SLIPPER & ROLL-TOP FREESTANDING BATHS

Transcription

1 SLIPPER & ROLL-TOP FREESTANDING BATHS JINS0051

2 PLEASE NOTE THIS PRODUCT REQUIRES 2 PERSONS OR MORE TO LIFT AND MANOUEVRE THIS PRODUCT INTO POSITION. The installation of freestanding baths will necessitate the sinking of pipework into the floor. Please plan for this prior to installation of the product. All screws and fittings for general installation are provided but specialist fixings for wall and floors may be required. Please ensure that the bath is fully checked prior to installation. Once removed from the box carefully unwrap the protective packaging from the bath for inspection purposes and re-use for protection whilst fitting. TO THE INSTALLER: Please read and follow this instruction carefully, as the guarantee is valid only if the bath is installed as directed. CAUTION Care Should be taken when drilling walls and floors to avoid any hidden wires or pipes. IMPORTANT: PLEASE LEAVE THIS INSTRUCTION MANUAL WITH THE END USER ONCE THE BATH HAS BEEN INSTALLED.

3 PARTS SUPPLIED x4 or x8 Dependent on product THESE COMPONENTS ARE SUPPLIED WITH THE BATH PARTS REQUIRED x4 EXPOSED WASTE KIT SHALLOW P TRAP THESE COMPONENTS ARE NOT SUPPLIED PLEASE PURCHASE SEPARATELY.

4 Remove bath from box and carefully upwrap the protective packaging NOTE: Before turning the bath over place a protective sheet on the floor, to ensure there is no damage to the product. 1 Turn the bath back over and position the feet on the underside of the bath using the fixings supplied NOTE: The feet are Universal Ensure the Area the bath will be located is level and check the feet are sat on the floor so the bath doesn t rock 2 Use a spirt level to check all feet are aligned with one another to prevent the bath rocking. Then tighten fixings joining the feet to the bath to ensure the feet are secure. 3

5 Now pre fit your chrome waste outlet pipe, NOTE:This pipe is not included with the bath or waste kit 4 Draw a pencil line on the floor around the bottom edge of the feet and inside the fixing hole on the base of the foot. 5 Lift product and place away from traced lines. Now prepare the marks for the suitable fixings require for the floor substrate. 6

6 Now place the bath back on the marks and begin connecting the pipework. Now the bath is in its final position water test the bath to ensure there are no leaks. 7 Use a spirt level to check all feet are aligned with one another to prevent the bath rocking. Then fully tighten the fixings connecting the feet to the bath as well as the fixings securing the bath to the floor. 8 EXAMPLE Now the product is in place, now position and plumb in the brassware. Note: Brassware style & placement shown is for example purposes only. 9

7 Bath Care and Maintenance FILLING: It is always advisable to run the cold water before turning on the hot tap. CLEANING: The bath should always be cleaned immediately after use, preferably whilst the water is running out and the bath is still warm. The film of insoluble soap products, body fats and grime which will otherwise harden on the bath surface are easily removed at this stage. In hard water districts insoluble lime salts are deposited below the waterline and also under leaking taps. If this deposit is allowed to build up it becomes increasingly difficult to remove and looks unsightly. If noticed, this should be promptly cleaned with hot, soapy water before wiping the bath dry. CLEANING MATERIALS: Cleaners of a gritty or abrasive nature should never be used. Worn washers on dripping taps should be replaced immediately. Do not use harsh abrasives particularly on the Jacuzzi logo. CHEMICALS: The bath surface has good resistance properties to acids and alkalis but should not be allowed to come into contact with organic solvents such as some dry cleaning agents and paint strippers. REMOVAL OF SCRATCHES: In the event of slight scratches in the bath surface, a mild abrasive (similar to metal polish) can be used to polish them out. Please note that burning cigarettes should never be allowed to come into contact with the surface of the bath or damage may ensue. For further information please contact your retailer. ISSUE 5