1.) Identification of the substance/mixture and of the company/undertaking Trade name Plonuran 50 WP Relevant identified uses of the substance or mixture and uses advised against Relevant identified uses of the substance or mixture Pesticide Details of the supplier of the safety data sheet Address Spiess-Urania Chemicals GmbH Heidenkampsweg 77 20097 Hamburg Telephone no. +49 (0)40-23652-0 Fax no. +49 (0)40-23652-255 Emergency telephone +49(0)40-23652-0 (8:00 a.m. to 4:00 p.m.) After 4:00 p.m. +49 (0) 40-78833366 Advice on Safety Data Sheet BUSINESS DEVELOPMENT: mail@spiess-urania.com 2.) Hazards identification Classification of the substance or mixture Classification in accordance with Directive 67/548/EEC or 1999/45/EC Xi; R41 Xn; R22 N; R50/53 Label elements Labelling according to Directive 1999/45/CE Hazard symbols Harmful Dangerous for the environment R phrases 22 Harmful if swallowed. 41 Risk of serious damage to eyes. 50/53 Very toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. S phrases 2 Keep out of the reach of children. 13 Keep away from food, drink and animal feedingstuffs. 26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. 35 This material and its container must be disposed of in a safe way. 39 Wear eye/face protection. 46 If swallowed, seek medical advice immediately and show this container or label. 57 Use appropriate container to avoid environmental contamination. 3.) Composition / information on ingredients Chemical characterization Mixture (prepaion) Hazardous ingredients copper-dihydroxide EC no. 243-815-9 Index no. - CAS no. 20427-59-2 Concention 77 %-b.w. Classification T; R23 Xn; R22 Xi; R41 N; R50/53 Hazard symbols T; N R phrases 22-23-41-50/53 4.) First aid measures General information In case of persisting adverse effects, consult a physician. Change contaminated, satued clothing. Poisonous symptoms can first be observed after several hours, there- fore medical observation for at least 48 hours is necessary. Seite 1(5)
After inhalation Remove affected person from the immediate area. Ensure supply of fresh air. If unconscious place in recovery position and seek medical advice. After skin contact Wash off immediately with soap and water. After eye contact Sepae eyelids, wash the eyes thoroughly with water (15 min.). Seek medical assistance. After ingestion Summon a doctor immediately and show label or packaging. Rinse mouth thoroughly with water. Never give anything by mouth to an unconscious person. Advice to doctor Treatment Treat symptomatically. 5.) Fire-fighting measures Suitable extinguishing media Foam; Carbon dioxide; extinguishing powder; Water spray jet Extinguishing media that must not be used for safety reasons Full water jet Special exposure hazards arising from the substance or prepaion itself, combustion products, resulting gases In the event of fire, the following can be released: Carbon dioxide (CO2); Carbon monoxide (CO); Combustion products of this material have to be classed invariably as respiory poison. Special protective equipment for fire-fighters Fire-fighting opeions, rescue and clearing work under effect of combustion and smoulder gases just may be done with breathing appaus. Wear protective clothing. Fire residues and contaminated firefighting water must be disposed off in accordance with the local regulations. 6.) Accidental release measures Personal precautions Refer to protective measures listed in sections 7 and 8. Ensure adequate ventilation. Avoid dust formation. Keep away sources of ignition. Environmental precautions Do not discharge into the drains/surface waters/groundwater. Methods for cleaning up/taking up Scoop-up mechanically. When picked up, treat material as prescribed under heading "Disposal consideions". 7.) Handling and storage Handling Advice on safe handling Avoid the formation and deposition of dust. Provide good ventilation of working area (local exhaust ventilation, if necessary). Avoid contact with skin and eyes. Advice on protection against fire and explosion Dust can form an explosive mixture with air. Take precautionary measures against static charges. Keep away from sources of heat and ignition. Storage Requirements for storage rooms and vessels Store product in closed containers. Advice on storage assembly Do not store together with foodstuffs. Further information on storage conditions Keep container tightly closed and dry in a cool, well-ventilated place. Recommended storage tempeure Value 0-30 C 8.) Exposure controls / personal protection Exposure limit values N O N E Seite 2(5)
Exposure controls Personal protective equipment Respiory protection If workplace exposure limits are exceeded, a respiion protection approved for this particular job must be worn. In case of dust formation, take appropriate measures for breathing protection in the event workplace threshold values are not specified. Respiory filter (part): P2 Hand protection In case of intensive contact, wear protective gloves (EN 374). Sufficient protection is given wearing suitable protective gloves checked according to i.e. EN 374, in the event of risk of skin contact with the product. Before use, the protective glove should be tested in any case for its specific work-station suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the manufacturer s instructions and information relating to the use, storage, care and replacement of protective gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Design opeions thus to avoid permanent use of protective gloves. Appropriate Material nitrile Material thickness > 0,3 mm Breakthrough time > 480 min. Appropriate Material rubber Material thickness > 0,5 mm Breakthrough time > 240 min. Eye protection Tightly fitting safety glasses (EN 166). Skin protection Normal chemical work clothing. General protective and hygiene measures Do not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Wash hands before breaks and after work. Provide eye wash fountain in work area. Do not inhale dust. 9.) Physical and chemical properties General information Form Colour Odour Powder light blue characteristic Important health, safety and environmental information Changes in physical state Type Type Flash point Self ignition Melting point not determined Boiling point not determined not applicable The product is self-igniting. Density Value 0,380 g/cm³ Bulk density Value 245 kg/m³ Solubility in water dispersible ph value Value 7,8 10.) Stability and reactivity Conditions to avoid Heat, naked flames and other ignition sources. Materials to avoid None known. Hazardous decomposition products No hazardous decomposition products known. Thermal decomposition No decomposition if used as prescribed. Seite 3(5)
danger of dust explosion 11.) Toxicological information Acute toxicity Acute oral toxicity LD50 1750 mg/kg Acute dermal toxicity LD50 > 2000 mg/kg Acute inhalational toxicity LC50 5,45 mg/l Duion of exposure 4 h Irritant/corrosive effects Irritant effect on skin Irritant effect on eyes Sensitisation non-irritant Experience in practice Inhalation of dusts may irritate the respiory tract. irritant - risk of strong eye injuries No sensitizing effects are known. Exercise customary precautions when handling chemicals. 12.) Ecological information Ecotoxicity Fish toxicity LC50 10 mg/l Duion of exposure 96 h Daphnia toxicity EC50 0,0422 mg/l Daphnia magna Duion of exposure 48 h Algae toxicity EC50 22,5 mg/l Scenedesmus subspicatus Duion of exposure 96 h Persistence and degradability Biodegradability Bioaccumulative potential not readily biodegradable Potentially bioaccumulative Do not discharge product unmonitored into the environment. 13.) Disposal consideions Product Allocation of a waste code number, according to the European Waste Catalogue, should be carried out in agreement with the regional waste disposal company. Seite 4(5)
Packaging Residuals must be removed from packaging and when emptied completely disposed of in accordance with the regulations for waste removal. Incompletely emptied packaging must be disposed of in the form of disposal specified by the regional disposer. 14.) Transport information Transport ADR/RID/ADN Classification code M7 Hazard identification no. 90 Technical name ENVIRONMENTALLY HAZARDOUS SUBSTANCE, SOLID, N.O.S. Tunnel restriction code E Environmentally hazardous substance mark Transport IMDG Proper shipping name ENVIRONMENTALLY HAZARDOUS SUBSTANCE, SOLID, N.O.S. EmS F-A+S-F Marine pollutant mark Transport ICAO/IATA Proper shipping name Environmentally hazardous substance, solid, n.o.s. Environmentally hazardous substance mark 15.) Regulatory information Safety, health and environmental regulations/legislation specific for the substance or mixture EU regulations Council Directive 96/82/EC on the control of major-accident hazards involving dangerous substances Annex I, part 2, category 9 a 16.) s of key data used to compile the data sheet: EC Directive 67/548/EC resp. 99/45/EC as amended in each case. Regulation (EC) No 1907/2006 (REACH), 1272/2008 (CLP) as amended in each case. EC Directives 2000/39/EC, 2006/15/EC, 2009/161/EC National Threshold Limit Values of the corresponding countries as amended in each case. Transport regulations according to ADR, RID, IMDG, IATA as amended in each case. The data sources used to determine physical, toxic and ecotoxic data, are indicated directly in the corresponding chapter. Relevant R-phrases (chapter 3): 22 Harmful if swallowed. 23 Toxic by inhalation. 41 Risk of serious damage to eyes. 50/53 Very toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. Department issuing safety data sheet UMCO Umwelt Consult GmbH Georg-Wilhelm-Str. 183 b, D-21107 Hamburg Tel.: +49 40 / 41 92 13 00 Fax: +49 40 / 41 92 13 57 e-mail: umco@umco.de This information is based on our present state of knowledge. However, it should not constitute a guarantee for any specific product properties and shall not establish a legally valid relationship. Seite 5(5)