SAFETY DATA SHEET RADIANCE FURNITURE POLISH

Transcription

1 Section: 1. PRODUCT AND COMPANY IDENTIFICATION Product name : Other means of identification : Not applicable. Recommended use : Furniture Polish Restrictions on use : Reserved for industrial and professional use. Product dilution information : Product is sold ready to use. Company : ECOLAB PTY LTD 2 Drake Avenue Macquarie Park, NSW Australia Emergency telephone number : , Issuing date : Section: 2. HAZARDS IDENTIFICATION GHS Classification Flammable aerosols : Category 1 Specific target organ toxicity - : Category 3 (Central Nervous System) single exposure Aspiration hazard : Category 1 GHS Label element Hazard pictograms : Signal Word Hazard Statements Precautionary Statements : Danger : Extremely flammable aerosol. May be fatal if swallowed and enters airways. May cause drowsiness or dizziness. : Prevention: Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Avoid breathing dust/ fume/ gas/ mist/ vapours/ spray. Use only outdoors or in a wellventilated area. Response: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or doctor/ physician if you feel unwell. IF SWALLOWED: Immediately call a POISON CENTER/doctor. Do NOT induce vomiting. Storage: Store in a well-ventilated place. Keep container tightly closed. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50 C/ 122 F / 7

2 Disposal: Dispose of contents/ container to an approved waste disposal plant. Other hazards : None known. Section: 3. COMPOSITION/INFORMATION ON INGREDIENTS Pure substance/mixture : Mixture Chemical Name CAS-No. Concentration: (%) solvent naphtha (petroleum), medium aliph butane propane Section: 4. FIRST AID MEASURES In case of eye contact In case of skin contact If swallowed : Rinse with plenty of water. : Rinse with plenty of water. : Contact the Poison's Information Centre (eg Australia ; New Zealand ). Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Aspiration hazard if swallowed - can enter lungs and cause damage. Get medical attention immediately. If inhaled Protection of first-aiders Notes to physician Most important symptoms and effects, both acute and delayed : Remove to fresh air. Treat symptomatically. Get medical attention if symptoms occur. : If potential for exposure exists refer to Section 8 for specific personal protective equipment. : Treat symptomatically. : See Section 11 for more detailed information on health effects and symptoms. Section: 5. FIREFIGHTING MEASURES Suitable extinguishing media Unsuitable extinguishing media Specific hazards during firefighting Hazardous combustion products Special protective equipment for firefighters Specific extinguishing methods : Water spray Dry chemical : High volume water jet : Extremely flammable aerosol. Pressurized container: May burst if heated. : Decomposition products may include the following materials: Carbon oxides : In case of fire, wear a full face positive-pressure self contained breathing apparatus and protective suit. : Fire residues and contaminated fire extinguishing water must be disposed of in accordance with local regulations. In the event of fire / 7

3 and/or explosion do not breathe fumes. Hazchem Code : 2YE Section: 6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures Environmental precautions Methods and materials for containment and cleaning up : Refer to protective measures listed in sections 7 and 8. : Do not allow contact with soil, surface or ground water. : Stop leak if safe to do so. Section: 7. HANDLING AND STORAGE Advice on safe handling Conditions for safe storage : Use only with adequate ventilation. Contents under pressure. Do not puncture. Wash hands thoroughly after handling. : Keep in a cool, well-ventilated place. Keep out of reach of children. Keep container tightly closed. Store in suitable labeled containers. Storage temperature : 0 C to 35 C Section: 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Components with workplace control parameters Components CAS-No. Form of exposure Permissible concentration butane TWA 800 ppm 1,900 mg/m3 Basis AU OEL Engineering measures : Effective exhaust ventilation system. Maintain air concentrations below occupational exposure standards. Personal protective equipment Eye protection Hand protection Skin protection Respiratory protection Hygiene measures : Safety glasses : Impervious gloves : No special protective equipment required. : When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. : Handle in accordance with good industrial hygiene and safety practice. Wash face, hands and any exposed skin thoroughly after handling. Section: 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance Colour : Aerosol. : white / 7

4 Odour : Perfumes, fragrances ph : , 100 % Flash point : closed cupnot applicable., Sustains combustion Odour Threshold Melting point/freezing point Initial boiling point and boiling range Evaporation rate Flammability (solid, gas) Upper explosion limit Lower explosion limit Vapour pressure Relative vapour density : < 35 C Relative density : Water solubility Solubility in other solvents Partition coefficient: n- octanol/water Auto-ignition temperature Thermal decomposition Viscosity, kinematic Explosive properties Oxidizing properties Molecular weight VOC Section: 10. STABILITY AND REACTIVITY Chemical stability Possibility of hazardous reactions Conditions to avoid Incompatible materials Hazardous decomposition products : Stable under normal conditions. : No dangerous reaction known under conditions of normal use. : None known. : Metals Bases Organic materials : No decomposition if stored and applied as directed. Section: 11. TOXICOLOGICAL INFORMATION Information on likely routes of exposure : Eye contact, Skin contact Potential Health Effects / 7

5 Eyes Skin Ingestion Inhalation Chronic Exposure : Health injuries are not known or expected under normal use. : Health injuries are not known or expected under normal use. : May be fatal if swallowed and enters airways. : Inhalation may cause central nervous system effects. : Health injuries are not known or expected under normal use. Experience with human exposure Eye contact Skin contact Ingestion Inhalation : No symptoms known or expected. : No symptoms known or expected. : Vomiting : Dizziness, Drowsiness Toxicity Acute oral toxicity Acute inhalation toxicity Acute dermal toxicity Skin corrosion/irritation Serious eye damage/eye irritation Respiratory or skin sensitization Carcinogenicity Reproductive effects Germ cell mutagenicity Teratogenicity STOT - single exposure STOT - repeated exposure Aspiration toxicity Components Acute oral toxicity Components Acute dermal toxicity : solvent naphtha (petroleum), medium aliph. LD50 rat: > 5,000 mg/kg : solvent naphtha (petroleum), medium aliph. LD50 rabbit: > 2,000 mg/kg Section: 12. ECOLOGICAL INFORMATION Ecotoxicity Environmental Effects : This product has no known ecotoxicological effects / 7

6 Product Toxicity to fish Toxicity to daphnia and other aquatic invertebrates Toxicity to algae Components Toxicity to fish : solvent naphtha (petroleum), medium aliph. 96 h LC50 Fish: 800 mg/l Persistence and degradability Bioaccumulative potential Mobility in soil Other adverse effects Section: 13. DISPOSAL CONSIDERATIONS Disposal methods Disposal considerations : Where possible recycling is preferred to disposal or incineration. If recycling is not practicable, dispose of in compliance with local regulations. Dispose of wastes in an approved waste disposal facility. : Dispose of as unused product. Empty containers should be taken to an approved waste handling site for recycling or disposal. Do not reuse empty containers. Dispose of in accordance with local, state, and federal regulations. Section: 14. TRANSPORT INFORMATION The shipper/consignor/sender is responsible to ensure that the packaging, labeling, and markings are in compliance with the selected mode of transport. Land transport (ADG) UN number : 1950 Description of the goods : AEROSOLS Class : 2.1 Hazchem Code : 2YE Environmentally hazardous : No Sea transport (IMDG/IMO) UN number : 1950 Description of the goods : AEROSOLS Class : 2.1 Marine pollutant : No Section: 15. REGULATORY INFORMATION / 7

7 National regulatory information Standard for the Uniform Scheduling of Medicines and Poisons : Schedule 5 The components of this product are reported in the following inventories: United States TSCA Inventory : On TSCA Inventory Canadian Domestic Substances List (DSL) : All components of this product are on the Canadian DSL. Australia. Industrial Chemical (Notification and Assessment) Act : New Zealand. Inventory of Chemicals (NZIoC), as published by ERMA New Zealand : Japan. ENCS - Existing and New Chemical Substances Inventory : not determined Japan. ISHL - Inventory of Chemical Substances (METI) : not determined Korea. Korean Existing Chemicals Inventory (KECI) : Philippines Inventory of Chemicals and Chemical Substances (PICCS) : China Inventory of Existing Chemical Substances : Section: 16. OTHER INFORMATION Sources of key data used to compile the Safety Data Sheet Globally Harmonized System of Classification and Labelling of Chemicals (GHS) IARC: (International Agency for Research on Cancer) US. National Toxicology Program (NTP) Report on Carcinogens ECHA List of Publishable Substances Registered EU HPVCs (High Production Volume Chemicals) Issuing date : version : 1.0 Prepared by : Regulatory Affairs REVISED INFORMATION: Significant changes to regulatory or health information for this revision is indicated by a bar in the left-hand margin of the SDS. The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text / 7