Reckitt Benckiser LLC. Morris Corporate Center IV 399 Interpace Parkway (P.O. Box 225) Parsippany, New Jersey

Transcription

1 Product name Distributed by SAFETY DATA SHEET 1. Product and company identification Finish Gelpacs All variants Finish Gelpacs All variants Reckitt Benckiser LLC. Morris Corporate Center IV 399 Interpace Parkway (P.O. Box 225) Parsippany, New Jersey Emergency telephone number (Medical) Emergency telephone number (Transport) Website (U.S. & Canada) CHEMTREC Outside U.S. and Canada (North America), call Chemtrec http// Product use Detergent for use in domestic automatic dishwashers This SDS is designed for workplace employees, emergency personnel and for other conditions and situations where there is greater potential for large-scale or prolonged exposure, in accordance with the requirements of USDOL Occupational Safety and Health Administration. This SDS is not applicable for consumer use of our products. For consumer use, all precautionary and first aid language is provided on the product label in accordance with the applicable government regulations, and shown in Section 15 of this SDS. Formulation # UPC Code / Sizes FF849749_1, FF849722_1 (Fresh); FF84975_1, FF849723_1 (Orange); FF849753_1, FF849726_1 (Lavender) tbd 2. Hazards identification Classification of the substance or mixture Not classified Percentage of the mixture consisting of ingredient(s) of unknown toxicity 81.1% GHS label elements Hazard pictograms Not applicable. Signal word No signal word. Hazard statements Precautionary statements General Prevention Response No known significant effects or critical hazards. Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand. Not applicable. Not applicable. Date of issue 1/9

2 2. Hazards identification Storage Disposal Supplemental label elements Hazards not otherwise classified Not applicable. Not applicable. None known. None known. 3. Composition/information on ingredients Substance/mixture Mixture There are no ingredients present which, within the current knowledge of the supplier and in the concentrations applicable, are classified as hazardous to health or the environment and hence require reporting in this section. 4. First aid measures Description of necessary first aid measures Ingestion Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Get medical attention if irritation occurs. Remove victim to fresh air and keep at rest in a position comfortable for breathing. Get medical attention if symptoms occur. In case of inhalation of decomposition products in a fire, symptoms may be delayed. The exposed person may need to be kept under medical surveillance for 48 hours. Flush contaminated skin with plenty of water. Remove contaminated clothing and shoes. Get medical attention if symptoms occur. Wash out mouth with water. Move to fresh air. If material has been swallowed and the exposed person is conscious, give small quantities of water to drink. Do not induce vomiting unless directed to do so by medical personnel. Get medical attention if symptoms occur. Most important symptoms/effects, acute and delayed Potential acute health effects No known significant effects or critical hazards. No known significant effects or critical hazards. No known significant effects or critical hazards. Ingestion No known significant effects or critical hazards. Over-exposure signs/symptoms Ingestion No specific data. No specific data. No specific data. No specific data. Indication of immediate medical attention and special treatment needed, if necessary Notes to physician Treat symptomatically. Specific treatments No specific treatment. Protection of first-aiders No action shall be taken involving any personal risk or without suitable training. See toxicological information (Section 11) Date of issue 2/9

3 5. Fire-fighting measures Extinguishing media Suitable extinguishing media Unsuitable extinguishing media Use an extinguishing agent suitable for the surrounding fire. None known. Specific hazards arising from the chemical Hazardous thermal decomposition products In a fire or if heated, a pressure increase will occur and the container may burst. Decomposition products may include the following materials carbon dioxide carbon monoxide nitrogen oxides sulfur oxides metal oxide/oxides Special protective actions for fire-fighters Special protective equipment for fire-fighters 6. Accidental release measures Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire. No action shall be taken involving any personal risk or without suitable training. Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode. Personal precautions, protective equipment and emergency procedures For non-emergency personnel For emergency responders No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilled material. Put on appropriate personal protective equipment. If specialised clothing is required to deal with the spillage, take note of any information in Section 8 on suitable and unsuitable materials. See also the information in "For nonemergency personnel". Environmental precautions Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Inform the relevant authorities if the product has caused environmental pollution (sewers, waterways, soil or air). Methods and materials for containment and cleaning up Small spill Large spill Stop leak if without risk. Move containers from spill area. Dilute with water and mop up if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and place in an appropriate waste disposal container. Dispose of via a licensed waste disposal contractor. Stop leak if without risk. Move containers from spill area. Prevent entry into sewers, water courses, basements or confined areas. Wash spillages into an effluent treatment plant or proceed as follows. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations (see Section 13). Dispose of via a licensed waste disposal contractor. Note see Section 1 for emergency contact information and Section 13 for waste disposal. Date of issue 3/9

4 7. Handling and storage Precautions for safe handling Protective measures Put on appropriate personal protective equipment (see Section 8). Conditions for safe storage, including any incompatibilities Not applicable. Do not store above the following temperature 5 C (122 F). Store in accordance with local regulations. Store in original container protected from direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials (see Section 1) and food and drink. Keep container tightly closed and sealed until ready for use. Containers that have been opened must be carefully resealed and kept upright to prevent leakage. Do not store in unlabeled containers. Use appropriate containment to avoid environmental contamination. 8. Exposure controls/personal protection Control Occupational exposure limits Appropriate engineering controls Environmental exposure controls Individual protection measures Hygiene measures Eye/face protection Skin protection Hand protection Body protection Other skin protection Respiratory protection Good general ventilation should be sufficient to control worker exposure to airborne contaminants. Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation. In some cases, fume scrubbers, filters or engineering modifications to the process equipment will be necessary to reduce emissions to acceptable levels. Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Appropriate techniques should be used to remove potentially contaminated clothing. Wash contaminated clothing before reusing. Ensure that eyewash stations and safety showers are close to the workstation location. Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases or dusts. If contact is possible, the following protection should be worn, unless the assessment indicates a higher degree of protection safety glasses with sideshields. Chemical-resistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical products if a risk assessment indicates this is necessary. Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Appropriate footwear and any additional skin protection measures should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Use a properly fitted, air-purifying or air-fed respirator complying with an approved standard if a risk assessment indicates this is necessary. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. Date of issue 4/9

5 9. Physical and chemical properties Appearance Physical state Color Liquid. [Liquid.covered by a PVOH pouch] Blue. Orange. Violet. Odor Odor threshold ph Melting point Boiling point Flash point Evaporation rate Flammability (solid, gas) Lower and upper explosive (flammable) limits Vapor pressure Vapor density Relative density Solubility Partition coefficient n- octanol/water Auto-ignition temperature Decomposition temperature Viscosity Characteristic. 9.1 to 9.9 [Conc. (% w/w) 1%] Easily soluble in the following materials cold water and hot water. 1. Stability and reactivity Reactivity Chemical stability Possibility of hazardous reactions Conditions to avoid Incompatible materials Hazardous decomposition products Dynamic (room temperature) 2 to 24 mpa s (2 to 24 cp) The product is stable. No specific data. 11. Toxicological information Information on toxicological effects Acute toxicity Irritation/Corrosion Sensitization Mutagenicity No specific test data related to reactivity available for this product or its ingredients. Under normal conditions of storage and use, hazardous reactions will not occur. Polymerization. There are no data available on the mixture itself. Do not mix with household chemicals Hazardous decomposition products carbon oxides, Various Organic chemicals. Date of issue 5/9

6 11. Toxicological information Carcinogenicity Reproductive toxicity Teratogenicity Specific target organ toxicity (single exposure) Specific target organ toxicity (repeated exposure) Aspiration hazard Information on the likely routes of exposure Potential acute health effects Ingestion No known significant effects or critical hazards. No known significant effects or critical hazards. No known significant effects or critical hazards. No known significant effects or critical hazards. Symptoms related to the physical, chemical and toxicological characteristics No specific data. No specific data. No specific data. Ingestion No specific data. Delayed and immediate effects and also chronic effects from short and long term exposure Short term exposure Potential immediate effects Potential delayed effects Long term exposure Potential immediate effects Potential delayed effects Potential chronic health effects General Carcinogenicity Mutagenicity Teratogenicity No known significant effects or critical hazards. No known significant effects or critical hazards. No known significant effects or critical hazards. No known significant effects or critical hazards. Date of issue 6/9

7 11. Toxicological information Developmental effects No known significant effects or critical hazards. Fertility effects No known significant effects or critical hazards. Numerical measures of toxicity Acute toxicity estimates 12. Ecological information Toxicity Persistence and degradability Bioaccumulative potential Mobility in soil Soil/water partition coefficient (KOC) Other adverse effects 13. Disposal considerations Disposal methods 14. Transport information No known significant effects or critical hazards. Waste packaging should be recycled. Waste must be disposed of in accordance with federal, state and local environmental control regulations. Not a DOT controlled material (United States). Not a TDG-controlled material. This preparation is not classified as dangerous according to international transport regulations (ADR/RID, IMDG or ICAO/IATA). 15. Regulatory information U.S. Federal regulations Clean Air Act Section 112 (b) Hazardous Air Pollutants (HAPs) Clean Air Act Section 62 Class I Substances TSCA 8(a) CDR Exempt/Partial exemption Not determined United States inventory (TSCA 8b) All components are listed or exempted. Clean Water Act (CWA) 311 Formaldehyde, solution Not listed Not listed Date of issue 7/9

8 15. Regulatory information Clean Air Act Section 62 Class II Substances DEA List I Chemicals (Precursor Chemicals) DEA List II Chemicals (Essential Chemicals) SARA 32/34 Not listed Not listed Not listed Composition/information on ingredients No products were found. SARA 34 RQ SARA 311/312 Classification State regulations Massachusetts New York New Jersey Pennsylvania Not applicable. Not applicable. Composition/information on ingredients No products were found. None of the components are listed. None of the components are listed. The following components are listed PROPYLENE GLYCOL; 1,2-PROPANEDIOL The following components are listed 1,2-PROPANEDIOL Label elements Signal word Hazard statements Precautionary measures None Required None required Avoid contact with eyes. 16. Other information Hazardous Material Information System (U.S.A.) Health Flammability Physical hazards Caution HMIS ratings are based on a -4 rating scale, with representing minimal hazards or risks, and 4 representing significant hazards or risks Although HMIS ratings are not required on MSDSs under 29 CFR , the preparer may choose to provide them. HMIS ratings are to be used with a fully implemented HMIS program. HMIS is a registered mark of the National Paint & Coatings Association (NPCA). HMIS materials may be purchased exclusively from J. J. Keller (8) Personal protection B Date of issue 8/9

9 16. Other information The customer is responsible for determining the PPE code for this material. National Fire Protection Association (U.S.A.) Health Flammability Instability/Reactivity Special Reprinted with permission from NFPA 74-21, Identification of the Hazards of Materials for Emergency Response Copyright 1997, National Fire Protection Association, Quincy, MA This reprinted material is not the complete and official position of the National Fire Protection Association, on the referenced subject which is represented only by the standard in its entirety. Copyright 21, National Fire Protection Association, Quincy, MA This warning system is intended to be interpreted and applied only by properly trained individuals to identify fire, health and reactivity hazards of chemicals. The user is referred to certain limited number of chemicals with recommended classifications in NFPA 49 and NFPA 325, which would be used as a guideline only. Whether the chemicals are classified by NFPA or not, anyone using the 74 systems to classify chemicals does so at their own risk. Date of issue Date of previous issue Version Prepared by 2 Reckitt Benckiser LLC. Product Safety Department 1 Philips Parkway Montvale, New Jersey USA. FAX Indicates information that has changed from previously issued version. Notice to reader To the best of our knowledge, the information contained herein is accurate. However, neither the above-named supplier, nor any of its subsidiaries, assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist. RB is a member of the CSPA Product Care Product Stewardship Program. Date of issue 9/9