Conforms to the National Code of Practice for the Preparation of Safety Data Sheets 2nd Edition [NOHSC2011(2003)]. SAFETY DATA SHEET 1. Identification of the material and supplier Names Product name SDS no. Formulation # Manufacturer Air Wick Candle Janus Air Wick Candle Janus #8178777_1 Qingdao KingKing A.C. Co,Ltd 25/F Futai Plaza, No.18 HK middle road, Qingdao, China +86 53 285718989287 Emergency telephone number Poison Information contact Best Base International Limited Company 3536 Linh Trung Export Processing Zone and Industrial Park III,Trang Bang District, Tay Ninh Province, Vietnam. Phone number 00846633898136. (5 pm 8 am EST Australia) +61 (02) 9857 2444 NewZealand (09) 839 0200 Australia 13 11 26 New Zealand 0800 764 766 or 0800 POISON Material uses Product use Candle Consumer 2. Hazards identification Statement of hazardous/ dangerous nature Classification Risk phrases Safety phrases Recommendations NONHAZARDOUS SUBSTANCE. NONDANGEROUS GOODS. regulated. classified S2 Keep out of the reach of children. S46 If swallowed, seek medical advice immediately and show this container or label. KEEP FREE FROM FOREIGN OBJECTS (e.g. MATCHES). Never leave a burning candle unattended, near flammable material or for more than 4 hours. Place on a flat, heat resistant surface, away from draughts. Store candle in an upright position. Keep wick trimmed to 1 cm to avoid excessive smoking. Do not move or tip while lit or before liquid hardens. Glass will be hot during and after use. Stop when less than 1 cm of product remains and never allow the candle to burn all the way down. Extinguish candle by blowing gently. Always leave at least 20cm between burning candles. Do not use if the glass is damaged. People suffering from perfume sensitivity should be cautious when using this product. Air Fresheners do not replace good hygiene practices. Do not burn candles on or near anything that can catch fire. Do not use on hot surfaces e.g. T.V. Do not allow the flame to touch the side of the glass holder. Do not use the glass candle holder for drinking purposes or for storing food. 3. Composition/information on ingredients Mixture Ingredient name Yes. CAS number benzyl benzoate 120514 < 10 Proportion % w/w There are no additional ingredients present which, within the current knowledge of the supplier and in the concentrations applicable, are classified as hazardous to health or the environment and hence require reporting in this section. Date of issue 03/02/2015. Page 1/6
Conforms to the National Code of Practice for the Preparation of Safety Data Sheets 2nd Edition [NOHSC2011(2003)]. 4. Firstaid measures Firstaid measures Inhalation Ingestion Skin contact Eye contact 5. Firefighting measures Extinguishing media Suitable suitable Special exposure hazards Hazardous thermal decomposition products Special protective equipment for firefighters Remove victim to fresh air and keep at rest in a position comfortable for breathing. Get medical attention if symptoms occur. Wash out mouth with water. Remove victim to fresh air and keep at rest in a position comfortable for breathing. If material has been swallowed and the exposed person is conscious, give small quantities of water to drink. Do not induce vomiting unless directed to do so by medical personnel. Get medical attention if symptoms occur. Flush contaminated skin with plenty of water. Remove contaminated clothing and shoes. Get medical attention if symptoms occur. Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Get medical attention if irritation occurs. Use an extinguishing agent suitable for the surrounding fire. None known. Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire. No action shall be taken involving any personal risk or without suitable training. No specific fire or explosion hazard. 6. Accidental release measures Personal precautions Environmental precautions Methods for cleaning up Small spill Large spill 7. Handling and storage Decomposition products may include the following materials carbon dioxide carbon monoxide Firefighters should wear appropriate protective equipment and selfcontained breathing apparatus (SCBA) with a full facepiece operated in positive pressure mode. No action shall be taken involving any personal risk or without suitable training. Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilt material. Put on appropriate personal protective equipment (see Section 8). Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers. Inform the relevant authorities if the product has caused environmental pollution (sewers, waterways, soil or air). Move containers from spill area. Vacuum or sweep up material and place in a designated, labelled waste container. Dispose of via a licensed waste disposal contractor. Move containers from spill area. Prevent entry into sewers, water courses, basements or confined areas. Vacuum or sweep up material and place in a designated, labelled waste container. Dispose of via a licensed waste disposal contractor. e see Section 1 for emergency contact information and Section 13 for waste disposal. Handling Put on appropriate personal protective equipment (see Section 8). Eating, drinking and smoking should be prohibited in areas where this material is handled, stored and processed. Workers should wash hands and face before eating, drinking and smoking. Remove contaminated clothing and protective equipment before entering eating areas. Date of issue 03/02/2015. Page 2/6
Conforms to the National Code of Practice for the Preparation of Safety Data Sheets 2nd Edition [NOHSC2011(2003)]. 7. Handling and storage Storage Manufacturer Exposure controls Engineering measures Hygiene measures Eyes Hands Respiratory Skin Store in accordance with local regulations. Store in original container protected from direct sunlight in a dry, cool and wellventilated area, away from incompatible materials (see Section 10) and food and drink. Keep container tightly closed and sealed until ready for use. Containers that have been opened must be carefully resealed and kept upright to prevent leakage. Do not store in unlabelled containers. Use appropriate containment to avoid environmental contamination. 8. Exposure controls/personal protection Australia Occupational exposure limits New Zealand Occupational exposure limits Recommended monitoring procedures Environmental exposure controls No exposure standard allocated. No exposure standard allocated. 9. Physical and chemical properties If this product contains ingredients with exposure limits, personal, workplace atmosphere or biological monitoring may be required to determine the effectiveness of the ventilation or other control measures and/or the necessity to use respiratory protective equipment. Reference should be made to appropriate monitoring standards. Reference to national guidance documents for methods for the determination of hazardous substances will also be required. Good general ventilation should be sufficient to control worker exposure to airborne contaminants. Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Appropriate techniques should be used to remove potentially contaminated clothing. Wash contaminated clothing before reusing. Ensure that eyewash stations and safety showers are close to the workstation location. Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists or dusts. If contact is possible, the following protection should be worn, unless the assessment indicates a higher degree of protection safety glasses with sideshields. Chemicalresistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical products if a risk assessment indicates this is necessary. Use a properly fitted, particulate filter respirator complying with an approved standard if a risk assessment indicates this is necessary. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation. In some cases, fume scrubbers, filters or engineering modifications to the process equipment will be necessary to reduce emissions to acceptable levels. Physical state Colour Odour Boiling point Melting point Vapour pressure Density Flash point Solid. Brown. Characteristic. Date of issue 03/02/2015. Page 3/6
Conforms to the National Code of Practice for the Preparation of Safety Data Sheets 2nd Edition [NOHSC2011(2003)]. 9. Physical and chemical properties Vapour density ph Viscosity Solubility Hazardous decomposition products 10. Stability and reactivity Chemical stability Possibility of hazardous reactions Conditions to avoid Materials to avoid The product is stable. 11. Toxicological information Acute toxicity Potential acute health effects Inhalation Ingestion Under normal conditions of storage and use, hazardous reactions will not occur. Under normal conditions of storage and use, hazardous decomposition products should not be produced. Product/ingredient name Result Species Dose Exposure benzyl benzoate LD50 Dermal Rabbit 4 g/kg LD50 Oral Rat 2800 mg/kg Irritation/Corrosion Eyes Respiratory Sensitiser Skin Respiratory Mutagenicity Carcinogenicity Reproductive toxicity Teratogenicity Skin contact Eye contact Potential chronic health effects Chronic toxicity Chronic effects Carcinogenicity Mutagenicity Teratogenicity Developmental effects Fertility effects Overexposure signs/symptoms Date of issue 03/02/2015. Page 4/6
Conforms to the National Code of Practice for the Preparation of Safety Data Sheets 2nd Edition [NOHSC2011(2003)]. 11. Toxicological information Inhalation Ingestion Skin Eyes 12. Ecological information Ecotoxicity Aquatic ecotoxicity Product/ingredient name benzyl benzoate Acute LC50 1.4 ppm Fresh water Fish Oncorhynchus mykiss 96 hours Other ecological information Product/ingredient name Other adverse effects Result Species LogPow BCF Potential benzyl benzoate 3.97 193.4 low 13. Disposal considerations Methods of disposal Special precautions Exposure The information in this section contains generic advice and guidance. The list of Identified Uses in Section 1 should be consulted for any available usespecific information provided in the Exposure Scenario(s). 13.1 Waste treatment methods Product Hazardous waste Packaging Methods of disposal 14. Transport information The generation of waste should be avoided or minimised wherever possible. Disposal of this product, solutions and any byproducts should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. Dispose of surplus and nonrecyclable products via a licensed waste disposal contractor. Waste should not be disposed of untreated to the sewer unless fully compliant with the requirements of all authorities with jurisdiction. Waste packaging should be recycled. Incineration or landfill should only be considered when recycling is not feasible. This material and its container must be disposed of in a safe way. Empty containers or liners may retain some product residues. Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers. Within the present knowledge of the supplier, this product is not regarded as hazardous waste, as defined by EU Directive 91/689/EEC. The generation of waste should be avoided or minimised wherever possible. Waste packaging should be recycled. Incineration or landfill should only be considered when recycling is not feasible. This material and its container must be disposed of in a safe way. Empty containers or liners may retain some product residues. Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers. Regulation UN number Proper shipping name Classes PG* Label Additional information ADG IMDG IATA PG* Packing group Date of issue 03/02/2015. Page 5/6
Conforms to the National Code of Practice for the Preparation of Safety Data Sheets 2nd Edition [NOHSC2011(2003)]. 15. Regulatory information Standard for the Uniform Scheduling of Medicines and Poisons Poison schedule (Australia) Australia inventory (AICS) New Zealand Inventory of Chemicals (NZIoC) Tracking Requirement determined. determined. Yes. 16. Other information Abbreviations and acronyms Date of issue / Date of revision Version Indicates information that has changed from previously issued version. Disclaimer ADG = Australian Code for the Transport of Dangerous Goods by Road and Rail HSNO = Hazardous Substances and New Organisms Act 1996 (New Zealand) IATA = International Air Transport Association IMDG = International Maritime Dangerous Goods N.O.S. = otherwise specified NOHSC = National Occupational Health and Safety Commission (Australia) 03/02/2015. 1 To the best of our knowledge, the information contained herein is accurate. However, neither the abovenamed supplier, nor any of its subsidiaries, assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist. Date of issue 03/02/2015. Page 6/6