, AFFF Unsuitable Extinguishing media Water Specific hazards Specific risks from exposure to the product itself or the decomposition products released upon heating and/or gases Carbon monoxide, carbon dioxide. Special protective equipment for fire fighters Normal fire equipment. Further information Hardened product with water. Use extinguishing measures that are appropriate to local circumstance and the surrounding area. Product does not burn. 6. Accidental Release Measures Personal Precautions Avoid breathing vapours. Follow the precautions described in sections 7 and 8. Contain spill to prevent spreading. Recording of the spilled material with non-combustible absorbent such as sand, earth, vermiculite or diatomaceous earth and place in suitable container to store in accordance with local regulations can be discharged. (See Section 13). Environment precautions Do not discard into surface water or sanitary sewer system. Warn local authorities in case of accidental disposals. Methods for cleaning up Bund and soak up with inert absorbent material (e.g. sand, universal binder, sawdust). Dispose of in accordance with local regulations. 7. Handling and Storage Handling Advice on safe handling Keep container tightly closed. Avoid contact with skin and eyes. Avoid discharge into sewers and waterways. Advice on protection against fire and explosion Smoking, eating and drinking should be prohibited in areas where the product is working. See section 8 for personal protection. Do not put the package under pressure, it is not resistant. Always keep in containers of same material as the original packaging. Takes into account the legal requirements for safe working. Storage Store in a dry, well ventilated place at temperatures between 5 c and 25 c. Avoid oxidising agents, strongly alkaline and strong acid materials.

3 8. Exposure Controls / Personal Protection Control parameters Exposure controls Provide adequate ventilation. Where possible, this should be achieved by the use of local exhaust ventilation. Respiratory protection Wear suitable respiratory equipment. Eye protection Avoid contact with eyes. Wear eye protection. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Skin and Body protection Avoid contact with skin. Wear suitable protective clothing. Wear suitable gloves. After contact with skin, wash immediately with plenty of water and seek medical advice. Appearance Appearance Odour Safety Data Flash Point Relative density Water solubility ph Viscosity 9. Physical and Chemical Properties White or coloured plaster Characteristics Not applicable Approx 1.7 g/cm3 Insoluble but miscible in all proportions Approx 8 Approx 250 Pa.s 10. Stability and Reactivity Stability Materials to avoid Hazardous decomposition Products Avoid temperatures above 60 c, direct sunlight and contact with heat sources. Keep away from oxidation resources, strong alkaline and acidic materials to avoid exothermal reactions After evaporation of the water, combustion will lead to the development of carbon dioxide CO2, carbon monoxide CO, nitrogen oxide Nox, and dense black smoke.

4 11. Toxicological Data on the mixture itself. The mixture has been assessed following the conventional method of the Dangerous mixtures Directive 1999/45/EC and not classified. Repeated or prolonged contact with the mixture may cause removal of natural fat from the skin resulting in nonallergic contact dermatitis and absorption through the skin. The liquid splashed in the eyes may cause irritation and reversible damage. This takes into account, where known, delayed and immediate effects and also chronic effects of components from short-term and long-term exposure by oral, inhalation and dermal routes of exposure and eye contact. 12. Ecological Information Do not allow to enter drains or water courses EcoToxicitity Toxicitity Persistence and degradability Bioaccumulative potential 13. Disposal Considerations Advice on disposal and packaging Disposal Waste product should not be discharged directly into drains or waterways without treatment. Disposal of product and packaging should always comply with local and national regulations. Waste water containing product should be treated in a separation and biological treatment plant. EU Waste code number No waste code number avaaible. 14. Transport Data Advice on Transport Transport product closed and upright. Persons involved in this work, must be informed in advance about what to do in an emergency. This product is not classified as Dangerous for Carriage.

5 15. Regulatory Information This product is not classified as dangerous under the Dangerous Preparations Directive 1999/45/EEC 16. Other Information S-phrases S 2 Keep out of the reach of children S 20/21 When using do not eat, drink or smoke S 22 Do not breathe dust S 23 Do not breathe gas/fumes/vapour/spray S 24/25 Avoid any inhalation, contact with skin and eyes. Wear suitable protective clothing and gloves S 26 In case of contact with eyes rinse immediately with plenty of water and seek medical advice. S 28 After contact with skin wash immediately with plenty of fresh water and soap. S 37 Wear suitable gloves. S 46 If swallowed, seek medical advice immediately and show this container or label S 62 If swallowed do not induce vomiting seek medical advice immediately. The information provided in this safety data sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as guidance for safe handling, use, processing, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text.