MATERIAL SAFETY DATA SHEET

Transcription

1 1. CHEMICAL PRODUCT AND COMPANY INFORMATION Product Name: Lubspar 110 (0290) MATERIAL SAFETY DATA SHEET Manufacturer Information: Tulco Oils, Inc E. Pine Street Tulsa, Oklahoma Product Use: Process Oil Emergency Phone Numbers: Chemtrec Tulco Oils, Inc. (800) Information: Product Safety Information (800) COMPOSITION/INFORMATION ON INGREDIENTS Component CAS No. Amount (Vol%) SEVERELY SOLVENT REFINED HEAVY PARAFFINIC PETROLEUM OIL EXPOSURE GUIDELINES (SEE SECTION 15 FOR ADDITIONAL EXPOSURE LIMITS) CAS No. Governing Body Exposure Limits 3. HAZARDS IDENTIFICATION EMERGENCY OVERVIEW Poses little or no immediate hazard. Hazards Ratings: Key: 0 = least, 1 = slight, 2 = moderate, 3 = high, 4 = extreme Health Fire Reactivity PPI NFPA HMIS X POTENTIAL HEALTH EFFECTS PRE-EXISTING MEDICAL CONDITIONS The following diseases or disorders may be aggravated by exposure to this product: Skin, INHALATION No acute effects expected. LC50 (mg/l): no data LC50 (mg/m3): no data 0290, Lubspar 110 1

2 LC50 (ppm): no data SKIN Practically non-toxic if absorbed through the skin. May cause minimal skin irritation. Draize Skin Score: no data Out of 8.0 LD50 (mg/kg): no data EYES No eye effect expected. INGESTION Practically non-toxic if ingested. LD50 (g/kg): no data 4. FIRST AID MEASURES INHALATION No specific treatment is necessary since this material is not likely to be hazardous by inhalation. If exposed to excessive levels of dusts or fumes, remove to fresh air and get medical attention if cough of other symptoms develop. SKIN Wash with soap and water. Get medical attention if irritation develops or persists. Wash clothing before reuse. EYES Hold eyelids apart and flush eyes with plenty of water for at least 15 minutes. If eye irritation persists, obtain medical treatment. INGESTION Material is practically non-toxic. Induction of vomiting is not required. Get medical attention immediately. 5. FIRE FIGHTING MEASURES EXTINGUISHING MEDIA Water spray Regular foam Dry chemical Carbon dioxide FIRE FIGHTING INSTRUCTIONS Wear structural fire fighting gear. As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. FLAMMABLE PROPERTIES Typical Minimum Maximum Text Result Units Method Flash Point 390 F COC Autoignition Temperature 725 ESTIMATED Lower Explosion Limit no data % Upper Explosion Limit no data % F 6. ACCIDENTAL RELEASE MEASURES Contain spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust. Use appropriate personal protective equipment as stated in Section 8 of this MSDS. Advise the Environmental Protection Agency (EPA) and appropriate state agencies, if required. Absorb spill with inert material (e.g., dry sand or earth), then place in a chemical waste container. Vacuum or sweep up material and place in a disposal container. 7. HANDLING AND STORAGE HANDLING Wash thoroughly after handling. 0290, Lubspar 110 2

3 STORAGE NFPA class IIIB storage. Flash point is greater than 200 degrees F. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Consult With a Health and Safety Professional for Specific Selections ENGINEERING CONTROLS Use with adequate ventilation. Ventilation is normally required when handling or using this product to keep exposure to airborne contaminants below the exposure limit. Mechanical ventilation recommended. PERSONAL PROTECTION EYE PROTECTION Safety glasses (with side shields) recommended. Splash proof chemical goggles are recommended to protect against the splash of product. GLOVES or HAND PROTECTION Protective gloves are recommended when prolonged skin contact cannot be avoided. The glove(s) listed below may provide protection against permeation. Gloves of other chemically resistant materials may not provide adequate protection. Neoprene; Nitrile; Viton; RESPIRATORY PROTECTION Concentration in air determines the level of respiratory protection needed. Use only NIOSH certified respiratory equipment. Respiratory protection is not usually needed unless product is heated or misted.. Half-mask air purifying respirator with dust / mist filters or HEPA filter cartridges is acceptable for exposures to ten (10) times the exposure limit. Full-face air purifying respirator with dust / mist filters or HEPA filter cartridges is acceptable for exposures to fifty (50) times the exposure limit. Protection by air purifying respirators is limited. Use a positive pressure-demand full-face supplied air respirator or SCBA for exposures greater than fifty (50) times the exposure limit. If exposure is above the IDLH (Immediately Dangerous to Life and Health) or there is the possibility of an uncontrolled release, or exposure levels are unknown, then use a positive pressure-demand fullface supplied air respirator with escape bottle or SCBA. Wear a NIOSH/MSHA-approved (or equivalent) fullfacepiece airline respirator in the positive pressure mode with emergency escape provisions. OTHER Where splashing is possible, full chemically resistant protective clothing (e.g., acid suit) and boots are required. Polyvinyl alcohol (PVA); The following materials are acceptable for use as protective clothing: Polyvinyl chloride (PVC); Neoprene; Nitrile; Viton; Polyurethane; Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Remove contaminated clothing and wash before reuse. For nonfire emergencies, respiratory protection may be necessary and wear appropriate protective clothing to avoid contact with material. 9. PHYSICAL AND CHEMICAL PROPERTIES Physical Property Typical Units Text Result Reference Appearance Amber Boiling Point F no data Bulk Density lb/gal no data Melting Point F no data Molecular Weight g/mole no data Octanol/Water Coefficient no data ph no data Specific Gravity 0.87 Solubility In Water wt % NIL Odor Little Odor Odor Threshold ppm no data Vapor Pressure mmhg 20 C 0290, Lubspar 110 3

4 Viscosity (F) F Viscosity (C) 40 C % Volatile wt % NIL 10. STABILITY AND REACTIVITY STABILITY Stable CONDITIONS TO AVOID Avoid heat, sparks and open flame. INCOMPATIBILITY Strong oxidizers HAZARDOUS DECOMPOSITION PRODUCTS Combustion may produce carbon monoxide, carbon dioxide and other asphyxiants. HAZARDOUS POLYMERIZATION Will not polymerize. 11. ECOLOGICAL INFORMATION No data available 12. DISPOSAL CONSIDERATIONS Follow federal, state and local regulations. This material is not a RCRA hazardous waste, if not contaminated. If material has been "used", RCRA criteria (ignitability, reactivity, corrosivity and toxicity) must be determined. Do not flush material to drain or storm sewer. Contract to authorized disposal service. 13. TRANSPORT INFORMATION Governing Body Mode Proper Shipping Name DOT Ground Petroleum Lubricating Oil Governing Body Mode Hazard Class UN/NA No. Label DOT Ground Not Regulated 14. REGULATORY INFORMATION Regulatory List Component CAS No. Title III Classifications Sections 311,312: 0290, Lubspar 110 4

5 Acute: NO Chronic: NO Fire: NO Reactivity: NO Sudden Release of Pressure: NO 15. OTHER INFORMATION Limits for the product- 5mg/m3, Oil Mist Limit, (OSHA PEL/ACGIH TLV) WHMIS Classification: not controlled. Please refer to the material safety data sheet for complete information. 0290, Lubspar 110 5