SAFETY DATA SHEET. Dust Mop Treatment. 1. Product and Company Identification. 2. Hazards Identification

Transcription

1 Product Code: Product Name: Company Name: Web site address: 5300 SUNBELT LABORATORIES P.O. BOX 1563 STAFFORD, TX Product and Company Identification Phone Number: (281) Emergency Contact: CHEM-TEL (800) Toxic To Reproduction, Category 2 2. Hazards Identification Page: 1 GHS Signal Word: GHS Hazard Phrases: GHS Precaution Phrases: GHS Response Phrases: GHS Storage and Disposal Phrases: OSHA Regulatory Status: Potential Health Effects (Acute and Chronic): Inhalation: Skin Contact: Eye Contact: Ingestion: Warning Suspected of damaging fertility or the unborn child. Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Keep container tightly closed. Ground/bond container and receiving equipment. Use explosion-proof electrical/ventilating/lighting/.../ equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Wear protective gloves/protective clothing/eye protection/face protection. Use personal protective equipment as required. IF ON SKIN (or hair): Remove/take off immediately all contaminated clothing. Rinse skin with water/shower. IF exposed or concerned: Get medical attention/advice. Store in cool/well-ventilated place. Store locked up. Dispose of contents/container to... This material is classified as hazardous under OSHA regulations. Chronic: Inhalation of vapors or contact with substance will result in contamination and potential harmful effects. May cause skin irritation. Dermatitis. May cause eye irritation. May cause coughing, difficult breathing and nausea. May cause dizziness, incoordination, and unconsciousness. May cause drowsiness or dizziness.

2 Page: 2 3. Composition/Information on Ingredients CAS # Hazardous Components (Chemical Name) Concentration Mineral oil, petroleum distillates, hydrotreated % Petroleum Distillates % Amyl acetate % Emergency and First Aid Procedures: In Case of Inhalation: In Case of Skin Contact: In Case of Eye Contact: In Case of Ingestion: Signs and Symptoms Of Exposure: Indication of any immediate medical attention and special treatment needed: Note to Physician: Flash Pt: > F (87.8 C) Autoignition Pt: Fire Fighting Instructions: Flammable Properties and Hazards: 4. First Aid Measures IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell. Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse. IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. IF ON SKIN (or hair): Remove/take off immediately all contaminated clothing. Rinse skin with water/shower. IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs, get medical advice/attention. Flush eye with water for 15 minutes. Get medical attention. IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell. If swallowed, do NOT induce vomiting. Nausea, vomiting, diarrhea. Shortness of breath, May cause mild skin and eye irritation. Dermatitis. IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell. Show this safety data sheet to the doctor in attendance. 5. Fire Fighting Measures Explosive Limits: LEL: UEL: Suitable Extinguishing Media:Dry chemical or CO2. DO NOT USE WATER! Unsuitable Extinguishing DO NOT USE WATER! Media: Hazardous Combustion Products: Protective Equipment: Wear self-contained breathing apparatus and protective clothing to prevent contact with skin and eyes. None.

3 Page: 3 6. Accidental Release Measures Steps To Be Taken In Case Material Is Released Or Spilled: Do not flush to sewer. Do not let product enter drains. Cover liquid spill with sand, earth or other non-combustible absorbent material. 7. Handling and Storage Precautions To Be Taken in Handling: Precautions To Be Taken in Storing: Other Precautions: Suitable: Store in a cool dry place. Not available. 8. Exposure Controls/Personal Protection CAS # Partial Chemical Name OSHA TWA ACGIH TWA Other Limits Mineral oil, petroleum distillates, hydrotreated Petroleum Distillates Amyl acetate PEL: 100 ppm TLV: 50 ppm STEL: 100 ppm Respiratory Equipment (Specify Type): Eye Protection: Protective Gloves: Other Protective Clothing: Engineering Controls (Ventilation etc.): Environmental Exposure Controls: Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. Splash proof safety goggles. It should not be construed as offering an approval for any specific use scenario. No special ventilation requirements. 9. Physical and Chemical Properties Physical States: [ ] Gas [ X ] Liquid [ ] Solid Appearance and Odor: ph: Melting Point: Boiling Point: > F (148.9 C) Flash Pt: > F (87.8 C) Evaporation Rate: Flammability (solid, gas): Clear. Banana-like odor. Explosive Limits: LEL: UEL: Vapor Pressure (vs. Air or mm Hg): Vapor Density (vs. Air = 1): 4.7

4 Specific Gravity (Water = 1):.810 at 77.0 F (25.0 C) Solubility in Water: Insoluble Octanol/Water Partition Coefficient: Percent Volatile: Autoignition Pt: Decomposition Temperature: Viscosity: Corrosion Rate: Reactivity: Stability: Conditions To Avoid - Instability: Incompatibility - Materials To Avoid: Hazardous Decomposition or Byproducts: Possibility of Hazardous Reactions: Conditions To Avoid - Hazardous Reactions: Toxicological Information: Carcinogenicity: % by volume. Excess heat. 10. Stability and Reactivity Strong oxidizing agents. Unstable [ ] Stable [ X ] Strong oxidizing agents. Heat. Will occur [ ] Will not occur [ X ] Product will not undergo polymerization. 11. Toxicological Information NTP? No IARC Monographs? No OSHA Regulated? No CAS # Hazardous Components (Chemical Name) NTP Mineral oil, petroleum distillates, hydrotreated heavy naphthenic Page: 4 IARC ACGIH OSHA n.a. n.a. n.a. n.a Petroleum Distillates n.a. n.a. n.a. n.a Amyl acetate n.a. n.a. n.a. n.a. Waste Disposal Method: LAND TRANSPORT (US DOT): 12. Ecological Information 13. Disposal Considerations 14. Transport Information DOT Proper Shipping Name: DOT Hazard Class: 9 CLASS 9 UN/NA Number:

5 CAS # Hazardous Components (Chemical Name) 15. Regulatory Information EPA SARA (Superfund Amendments and Reauthorization Act of 1986) Lists Mineral oil, petroleum distillates, hydrotreated Page: 5 S. 302 (EHS) S. 304 RQ S. 313 (TRI) No No No Petroleum Distillates No No No Amyl acetate No Yes 5000 LB No This material meets the EPA 'Hazard Categories' defined for SARA Title III Sections 311/312 as indicated: [X] Yes [ ] No Acute (immediate) Health Hazard [X] Yes [ ] No Chronic (delayed) Health Hazard [ ] Yes [X] No Fire Hazard [ ] Yes [X] No Sudden Release of Pressure Hazard [ ] Yes [X] No Reactive Hazard CAS # Hazardous Components (Chemical Name) Other US EPA or State Lists Mineral oil, petroleum distillates, hydrotreated TSCA: Inventory Petroleum Distillates TSCA: Inventory Amyl acetate CWA NPDES TSCA: Inventory, 4 Test, 8A PAIR 16. Other Information Revision Date: 07/06/2015 Hazard Rating System: HMIS: HEALTH FLAMMABILITY REACTIVITY PPE Flammability Health NFPA: 2 1 Instability Special Hazard Additional Information About This Product: Company Policy or Disclaimer: DISCLAIMER: To the best of our knowledge, the information contained herin is accurate. There is no assumption of liability for accuracy contained within this information. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text.