MATERIAL SAFETY DATA SHEET

Transcription

1 MATERIAL SAFETY DATA SHEET DESCRIPTION WHITE SEAMSEAL BUTYL NON SETTING BEDDING MASTIC 380ML ORDER CODE S 3285 MSDS SECTION 1: Identification of the substance / preparation and company 1.1 Product identifier S Relevant identified uses of the substance or mixture and uses advised against Sealant 1.3 Details of the supplier of the safety data sheet: Unit 6, Milton Business Centre Wick Drive, New Milton Hants, BH25 6RH Tel: Fax: sales@sealsplusdirect.co.uk 1.4 Emergency telephone number Tel: (Mon Fri 8:30am 5pm) SECTION 2: Hazards Identification Solvents may be absorbed through the skin. Prolonged and repeated contact may cause drying of the skin and possibly dermatitis. SECTION 3: Composition / information on ingredients Chemical characterisation Homogeneous mixture of mineral filler, synthetic rubber, inert liquid polymer and white spirit. Hazardous Ingredients: White Spirit This information and our technical advice, whether verbal, in writing or by way of trials, is given in good faith but without warranty. This also applies where proprietary rights are involved. Our advice does not release you from the obligations to check its validity and to test our products as to their suitability for the intended use. The storage, application and use of our products are beyond our control and, therefore, entirely your own responsibility. Our products are sold in accordance with our General Conditions of Sale. The information contained within this data sheet is subject to change without notice. Page 1 of 7 Issue date:

2 Name CAS No. EC No. Conc. (%w/w) Classification & R phrases White spirit % Xn, R10,65 SECTION 4: First Aid Measures Eye contact Wash eye thoroughly with cold water. If irritation persists seek medical attention Skin contact Wash affected area thoroughly with soap and water. Inhalation Move into fresh air. If problems persist, seek medical advice. Ingestion If confined to the mouth, do not swallow; wash out mouth with water. If swallowed, drink water and seek medical advice, showing the container/label/safety data sheet. Do not induce vomiting. Medical Treatment Give symptomatic treatment. SECTION 5: Fire-fighting Measures Suitable extinguishing media Carbon dioxide, foam, dry powder or fine water spray. Water can be used to cool fire exposed containers. Unsuitable extinguishing media None known. Special protective equipment / procedures A self-contained respirator and protective clothing should be worn. Keep containers cool with water spray until well after fire is out. Determine the need to evacuate or isolate the area according to your local emergency plan. Hazardous combustion products Carbon oxides and traces of incompletely burned carbon compounds. Page 2 of 7 Issue date:

3 SECTION 6: Accidental Release Measures Personal precautions Wear proper protective equipment. Precautions to protect the environment Do not allow large quantities to enter drains or surface waters. Methods for cleaning up Scrape up and place in a container fitted with a lid. The spilled product produces an extremely slippery surface. SECTION 7: Handling and Storage Advice on safe handling General ventilation is recommended. Avoid skin and eye contact. Do not breathe vapour. Advice on storage Store in cool dry conditions below 25 C and away from direct sunlight or heat sources. Unsuitable packaging materials None known SECTION 8: Exposure Controls / Personal Protection Exposure controls for hazardous components Name CAS No. Exposure Limits White Spirit Suppliers recommendation: mg/m³ for an 8 hour TWA reference period Personal protection equipment Respiratory protection Not necessary when used in a well-ventilated area. If needed, use an air purifying respirator conforming to Type A (EN141). Check with protective equipment manufacturers Skin protection Chemical protective gloves should be worn where repeated or prolonged contact can occur Page 3 of 7 Issue date:

4 Eye protection Safety glasses should be used Hygiene measures Exercise good industrial hygiene practice. Wash after handling, especially before eating, drinking or smoking Additional information None known SECTION 9: Physical and Chemical Properties Appearance and odour Soft paste with a solvent odour. Colour Cream, Grey and white Flash point 78 C Specific Gravity 1.6g/cm³ Volatile Content 6-8% Solubility Insoluble in water. Some components soluble in organic liquids The above information is not intended for use in preparing product specifications. SECTION 10: Stability and Reactivity Stability Stable at room temperature Conditions to avoid Heat sources, sources of ignition, direct sunlight, etc Materials to avoid None known Hazardous decomposition products Page 4 of 7 Issue date:

5 During combustion Carbon monoxide and Carbon dioxide will be generated SECTION 11: Toxicological Information On contact with eye May cause smarting and irritation. On skin contact Prolonged contact may defat and dry skin leading to possible irritation and dermatitis. If inhaled Not applicable. On ingestion May cause irritation of the mouth, throat and digestive system and eventual vomiting. Other health hazard information Not known SECTION 12: Ecological Information Environmental fate and distribution Contains biodegradable and non-biodegradable components. Ecotoxicity effects Low aquatic and terrestrial ecotoxicity. Product should not be allowed into drains or watercourses. SECTION 13: Disposal Consideration Product disposal Product should be disposed of as solid waste by incineration or landfill via a licensed waste disposal contractor. DO NOT empty product into drains. Packaging disposal Packaging should be disposed of as solid waste by incineration or landfill via a licensed waste disposal contractor. SECTION 14: Transport Information Road / Rail (ADR/RID) Not subject to ADR/RID Page 5 of 7 Issue date:

6 Sea transport (IMDG) Not subject to IMDG code Air transport (ICAO) Not subject to ICAO regulations SECTION 15: Regulatory Information Classification as required by The Chemicals (Hazard Information & packaging for Supply) CHIP Regulations Labelling according to EEC directive Nature of hazard No specific regulatory or labelling requirements. Hazard symbols No specific regulatory or labelling requirements. R-phrases No specific regulatory or labelling requirements. S-phrases No specific regulatory or labelling requirements EINECS All ingredients listed or exempt SECTION 16: Other Information Revision date Refer to the date at bottom of sheet This product Safety Data Sheet was prepared in compliance with Commission Directive 91/155/EEC, 67/548/EEC and 1999/45/EC as well as their relevant amendments, on the approximation of laws, regulations and administrative provisions relative to the classification, packaging and labelling of dangerous substances and preparations. This product should only be used as stated in Seals+Direct Literature. It is the responsibility of the persons in receipt of this Material Safety Data Sheet to ensure that the information contained herein is properly read and understood by all people who may use, handle, dispose or in any way come in to contact with the product. If the recipient subsequently produces a formulation containing the Seals+Direct product, it is the recipient s sole responsibility to ensure the transfer of all relevant information Page 6 of 7 Issue date:

7 from the Seals+Direct Material Safety Data Sheet to their own Material Safety Data Sheet in compliance with Commission Directive 1999/45/EC. All sections of this Material Safety Data Sheet have been amended since the previous version. Page 7 of 7 Issue date: