University R&D Panel 5th International Supercritical CO2 Power Cycles Symposium San Antonio, TX March 30, 2016

Similar documents
University of Cincinnati

Aeroelasticity of Turbomachines

University of Cincinnati

THEORETICAL EVALUATION OF FLOW THROUGH CENTRIFUGAL COMPRESSOR STAGE

FUTURE Flutter-Free Turbomachinery Blades

Copyright by Turbomachinery Laboratory, Texas A&M University

START UP MODELING OF KAIST MICRO MODULAR REACTOR COMPRESSOR USING BETA LINE METHOD WITH GAMMA+ CODE

Supercritical CO2 Power Cycles: Design Considerations for Concentrating Solar Power

Rub Tolerant Labyrinth Seals

Application of Sweep to Low Pressure Turbine Cascade Blade for Tip Flow Containment

UNDERSTANDING WET GAS IN A SUPERCRITICAL CO 2 CYCLE. Melissa Poerner, P.E. Grant Musgrove Griffin Beck Craig J. Nolen Southwest Research Institute

APPLICATION OF RESEARCH RESULTS AT LM WIND POWER

Effects of Air Injection on Aerodynamic Performance of a Single-Stage Transonic Axial Compressor

A STUDY ON AIRFOIL CHRACTERISTICS OF A ROTOR BLADE FOR WIND MILL

WESEP 594 Research Seminar

The 4th International Symposium - Supercritical CO2 Power Cycles September 9-10, 2014, Pittsburgh, Pennsylvania (Style Event Detail )

S-CO 2 Brayton Recompression Loop Design and Control

Publications list David Munday

COMPRESSORS WITH SIDE STREAM

CFD development for wind energy aerodynamics

CFD ANALYSIS TO INVESTIGATE THE EFFECT OF AXIAL SPACING IN A SINGLE STAGE TRANSONIC AXIAL FLOW COMPRESSOR

The Aerodynamic Design and Investigation of Loading Distribution of a Mixed Flow Compressor

Inlet Influence on the Pressure and Temperature Distortion Entering the Compressor of an Air Vehicle

Higher Gas Turbine Operation Flexibility by Improved Diffuser Vanes of a Radial Compressor

Supercritical CO 2 Power Cycles: Design Considerations for Concentrating Solar Power

Torque & Drag & Buckling

Simplicity in VRU by using a Beam Gas Compressor

An Impeller Blade Analysis of Centrifugal Gas Compressor Using CFD

CFD Simulation and Experimental Validation of a Diaphragm Pressure Wave Generator

TEPZZ 7_687ZA_T EP A1 (19) (11) EP A1 (12) EUROPEAN PATENT APPLICATION. (43) Date of publication: Bulletin 2014/15

Co-Flow Jet Airfoil for Ultra-High Efficiency and Quiet Aircraft

EXPERIMENTAL INVESTIGATION OF LIFT & DRAG PERFORMANCE OF NACA0012 WIND TURBINE AEROFOIL

Computational Fluid Dynamics

White Paper. Solution For Compressor Anti-Surge Control The Triconex methodology. What s Inside

Efficiency Improvement of a New Vertical Axis Wind Turbine by Individual Active Control of Blade Motion

DEVELOPMENT OF A FLEXIBLE MODELING TOOL FOR PREDICTING OPTIMAL OFF-DESIGN PERFORMANCE OF SIMPLE AND RECOMPRESSION BRAYTON CYCLES

Numerical Investigation of Inlet Distortion on an Axial Flow Compressor Rotor with Circumferential Groove Casing Treatment

Inlet Influence on the Pressure and Temperature Distortion Entering the Compressor of an Air Vehicle

Centrifugal Compressor Configuration, Selection and Arrangement: A User s Perspective

Numerical Investigation of Multi Airfoil Effect on Performance Increase of Wind Turbine

CFD Analysis of Supercritical Airfoil with Different Camber

V. A. Sedunin 1, O. V. Komarov 1, V. L. Blinov 1, A. V. Skorokhodov 1 & A. O. Procopets 2. Abstract. 1 Introduction

Increased Project Bankability : Thailand's First Ground-Based LiDAR Wind Measurement Campaign

Compressor Seal Replacement and Upgrades SERVICES

SUBJECT INDEX. Dashpot load Dead space - 115, 118 Degrees of freedom - 51 Design guidelines for Ringboms

Gas Turbine Performance Analysis

Investigation on 3-D Wing of commercial Aeroplane with Aerofoil NACA 2415 Using CFD Fluent

RICK FAUSEL, BUSINESS DEVELOPMENT ENGINEER TURBOMACHINERY CONTROL SYSTEM DESIGN OBJECTIVES

INVESTIGATION OF PRESSURE CONTOURS AND VELOCITY VECTORS OF NACA 0015IN COMPARISON WITH OPTIMIZED NACA 0015 USING GURNEY FLAP

AN ISOLATED SMALL WIND TURBINE EMULATOR

Making Clean Power Possible: A Gas Turbine-driven, Integrally Geared Compressor Solution for the sco2 Allam Cycle

Numerical Fluid Analysis of a Variable Geometry Compressor for Use in a Turbocharger

TITLE: Assessing the Hydrodynamic Performance of Fouling-Release Surfaces (ONR Research Contract # N WR )

Modeling of Scroll Compressor Using GT-Suite

CIRCULATION CONTROLLED AIRFOIL ANALYSIS THROUGH 360 DEGREES ANGLE OF ATTACK

Master's degree in Aerospace Engineering

Aerodynamic Performance Optimization Of Wind Turbine Blade By Using High Lifting Device

SPE Fuel gas supply (at the flowstations and gathering centers) and artificial lift gas supply for the lift gas compressors at GC1 are

ANALYSIS OF AERODYNAMIC CHARACTERISTICS OF A SUPERCRITICAL AIRFOIL FOR LOW SPEED AIRCRAFT

Computational Fluid Flow Analysis of Formula One Racing Car Triya Nanalal Vadgama 1 Mr. Arpit Patel 2 Dr. Dipali Thakkar 3 Mr.

ADVANCES IN AERODYNAMICS OF WIND TURBINE BLADES

UNIQUE ADVANTAGES OF PIPENET

Flow Analysis of Upstream Fluid Flow using Simulation for Different Positions of Optimized Inlet Guide Vane in Centrifugal Air Compressor

Altair Constellation Returns Humans to the Moon

Wind turbine Varying blade length with wind speed

The EllipSys2D/3D code and its application within wind turbine aerodynamics

Dynamic Analysis of a Multi-Stage Compressor Train. Augusto Garcia-Hernandez, Jeffrey A. Bennett, and Dr. Klaus Brun

Turbo Blowers. Combustion Excellence Since Features. Benefits

Education. Professional Experience. Research Interests. Honors and Awards

Experimental Characterization and Modeling of Helium Dispersion in a ¼-Scale Two-Car Residential Garage

Modelling Near-Surface Processes

Development of a High-Flow Centrifugal Compressor Stage

Design and Evaluation of Adaptive Traffic Control System for Heterogeneous flow conditions

Injector Dynamics Assumptions and their Impact on Predicting Cavitation and Performance

RESTAGE OF CENTRIFUGAL GAS COMPRESSORS FOR CHANGING PIPELINE LANDSCAPES

Optimization of a Wing-Sail shape for a small boat

Alternative Measures of Economic Activity. Jan J. J. Groen, Officer Research and Statistics Group

ISO INTERNATIONAL STANDARD. Cryogenic vessels Pressure-relief accessories for cryogenic service Part 1: Reclosable pressure-relief valves

Computational studies on small wind turbine performance characteristics

An Experimental Investigation of Active and Passive Control of Rotating Stall in Axial Compressors

Numerical Studies on the Effect of Slotted Casing Treatment on the Performance of a Transonic Axial Flow Compressor

» Wind Propulsion for Cargo Ships «Performance Parameters and Operational Aspects

Computationally Efficient Determination of Long Term Extreme Out-of-Plane Loads for Offshore Turbines

Self-Organizing Signals: A Better Framework for Transit Signal Priority

VGV optimization for performance

OPTIMIZATION OF SINGLE STAGE AXIAL FLOW COMPRESSOR FOR DIFFERENT ROTATIONAL SPEED USING CFD

ACCURATE PRESSURE MEASUREMENT FOR STEAM TURBINE PERFORMANCE TESTING

Performance of GOE-387 Airfoil Using CFD

STUDY OF THE FLOW OVER WIND TURBINE BLADE

Grid Generation for Screw Compressors with Variable Geometry Rotors

Upgrading Vestas V47-660kW

Design & Analysis of Natural Laminar Flow Supercritical Aerofoil for Increasing L/D Ratio Using Gurney Flap

Numerical simulation of aerodynamic performance for two dimensional wind turbine airfoils

Ameliorating the Negative Damping in the Dynamic Responses of a Tension Leg Spar-Type Support Structure with a Downwind Turbine

OPTIMIZATION OF RECUPERATER FIN GEOMETRY FOR MICRO GAS TURBINE

International Research Journal of Electronics and Computer Engineering Vol 1(3) Oct-Dec 2015

5th Symposium on Integrating CFD and Experiments in Aerodynamics (Integration 2012) th Symposium on Integrating CFD and Experiments in Aerodynam

Vibration-Free Joule-Thomson Cryocoolers for Distributed Microcooling

List of Publications (Not Complete Yet)

Achievable Efficiency and Stability of Supercritical CO 2 Compression Systems

Transcription:

University R&D Panel 5th International Supercritical CO2 Power Cycles Symposium San Antonio, TX March 30, 2016 Jay Kapat Center for Advanced Turbomachinery & Energy Research (CATER) University of Central Florida, Orlando FL 1

Background: We are located in Orlando Siemens Alstom -> Ansaldo Mitsubishi Pratt & Whitney GE Aviation, avionics Enterprise Florida 5 th International Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas Aerojet Rocketdyne 2

Location led to Creation of CATER Current Industrial Partners Siemens Energy Center GE Global Research Center Alstom Power -> Ansaldo Aerojet Rocketdyne

2013: ASME Turbo Expo, San Antonio (GT2013-94799) ASME Power, Boston (POWER2013-98231) Our interest started with sco2 turbomachineries. Accurate cycle analysis and optimization is needed to establish useful boundary conditions. Using Genetic Algorithm and in-house cycle code for optimization, RC, RRC, RRIRC and various other variations were compared. Efficiency vs complexity? Decided to focus on RC and RRC only. A mean-line design for a 100 MW turbine started existing loss models may not be very accurate: small relative tip clearance, larger work transfer compared to the size of the airfoils The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 4

2014: ASME Turbo Expo, Dusseldorf (GT2014-27152, 27214) In case one is interested in higher TIT requiring cooling, large (TIT T c,exit )/TIT can simplify cooling 2-d Aero-simulation Cycle specific power can be important for thermo-economic optimization. The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 5

2014: SCO2 Symposium, Pittsburgh 2015: ASME Turbo Expo, Montreal (GT2015-43761) Adapted from Carman et al., Turbo Expo 2002, Amsterdam The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 6

Moving Forward: Learning from History http://www.siemens.com/press/pool/d e/pressebilder/2010/photonews/300d pi/pn201002/pn201002-02_300dpi.jpg 400 MW in simple cycle, 2011 (Irsching) ASME Historic Landmark 1 st Utility Gas Turbine, 4MW, 1939 (Neuchatel) The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 7

Moving Forward: Learning from History http://www.siemens.com/press/pool/d e/pressebilder/2010/photonews/300d pi/pn201002/pn201002-02_300dpi.jpg 400 MW in simple cycle, 2011 (Irsching) ASME Historic Landmark 1 st Utility Gas Turbine, 4MW, 1939 (Neuchatel) Echogen EPS-100 In 75 years? The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 8

Potential Topics Better Understanding of turbomachinery aerodynamics Tip loss, secondary flows, surge Oxy-Combustion system for direct firing Kinetics (UCF UTSR project), dynamics and acoustics, combustor design High temperature recuperators at lower cost? Highest temperature is not limited by turbine, but by recuperator Cooling and SAS: large (TIT T c,exit )/TIT can lead to simpler/innovative cooling but what does it do to the cycle? Fluid dynamics of leakage flows: Seal optimization Materials and manufacturing blisk?? impact on self/forced excitation material compatibility; coatings; accurate corrosion models life prediction under cyclic loads The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 9

Moving Forward: Learning from History http://www.siemens.com/press/pool/d e/pressebilder/2010/photonews/300d pi/pn201002/pn201002-02_300dpi.jpg 400 MW in simple cycle, 2011 (Irsching) ASME Historic Landmark 1 st Utility Gas Turbine, 4MW, 1939 (Neuchatel) System testing and system demo Optimized system through component optimization The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 10

Help needed from/for US Academics Real fluid effect and near-critical effect need to be brought to the classrooms. The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 11

Help needed from/for US Academics Real fluid effect and near-critical effect need to be brought to the classrooms. If we need to get our young faculty members and best of the doctoral students energized, We need to bring in potential fundamental publication and funding opportunities The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 12

Help needed from/for US Academics Real fluid effect and near-critical effect need to be brought to the classrooms. If we need to get our young faculty members and best of the doctoral students energized, We need to bring in potential fundamental publication and funding opportunities NSF/NETL such as NSF/EPRI for ACC??? DOE - BES The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 13

Thank you! The Supercritical CO2 Power Cycles Symposium, March 29-31, 2016, San Antonio, Texas 14