of bullets, about 100 bullets are manufa Though less force is required, it becomes a t assembly machine came into existence. is a circle.

Transcription

1 the rod and is forced pushed with the help o next flange is placed with an angle 120 de forced into the rod. The same procedure is third flange. Following this manual proced of bullets, about 100 bullets are manufa Though less force is required, it becomes a t workers to do hammering. To eliminate this also enhance the production, the idea of assembly machine came into existence. The Bullet is being fitted with the copper f three in number and they have been fitted 120 degrees so that when the flanges are m then their straight vision makes an angle of is a circle.

2 Figure 3: Standard graph for pressure The above graph is a standard chart wh determining the air pressure inside the cylind diameter and force. The abscissa represents t KPa and ordinate represents force in N. Th are given by the colour lines. Knowing any parameters we can find the third. In t calculated the diameter of bore and require hence could find the air pressure that is need

3 Figure 5: Shear Stress Analysis o ANSYS software has been used for the analy In this force is exerted at the edge of the cyclic strokes during the operation. Hence loads, the frame is tested it in shear. Maximum shear stresses are generated at th the bolts and edges.

4 Total force acting on frame will be: Weight of cylinder =17 N Force of stroke=160n Weight of L plates=17.08*2=35 N Total weight=509n Selecting 100*100 square plate Load carrying capacity =800N FOS (factor of safety) =800/509=1.57 As the bottom plate is safe so will be the upp Analysis of L-Plate

5 2.6 Adon Block Figure 13: Catia part of base p Design of Adon Block Series Table 4: Type of Adon block and Square Tap Load Hole Assembly Height WE Low Heavy WEH- CA Tap hole - Dr h

6 2.7 Design of Rail HIWIN offers a number of standard rail leng lengths feature end mounting hole pla predetermined values (E). For non-standard sure to specify the E-value to be no greater (P) dimension. An E-value greater than this will result in un Calculations for design of rail L= (n 1) P + 2 E L: Total length of rail (mm) n: Number of mounting holes P: Distance between any two holes (mm) E: Distance from the center of the last hole t

7 indexing mechanism is made. Figure 18: Catia part of assembly indexi

8 Figure 22: Drafted part drawing of d

9 flow of a liquid or gas at a certain pressur used to allow high-pressure fluid supply lin reduced to safe and/or usable pressu applications. Gas pressure regulators are use pressure and are not used for measuring meters, Rota meters or Mass Flow Contro accurately regulate gas flow rates Pneumatic lubricator A pneumatic lubricator injects an aerosoliz into an airline to provide lubrication to the parts of pneumatic tools, and to other actuating cylinders, valves and motors.

10 pneumatic actuators, Transactions of th of Dynamic systems, Measurement and no.4, 1997, pp [2] Ming-Hung Tsai, Design and C Pneumatic Cylinder Precision Positionin Loading. [3] Robert B. van Varseveld and Ga Accurate Position Control of a Pneumat [4] A. ILCHMANN, Pneumatic cylinde feedback force-control. International J Vol. 79, No. 6, June 2006, Author Profile Vineet Kadam received the Bachelo Mechanical Engineering from DYPIEMR, P 2016.Currently working with Dassault S research and development Quality assu engineer.