Safety Data Sheet REMEDY PHYTOPLEX ANTIFUNGAL OINTMENT Section 1. Identification Product Identifier Synonyms Manufacturer Stock Numbers Recommended use Uses advised against Manufacturer Contact Address REMEDY PHYTOPLEX ANTIFUNGAL OINTMENT MSC092625; MSC092625H ; MSC092625PACK MSC092625; MSC092625H ; MSC092625PACK Medline Industries, Inc. One Medline Place Mundelein, IL, 60060 USA Phone Emergency Phone Fax (800) 633-5463 (800) 424-9300 (847) 643-4436 CHEMTREC CHEMTREC Website www.medline.com Section 2. s Identification Classification Signal Word Pictogram Statements Precautionary Statements Response Prevention Storage Disposal EYE DAMAGE/IRRITATION - Category 2B Warning Causes eye irritation If eye irritation persists: Get medical advice/attention. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Wash affected area thoroughly after handling. Ingredients of unknown 0% Page 1 of 5
toxicity s not Otherwise Classified Section 3. Ingredients CAS Ingredient Name Weight % Occupational exposure limits, if available, are listed in Section 8. Section 4. First-Aid Measures General Advice: Eye Contact: Skin Contact: Inhalation: Ingestion: Take proper precautions to ensure your own health and safety before attempting rescue and providing first aid. Consult a physician. Show this safety data sheet to the doctor in attendance. Move out of dangerous area. Flush eyes with large amounts of water for at least 15 minutes while holding eyelids open. Tilt head to avoid contaminating unaffected eye. Get immediate medical attention. Wash with soap and water; if irritation persists, seek medical attention. Seek medical attention if large quantities are ingested Section 5. Fire Fighting Measures Suitable Extinguishing Media Unsuitable Extinguishing Media Special Fire Fighting Procedures: Unusual Fire and Explosion s: In case of fire, use Dry Chemical, Foam and Carbon Dioxide (CO2) Self contained breathing apparatus and full protective clothing recommended. Combustion products are toxic Section 6. Accidental Release Measures Non-hazardous Small Spill: Non-hazardous Large Spill: Should be cleaned up at the time of the spill. Take all necessary precautions and wear any personal protective equipment that is applicable. Dispose of per local and state regulations. Should be cleaned up at the time of the spill. May require special treatment, equipment and/or emergency assistance. Dispose of per local and state regulations. Section 7. Handling and Storage Handling Non-hazardous: Storage Non-hazardous: This product is considered to be an article which does not release or otherwise result in exposure to a hazardous chemical under nomal use conditions. Store in original package. Discard unused portion. Do not reuse. No special storage conditions required. Page 2 of 5
Section 8. Exposure Controls/Personal Protection Occupational Exposure Limits Personal Protective Equipment Engineering Controls: Respiratory Protection: Eye Protection: Skin Protection: Work/hygienic practices: Ingredient Name ACGIH TLV OSHA PEL STEL Goggles, Gloves Ventilation: None required. None required for normal use. For prolonged exposure, use appropriate goggles, protective clothing and gloves. Protective Gloves: Gloves Handle in accordance with good industrial hygiene and safety practice. Wash thoroughly with soap and water after handling and before eating, drinking, or using tobacco. Safety shower and eye wash should be available close to work areas. Section 9. Physical and Chemical Properties Physical State Liquid Color Clear, solid at room temperature Odor Odorless Odor Threshold Solubility Negligible Partition coefficient Water/n-octanol VOC% Viscosity Specific Gravity 0.88 Density lbs/gal Pounds per Cubic Foot Flash Point 400Deg C min FP Method COC Ph Melting Point 54-60Deg C Boiling Point Boiling Range LEL UEL Evaporation Rate Flammability Decomposition Temperature Auto-ignition Temperature Vapor Pressure Vapor Density Page 3 of 5
Section 10. Stability and Reactivity Stability: Incompatibility (Materials to Avoid): Incompatibility (Materials to Avoid): ous Decomposition or Byproducts: ous Polymerization Conditions to avoid: Stable. Strong oxidizing agents. Heat Thermal decomposition products: Carbon monoxide and carbon dioxide. Will not occur. Section 11. Toxicological Information Acute Toxicity: Eye Contact Contact may cause temporary moderate irritation Acute Toxicity: Skin Contact May cause mild irritation on patients with sensitive skin Acute Toxicity: Inhalation Acute Toxicity: Ingestion May be harmful if swallowed Carcinogenicity: Chronic Toxicity: Section 12. Ecological Information No Data Available Section 13. Disposal Waste Disposal: Section 14. Transport Information Waste must be disposed of in accordance with federal, state and local environmental control regulations. UN Number UN Proper Shipping Name DOT Classification Packing Group IATA: IMDG: Page 4 of 5
Section 15. Regulatory Information General Product Information Clean Air Act Component Analysis Food & Drug Administration State Regulations: General Product Information State Regulations: Component Analysis Other Regulations: Other Classifications: WHMIS (Canada): California Prop.65: Section 16. Other Information Revision Date 5/27/2015 Legend - Not Applicable N.E. - Not Established N.D. - Not Determined HMIS (U.S.A.): Health O HMIS (U.S.A.): Flammability O HMIS (U.S.A.): Physical O Association (U.S.A): Health Association (U.S.A): Flammability Association (U.S.A): Instability Association (U.S.A): Special Additional Information The information contained herein is furnished without warranty or legal responsibility of any kind. Employers should use this information only as a supplement to other information gathered by them and must make independent determination of suitability and completeness of information from all sources to assure proper use of these materials and the safety and health of employees Page 5 of 5