MATERIAL SAFETY DATA SHEET

Transcription

1 1030 Visco Drive Nashville, TN MATERIAL SAFETY DATA SHEET SECTION 1: PRODUCT AND COMPANY IDENTIFICATION EMERGENCY ASSISTANCE GENERAL MSDS ASSISTANCE Pine Bluff Materials: (870) Pine Bluff Materials (870) PRODUCT NAME: Natural Sand or Gravel CHEMICAL NAME: Natural Sand or Gravel SYNONYMS: Construction Aggregate CHEMICAL FAMILY: Rock ISSUE DATE: October 14, 2011 REVISED DATE: January 21, 2016 SECTION 2: COMPOSITION / INFORMATION ON INGREDIENTS Component CAS # % Natural Sand or Gravel* ne 100 Crystalline Silica (quartz) >1 *Composition varies naturally, typically contains high levels crystalline silica (quartz) SECTION 3: HAZARDS IDENTIFICATION EMERGENCY OVERVIEW: CAUTION! Prolonged inhalation of crystalline silica can cause lung damage and cancer. This product is considered an inhalation hazard when used in a manner that generates airborne dust in excess of established health and safety standards and guidelines, which requires additional personal protective equipment (PPE) or engineering control measures to control airborne dust levels, such as local exhaust ventilation, utilizing wet methods and performing work in open air environments. Consult section 8 for proper PPE to use with this material. Contact with natural sand and gravel may be irritating to the skin, eyes and respiratory tract. Avoid contact with the eyes and wear appropriate skin and eye protection when necessary. Appropriate respiratory protection should be worn to protect workers from exposures to airborne dust when engineering controls are not feasible. PRIMARY ROUTES OF ENTRY: Eye contact, inhalation, and ingestion TARGET ORGANS: Skin, Eyes, Respiratory system SIGNS AND SYMPTOMS OF EXPOSURE: Generally this product may generate dust and cause irritation to the eyes, throat and upper respiratory system. Inhalation exposure can cause coughing and wheezing. Page 1 of 7

2 Chronic exposure to crystalline silica may cause decreased pulmonary function and progressive respiratory symptoms. In some cases, there may be no signs or symptoms of exposure to crystalline silica. POTENTIAL HEALTH EFFECTS: Health effects are dependent on exposure concentration and duration of exposure. Chronic exposure to crystalline silica can cause lung damage and cancer. EYE CONTACT: Dust produced from mechanical operations may irritate the eyes causing redness and watering, pain and burning. Crystalline silica can cause abrasion of the cornea. SKIN CONTACT: Dusts may cause mechanical irritation. INHALATION: Under normal conditions, inhalation may cause respiratory irritation. Prolonged inhalation of crystalline silica can cause lung damage and cancer. INGESTION: Ingestion is not a primary route of exposure under normal working conditions. CARCINOGEN STATUS: Natural Sand and Gravel is not listed as a carcinogen by ACGIH, OSHA, NTP, or IARC. However, natural sand and gravel contains crystalline silica which is in preparation from International Agency Research on Cancer (IARC) to be classified as a group 1 carcinogen (carcinogenic to humans). National Toxicology Program recognizes respirable silica as known to be a human carcinogen. CONDITIONS GENERALLY RECOGNIZED: May aggravate any pre-existing respiratory conditions. SECTION 4: FIRST AID MEASURES EYE CONTACT: Immediately flush the eyes with large amounts of room temperature water for a minimum of 15 minutes. Hold the eyelids apart during the flushing operation. Get immediate medical attention if irritation persists. SKIN CONTACT: Wash affected areas thoroughly with water. INHALATION: Remove the person from the exposure and move to fresh air. Get immediate medical attention if severe coughing or breathing difficulty occurs. INGESTION: Seek medical attention if discomfort occurs. SECTION 5: FIRE FIGHTING MEASURES FLASHPOINT: FLAMMABLE LIMITS (% VOLUME IN AIR) Lower Explosive Limit (LEL): Upper Explosive Limit (UEL): AUTO IGNITION TEMPERATURE: FIRE EXTINGUISHING MEDIA: t Combustible t Applicable t Applicable t Combustible ne Required Page 2 of 7

3 FIRE FIGHTING PROCEDURES: Avoid inhalation of material or combustion by-products. Wear fire fighter s protective clothing and a NIOSH-approved self-contained breathing apparatus (SCBA). UNUSUAL FIRE AND EXPLOSIVE HAZARDS: Contact with powerful oxidizing agents may cause fire and/or explosion. NFPA RATING: Health = 1 (Can cause irritation) Fire = 0 (will not burn) Reactivity = 0 (Stable) Special = ne SECTION 6: ACCIDENTAL RELEASE MEASURES PERSONAL PROTECTIVE EQUIPMENT: Use the personal protective equipment recommended in Section 8. SPILL PROCEDURES: Use procedures that minimize airborne dust generation. DISPOSAL: Follow the procedures recommended in Section 13. SECTION 7: HANDLING AND STORAGE HANDLING: Wear personal protective equipment and follow the exposure control measures recommended in Section 8. Avoid contact with skin, eyes and prolonged breathing of airborne dust. STORAGE: Under normal conditions, no special handling precautions are required for this product. SECTION 8: EXPOSURE CONTROL MEASURES / PERSONAL PROTECTION Crystalline Silica (quartz) COMPONENT OSHA PEL ACGIH* NIOSH RELs Respirable Dust Total Dust!" $%/$ ' % )*+, -. /" $%/$ ' % )*+, mg/m mg/m 3 ENGINEERING CONTROLS: Utilize engineering control measures to control airborne dust levels, such as local exhaust ventilation, utilizing wet methods and performing work in open air outdoor environments to control airborne levels of dust below the exposure limits and guidelines. EYE PROTECTION: Wear approved safety glasses with side shields and/or an appropriate full faced shield. All eye protection should be selected and worn in accordance with the OSHA eye and face protection guidelines outlined in 29 CFR and Page 3 of 7

4 SKIN PROTECTION: Under normal conditions, the use of additional PPE is not necessary to protect the skin. However, protective clothing, including gloves, aprons, and other outer garments may be desirable in extremely dusty areas. All PPE should be selected and worn in accordance with 29 CFR and RESPIRATORY PROTECTION: Wear a NIOSH approved respirator to prevent inhalation overexposures to dust. Respirators must be selected based on the airborne levels found in the workplace and must not exceed the working limits of the respirator. All respirators should be selected and worn in accordance with 29 CFR and SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES PHYSICAL STATE: Granular COLOR: Gray/White/Light Tan/Reddish ODOR: Odor PH: BOILING POINT MELTING POINT: WATER SOLUBILITY: 0 SPECIFIC GRAVITY: VAPOR DENSITY (AIR): NA VAPOR PRESSURE: NA MOLECULAR FORMULA: MOLECULAR WEIGHT: SECTION 10: STABILITY AND REACTIVITY STABILITY: CONDITIONS TO AVOID: INCOMPATIBLE MATERIALS: Stable at normal temperatures and pressures Stable at normal temperatures and pressures Contact with powerful oxidizing agents listed in the following table may cause fire and/or explosions. Silica dissolves in hydrofluoric acid producing a corrosive gas- silicon tetraflouride. Fluorine Boron Trifluoride Chlorine Trifluoride Manganese Trifluoride Oxygen Difluoride HAZARDOUS DECOMPOSITION PRODUCTS: When heated, quartz is transformed into tridymite (above 860 o C/1580 o F and cristobalite (above 1470 o C/2678 o F). Both tridymite and cristobalite are considered more fibrogenic to the lungs than quartz. HAZARDOUS POLYMERIZATION: Page 4 of 7

5 SECTION 11: TOXICOLOGICAL INFORMATION TOXICITY DATA: This product is a mixture for which no specific toxicologist data exists. RESPIRABLE SILICA: LD50 Rat IV 500 mg/kg bw /Quartz ( um) CARCINOGENICITY: REPRODUCTIVE EFFECTS: MUTAGENICITY: TERATOGENICITY: This product is considered carcinogenic by OSHA, NTP and IARC. Silicosis, lung cancer, autoimmune disease, tuberculosis, kidney disease and respiratory disease have been reported in occupational over exposures to crystalline silica. Inhaling respirable dust and/or crystalline silica may aggravate pre-existing respiratory conditions. SECTION 12: ECOLOGICAL INFORMATION ECOTOXICITY: There is limited information available for this product. ENVIRONMENTAL FATE: There is limited information available for this product. SECTION 13: DISPOSAL CONSIDERATIONS WASTE DISPOSAL: Dispose in accordance with all applicable federal, state, and local regulations. Waste characterization and compliance with applicable laws are the responsibility of the waste generator. RCRA P-Series: t Listed RCRA U-Series: t Listed SECTION 14: TRANSPORTATION INFORMATION SHIPPING NAME: t Regulated IATA HAZARD CLASS: t Regulated DOT HAZARD CLASS: t Regulated IMGD CLASS: t Regulated DOT SHIPPING ID: t Required RID/ADR CODES: t Regulated PACKING GROUP: t Required PACKING GROUP: t Regulated LABEL: t Required HAZARD ID: t Regulated This product is not regulated as a hazardous material by the U.S. Department of Transportation (DOT), IMGD, EU, United Nations, IATA or the Canadian Transportation of Dangerous Goods (TDG) regulations. Page 5 of 7

6 SECTION 15: REGULATORY INFORMATION CERCLA Sections 102a/103 (40 CFR 302.4): t Regulated SARA Title III Section 302 (40 CFR ): t Regulated SARA Title III Section 304 (40 CFR ): t Regulated SARA Title III Section 313 (40 CFR ): t Regulated SARA Title III Section 311/312 Hazardous Categories (40 CFR ): Acute: Chronic: Fire: Reactive: Sudden Release: OSHA/MSHA Hazard Communication: This product is considered by OSHA/MSHA to be hazardous chemical and should be included in the employer s hazard communication program. California Proposition 65 : TSCA: WHMIS: t Regulated- Crystalline silica is classified by the state of California as a substance known to be a human carcinogen. Listed on the Inventory May be subject to this requirement based on intended use and worker exposure SECTION 16: OTHER INFORMATION THE INFORMATION LISTED IN THIS DOCUMENT RELATES ONLY TO THE MATERIAL DESIGNATED AND MAY NOT BE VALID FOR SUCH MATERIAL USED IN COMBINATION WITH ANY OTHER MATERIALS OR IN ANY PROCESS. THE INFORMATION CONTAINED IN THIS MATERIAL SAFETY DATA SHEET WAS COMPILED FROM SOURCES CONSIDERED TO BE ACCURATE AND THUS IS BELIEVED TO BE ACCURATE. IT IS OFFERED FOR YOUR CONSIDERATION, INVESTIGATION AND VERIFICATION. IT IS THE USER S RESPONSIBILITY TO DETERMINE IF THIS PRODUCT IS SUITABLE FOR ITS PROPOSED APPLICATION(S) AND TO FOLLOW NECESSARY SAFETY PRECAUTIONS. Formal hazard ratings have not been determined by HMIS and NFPA for this product. The hazard ratings used for this MSDS are based on the criteria of HMIS and NFPA and our professional judgment. NFPA RATING: Health = 1 (can cause irritation) Fire = 0 (will not burn) Reactivity = U (Stable) Special = ne HMIS RATING: Health = 1 (Slight) Flammability = 0 (minimal) Physical = 0 (minimal) Page 6 of 7

7 PREPARED BY: Conestoga-Rovers and Associates DATE OF ISSUE: October 14, 2011 REVISED DATE: January 21, 2016 COMMON TERMS AND ACRONYMS: ACGIH: CAS#: CERCLA: DOT: EPA: HMIS: IARC: LEL: MSHA: NFPA: NIOSH: NTP: OSHA: PEL: PPE : RCRA: SARA: TLV: TSCA: TWA: UEL: American Conference of Governmental Industrial Hygienists Chemical Abstracts System Number Comprehensive Environmental Response, Compensation, and Liability Act Department of Transportation U.S. Environmental Protection Agency Hazardous Materials Identification System International Agency for Research on Cancer Lower Explosive Limit Mine Safety and Health Administration National Fire Protection Association National Institute for Occupational Safety and Health National Toxicology Program Occupational Safety and Health Administration Permissible Exposure Limit Personal Protective Equipment Resource Conservation and Recovery Act Superfund Amendments and Reauthorization Act Threshold Limit Value Toxic Substances Control Act Time Weighted Average Upper Explosive Limit Page 7 of 7