Safety Data Sheet Page 1 of 5 SF-TEROSON PU 9225 COMP. A EX Revision: 12.11.2013 printing date: 19.12.2016 Section 1. Identification of the substance/preparation and of the company/undertaking Product name: SF-TEROSON PU 9225 COMP. A EX Identification of manufacturer, importer or distributor Manufacturer: Henkel AG & Co. KGaA, Heidelberg, Henkel Teroson Straße 57, 69112 Heidelberg, Germany. Phone: +49-6221-704-0 Fax: +49-6221-704-698 Importer: Henkel Thailand Ltd The Offices at Centralworld, 35th Floor, 999/9 Rama 1 Rd, Kwang Patumwan, Khet Patumwan, Bangkok 10330, Thailand. Phone : + 6622098000 Fax : +6622098008 Information office (content SDS): ap-ua-psra.sea@henkel.com Section 2. Composition / information on ingredients General chemical description: Adhesive Declaration of ingredients: Hazardous components CAS-No. EINECS content Classification 10-30 % Xi - Irritant; R36 Hazard classification: Not required according to the regulations. Section 3. Hazards identification Inhalation: Move to fresh air, consult doctor if complaint persists. Section 4. First aid measures Skin contact: Rinse with running water and soap. Apply replenishing cream. Change all contaminated clothing. Eye contact: Rinse immediately with plenty of running water (for 10 minutes). Seek medical attention if necessary.
Page 2 of 5 Ingestion: Rinse mouth, drink 1-2 glasses of water, do not induce vomiting, consult a doctor. Suitable extinguishing media: All common extinguishing agents are suitable. Special protection equipment for firefighters: Wear self-contained breathing apparatus. Particular danger/case of fire: In case of fire toxic gases can be released. Section 5. Fire fighting measures Personal precautions: Danger of slipping on spilled product. Environmental precautions: Do not empty into drains / surface water / ground water. Section 6. Accidental release measures Clean-up methods: Remove with liquid-absorbing material (sand, peat, sawdust). Dispose of contaminated material as waste according to Chapter 13. Section 7. Handling and storage Handling: Avoid contact with e, skin and clothing. Wash thoroughly after handling. Avoid breathing fumes if this product is used at high temperatures. Use only with adequate ventilation. Do not take internally. For industrial use only. Storage: Ensure good ventilation/extraction. Store in a cool, dry place. Temperatures between + 10 C and + 25 C Protect from direct sun-light and temperature above 50 C in any case. Section 8. Exposure controls / personal protection Respiratory protection: Suitable breathing mask when there is inadequate ventilation. Hand protection: Chemical-resistant protective gloves (EN 374). Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes permeation time as per EN 374): Polychloroprene (CR; >= 1 mm thickness) or natural rubber (NR; >=1 mm thickness) Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time as per EN 374): Polychloroprene (CR; >= 1 mm thickness) or natural rubber (NR; >=1 mm thickness) This information is based on literature references and on information provided by glove manufacturers, or is derived by analogy with similar substances. Please note that in practice the working life of chemical-resistant protective gloves may be considerably shorter than the permeation time determined in accordance with EN 374 as a result of the many influencing factors (e.g. temperature). If signs of wear and tear are noticed then the gloves should be replaced.
Page 3 of 5 Eye protection: Protective goggles Body protection: Engineering controls: Ensure good ventilation/extraction. Hygienic measures: Do not eat, drink or smoke while working. Wash hands before work breaks and after finishing work. Section 9. Physical and chemical properties Appearance: Odor: Specific gravity: Density: Solubility: VOC content (2004/42/EC) yellow liquid odorless 1,43 1,43 g/cm3 Solvent: Water, Not miscible 0 % (VOCV 814.018 VOC regulation CH) Conditions to avoid: Stable under recommended storage conditions. None if used for intended purpose. Materials to avoid: None if used for intended purpose. Hazardous decomposition products: No decomposition if used according to specifications. Section 10. Stability and reactivity Section 11. Toxicological information General toxicological information: To the best of our knowledge no harmful effects are to be expected if the product is handled and used properly. Acute oral toxicity:
Page 4 of 5 Acute inhalative toxicity: Exposure time Acute dermal toxicity: General ecological information: Do not empty into drains, soil or bodies of water. Section 12. Ecological information Section 13. Disposal considerations Product of disposal: In consultation with the responsible local authority, must be subjected to special treatment. Packaging Disposal for uncleaned package: Packaging that cannot be cleaned are to be disposed of in the same manner as the product. Section 14. Transport information General information: Not hazardous according to RID, ADR, ADNR, IMDG, IATA-DGR. Indication of danger: Not required according to the regulations. Section 15. Regulations - classification and identification Global inventory status: Regulatory list EINECS TSCA INV (CN) Notification Section 16. Other information Issue date: 19.12.2016
Page 5 of 5 Disclaimer This information is based on our current level of knowledge and relates to the product in the state in which it is delivered. It is intended to describe our products from the point of view of safety requirements and is not intended to guarantee any particular properties. This safety data sheet was prepared in accordance with Council Directive 67/548/EEC and it's subsequent amendments, and Commission Directive 1999/45/EC.