68 MEGA OBSTACLE COURSE

Transcription

1 68 MEGA OBSTACLE COURSE General info 68 x13 x operator(s) required 4 passengers max at one time 2 at the start line and 2 going over big slide Max weight per person 225lbs Minimum height 36 2 x 1.0 hp blowers Setup Unroll the inflatable onto a flat ground area, install at least 6 ground stakes around the perimeter, and loosely tie the tethers to the ground stakes. Connect blower to the unit and turn on. As the unit inflates close the (6) zippers located on the side of the inflatable. Secure the tethers after the unit if fully inflated. 2 Stakes must be located at the front, 2 in the middle, and 2 at the end of the inflatable. If the wind is 15 mph or above, there must be an additional 4 stakes used, 2 for each slide. The two inflatables are attached by weaving a bungee cord between the inflatables. Perform a final safety check around the unit prior to letting passengers on. Warning: Prior to setting the stakes into the ground, check for sprinkler systems, water or electricity lines. How to play The operator will allow 2 passengers to race each other through the inflatable. Once the first 2 passengers have climbed the tall slide, the next 2 passengers are allowed to go. If there are young children on this inflatable, Bounce Around recommends there be an additional operator on top of the large slide to help the young children climb this wall. If there are young children racing, the operator may let the next group go when the first group is crawling through the giant holes in the middle of the inflatable. NO JUMPING OFF BIG SLIDE! MUST SLIDE DOWN. NO FLIPPING NO HEAD FIRST NO HITTING - 4 PASSENGERS AT A TIME Take down Begin by disconnecting power to the blower; unzip the backside of the bounce house. After unit is deflated, fold the unit into 3rds. Roll from the exit to middle and middle to starting line. Leaving the air tubes open helps let the air out while rolling. Mother Nature In the event of severe weather (lightning, 20+ mph winds, rain, etc) safely exit the inflatable unit, disconnect power, and go indoors for your safety. Once the weather has passed, you may continue using the inflatable after examining the unit for safety. When the inflatable is wet, please inflate and dry off. Warning: If the unit has become wet you must notify Bounce Around Inflatables as this can damage the unit if it is not dried correctly. In the example that you do not notify us, we may charge you the full amount to fix the unit. Basics All players should remove shoes, jewelry, and any hard or sharp items from their pockets that could cause injury. To avoid neck and back injuries, FLIPS ARE NOT ALLOWED. I the lessee have read and understood the rules for this inflatable. The lessee has agreed to follow the rules that are presented by Bounce Around Inflatables, LLC. Lessee: Date:

2 5500 S. Wexford Ct. Sioux Falls, SD Phone: SET UP The Bounce Around Inflatable may weigh over 300 lbs. Caution should be exercised when lifting and handling the equipment. Use a dolly to move the equipment. Please pay attention to how it was rolled up. We ask that the inflatable comes rolled back up the same way you received it. Thank you, Bounce Around Inflatables, LLC. DO NOT set up when windy and or it rains. MUST use a tarp when placing on tar or cemented areas. No tarp necessary on grass. Select a level area that is a safe distance from water, walls and other obstructions. Make certain that there are no overhead utility wires and ground obstacles such as protruding sprinklers or underground pipes of any kind before laying the protective tarp on the selected area. Place the Bounce Around Inflatable in the middle of the tarp and unroll the unit after removing the straps. (unrolls from back to front of inflatable) The Obstacle Course comes in two inflatables that need to be connected together. The bag with the green tag is the starting point of the inflatable. Take this inflatable out of the bag and start to unroll where you want your starting line. Second, take the 2 nd inflatable out and lined it up with the end of the first one. You will be connecting these two inflatables with a bungee cord. Continue to roll the second inflatable to the end part.

3 Connect either tube snugly (choose the one closest to the electricity source) to the blower using the strap attached to the tube. Make sure that all intake openings of the blower are free from any obstructions. 8. Twist the vent (the other tube) several times, fold it over and secure snugly with the attached strap. Close any extra zipper vents that may be open on the inflatable for quick deflation. NOTE: Not all inflatables have more than one tube. Only applicable if there is more than 2 air tubes.

4 9. Drive an anchor at least 3 feet from the inflatable to the ground at a 45 degree angle with the head pointing away from the Inflatable unit. Secure the unit at all times to the corresponding number of anchors. Use the straps to attach the anchors to all the double-loops as provided in specific areas on the base of the Inflatable unit. Large units with high profiles (Giant Slides, etc) have additional tie down loops that are located at higher points. Each of these additional locations should also be attached to the anchor at a 45 angle. 10. Plug the blower into the closest properly grounded (GFCI) 110v outlet only after you carefully read the blower manufacturer's safety instructions. Turn the switch on and wait (approximately 2 minutes) until the Bounce Around Inflatable is fully inflated and the equipment and all parts have been examined for potentially unsafe conditions before letting children in the Bounce Around Inflatable. As it inflates there may be zippers that need to be closed. If the inflatable feels soft, a zipper or end must be closed off. 11.This unit requires continuous air pressure. Do not turn the blower off while children are in the Bounce Around Inflatable. DEFLATION PROCEDURES 1. Make sure there are no children inside or around the Bounce Around Inflatable unit before you turn the switch off and unplug the blower. 2. Disconnect the air tube from the blower and untie the second air tube. Unzip the quick release air chambers usually located beside the air tubes. Let both air tubes lie parallel to each other so the air can escape freely.

5 3. As the Bounce Around Inflatable deflates, arrange the columns to fall on top of the base making sure that the deflated unit is evenly spread out. IMPORTANT When rolling inflatable, make sure all colored vinals are inside of roll. You should only be able to see the bottom of inflatable once completely rolled. This will protect inflatable during transport and keep the lessee from receiving damage fee s When rolling, be sure to start the roll as tight as possible, as this will create easy mobility and easier maneuvering. 4. Undo the bungee cord holding the inflatables together. Start with the inflatable with the large slide first. Standing in front of landing part of the slide, fold the left side 1/3 towards the middle. The right side will fold overtop of the left side making it into 3rds. (Same way you fold a piece of paper to put into an envelope.)

6 5. Roll from back to front. Start at the landing of the tall slide and roll nd towards the middle. Tie up that inflatable. Fold the 2 inflatable same as the first. Roll from the middle to the starting line of the nd 2 inflatable. Put this inflatable in the bag with the green tag attached to the bag. (starting line inflatable goes with green tag) Please make sure to start from back of Obstacle Course to middle, then from middle to the start line. This makes unrolling inflatable much easier if everyone rolls it the same. Thank you, Bounce Around. 6. Secure the roll with each strap 7. Dolly the Bounce Around tied into a slip knot. unit into a dry area for storage.