1) CHEMICAL PRODUCT AND COMPANY IDENTIFICATION Product Name : FARSPERSE BLACK PB705 Intended Use : Colourant for natural latex products Colourant for water based emulsion coating Manufacturer : No. 3, Lorong Seruling 5, Kawasan Perindustrian Valdor, 14200 Sungai Bakap, S.P.S Penang, Malaysia. Emergency Telephone: 604 5828816 (Hunting Line) E-mail : marketing@farbentechnique.com Website : www.farbentechnique.com 2) COMPOSITION / INFORMATION ON INGREDIENTS Ingredients CAS No Furnace Process Carbon Black 1333-86-4 Non-Ionic Surfactant 127087-87-0 Propylene Glycol USP Grade as carrier 57-55-6 BGA approved preservatives 26172-55-4 Water 7732-18-5 3) HAZARD IDENTIFICATION Not classified as hazardous 01 June 2011 Page 1 of 5
4) FIRST AID MEASURES General : In all cases of doubt, or when symptoms persist, seek attention. Never give anything by mouth to an unconscious person. Inhalation : Remove to fresh air, keep the patient warm at rest. If breathing is irregular or stopped, administer artificial respiration, Give nothing by mouth, If unconscious place in the recovery position and seek medical advice. Eye Contact : Contact lenses should be removed. Irrigate copiously with clear fresh water for at least 10minutes, holding the eyelids apart, and seek medical advice. Skin Contact : Remove contaminated clothing. Wash skin thoroughly with soap and water or use proprietary skin cleaner. Do not use solvent or thinners Ingestion : If accidentally swallowed obtain immediate medical attention. Keep at rest. Do not induce vomiting. 5) FIRE FIGHTING MEASURES Extinguishing Media : Alcohol resistant foam, C02, powder, water spray / mist Not suitable : Water jet Fire hazard : As the product contains combustible organic components, fire will produce dense black smoke containing hazardous products of combustion. Exposure to decomposition products may be a hazard to health. Appropriate self - contained breathing apparatus may be required. Cool closed containers exposed to fire with water spray. Do not allow run off from fire fighting to enter drains or watercourses. 6) ACCIDENTAL RELEASE MEASURES Exclude non-essential personnel. Refer to protective measures listed in Section 7 and 8. Contain and collect with non-combustible material, eg sand, earth, vermiculite, diatomaceous earth and place in suitable container for disposal in accordance with the waste regulations (see Section 13). Do not allow to enter drains or water courses. Clean with detergent; avoid the use of solvents. If the product enters drains or sewers, the Department of Environment should be contacted immediately. 01 June 2011 Page 2 of 5
7) HANDLING AND STORAGE Handling : Keep containers tightly closed. Exclude sources of heat, sparks and open flame. Avoid contact with skin and eyes. Do not breathe vapor Storage : Store in a dry, well-ventilated place away from sources of heat, direct sunlight and water. Generally temperature not exceeding 40 º C should be sufficient. However, it is very important that the s MUST NOT be exposed to freezing condition that causes the s to freeze. The s MUST NOT get frozen even tiny amount, as freezing will affect the colour. Prevent unauthorized access. Containers that are opened should be properly resealed and kept upright to prevent leakage. 8) EXPOSURE CONTROLS / PERSONAL PROTECTION Engineering measures : Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction. Suitable respiratory protective equipment should be worn. Personal Protective Equipment : Respiratory : Suitable respiratory protective equipment should be worn. Hands : Where skin exposure may occur, polyvinylalcohol, neoprene or nitrile rubber gloves should be used. Barrier creams may help to protect exposure areas of skin but are not substitutes for full physical protection. They should not be applied once exposure has occurred. Eyes : Eye protection designed to protect against liquid splash should be worn. Skin and Body : Cotton or cotton / synthetic overalls or coveralls are normally suitable. Grossly Body contaminated clothing should be removed and the skin washed with soap and water or a proprietary skin cleaner. 9) PHYSICAL AND CHEMICAL PROPERTIES Physical state : Fluid paste, viscous Solubility : Dispersible Odour : Noticeable but not offensive Boiling range : 90 to 110 C Flash point : Not applicable ph : 9.0 11.0 Density : 1.2 to 1.5 g/cm 3 Volatile content : 64.3-68.3% 01 June 2011 Page 3 of 5
10) STABILITY AND REACTIVITY Stable under the recommended storage and handling conditions (see Section 7). In a fire, hazardous decomposition products such as smoke, carbon monoxide and oxides of nitrogen may be produced. Keep away from oxidizing agents and strongly alkaline and acidic materials to prevent the possibility of separation. 11) TOXICOLOGY INFORMATION There are no data available on the product itself. Wherever possible, FDA or BGA approved additives are being used. The organic pigments used are inert and heat stable. Splash in the eyes may cause discomfort and reversible local damage. Our grade meets EN71 Part II for Heavy Metals Content. 12) ECOLOGICAL INFORMATION There are no data available on the product itself. The product should not be allowed to enter drains or watercourses or be deposited where it can affect ground or surface waters. The Air Pollution Control / Integrated Pollution Control requirements or regulations made under the Environmental Protection Act may apply to the use of this product. 13) DISPOSAL CONSIDERATIONS Do not allow into drains or water courses of where ground or surface waters may be affected. Wastes including emptied containers, are controlled wastes and should be disposed off in accordance with regulations made under the control of Pollution Act and the Environmental Protection Act. Using information provided in this data sheet, advice should be obtained from the Department of Environment where the special waste regulations apply. 14) TRANSPORT INFORMATION Transport requirements in accordance with ADR for road, RID for rail, IMDG for and ICAO-IATA for air.not classified as hazardous for carriage under the above regulations. UN Number : not applicable Dryer shipping name : - IMDG Class : - Packaging group : - EMS : - MFAG : - Subsidiary risk : - Marine pollutant : - ADR / RID Class : - ADR / RID item no. : - ICAO-IATA Class : - Label name : - 15) REGULATORY INFORMATION Supply hazard labeling not required: - 01 June 2011 Page 4 of 5
Symbol : - Risk phrases : - Named substances : - Safety phrases : - 16) OTHER INFORMATION The product should not be used for purposes other than those shown in Section 1. As the specific conditions of use of the product are outside the supplier s control, the user is responsible for ensuring that the requirement of relevant legislation are complied with. The information contained in this material safety data sheet is based on the present state of knowledge and current legislation of Malaysia. It provides guidance on health, safety and environment aspect of the product and should not be construed as any guarantee of technical performance or suitability for any particular applications. 01 June 2011 Page 5 of 5