CNI AMS-4XL Section 1: Material Identification. Section 2: Hazard Identification

Transcription

1 SAFETY DATA SHEET CNI AMS-4XL Section 1: Material Identification Product Name: GHS product identifier: Company: Recommended use: Recommended restrictions: Synonyms: CNI AMS-4XL Ammonium sulfate CNI 800 Business Park Drive, Hwy 82 West Leesburg, GA Water conditioner None available Ammonium sulphate, diammonium sulfate Emergency Telephone Number: CNI Tel: Section 2: Hazard Identification GHS classification: Health hazards: Causes skin irritation Category 2 GHS label elements: Signal word: Warning Hazard statement: Causes skin irritation Causes eye irritation Harmful if swallowed or inhaled Precautionary statement: Prevention: Wash thoroughly after handling. Wear protective gloves. Response: If skin irritation occurs get medical advice/attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists get medical advice/attention. IF ON SKIN OR CLOTHING: Wash with plenty of soap and water. Take off contaminated clothing and wash before reuse. IF SWALLOWED: Call poison center or doctor/physician if you feel unwell. IF INHALED: Remove person to fresh air. Storage: Store in well ventilated place. Keep container tightly closed Disposal: Dispose of contents/container in accordance with local/regional/national/ international regulations Specific hazards: None available Page 1 of 6

2 Components CAS No. Percent Ammonium sulfate Defoamer, surfactant, drift reduction solution Proprietary 6.25 Inerts Proprietary Eye Contact: Section 3: Composition Information Section 4: First-Aid measures Immediately flush eyes with water; remove contact lenses, if present, after the first 6 minutes then continue flushing eyes for at least 15 minutes. Obtain medical attention without delay, preferably from an ophthalmologist. Skin Contact: Inhalation: Ingestion: Immediately flush skin with water while removing contaminated clothing and shoes. Get medical attention if symptoms occur. Wash clothing before reuse. Move person to fresh air; If not breathing give artificial respiration. If breathing is difficult, oxygen should be administered by a qualified personnel. Call a physician or transport to medical facility. If swallowed, seek medical attention. Do not induce vomiting unless directed to do so by medical personnel. Section 5: Fire Fighting Measures Suitable extinguishing media: Specific hazards arising from the chemical: Protective equipment and precautions for firefighter s: Water spray, foam solution, CO 2, dry chemical None known Assure self-contained breathing apparatus is worn. Fight fire from upwind. Prevent runoff if possible. Section 6: Accidental Release Measures Personal Precautions: Isolate area. Keep unnecessary and unprotected personnel from entering the area. Refer to Section 7, Handling, for additional precautionary measures. Keep upwind of spill. Spilled material may cause a slipping hazard. Ventilate area of leak or spill. Use appropriate safety equipment. For additional information, refer to Section 8, Exposure Controls and Personal Protection. Environmental Precautions: Prevent further leakage or spillage if safe to do so. Do not contaminate water. Methods for containment: Methods for cleaning up: Stop the flow of material, if this is without risk. Collect and dispose of spillage as indicated in section 13. Prevent entry into waterway, sewers, basements or confined areas. Pick up spills with absorbent material and place in suitable properly labeled containers. Section 7: Handling and Storage Handling: Storage: Wash hands and other exposed areas with mild soap and water before eating, drinking, or smoking and again when leaving work. Handle in accordance with good industrial hygiene and safety procedures. Store in a dry place. Store in original container. Do not store near food, foodstuffs, drugs or potable water supplies. Page 2 of 6

3 Section 8: Exposure Controls/ Personal Protection Occupational exposure limits: Engineering controls: Personal protective equipment: Eye/Face Protection: Skin Protection: Hand protection: Use engineering controls to maintain airborne level below exposure limit requirements or guidelines. If there are no applicable exposure limit requirements or guidelines, use only with adequate ventilation. Local exhaust ventilation may be necessary for some operations. Use chemical goggles Use protective clothing chemically resistant to this material. Selection of specific items such as face shield, boots, apron, or full body suit will depend on the task. Safety shower should be located in immediate work area. Remove contaminated clothing immediately, wash skin area with soap and water, and launder clothing before reuse or dispose of properly. Use gloves chemically resistant to this material. Examples of preferred glove barrier materials include: Neoprene, Nitrile/butadiene rubber ( nitrile or NBR ), or Polyvinyl chloride ( PVC or vinyl ). Respiratory Protection: Respiratory protection should be worn when there is a potential to exceed the exposure limit requirements or guidelines. If there are no applicable exposure limit requirements or guidelines, use an approved respirator. Selection of air-purifying or positive-pressure supplied-air will depend on the specific operation and the potential airborne concentration of the material. Section 9: Physical and Chemical Properties Physical state: Liquid Color: Blue Form: Liquid Odor: Slight Odor threshold: Ph: Melting/freezing point: <15 F Boiling point: Flash point: Evaporation rate: Flammability: Flammability limits in air, lower: Flammability limits in air, upper: Vapor pressure: Vapor density: Relative density: 1.20 g/ml Solubility: Complete in water Octanol/water coefficient: -5.1 (ammonium sulfate) Auto-ignition temperature: Decomposition temperature: Viscosity: Page 3 of 6

4 Chemical stability/instability: Stable at typical use temperatures Conditions to avoid: Avoid extreme temperatures Incompatible materials: Avoid contact with: Strong acids, Strong bases, Strong oxidizers Possibility of hazardous reactions: Will not occur Hazardous decomposition products: Oxides of nitrogen and sulfur Toxicology data: Section 10: Stability and Reactivity Section 11: Toxicological Information Components: Ammonium sulfate ( ) Routes of exposure: Acute effects: Mutagenicity: Skin corrosion/irritation: Serious eye damage/eye irritation: Specific target organ toxicitysingle exposure: Specific target organ toxicityrepeated exposure: Other information: Test results: Acute oral LD 50 (rat): 5000 mg/kg Acute dermal LD 50 (rabbit): 3 g/kg Skin contact, eye contact, ingestion, inhalation Skin irritation. Eye irritation. Harmful if swallowed or inhaled. Non-mutagenic for bacteria and/or yeast Causes skin irritation Causes eye irritation Not classified Not classified Section 12: Ecological Information Ecotoxicological data: Components: Test results: Ammonium sulfate LC 50 Fish 1 (Exposure time: 96 h - Species: Oncorhynchus mykiss [static]): EC 50 Daphnia 1 (Exposure time: 24 h - Species: Daphnia magna): LC 50 Fish 2 (Exposure time: 96 h - Species: Oncorhynchus mykiss [flow-through]): EC 50 Daphnia 2 (Exposure time: 48 h - Species: Daphnia magna): Persistence and degradability: Bioaccumulation: Mobility in soil: Other adverse effects: Not established Not established Avoid release to the environment mg/l 423 mg/l mg/l 14 mg/l Page 4 of 6

5 Section 13: Disposal Considerations Disposal methods: Contaminated packaging: Dispose of in accordance with label instructions and all applicable regulations. Dispose of in accordance with applicable federal, state and local regulations. In accordance with ICAO/IATA/DOT/TDG: Section 14: Transport Information UN number: UN proper shipping name: Transport hazard classes: Packing group: Environmental hazards: Transport in bulk: Special precautions: Section 15: Regulatory Information International inventories TSCA: EINECS/ELINCS: ENCS: IECSC: KECL: PICCS: AICS Superfund Amendments and Reauthorization Act of 1986 Title III (Emergency Planning and Community Rightto-Know Act of 1986) Sections 311 and 312: Immediate (Acute) Health Hazard: Yes Delayed (Chronic) Health Hazard: No Fire Hazard: No Reactive Hazard: No Sudden Release of Pressure Hazard: No Superfund Amendments and Reauthorization Act of 1986 Title III (Emergency Planning and Community Rightto-Know Act of 1986) Section 313: This product contains the following substances which are subject to the reporting requirements of Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 and which are listed in 40 CFR 372. Component CAS # Amount Ammonium sulfate % Page 5 of 6

6 Section 16: Other Information Disclaimer: CNI recommends that each customer or recipient of this SDS to study it carefully and consult appropriate expertise, as necessary or appropriate, to become aware of and understand the data contained in this SDS and any hazards associated with the product. The information herein is provided in good faith and believed to be accurate as of the effective date shown below. However, no warranty, express or implied, is given. Regulatory requirements are subject to change and may differ between various locations. It is the buyer s/user s responsibility to ensure that his activities comply with all federal, state, provincial or local laws. The information presented here pertains only to the product as shipped. Since conditions for use of the product are not under the control of the manufacturer, it is the buyer s/user s duty to determine the conditions necessary for the safe use of this product. Due to the proliferation of sources for information such as manufacturerspecific SDSs, we are not and cannot be responsible for SDSs obtained from any source other than ourselves. If you have obtained an SDS from another source or if you are not sure that the SDS you have is current, please contact us for the most current version. Revised: November 11, 2014 Page 6 of 6