Material Safety Data Sheet

Transcription

1 Material Safety Data Sheet KEYSTONE LIQUID HEAVY DUTY DISHMACHINE 1. Trade name of product Product use Code Date of issue Product and company identification Product dilution information Supplier's information 2. Physical state Emergency overview KEYSTONE LIQUID HEAVY DUTY DISHMACHINE Machine Warewashing Detergent Up to.14 oz/gal or 1.1 ml/l in water Ecolab Co. 515 Tomken Road Mississauga ON L4W 2X August-211 EMERGENCY HEALTH INFORMATION Outside United States and Canada CALL (in USA) Hazards identification Routes of entry Skin contact, Eye contact, Inhalation, Ingestion Potential acute health effects Eyes Corrosive to eyes. Skin Inhalation Ingestion Liquid. DANGER! CAUSES RESPIRATORY TRACT, DIGESTIVE TRACT, EYE AND SKIN BURNS. Do not ingest. Do not get in eyes, on skin or on clothing. Do not breathe vapour or spray. Keep container closed. Use only with adequate ventilation. Wash thoroughly after handling. Corrosive to the skin. Corrosive to the respiratory system. Causes burns to mouth, throat and stomach. See toxicological information (Section 11) 3. Composition/information on ingredients Liquid. CAUTION! No specific hazard. No specific hazard. Name CAS number % by weight SODIUM HYDROXIDE Within the present knowledge of the supplier, this product does not contain any hazardous ingredients in quantities requiring reporting, in accordance with local regulations. 1/6

2 4. Eye contact Skin contact Inhalation Ingestion 5. First-aid measures In case of contact, immediately flush eyes with cool running water. Remove contact lenses and continue flushing with plenty of water for at least 15 minutes. Get medical attention immediately. In case of contact, immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Get medical attention immediately. Wash clothing before reuse. Clean shoes thoroughly before reuse. If inhaled, remove to fresh air. If exposed person is not breathing, give artificial respiration or oxygen applied by trained personnel. Get medical attention immediately. If material has been swallowed and the exposed person is conscious, give small quantities of water to drink. Do not induce vomiting. Never give anything by mouth to an unconscious person. Get medical attention immediately. Fire-fighting measures Auto-ignition temperature Flammable limits Hazardous thermal decomposition products Special remarks on fire hazards Special remarks on explosion hazards Fire-fighting media and instructions Special protective equipment for fire-fighters 6. Personal precautions Environmental precautions Methods for cleaning up Accidental release measures 31 August 211 No known effect after eye contact. Rinse with water for a few minutes. No known effect after skin contact. Rinse with water for a few minutes. No special measures required. Treat symptomatically. Get medical attention if symptoms occur. Decomposition products may include the following materials carbon dioxide carbon monoxide metal oxide/oxides Use an extinguishing agent suitable for the surrounding fire. Dyke area of fire to prevent runoff. In a fire or if heated, a pressure increase will occur and the container may burst. Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode. Initiate company's spill response procedures immediately. Keep people out of area. Put on appropriate personal protective equipment (see section 8). Do not touch or walk through spilt material. Avoid contact of spilt material and runoff with soil and surface waterways. Follow company's spill procedures. Keep people away from spill. Put on appropriate personal protective equipment (see section 8). Absorb/neutralise liquid material. Use a tool to scoop up solid or absorbed material and put into appropriate labelled container. Use a water rinse for final clean-up. Use personal protective equipment as required. Avoid contact of large amounts of spilt material and runoff with soil and surface waterways. Use a water rinse for final clean-up. 2/6

3 6. 7. Handling Storage 8. Engineering measures Accidental release measures Handling and storage Do not ingest. Do not get in eyes, on skin, or on clothing. Do not breathe vapour or spray. Keep container closed. Use only with adequate ventilation. Wash thoroughly after handling. Keep out of reach of children. Keep container tightly closed. Do not store above the following temperature 5 C Exposure controls/personal protection Personal protection Eyes Use chemical splash goggles. For continued or severe exposure wear a face shield over the goggles. Hands Skin Respiratory Use only with adequate ventilation. If user operations generate dust, fumes, gas, vapour or mist, use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure to airborne contaminants below any recommended or statutory limits. Provide suitable facilities for quick drenching or flushing of the eyes and body in case of contact or splash hazard. Use chemical-resistant, impervious gloves. Use synthetic apron, other protective equipment as necessary to prevent skin contact. Wear appropriate respirator when ventilation is inadequate and occupational exposure limits are exceeded. Wash thoroughly after handling. Keep out of reach of children. 31 August 211 Good general ventilation should be sufficient to control worker exposure to airborne contaminants. No protective equipment is needed under normal use conditions. No protective equipment is needed under normal use conditions. No protective equipment is needed under normal use conditions. No special protection is required. Occupational exposure limits TWA (8 hours) STEL (15 mins) Ceiling Ingredient List name ppm mg/m³ Other ppm mg/m³ Other ppm mg/m³ Other Notations sodium hydroxide US ACGIH 2/ AB 4/ [3] BC 9/ ON 7/ QC 6/ [3]Skin sensitisation 9. Physical and chemical properties Physical state Liquid. Flash point > 1 C Product does not support combustion. Colour Red [Dark] Odour Odourless ph 12.5 to 14.5 [Conc. (% w/w) 1%] Boiling/condensation point Liquid. > 1 C Colourless. Odourless 1.5 to /6

4 9. Physical and chemical properties Melting/freezing point Relative density Vapour pressure Vapour density 1.1 to August 211 Odour threshold Evaporation rate Viscosity Dispersibility properties Solubility LogKow 1. Stability and reactivity Stability Conditions of instability Reactivity Hazardous decomposition products The product is stable. Under normal conditions of storage and use, hazardous polymerisation will not occur. Slightly reactive or incompatible with the following materials acids and moisture. Under normal conditions of storage and use, hazardous decomposition products should not be produced. Hazardous polymerisation Under normal conditions of storage and use, hazardous polymerisation will not occur. 11. Toxicity data Toxicological information Potential acute health effects Eyes Corrosive to eyes. Skin Inhalation Ingestion Corrosive to the skin. Corrosive to the respiratory system. Causes burns to mouth, throat and stomach. Potential chronic health effects Carcinogenic effects Mutagenic effects Teratogenic effects Reproductive effects Sensitization to Product Synergistic products (toxicologically) Product/ingredient name Test Route Result Species 4/6

5 11. Toxicological information sodium hydroxide LD5 Dermal >2 mg/kg Rabbit LD5 Dermal 135 mg/kg Rabbit LD5 Oral 5 mg/kg Rabbit LD5 Oral 3 to 5 mg/kg Rat LDLo Oral 5 mg/kg Rabbit Other adverse effects Target organs 12. Ecological information Ecotoxicity 13. Waste disposal August 211 Contains material which may cause damage to the following organs upper respiratory tract. Not reported Disposal considerations Avoid disposal. Attempt to use product completely in accordance with intended use. Disposal should be in accordance with applicable regional, national and local laws and regulations. Transport information Diluted product can be flushed to sanitary sewer. Discard empty container in trash. Certain shipping modes or package sizes may have exceptions from the transport regulations. The classification provided may not reflect those exceptions and may not apply to all shipping modes or package sizes. TDG Classification TDG Proper shipping name Class 8 Packing group UN1824 SODIUM HYDROXIDE SOLUTION II For transport in bulk or using IMDG regulations, see shipping documents for specific transportation information. Not intended for transport. 15. Regulatory information WHMIS Class E Corrosive material Not hazardous by WHMIS criteria. Canada inventory All components are listed or exempted. This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and the MSDS contains all the information required by the Controlled Products Regulations. 16. Other information 5/6

6 16. Other information Hazardous Material Information System (U.S.A.) 31 August 211 Health * 3 Health Physical hazards Physical hazards National Fire Protection Association (U.S.A.) Health 3 Instability/Reactivity Health Instability/Reactivity Special Special Date of issue Responsible name 31-August-211 Regulatory Affairs Indicates information that has changed from previously issued version. Notice to reader The above information is believed to be correct with respect to the formula used to manufacture the product in the country of origin. As data, standards, and regulations change, and conditions of use and handling are beyond our control, NO WARRANTY, EXPRESS OR IMPLIED, IS MADE AS TO THE COMPLETENESS OR CONTINUING ACCURACY OF THIS INFORMATION. 6/6