MAKERS OF ADHESIVES, SEALANTS, AND RELATED PRODUCTS SINCE 1958. Chem-Rez (Part A) (Epoxy) - MATERIAL SAFETY DATA SHEET -
MAKERS OF ADHESIVES, SEALANTS, AND RELATED PRODUCTS SINCE 1958. - MATERIAL SAFETY DATA SHEET - Chem-Rez (Part A) (Epoxy) Address: 8428 Shepard RD SE T2C 1R6, Calgary, AB Phone: [403] 252.7803 Fax: [403] 252.2384 SECTION ONE MANUFACTURER S NAME: Chemtron Manufacturing Ltd. ADDRESS: 8428 Shepard Road SE Calgary, AB T2C 1R6 EMERGENCY PHONE: 252-7803 TRADE NAME: Chem-Rez (Part A) CHEMICAL FAMILY Epoxide COMMON NAME Bisphenol A Epoxy Resin MATERIAL USE: Liquid Resin WHIMS CLASSIFICATION D.2.B. T.D.G. CLASSIFICATION: Not Regulated SECTION TWO - HAZARDOUS INGREDIENTS HAZARDOUS INGREDIENTS Considered nonhazardous as per WHIMS regulations % T.L.V. C.A.S.# LD/50 LC/50 80-100 Not Available 25068-38-06 See Section 6 See Section 6 SECTION THREE - PHYSICAL DATA PHYSICAL STATE: APPEARANCE & ODOUR: VAPOUR PRESSURE: VAPOUR DENSITY (AIR=1) EVAPORATION RATE: BOILING POINT (DEG C): FREEZING POINT (DEG c): PH: SPECIFIC GRAVITY: SOLUBILITY IN WATER: COEFFICIENT OF WATER/OIL: DISTRIBUTION: Liquid Clear liquid, slight odour ca. 1 mm Hg at 180o C Not applicable approx. >200o C 1.15g/cm3 Insoluble Pg 2of5 Phone: (403) 252-7803 Fax: (403) 252-2384 www.chemtron.ca
SECTION FOUR - FIRE AND EXPLOSION HAZARD DATA SPECIAL PROCEDURES: FLASH POINT (C), METHOD: AUTO IGNITION TEMPERATURE: UPPER FLAMMABLE LIMIT (% VOL): LOWER FLAMMABLE LIMIT (% VOL): HAZARDOUS COMBUSTION PRODUCTS: EXPLOSION DATA: Firefighters should wear the usual protective gear; selfcontained breathing apparatus. 250o C, closed cup Not applicable Not established Not established Carbon monoxide, carbon dioxide, aldehydes SENSITIVITY TO STATIC: Not established DISCHARGE SENSITIVITY TO IMPACT: Not established SECTION FIVE - REACTIVITY DATA CHEMICAL STABILITY: COMPATIBLE WITH OTHER SUBSTANCES: HAZARDOUS PRODUCTS OF DECOMPOSITION: YES, WHICH CONDITIONS? Under normal conditions NO, WHICH CONDITIONS?Elevated temperatures, strong acids or bases in bulk YES, WHICH ONES? NO, WHICH ONES? Strong oxidizing agents Carbon monoxide, carbon dioxide, aldehydes SECTION SIX - TOXICOLOGICAL PROPERTIES EFFECTS OF ACUTE EXPOSURE: EFFECTS OF CHRONIC EXPOSURE: LD50 OF MATERIAL, SPECIES & ROUTE: LC50 OF MATERIAL, SPECIES & ROUTE: EXPOSURE LIMIT OF MATERIAL: IRRITANCY OF MATERIAL: SENSITIZATION TO MATERIALS: CARCINOGENICITY OF MATERIAL: TERATOGENICITY OF MATERIAL: MUTAGENICITY OF MATERIAL: Causes skin and eye irritation, dermatitis Potential sensitizer SKIN CONTACT: Moderate irritation EYE CONTACT: Slight irritation + 1g/kg, rat, oral + 6g/kg, rabbit, dermal Refer to route of entry Moderate sensitizer Not carcinogenic Not teratogenic Not mutagenic Pg 3of5 Phone: (403) 252-7803 Fax: (403) 252-2384 www.chemtron.ca
FIRST AID SKIN CONTACT: SKIN ABSORPTION: EYE CONTACT: INHALATION: INGESTION: Wash with soap and water or use waterless handcleaners. Do not use solvents or thinners to clean the skin. Get medical attention. No data Flush with large amounts of water while holding eyelids open. Get medical attention. Remove victim to fresh air. If breathing is difficult, give oxygen; if breathing stopped, give artificial respiration. Get medical attention. If victim is conscious, give large amounts of water. Call a physician. NO NOT INDUCE VOMITING, unless directed by a physician. SECTION SEVEN - PREVENTATIVE MEASURES GLOVES/TYPE: Rubber or plastic RESPIRATOR/TYPE: If natural ventilation is inadequate, wear a NIOSH approved cartridge respirator with organic vapour cartridge. EYE/TYPE: Wear chemical splash goggles or safety glasses with side shields if splashing may occur. FOOTWEAR: Not specified CLOTHING/TYPE: Wear protective apron if splashing or repeated contact is likely. OTHER/TYPE: Use barrier cream VENTILATION REQUIREMENTS: Natural ventilation is usually adequate. If necessary, use local exhaust. LEAK/SPILL: Absorb into sand or other absorbent material. Shovel into closeable container for disposal. Wear protective equipment specified above. WASTE DISPOSAL: Flush residue well with detergent solution. Dispose of in accordance with government regulations. HANDLING PROCEDURES AND EQUIPMENT: Avoid all personal contact. Use adequate ventilation. For industrial use only. STORAGE NEEDS: Keep container tightly closed. Store away from heat. SPECIAL SHIPPING INSTRUCTIONS: See Sections 1 and 2 SECTION EIGHT - PREPERATION INFORMATION TELEPHONE NUMBER: 403-252-7803...Continued Pg 4of5 Phone: (403) 252-7803 Fax: (403) 252-2384 www.chemtron.ca
DISCLAIMER: The information contained herein is based on the information available at the indicated date of preparation. The information contained herein relates only to this product or material, and may not be valid when used in combination with any other product, material or in any process. Without limitation on rights and remedies of Chemtron Manufacturing Ltd., Chemtron assumes no responsibility for injury to anyone caused by the material if reasonable safety procedures are not adhered to as stipulated in the data sheet or for any abnormal use of the material, even if reasonable safety procedures are followed. If the product is not to be used for a purpose or under conditions which are normal or reasonably foreseeable, the information herein cannot be relied upon. Chemtron makes this MSDS available for use by its customers only, and any vendee of such customer and any other third person or entity assumes the risk of use of the material. DATED: January 15, 2009 Pg 5of5 Phone: (403) 252-7803 Fax: (403) 252-2384 www.chemtron.ca