Safety Data Sheet. 2-Cycle Engine Oil

Transcription

1 Page 1 of 5 Safety Data Sheet for Date Prepared: SECTION 1 CHEMICAL PRODUCT AND COMPANY IDENTIFICATION Product Identifier Manufacturer s Name Adroit Bioproducts, Inc. Address 8 North Main Street Northwood, ND General Use Fuel additive for 2-cycle engines Emergency Telephone Numbers Contact for Additional Information Website: SECTION 2 HAZARDS IDENTIFICATION Signal Word: CAUTION Hazard statements: This product is NOT classified as hazardous according to 29 CFR 1910, amended to conform to the United Nations Globally Harmonized System of Classification and Labelling of Chemicals (OHSA/GHS); SOR/88-66, the Canadian Controlled Products Regulations (CPR); and/or NOM-002-SCT-2003 (Mexico). Adroit Bioproduct s is added to gasoline. After this product is added to gasoline, the resulting mix must be handled with the same caution used for handling gasoline. Before using this product, consult Safety Data Sheet for gasoline product and follow all precautionary measures and procedures stated there.

2 Date Prepared: Page 2 of 5 Precautions: Response: Remove all sources of ignition, including sparks. Use non-sparking, explosion-proof tools and equipment. Do not eat, drink, or smoke while using this product. Provide sufficient ventilation to minimize ignition potential. Provide a source of clean water for flushing eyes and skin. Wear oil-resistant gloves while handling this product. Wash hands thoroughly after handling. If swallowed, call emergency, a physician, or nearest Poison Control Center. Rinse mouth thoroughly. If on skin, wash with plenty of soap and water. If skin irritation occurs, seek medical attention immediately. If on clothing, wash thoroughly before wearing again. If inhaled, remove person to fresh air and keep comfortable for breathing, and immediately call emergency, physician, or nearest Poison Control Center. Potential Health Effects, Based on Individual Components (May Vary Among Individuals) Eye: Liquid, fumes, mists, or vapors may cause irritation. Skin: May cause irritation. Ingestion: May cause moderate irritation to mouth, throat, and stomach, and induce nausea and vomiting. Inhalation: May cause irritation to respiratory tract (mouth, nose, throat, lungs) May cause irritation to Eyes, Gastrointestinal Tract, and Skin with prolonged and/or repeated exposure. Medical conditions aggravated by exposure: Chronic effects: SECTION 3 COMPOSITION/INFORMATION ON INGREDIENTS COMPONENT CAS NUMBER % BY WEIGHT Modified Vegetable Oils (may contain one of the following oils: soybean % to 100 % oil, or canola oil) See Section 8 for exposure guidelines. SECTION 4 SYMPTOMS AND FIRST AID MEASURES Significant health injuries are not expected under normal handling and use prior to mixing with gasoline. After product is mixed with gasoline, follow all precautions and safety measures used for handling and use of gasoline. Eye Contact: Not expected to pose health issues for the eye. Skin Contact: Prolonged or excessive direct contact with skin may result in mild skin irritation. Signs and symptoms of skin irritation may include redness and swelling. Inhalation: Excessive inhalation of mist may result in respiratory irritation. Signs and symptoms of respiratory irritation may include runny nose, sore throat, coughing, chest discomfort, shortness of breath, and reduced lung function. Ingestion: Not expected to be an exposure route. Aggravated Medical Conditions: Pre-existing skin, eye, and respiratory disorders may be aggravated by exposure to this product. Other Health Effects: None recognized. FIRST AID FOR EYES: Quickly and gently blot product off the face. Immediately flush the contaminated eye(s) with clean, lukewarm, gently flowing water for minutes while holding the eyelid(s) open. If contact lens is/are present, do not delay irrigation or

3 Date Prepared: Page 3 of 5 attempt to remove the lens until after flushing is complete. Take care not to rinse contaminated water into the unaffected eye or onto the face. Immediately obtain medical attention. FIRST AID FOR SKIN: Not applicable. FIRST AID FOR INGESTION: Never give anything by mouth to a victim who is rapidly losing consciousness, is unconscious, or is convulsing. Have victim rinse mouth thoroughly with water. Do NOT induce vomiting. Have victim drink a glass of water (2 to 8 ounces or 60 to 240 ml). Immediately obtain medical attention. FIRST AID FOR INHALATION: Not expected to be an exposure route as supplied. If respiratory symptoms develop, seek medical attention. SECTION 5 FIRE FIGHTING MEASURES FLASH POINT: > 650 F prior to mixing with gasoline. FLAMMABLE PROPERTIES: Product does not pose fire hazard prior to being mixed with gasoline. SUITABLE EXTINGUISHING MEDIA: Dry chemical. Dry chemical powder. Carbon dioxide (CO2). Foam. Sand. Fog. Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. SECTION 6 ACCIDENTAL RELEASE MEASURES SPILL OR LEAK PROCEDURE: Product does not pose adverse environmental impact prior to its being mixed with gasoline, so handle in accordance with good industrial hygiene and safety practice. In the event of spill or leak, contain spill, material if possible. Collect with compatible absorbent material, dry spill kit, or sand, and place the collected materials in marked container(s) with tight fitting cover for disposal. If spill or leaked on floor, floor may be slippery use care and clean thoroughly. Keep out of sewer, septic system, ground water, and open waters. OTHER INFORMATION: Oil soaked materials may spontaneously combust if not stored and disposed of properly. Take all available precautions. SECTION 7 HANDLING AND STORAGE STORAGE TEMPERATURE: > 32 F HANDLING AND STORAGE PRECAUTIONS: Use personal protection recommended in Section 8. Do not cut, weld, drill, or otherwise expose empty or full containers of product to heat, sparks, pilot lights, open flames, static electricity, or other sources of heat or ignition. Open containers slowly in case of pressure accumulation. Bind and ground containers during transfer. Vapors are/may be heavier than air and may cause ignition away from storage or handling location. Use non-sparking tools. To ensure product quality, protect from exposure to direct sunlight for prolonged periods of time. Avoid creasing or impacting container sidewalls. Do not eat, drink, or smoke in usage or storage areas. Wash hands after handling and before eating, drinking, or smoking. Do not rub eyes with soiled hands. SECTION 8 PERSONAL PROTECTION/EXPOSURE CONTROLS Handle in accordance with good industrial hygiene and safety practice. ENGINEERING CONTROLS: Provide sufficient general and local explosion-proof ventilation to minimize ignition potential. Provide a source of clean water for flushing eyes and skin. EYE PROTECTION REQUIREMENTS: Use ANSI-approved eye protection (e.g. safety glasses, goggles), as required by work conditions. SKIN PROTECTION REQUIREMENTS: Oil-resistant gloves and clothing, as needed, to prevent skin contact. Wash hands before eating, drinking, or smoking after handling product. RESPIRATORY PROTECTION: In case of mist, spray or aerosol exposure, wear suitable precautionary personal respiratory protection. SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES Physical Form: Liquid Solubility in Water: Insoluble Color: Amber to reddish brown Specific Gravity (Water = 1):

4 Date Prepared: Page 4 of 5 Odor: None Evaporation Rate: No information available Boiling Range: >300 F Vapor Pressure (mm Hg): No information available ph: Vapor Density (Air = 1) No information available SECTION 10 REACTIVITY Stability: Hazardous Polymerization: Incompatibilities (Materials to Avoid): Hazardous Decomposition Products: Stable under normal conditions. None known SECTION 11 TOXICOLOGICAL INFORMATION Product has not been specifically tested as a whole. This product is NOT classified as hazardous according to 29 CFR 1910, amended to conform to the United Nations Globally Harmonized System of Classification and Labelling of Chemicals (OHSA/GHS); SOR/88-66, the Canadian Controlled Products Regulations (CPR); and/or NOM-002-SCT-2003 (Mexico). Acute toxicity Skin corrosion/irritation Serious eye damage/eye irritation Respiratory or skin sensitization Germ cell mutagenicity Carcinogenicity Reproductive toxicity STOT single exposure STOT- repeated exposure Aspiration hazard Based on available data, no evidence of acute toxicity. Based on available data, not, or only slightly irritating. Based on available data, no evidence of serious eye damage/irritation. Based on available data, not expected to be a skin or respiratory sensitizer. Based on available data, no evidence of carcinogenicity. Based on available data, no evidence of reproductive toxicity. Based on available data, no known aspiration hazard. SECTION 12 ECOLOGICAL INFORMATION Volatile Organic Compound (VOC) levels measured at < 25 g/l. SECTION 13 DISPOSAL CONSIDERATIONS Whenever possible, as rules and regulations allow, please recycle or manage materials to minimize waste. Recycle or dispose of contents and empty containers according to federal, state and local regulations. Keep out of trash, water, sewer, and drainage systems. Oils may be recycled, incinerated, or fuel blended at an EPA-permitted facility. SECTION 14 TRANSPORTATION INFORMATION DOMESTIC TRANSPORT REGULATIONS (USA) DOT: Not regulated. DOMESTIC TRANSPORT REGULATIONS (Canada) TDG: Not regulated. DOMESTIC TRANSPORT REGULATIONS (Mexico) MEX: Not regulated. INTERNATIONAL TRANSPORT REGULATIONS ICAO: Not regulated. IATA: Not regulated. IMDG/IMO: Not regulated. SECTION 15 REGULATORY INFORMATION Information not available.

5 Date Prepared: Page 5 of 5 SECTION 16 OTHER INFORMATION Prepared By: Adroit Bioproducts, Inc. Original Preparation Date: Revision Date: Revision Number: Reason for Revision: This version replaces all previous versions. The information provided on this (M)SDS is correct to the best of Adroit Bioproducts knowledge, information and belief at the date of its publication. The information is designed only as a guide for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered as a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other material or in any process, unless specified in the text. Conditions of use are beyond the supplier's control and therefore users are responsible to verify this data under their own operating conditions to determine whether the product is suitable for their particular purposes and they assume all risks of their use, handling and disposal of the product. Adroit Bioproducts, Inc., and its employees assume no responsibility for injury or damage from the use of this product. End of Sheet