A force can be measured using an instrument called a force meter (sometimes called a newton meter or spring balance)

Similar documents
Push & Pull You can see the forces push and pull at work with this door. We can push the door to close it, or pull the handle to open it.

The amount of matter in an object.

Figure 1. The distance the train travels between A and B is not the same as the displacement of the train.

The table below shows how the thinking distance and braking distance vary with speed. Thinking distance in m

JSUNIL TUTORIAL,BIHAR FORCE AND PRESSURE. Forces which act only when there is physical contact between two interacting objects are known as

7.3.9 Unbalanced forces

Newton s Laws of Motion

Exam Unit 5: Motion and Forces

Flying High. HHJS Science Week Background Information. Forces and Flight

(a) Calculate the speed of the sphere as it passes through the lowest point of its path.

During part of the journey the car is driven at a constant speed for five minutes.

Friction: A Force That Opposes Motion

Gravity, Force and Work

NAME:... SCHOOL: LINEAR MOTION. Answer ALL questions in this paper in the spaces provided.

During the Push What kind of motion does the puck have at this time? Is it speeding up, slowing down, not moving, or moving at a steady speed?

Key Terms Chapter 7. boiling boiling point change of state concentration condensation deposition evaporation flow rate fluid freezing point

Force and Motion Test Review

What do we know about air? What have we observed?

Quarterly Science Benchmark Assessment (QSBA) Physical Science. Quarter 1

NAME:... SCHOOL: FORCE INSTRUCTIONS TO CANDIDATES. Answer ALL questions in this paper in the spaces provided.

P2a Force, Acceleration and Graphs

EOY Force and Motion REVIEW

Chapter 9. Forces and Fluids

at home plate at 1st base at 2nd base at 3rd base back at home distance displacement

Supported by. A seven part series exploring the fantastic world of science.

Basics, Types, Use and Applications

Name: Section: Force and Motion Practice Test

PHYSICS 20 Vectors and Dynamics

Science Assessment Year 5: Paper A: Forces. Measuring Forces. of the Earth? a) Mass is a force. b) Weight is a force. c) Length is a force.

7.3.5 Force Diagrams. 115 minutes. 161 marks. Page 1 of 47

AQA P2.1.2 Forces and motion

PYP 001 First Major Exam Code: Term: 161 Thursday, October 27, 2016 Page: 1

Questions. theonlinephysicstutor.com. facebook.com/theonlinephysicstutor. Name: Edexcel Drag Viscosity. Questions. Date: Time: Total marks available:

MULTIPLE CHOICE. Choose the one alternative that best completes the statement or answers the question.

1. Determine his speed when he reaches the photo radar car.

Friction occurs when surfaces slide against each other.

SCIENCE and TECHNOLOGY CYCLE 3 MCCAIG ELEMENTARY

SPEED, VELOCITY, ACCELERATION, & NEWTON STUDY GUIDE - Answer Sheet 1) The acceleration of an object would increase if there was an increase in the

3. Approximately how far will an object near Earth's surface fall in 3.0 seconds? m m m m

DYNAMICS PROBLEM SOLVING

Science 8 Chapter 9 Section 1

6. What net external force is required to give a 25 kg suitcase an acceleration of 2.2 m/s2 to the right? Draw a free-body diagram of the suitcase.

Today Mr. Happer told us to use the following physics vocabulary words and relate them to our experiment:

Density and Buoyancy Notes

Exploration Series. MODEL ROCKET Interactive Physics Simulation Page 01

Unit conversions: 9. An defensive lineman weighs 330 pounds. What is his mass in kg (given 2.2 pounds = 1 kg)? 330 lb 1 kg. 2.2 lb 10.

Chapter Five: Density and Buoyancy

STATION 1: HOT WHEELIN PHYSICS 1. Define Newton s First Law. 2. Describe the motion of the untaped washer when the car hits the pencils.

Notes Chapter 3. Buoyancy

Very Basic Design Considerations for Water-Bottle Rockets

Question: Bicycles. Observations About Bicycles. Static Stability, Part 1. Static Stability, Part 2. Static Stability, Part 3

Instructor: Biswas/Ihas/Whiting PHYSICS DEPARTMENT PHY 2053 Exam 1, 120 minutes October 14, 2009

Motion and Speed Classwork Classwork #1

WONDERLAB: THE EQUINOR GALLERY. The science and maths behind the exhibits 30 MIN INFORMATION. Topic FORCES. Age

Exploration Series. HOT AIR BALLOON Interactive Physics Simulation Page 01

7.3.6 Friction and Air resistance

Force, Motion and Energy Review

A child places a car of mass 95 g on the track. She adjusts the controller to a power of 4.2 W so the car accelerates from rest for 0.40 s.

Kinematics Review. What distance did the object travel in moving from point A to point B? A) 2.5 m B) 10. m C) 20. m D) 100 m

Regents Exam Practice: Measurement, Kinematics, Free Fall, PJM, and UCM

Chapter 6. You lift a 10 N physics book up in the air a distance of 1 meter at a constant velocity of 0.5 m/s. The work done by gravity is

Fluids. How do fluids exert pressure? What causes objects to float? What happens when pressure in a fluid changes? What affects the speed of a fluid?

Exploration Series. TIRE PRESSURE Interactive Physics Simulation Page 01

Wonder. Research. Test and Discover. When you blow up a balloon and let go, why does it fly all over the place? How can you control its speed?

Jeddah Knowledge International School. Science Revision Pack Answer Key Quarter 3 Grade 10

Student Exploration: Uniform Circular Motion

Types of Forces. Pressure Buoyant Force Friction Normal Force

Speed Reading. Forces Cause Change. The force of a bat hitting a baseball causes the baseball to change direction.

Episode 209: Drag, air resistance and terminal velocity

Name Middle Grades Student Activity

NCERT solution for Force and Pressure

Question: Bicycles. Vehicle s Static Stability, Part 1. Observations About Bicycles. Vehicle s Static Stability, Part 2

10.4 Buoyancy is a force

3) A horse gallops a distance of 10 kilometers in a time of 30 minutes. Its average speed is A) 15 km/h. B) 20 km/h. C) 30 km/h. D) 40 km/h.

Commercial Diving 9 month program at Holland College

Acceleration= Force OVER Mass. Design Considerations for Water-Bottle Rockets

Set-Up: Students will be working at the computer lab for 1 period (min), 2 different colored pens or pencils.

The Science of Boat Design

7.3.2 Distance Time Graphs

Physics 117A Exam #1 Fall 2006

Physics 2048 Test 1 Fall 2000 Dr. Jeff Saul Name:

Lesson 6 Aerodynamics and flying

The table below shows how the thinking distance and braking distance vary with speed. Thinking distance in m

Unit 2: Kinematics in 1-D Exam Preparation

2015 EdExcel A Level Physics Topic 4. Density and upthrust

Page 1

A tennis player hits a ball at a height of 2.4 m. The ball has an initial horizontal velocity.

1. Find the potential energy of 20 Kg mass child sitting on a roof 10 m above the ground.

Standard Grade Physics Measuring Motion Name: Class: Teacher:

PHYSICS 12 NAME: Kinematics and Projectiles Review

Card 1 Chapter 17. Card 2. Chapter 17

Unit 1 Lesson 5 Fluids and Pressure. Copyright Houghton Mifflin Harcourt Publishing Company

Physics terms. coefficient of friction. static friction. kinetic friction. rolling friction. viscous friction. air resistance

LAUNCH IT. DESIGN CHALLENGE Design and build an air-powered rocket that can hit a target at least 5 feet away.

Unit 2: Kinematics in 1-D Exam Preparation

Four forces on an airplane

REVIEW : KINEMATICS

Appendix : Categorization Task. Instructions

Copyright 2014 Edmentum - All rights reserved.

Section 2 What Is a Force?

Transcription:

Forces A force is any kind of PUSH or PULL. The unit of force is the newton (N). A force can be measured using an instrument called a force meter (sometimes called a newton meter or spring balance) Using a force meter to measure weight Using a force meter to measure friction A force will bring about one of the following changes: i. Make an object move faster (accelerate) ii. Make a moving object slow down iii.make a moving object change direction iv. Make an object change shape. eg cause a spring to stretch Examples of different kinds of force: Magnetism Gravity (which causes an object to have weight) Electrostatic (static charges cause objects to attract or repel each other) Friction which will try and make any moving object to slow down.

Forces usually work in pairs When a ball is in water the water pushes up on the ball helping it float. This upward force is called upthrust. Upthrust pushes UP. Gravity pulls DOWN. If the ball is floating then these two forces are the same strength. Balanced and unbalanced forces Most objects have TWO forces on them. If these two forces are the same the object will not move (Or will stay moving at a steady speed) A book on the table does not fall to the ground because the table pushes up

Other examples A man falling with a parachute has two forces on him Gravity pulls him down. Air resistance pushes up. If the man is falling at a steady speed then these two forces must be the same. A rocket balloon has two forces on it. The air coming out of the back pushes the balloon forwards. Air resistance slows the balloon down. if the thrust pushing forwards is larger than the air resistance then the rocket speeds up. Mass and weight The mass of an object will never change. Mass is measured in kilograms Weight depends on the pull of gravity. If the pull of gravity increases or decreases then so will the weight. The Earth s gravity pulls with a force of 10 N on every 1 kg. eg A block of butter has a mass of 2 kg. on the Earth. What is its weight? The pull of the Earth's gravity is 10N/kg so the weight of the butter is 2 x 10 which = 20NOn the Moon (where the gravity is less than the Earth the mass will still be 2 kg but it s weight will be LESS than before.

A moving car The car will remain stationary until a force P pushes it forwards. If the car is moving at a steady speed then the force P will equal the force F. The force W (the weight of the car) caused by gravity, must be balanced by the road pushing upwards supporting the car. Friction Friction is a force which tries to slow down a moving object. It always pushes in the OPPOSITE direction to the direction of movement Friction can be lowered several ways (eg when sliding a wooden block across the table: Lubricating the surface between the block and the table. Placing bearings (rollers) between the block and the table. Changing the surface of the block (eg coating with PTFE or nylon) Making the block smoother. Click on the image above to see a friction simulation Disadvantages of friction: overheating in bearings, increase fuel consumption in cars, lowers the top speed of cars, bicyclists or skiers, tries to slow down any moving object, overheating in objects moving through the air at high speed. Advantages of friction: Allows cars, bicycles, etc to speed up, slow down or change direction. Without friction we would not be able to walk, run, stop, or change direction. Friction helps to stop things (eg furniture) from sliding around. Air resistance can be used to slow down a fast moving object (eg using a parachute). Of course there may be other factors as well that make the most expensive trainer better such as comfort and durability but they would need to be investigated in separate experiments.

Thinking, braking and stopping distances When driving sometimes the driver to brake very rapidly (eg if a dog runs out in front of the car). The distance it takes to stop depends on two factors: Thinking distance - This is the distance the car travels between spotting the hazard and actually applying the brakes. It is caused by time it takes the driver to react to the situation and realise that he needs to stop. Braking distance - The braking distance is the distance you travel between applying the brakes and actually coming to a stop. Stopping distance = thinking distance + braking distance Factors that might increase stopping distance: Thinking distance can be increased by: feeling tired alcohol and drugs driving faster getting distracted Braking distance can be increased by: Driving faster Roads being icy or wet something wrong with the car (eg bald tyres or poor brakes) NOTE: You do not need to know what the actual stopping distances are, just what might affect them.

Investigation to discover if the more expensive trainer has a better grip Measuring the friction between a trainer and the bench. Prediction: The more expensive brand will perform better Method: The trainer is being pulled by the spring balance. We can repeat the experiment using different trainers but to keep it a fair test each trainer must be loaded with weights so that they all weigh the same. The trainers should also all be the same shoe size Independent variable (what we are testing): The make of trainer (ie the material in contact with the bench) Dependent variable (what we are measuring): The force (in newtons) required to pull the trainer at a steady speed across the bench Other variables (to be kept the same for each experiment): Size and mass of trainer Results: Bar Graph Type of shoe Force required to pull the trainer (N) A 5 B 8 C 7 D 4 Force (N) 8 7 6 5 4 3 2 1 A B C D E Type of shoe