Particle Intermediate Solution

Anteo Technologies Pty Ltd Chemwatch Hazard Alert Code: 1 Safety Data Sheet according to WHS and ADG requirements S.GHS.AUS.EN SECTION 1 IDENTIFICATION OF THE SUBSTANCE / MIXTURE AND OF THE COMPAN / UNDERTAKING Product Identifier Product name Synonyms Other means of identification Relevant identified uses of the substance or mixture and uses advised against Relevant identified uses Storage of Mix Go activated particles. For laboratory use. Details of the supplier of the safety data sheet Registered company name Anteo Technologies Pty Ltd Address Unit 4 26 Brandl St. QLD 4113 Australia Telephone 61 7 3219 0085 Fax 61 7 3219 0553 Website www.anteotech.com Email contact@anteotech.com Emergency telephone number Association / Organisation Emergency telephone numbers Other emergency telephone numbers SECTION 2 HAZARDS IDENTIFICATION Classification of the substance or mixture NON-HAZARDOUS CHEMICAL. NON-DANGEROUS GOODS. According to the WHS Regulations and the ADG Code. CHEMWATCH HAZARD RATINGS Flammability 0 Toxicity 1 Body Contact 1 Reactivity 1 Chronic 0 Min Max 0 = Minimum 1 = Low 2 = Moderate 3 = High 4 = Extreme Poisons Schedule Classification Label elements GHS label elements SIGNAL WORD NOT APPLICABLE Hazard statement(s) Precautionary statement(s) Prevention Precautionary statement(s) Response

Page 2 of 6 Precautionary statement(s) Storage Precautionary statement(s) Disposal SECTION 3 COMPOSITION / INFORMATION ON INGREDIENTS Substances See section below for composition of Mixtures Mixtures CAS No %[weight] Name Ingredients determined not to be hazardous SECTION 4 FIRST AID MEASURES Description of first aid measures Eye Contact Skin Contact Inhalation Ingestion If this product comes in contact with the eyes: Wash out immediately with fresh running water. Ensure complete irrigation of the eye by keeping eyelids apart and away from eye and moving the eyelids by occasionally lifting the upper and lower lids. Seek medical attention without delay; if pain persists or recurs seek medical attention. Removal of contact lenses after an eye injury should only be undertaken by skilled personnel. If skin contact occurs: Immediately remove all contaminated clothing including footwear. Flush skin and hair with running water (and soap if available). Seek medical attention in event of irritation. If fumes aerosols or combustion products are inhaled remove from contaminated area. Other measures are usually unnecessary. If swallowed do NOT induce vomiting. If vomiting occurs lean patient forward or place on left side (head-down position if possible) to maintain open airway and prevent aspiration. Observe the patient carefully. Never give liquid to a person showing signs of being sleepy or with reduced awareness; i.e. becoming unconscious. Give water to rinse out mouth then provide liquid slowly and as much as casualty can comfortably drink. Seek medical advice. Indication of any immediate medical attention and special treatment needed Treat symptomatically. SECTION 5 FIREFIGHTING MEASURES Extinguishing media There is no restriction on the type of extinguisher which may be used. Use extinguishing media suitable for surrounding area. Special hazards arising from the substrate or mixture Fire Incompatibility Avoid contamination with oxidising agents i.e. nitrates oxidising acids chlorine bleaches pool chlorine etc. as ignition may result Advice for firefighters Fire Fighting Alert Fire Brigade and tell them location and nature of hazard. Wear breathing apparatus plus protective gloves in the event of a fire. Prevent by any means available spillage from entering drains or water courses. Use fire fighting procedures suitable for surrounding area. Non combustible. Not considered a significant fire risk however containers may burn. Fire/Explosion Hazard HAZCHEM Decomposes on heating and produces toxic fumes of: carbon dioxide (CO2) hydrogen chloride phosgene nitrogen oxides (NOx) metal oxides other pyrolysis products typical of burning organic material. SECTION 6 ACCIDENTAL RELEASE MEASURES Personal precautions protective equipment and emergency procedures

Page 3 of 6 See section 8 Environmental precautions See section 12 Methods and material for containment and cleaning up Minor Spills Major Spills Clean up all spills immediately. Avoid breathing vapours and contact with skin and eyes. Control personal contact with the substance by using protective equipment. Contain and absorb spill with sand earth inert material or vermiculite. Moderate hazard. Clear area of personnel and move upwind. Alert Fire Brigade and tell them location and nature of hazard. Wear breathing apparatus plus protective gloves. Personal Protective Equipment advice is contained in Section 8 of the SDS. SECTION 7 HANDLING AND STORAGE Precautions for safe handling Safe handling Other information Avoid all personal contact including inhalation. Wear protective clothing when risk of exposure occurs. Use in a well-ventilated area. Avoid contact with moisture. DO NOT allow clothing wet with material to stay in contact with skin Store in original containers. Keep containers securely sealed. Store in a cool dry well-ventilated area. Store away from incompatible materials and foodstuff containers. Conditions for safe storage including any incompatibilities Suitable container Storage incompatibility Glass or polypropylene bottles. Avoid reaction with oxidising agents SECTION 8 EXPOSURE CONTROLS / PERSONAL PROTECTION Control parameters OCCUPATIONAL EXPOSURE LIMITS (OEL) INGREDIENT DATA EMERGENC LIMITS Ingredient Material name TEEL-1 TEEL-2 TEEL-3 Ingredient Original IDLH Revised IDLH Exposure controls Appropriate engineering controls Engineering controls are used to remove a hazard or place a barrier between the worker and the hazard. Well-designed engineering controls can be highly effective in protecting workers and will typically be independent of worker interactions to provide this high level of protection. The basic types of engineering controls are: Process controls which involve changing the way a job activity or process is done to reduce the risk. Enclosure and/or isolation of emission source which keeps a selected hazard "physically" away from the worker and ventilation that strategically "adds" and "removes" air in the work environment. Personal protection Eye and face protection Skin protection Hands/feet protection Safety glasses with side shields. Chemical goggles. Contact lenses may pose a special hazard; soft contact lenses may absorb and concentrate irritants. A written policy document describing the wearing of lenses or restrictions on use should be created for each workplace or task. See Hand protection below Wear chemical protective gloves e.g. PVC. Wear safety footwear or safety gumboots e.g. Rubber The selection of suitable gloves does not only depend on the material but also on further marks of quality which vary from manufacturer to manufacturer. Where the chemical is a preparation of several substances the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. The exact break through time for substances has to be obtained from the manufacturer of the protective gloves and has to be observed when making a final choice. Personal hygiene is a key element of effective hand care.

Page 4 of 6 Body protection Other protection Thermal hazards See Other protection below Overalls. P.V.C. apron. Barrier cream. SECTION 9 PHSICAL AND CHEMICAL PROPERTIES Information on basic physical and chemical properties Appearance Clear light green odourless liquid; mixes with water. Physical state liquid Relative density (Water = 1) Odour Odour threshold ph (as supplied) Melting point / freezing point ( C) Initial boiling point and boiling range ( C) Partition coefficient n-octanol / water Auto-ignition temperature ( C) Decomposition temperature Viscosity (cst) Molecular weight (g/mol) Flash point ( C) Taste Evaporation rate Explosive properties Upper Explosive Limit (%) Flammability Oxidising properties Surface Tension (dyn/cm or mn/m) Lower Explosive Limit (%) Volatile Component (%vol) Vapour pressure (kpa) Gas group Solubility in water (g/l) Miscible ph as a solution (1%) Vapour density (Air = 1) VOC g/l SECTION 10 STABILIT AND REACTIVIT Reactivity See section 7 Chemical stability Possibility of hazardous reactions Unstable in the presence of incompatible materials. Product is considered stable. Hazardous polymerisation will not occur. See section 7 Conditions to avoid See section 7 Incompatible materials See section 7 Hazardous decomposition products See section 5 SECTION 11 TOXICOLOGICAL INFORMATION Information on toxicological effects Inhaled Ingestion Skin Contact Eye Chronic Not normally a hazard due to non-volatile nature of product Considered an unlikely route of entry in commercial/industrial environments Accidental ingestion of the material may be damaging to the health of the individual. Skin contact is not thought to have harmful health effects (as classified under EC Directives); the material may still produce health damage following entry through wounds lesions or abrasions. Open cuts abraded or irritated skin should not be exposed to this material There is some evidence to suggest that this material can cause eye irritation and damage in some persons. There is limited evidence that skin contact with this product is more likely to cause a sensitisation reaction in some persons compared to the general population. As with any chemical product contact with unprotected bare skin; inhalation of vapour mist or dust in work place atmosphere; or ingestion in any form should be avoided by observing good occupational work practice. Particle Intermediate Solution TOXICIT IRRITATION Legend: 1. Value obtained from Europe ECHA Registered Substances - Acute toxicity 2.* Value obtained from manufacturer's SDS. Unless otherwise specified data extracted from RTECS - Register of Toxic Effect of chemical Substances Acute Toxicity Carcinogenicity

Page 5 of 6 Skin Irritation/Corrosion Serious Eye Damage/Irritation Respiratory or Skin sensitisation Mutagenicity Reproductivity STOT - Single Exposure STOT - Repeated Exposure Aspiration Hazard Legend: Data available but does not fill the criteria for classification Data available to make classification Data to make classification SECTION 12 ECOLOGICAL INFORMATION Toxicity Ingredient Endpoint Test Duration (hr) Species Value Source Legend: Extracted from 1. IUCLID Toxicity Data 2. Europe ECHA Registered Substances - Ecotoxicological Information - Aquatic Toxicity 3. EPIWIN Suite V3.12 (QSAR) - Aquatic Toxicity Data (Estimated) 4. US EPA Ecotox database - Aquatic Toxicity Data 5. ECETOC Aquatic Hazard Assessment Data 6. NITE (Japan) - Bioconcentration Data 7. METI (Japan) - Bioconcentration Data 8. Vendor Data DO NOT discharge into sewer or waterways. Persistence and degradability Ingredient Persistence: Water/Soil Persistence: Air Bioaccumulative potential Ingredient Bioaccumulation Mobility in soil Ingredient Mobility SECTION 13 DISPOSAL CONSIDERATIONS Waste treatment methods Product / Packaging disposal Legislation addressing waste disposal requirements may differ by country state and/ or territory. Each user must refer to laws operating in their area. In some areas certain wastes must be tracked. A Hierarchy of Controls seems to be common - the user should investigate: Reduction Reuse Recycling Disposal (if all else fails) This material may be recycled if unused or if it has not been contaminated so as to make it unsuitable for its intended use. DO NOT allow wash water from cleaning or process equipment to enter drains. It may be necessary to collect all wash water for treatment before disposal. In all cases disposal to sewer may be subject to local laws and regulations and these should be considered first. Where in doubt contact the responsible authority. Recycle wherever possible. Consult manufacturer for recycling options or consult local or regional waste management authority for disposal if no suitable treatment or disposal facility can be identified. Dispose of by: burial in a land-fill specifically licensed to accept chemical and / or pharmaceutical wastes or incineration in a licensed apparatus (after admixture with suitable combustible material). Decontaminate empty containers. SECTION 14 TRANSPORT INFORMATION Labels Required Marine Pollutant HAZCHEM NO Land transport (ADG): NOT REGULATED FOR TRANSPORT OF DANGEROUS GOODS Air transport (ICAO-IATA / DGR): NOT REGULATED FOR TRANSPORT OF DANGEROUS GOODS Sea transport (IMDG-Code / GGVSee): NOT REGULATED FOR TRANSPORT OF DANGEROUS GOODS Transport in bulk according to Annex II of MARPOL and the IBC code

Page 6 of 6 SECTION 15 REGULATOR INFORMATION Safety health and environmental regulations / legislation specific for the substance or mixture National Inventory Australia - AICS Canada - DSL Canada - NDSL China - IECSC Europe - EINEC / ELINCS / NLP Japan - ENCS Korea - KECI New Zealand - NZIoC Philippines - PICCS USA - TSCA Legend: Status = All ingredients are on the inventory N = Not determined or one or more ingredients are not on the inventory and are not exempt from listing(see specific ingredients in brackets) SECTION 16 OTHER INFORMATION Other information Classification of the preparation and its individual components has drawn on official and authoritative sources as well as independent review by the Chemwatch Classification committee using available literature references. The SDS is a Hazard Communication tool and should be used to assist in the Risk Assessment. Many factors determine whether the reported Hazards are Risks in the workplace or other settings. Risks may be determined by reference to Exposures Scenarios. Scale of use frequency of use and current or available engineering controls must be considered. Definitions and abbreviations PC-TWA: Permissible Concentration-Time Weighted Average PC-STEL: Permissible Concentration-Short Term Exposure Limit IARC: International Agency for Research on Cancer ACGIH: American Conference of Governmental Industrial Hygienists STEL: Short Term Exposure Limit TEEL: Temporary Emergency Exposure Limit IDLH: Immediately Dangerous to Life or Health Concentrations OSF: Odour Safety Factor NOAEL :No Observed Adverse Effect Level LOAEL: Lowest Observed Adverse Effect Level TLV: Threshold Limit Value LOD: Limit Of Detection OTV: Odour Threshold Value BCF: BioConcentration Factors BEI: Biological Exposure Index This document is copyright. Apart from any fair dealing for the purposes of private study research review or criticism as permitted under the Copyright Act no part may be reproduced by any process without written permission from CHEMWATCH. TEL (+61 3) 9572 4700. end of SDS