Safety data sheet according to 1907/2006/EC, Article 31

Transcription

1 Page 1/6 * SECTION 1: Identification of the substance/mixture and of the company/ undertaking Product identifier Relevant identified uses of the substance or mixture and uses advised against - Application of the substance / the mixture concrete protection Details of the supplier of the safety data sheet - Manufacturer/Supplier: Ha-Be Betonchemie GmbH & Co. KG Stuevestrasse HAMELN, GERMANY - Further information obtainable from: Product Safety Department reach@ha-be.com Emergency telephone number: Only available during office hours. * SECTION 2: Hazards identification Classification of the substance or mixture - Classification according to Regulation (EC) No 1272/2008 The product is not classified according to the CLP regulation. - Classification according to Directive 67/548/EEC or Directive 1999/45/EC Not applicable. - Information concerning particular hazards for human and environment: The product does not have to be labelled due to the calculation procedure of the "General Classification guideline for preparations of the EU" in the latest valid version. - Classification system: The classification is according to the latest editions of the EU-lists, and extended by company and literature data Label elements - Labelling according to Regulation (EC) No 1272/2008 Void - Hazard pictograms Void - Signal word Void - Hazard statements Void - Information concerning particular hazards for human and environment: The proper disposal of used oil has to be carried out. An unproper disposal causes a danger of the environment. Any addition of components, e.g. solvents and cooling agents are forbidden Other hazards - Results of PBT and vpvb assessment - PBT: Not applicable. - vpvb: Not applicable. * SECTION 3: Composition/information on ingredients Chemical characterisation: Mixtures - Description: aqueous UV coating - Dangerous components: Void (Contd. on page 2)

2 Page 2/6 (Contd. of page 1) * SECTION 4: First aid measures Description of first aid measures - General information: No special measures required. Position and transport stably in side position. - After inhalation: Supply fresh air; consult doctor in case of complaints. In case of unconsciousness place patient stably in side position for transportation. - After skin contact: Immediately wash with water and soap and rinse thoroughly. Generally the product does not irritate the skin. - After eye contact: Rinse opened eye for several minutes under running water. - After swallowing: Do not induce vomiting; call for medical help immediately Most important symptoms and effects, both acute and delayed Indication of any immediate medical attention and special treatment needed * SECTION 5: Firefighting measures Extinguishing media - Suitable extinguishing agents: Use fire extinguishing methods suitable to surrounding conditions. CO2, powder or water spray. Fight larger fire with alcohol resistant foam. - For safety reasons unsuitable extinguishing agents: Water with full jet Special hazards arising from the substance or mixture In case of fire, the following products can be released: Carbon monoxide (CO) Formation of toxic gases is possible during heating or in case of fire Advice for firefighters - Protective equipment: Wear self-contained respiratory protective device. - Additional information Collect contaminated fire fighting water separately. It must not enter the sewage system. * SECTION 6: Accidental release measures Personal precautions, protective equipment and emergency procedures Wear protective equipment. Keep unprotected persons away Environmental precautions: Do not allow to enter sewers/ surface or ground water. Inform respective authorities in case of seepage into water course or sewage system Methods and material for containment and cleaning up: Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust) Reference to other sections See Section 7 for information on safe handling. See Section 8 for information on personal protection equipment. See Section 13 for disposal information. * SECTION 7: Handling and storage Precautions for safe handling Keep away from heat and direct sunlight. Wear suitable respiratory protective device when decanting larger quantities without extractor facilities. Only handle and refill product in closed systems. (Contd. on page 3)

3 Page 3/6 - Information about fire - and explosion protection: No special measures required Conditions for safe storage, including any incompatibilities - Storage: - Requirements to be met by storerooms and receptacles: Store in a cool location. - Information about storage in one common storage facility: Do not store together with oxidising and acidic materials. Do not store together with alkalis (caustic solutions). - Further information about storage conditions: Protect from heat and direct sunlight Specific end use(s) (Contd. of page 2) * SECTION 8: Exposure controls/personal protection - Additional information about design of technical facilities: No further data; see item Control parameters - Ingredients with limit values that require monitoring at the workplace: The product does not contain any relevant quantities of materials with critical values that have to be monitored at the workplace. - Additional information: The lists valid during the making were used as basis Exposure controls - Personal protective equipment: - General protective and hygienic measures: The usual precautionary measures are to be adhered to when handling chemicals. Avoid close or long term contact with the skin. Do not inhale gases / fumes / aerosols. - Respiratory protection: Use suitable respiratory protective device only when aerosol or mist is formed. - Protection of hands: The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation - Material of gloves The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. - Penetration time of glove material The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed. - Eye protection: Safety glasses - Body protection: Protective work clothing * SECTION 9: Physical and chemical properties Information on basic physical and chemical properties - General Information - Appearance: Form: Fluid Colour: Whitish - Odour: Mild - ph-value: - Change in condition Melting point/melting range: Undetermined. (Contd. on page 4)

4 Page 4/6 Boiling point/boiling range: > 100 C - Flash point: not applicable - Self-igniting: Product is not selfigniting. - Danger of explosion: Product does not present an explosion hazard. - Explosion limits: Lower: Upper: - Vapour pressure: - Density at 20 C: 1.04 g/cm³ - Solubility in / Miscibility with water: - Viscosity: Dynamic: Kinematic: Fully miscible. - Solvent content: Organic solvents: < 0.6 % Other information (Contd. of page 3) * SECTION 10: Stability and reactivity Reactivity Chemical stability - Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications Possibility of hazardous reactions Violent reactions with strong alkalis and oxidising agents. Reacts with strong acids Conditions to avoid Incompatible materials: Hazardous decomposition products: No dangerous decomposition products known. SECTION 11: Toxicological information Information on toxicological effects - Acute toxicity - Primary irritant effect: - Skin corrosion/irritation Based on available data, the classification criteria are not met. - Serious eye damage/irritation Based on available data, the classification criteria are not met. - Respiratory or skin sensitisation Based on available data, the classification criteria are not met. - CMR effects (carcinogenity, mutagenicity and toxicity for reproduction) - Germ cell mutagenicity Based on available data, the classification criteria are not met. - Carcinogenicity Based on available data, the classification criteria are not met. - Reproductive toxicity Based on available data, the classification criteria are not met. - STOT-single exposure Based on available data, the classification criteria are not met. - STOT-repeated exposure Based on available data, the classification criteria are not met. - Aspiration hazard Based on available data, the classification criteria are not met. (Contd. on page 5)

5 Page 5/6 (Contd. of page 4) * SECTION 12: Ecological information Toxicity - Aquatic toxicity: Persistence and degradability Easily eliminable from water Bioaccumulative potential Mobility in soil - Additional ecological information: - General notes: Do not allow product to reach ground water, water course or sewage system. Water hazard class 1 (German Regulation) (Self-assessment): slightly hazardous for water Results of PBT and vpvb assessment - PBT: Not applicable. - vpvb: Not applicable Other adverse effects * SECTION 13: Disposal considerations Waste treatment methods - Recommendation When storing used mineral oil products, ensure that the categories for waste oil and mixing instructions are observed. - Uncleaned packaging: - Recommendation: Packaging may be reused or recycled after cleaning. - Recommended cleansing agents: Diluted caustic solution. SECTION 14: Transport information UN-Number - ADR, ADN, IMDG, IATA Void UN proper shipping name - ADR, ADN, IMDG, IATA Void Transport hazard class(es) - ADR, ADN, IMDG, IATA - Class Void Packing group - ADR, IMDG, IATA Void Environmental hazards: Not applicable Special precautions for user Not applicable Transport in bulk according to Annex II of Marpol and the IBC Code Not applicable. - Transport/Additional information: Not dangerous according to the above specifications. - UN "Model Regulation": Void SECTION 15: Regulatory information Safety, health and environmental regulations/legislation specific for the substance or mixture Chemical safety assessment: A Chemical Safety Assessment has not been carried out. (Contd. on page 6)

6 Page 6/6 (Contd. of page 5) SECTION 16: Other information The above information describes exclusively the safety requirements of the product(s) and is based on our present-day knowledge. It does not represent a guarantee for the properties of the product(s) described in terms of the legal warranty regulations. Properties of the product are to be found in the respective product leaflet.