Bernhard Thomas September EnCal 3000 prochain Energy in Gas with ROI

Transcription

1 Bernhard Thomas September 2018 EnCal 3000 prochain Energy in Gas with ROI

2 Agenda 1 Introduction The new EnCal 3000 prochain Technical details Outlook

3 Introduction 2

4 What we measure and why 3 What we measure Heating Value Density Compressibility Composition Why we measure Volume to energy to $value

5 Current Gas Analyzer Portfolio 4 Gas Analyzer GasLab Q2 - Fast correlative analyzer for natural gas The GasLab Q2 ensures a fast online natural gas analysis with ISO/GPA/ASTM calculations. It has a small footprint and requires no carrier gas. It fulfills accuracy Class A according to OIML R140. Gas Chromatograph EnCal High accuracy energy measurement The EnCal 3000 is specially designed for fiscal energy measurement of natural gas. It uses chromatography components based on the latest Micro Electro Mechanical Systems (MEMS) technology and capillary columns. This yields in highly repeatable and accurate analysis results.

6 Gas Chromatograph EnCal Features Modular setup Agilent column modules Stand-alone operation 5 streams capability Auto calibration / Internal bypass Outside installation possible Serial &TCP Modbus ATEX / IECEx / FM Exd approved Applications Available for a wide variety of applications (Natural/Bio/eGas, H2S, CO2, Odorants, up to 13 components with a Quad)

7 The new EnCal 3000 prochain 6

8 Gas Chromatograph EnCal 3000 prochain 7 Multi-stream custody transfer gas chromatograph Own GC module technology - Dual column, single train - Market leading MEMS GC techniques 5 streams with one analyzer ISO / GPA / ASTM* and AGA* calculations Application: C6+ ATEX / IECEx / ccsaus Exd approved Lowest carrier gas consumption in the world *Not in first release

9 Gas Chromatograph EnCal 3000 prochain 8 Multi-stream custody transfer gas chromatograph Up to two GC modules* Modular electronics, based on Elster encore platform Easy-to-use PC software Local display optional Local USB-port optional *Not in first release

10 Installation everywhere 9 Ambient temperature -25 to +55 C / -13 to 131 F Place of use Installation close to the sampling point up to Ex Zone 1 Inside or Outside

11 Measure everything (up to C6+) 10

12 Calculate everything 11 Calculated values Density - kg/m3 - lb/scf Wobbe index Compressibility Heating Values - MJ/m3 - BTU/scf - kj/kg Supported standards ISO 6976 GPA-2172 ASTM D3588* AGA-5* *Not in first release

13 Options 12 Local display Mounting plate Local USB

14 Comparison EnCal 3000 prochain vs. EnCal EnCal 3000 prochain EnCal 3000 Application range C 6 + C 6 + / C 9 / C 9 HCDP / Bio / egas / H 2 S Accuracy 0,25% (with SLC); 0,1% can be increased with multi level calibration (MLC). Repeatability 0,025%RSD 0,005%RSD Cycle time C 6 + max. 4 min 3 min Ex approval (Exd) ATEX / IECEx / ccsaus ATEX / IECEx / FM Metrology NIM (China)*, OIML R140 class A* National approvals for Germany, France, etc. Helium usage 7 years one bottle (50 liter) 2 years one bottle (50 liter) Configuration software ensuite RGC3000 (Agilent) *Not in first release

15 Technical details 14

16 GCM new development, own technology 15 Main application: C6+ analysis - Accuracy: 0,25% (with SLC); can be increased with multi level calibration (MLC). - Repeatability: 0,025%RSD - Limit of detection C5: 50ppm Very low helium consumption (half of EnCal 3000) Single train, dual column Easy configuration, simple troubleshooting Channel replacement with two screws Cycle time C6+: Analysis time 2-2,5 min + cooling phase up to 1,5 min cycle (depending on ambient temperature)

17 Complete GC module on single PCB 16 GCM1000 concept: - 1 injector, fixed loop - 2 detectors - Pre column + main column - Backflush to detector

18 GCM1000 concept 17

19 Separation column 18 Channel length of cm Channel diameter of 0,2 0,4 mm Manufactured using MEMS technology: located on a silicon/pyrex chip in a meandering configuration.

20 Sample injector 19 The injection must guarantee the precise delivery of the sample in terms of volume, pressure, temperature and flow rate. Manufactured using MEMS technology: Channels etched in silicon and diaphragm valves. Achieves high-precision control of the injection volume and temperature.

21 Thermal Conductivity Detector (TCD) 20 Wheatstone bridge Manufactured using MEMS technology: Circuit of 4 freely suspended platinum filaments on a Silicon/Pyrex chip.

22 Gas supply connections 21 Connection Position on the device/note Sample gas streams 1 5 Calibration gas cylinder with P1-1K Carrier gas cylinder with helium Sample and blocking vent (SBV) Module vent (MV) It is possible to measure up to 5 different gases in sequence. Used to maintain measurement accuracy. For transporting the measurement gas inside the device; waste gas is released into the housing. The unmeasured sample gas is released at ambient pressure. The waste sample and carrier gas is released at ambient pressure. Purge vent (PV) Flushing or bypass gas is released at a high flow rate.

23 Inputs/Outputs & Communication Interfaces 22 Digital outputs: 2 (24V DC, common earth, electrically isolated) Digital inputs: 2 (maximum supply voltage 9V, electrically isolated) Communication interfaces 1 x Ethernet (TCP/IP; Modbus; ftp; http) 2 x RS485 (Modbus serial/optional display near the device)

24 Local Display (optional) 23 LCD graphic display 128 x 64 dots Operates independently from ensuite Powered by the device Connected to optional IS display board Display values - Serial number, IP address - Errors/Warnings, operating mode - Current operating step, Current calculation standard with the selected settings - Higher heating value, Density at base conditions, Superior Wobbe index, Compressibility factor, Methane number, Carbon dioxide - Gas analysis with 10 components and the total of the C6+ components

25 encore platform 24 Based on proven encore platform (used for FC, USM, GC) Enhanced interface possibilities: - Freely definable Modbus communication (slave/client and master/server) Embedded archives - Events - Hourly/daily / monthly averages Built-in web server for remote front panel Parameterization & Analysis software ensuite (used for all Elster Gas metering devices) EnCal 3000 prochain

26 System overview 25

27 Outlook 26

28 Next steps Usage of the second module for: - egas (power-to-gas technology): H 2 - Biogas: H2, O 2

29 28