SAFETY DATA SHEET (SDS)

Transcription

1 1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY Product 303WG Epoxy Floor Paint Base Component Company Name Rawlins Paints Northspeed House Moorview Holbeck Leeds LS11 9NF Tel: +44 (0) Fax: +44 (0) HAZARDS IDENTIFICATION Classification of substance Label Elements Signal Word: Warning GHS Pictogram: Hazard Statement: Causes skin irritation. (H315) May cause an allergic skin reaction. (H317) Causes serious eye irritation. (H319) Precautionary Statement (Prevention): Wear protective gloves/protective clothing/eye protection. (P280). Precautionary Statement (Response): IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower (P ). IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do continue rinsing. (P ). Precautionary Statement (Disposal): Dispose contents/container in accordance with local regulation (P501). Hazardous Components for labelling: None Page 1 of 6

2 3. COMPOSITION/INFORMATION ON INGREDIENTS Regulation (EC) no 1272/2008 Mixtures Component Oxirane, 2-2 -[(1- methylethylidene) bis(4,1- phenyleneoxymet hylene)]bis-,homopolymer EINECS no. REACH no. CAS no Water Content 50-60% 40-50% Hazard Class/Hazard Category/Hazard Statement Skin Sens. 1; H317 Skin Irrit. 2; H315 Eye Irrit. 2; H FIRST AID MEASURES Skin contact Eye contact Ingestion Inhalation Wash contaminated skin with soap and water. Remove contaminated clothing and shoes. Wash contaminated clothing thoroughly with water before removing it or wear gloves. Continue to rinse for at least 10 minutes. Get medical attention. In the event of any complaints or symptoms, avoid further exposure. Wash clothing before reuse. Clean shoes thoroughly before reuse. Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Continue to rinse for at least 10 minutes. Wash out mouth with water. Remove denture if any. Remove victim to fresh air and keep at rest in a position comfortable for breathing. If material has been swallowed and the exposed person is conscious, give small quantities of water to drink. Stop if the exposed person feels sick as vomiting may be dangerous. Do not induce vomiting unless directed to do so by medical personnel. If vomiting occurs, the head should be kept low so that vomit doesn t enter the lungs. Get medical attention Remove victim to fresh air and keep at rest in a position comfortable for breathing. Potential acute health effects Eye Contact Inhalation Skin Contact Ingestion : Irritating to eyes : No known significant effects or critical hazards : Irritating to skin, may cause sensitization by skin contact : Irritating to mouth, throat and stomach Note to physician Treat symptomatically. Contact poison treatment specialist immediately if large quantities have been ingested. Page 2 of 6

3 5. FIRE-FIGHTING MEASURES Extinguishing media Exposure hazards Protection of firefighters Use an extinguishing agent suitable for the surrounding fire. In a fire, or if heated, a pressure increase will occur and the container may burst. Decomposition products may include the following materials: Carbon Monoxide Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire. No action shall be taken involving any personal risk or without suitable training. Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with full face-piece operated in in positive pressure mode. Clothing for fire-fighters (including helmets, protective boots and gloves) conforming to EN469 will provide a basic level of protection for chemical incidents. Burning produces noxious & toxic fumes. 6. ACCIDENTAL RELEASE MEASURES Personal precautions No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilt material. Wear appropriate personal protective equipment (PPE). Environmental precautions Clean-up procedures 7. HANDLING AND STORAGE Handling requirements Storage conditions Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers. Inform the relevant authorities if the product has caused environmental pollution. Stop leak if without risk. Move containers from spill area. Absorb with an inert, dry material and place in an appropriate waste disposal container. Dispose of via a licensed waste disposal contractor. Put on suitable PPE (see section 8). Do not get in eyes or on skin or clothing. Do not ingest. Avoid breathing vapour or mist. Refer to special instructions/safety data sheet prior to use. Keep in original container or an approved alternative made from a compatible material, keep tightly closed when not in use. Empty containers retain product residue. Do not reuse container. Store in accordance with local regulations. Store in original containers protected from direct sunlight in a cool, dry place with good ventilation away from incompatible materials (see section 10) as well as food and drink. Keep container tightly closed and sealed until ready for use. Containers that have been opened must be carefully resealed and kept in an upright position to prevent leakage. Do not store in unlabeled containers. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Personal Protective Equipment Engineering measures No special ventilation requirements. Good general ventilation should be sufficient to control worker exposure to airborne contaminants. If this product contains ingredients with exposure limits (no known) use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure below any recommended or statutory limits. Page 3 of 6

4 Hand protection Eye protection Skin protection Respiratory protection Hygiene Measures PVC disposable gloves. Safety eyewear complying with an approved standard should be used to avoid exposure to liquid splashes or mists. PPE for the body should be selected based on the task being performed and the risks involved. During application of product, forearms & legs should be fully covered. In case of inadequate ventilation wear respiratory protection. Respirator selection must be based on known or anticipated exposure levels, the hazard of the product and the safe working limits of the selected respirator. Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Appropriate techniques should be used to remove potentially contaminated clothing. Contaminated work clothing should not be allowed out of the workplace. Wash contaminated clothing before reusing. Ensure that eyewash station are close to the workstation location. 9. PHYSICAL AND CHEMICAL PROPERTIES State Liquid Colour Pigmented Odour Slight Solubility in water Insoluble Density >1.11g/cm³ [20 C(68 F)] Flash point C Closed cup: >250 C [DIN EN22719 (Pensky-Martens closed cup)] 10. STABILITY AND REACTIVITY Stability Stable Conditions to avoid Materials to avoid Haz. Decompositon Products No Specific data Oxidising Agents Under normal conditions of storage and use, none should be produced. 11. TOXICOLOGICAL INFORMATION Irritation Eye : Contact with eyes may cause irritation Skin : No known significant effects or critical hazards. Inhalation Effects : Presents elevated inhalation risk when used in spray or aerosol applications Ingestion : No known significant effects or critical hazards. Symptoms : No known significant effects or critical hazards. Acute Toxicity Acute oral toxicity : No known significant effects or critical hazards. Inhalation : No known significant effects or critical hazards. Acute Dermal Toxicity : No known significant effects or critical hazards. Skin Corrosion/irritation : Non-irritant to skin of rabbit Serious eye irritation : Mild eye irritation Sensitisation : No known significant effects or critical hazards. Page 4 of 6

5 General : No known significant effects or critical hazards. Carcinogenicity : No known significant effects or critical hazards. Mutagenicity : No known significant effects or critical hazards. Teratogenicity : No known significant effects or critical hazards. Developmental effects : No known significant effects or critical hazards. Fertility effects : No known significant effects or critical hazards. Other Information : Not available. 12. ECOLOGICAL INFORMATION Toxicity Aquatic Toxicity Toxicity to other organisms : No known significant effects or critical hazards. : No known significant effects or critical hazards. Mobility in Soil Soil/Water partition coefficient (K oc) : Not available Mobility : Not available Results of PBT and vpvb assessment : Not applicable. Other adverse effects : No known significant effects or critical hazards. 13. DISPOSABLE CONSIDERATIONS Disposal Methods The generation of waste should be avoided or minimised wherever possible. Significant quantities of waste product residues should not be disposed of via the foul sewer but processed in a suitable effluent treatment plant. Dispose of surplus and non-recyclable via a licensed waste disposal contractor. Disposal of this product, solutions and any byproducts should at all times comply with the requirements of environmental protection and waste disposal regulation and any regional local authority requirements. Waste packaging should be recycled. Incineration or landfill should only be considered when recycling is not feasible. This material and its container must be disposed of in a safe way. Care should be taken when handling emptied containers that have not been cleaned or rinsed out. Empty containers may retain product residues. Avoid dispersal of spilt material and runoff, as well as contact with soil, waterways, drains or sewers. 14. TRANSPORT INFORMATION UN UN Proper Shipping Name Number ADR/RID - Not classified as dangerous goods IMDG - Not classified as dangerous goods IATA - Not classified as dangerous goods 15. REGULATORY INFORMATION Safety, health and Occupational Restrictions: environmental regulations/legislation specific to Status of registration: substance or mixture REACH (EU) TSCA (USA) DSL (CDN) AICS (AUS) METI (J) ECL (KOR) PICCS (RP) IECSC (CN) Preregistered, registered or exempted Page 5 of 6

6 16. OTHER INFORMATION Other information Read in conjunction with the appropriate CURING AGENT component Safety Data Sheet. Legal disclaimer The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. E J Rawlins & Co. Ltd shall not be held liable for any damage resulting from handling or from contact with the above product. Page 6 of 6