SECTION I PRODUCT AND COMPANY IDENTIFICATION Product Name: Identification Number: Trim-Tex Mud-Max BPMTRMTEXMUD SECTION II COMPOSITION/INFORMATION ON INGREDIENTS This product consists of a mixture/preparation. WT/WT% Item CHEMICAL NAME: CAS Number Less Than This product is non-hazardous by definition of Hazard Communication Standard (29 CFR 1910.1200). This product contains no hazardous ingredients at or above OSHA reportable levels. (See Section 16 for abbreviation legend) SECTION III HAZARDS IDENTIFICATION EMERGENCY OVERVIEW Do not transfer to unmarked containers. Keep from reach of children. Keep container closed when not in use. Containers of this material may be hazardous when emptied, since containers retain product residues (vapor, liquid, and/or solid). All hazard precautions given must be observed. Do not flame cut, braze or use a welding torch on containers. Intentional misuse may be harmful. EFFECTS OF OVEREXPOSURE: Eye Contact: Skin Contact: Inhalation: Ingestion: Chronic Hazards: Primary Route of Entry: May cause eye irritation, redness, tearing, blurred vision. Prolonged or repeated contact may cause moderate irritation. This is not an anticipated route of entry. This is not an anticipated route of entry. No information. Skin contact & Eye contact Trim-Tex Mud-Max 1 of 6
SECTION IV FIRST-AID PROCEDURES Inhalation: Skin Contact: Eye Contact: Ingestion: No information Thoroughly wash exposed area with soap and water. Remove contaminated clothing. Launder contaminated clothing before re-use. Get medical attention if irritation persists. Mineral oil, baby oil, makeup remover, mineral spirits, or other similar mild solvent may be used to remove the sticky resin residue left by the adhesive. Flush with large amounts of water, lifting upper and lower lids occasionally and get medical attention. Do not induce vomiting. Give two glasses of water if conscious. Never give anything by mouth to an unconscious person. Get immediate medical attention. SECTION V FIRE-FIGHTING MEASURES Suitable Extinguishing Media: CO 2, Dry Chemical, Water Fog Fire Fighting Procedures: Wear self-contained breathing apparatus with a full face piece operated in pressure-demand or other positive pressure mode when fighting fires. Keep fire exposed containers cool with water fog. Flash Point: N/A Lower Explosive Limit: N/A Upper Explosive Limit: N/A Auto-ignition Temperature: N/D Unsual Fire and Explosion Hazards: Closed containers can build pressure and may rupture if exposed to fire. SECTION VI ACCIDENTAL RELEASE MEASURES METHODS FOR CLEANING UP: Stop spill at source prevent spreading. Avoid skin contact with liquid. Soak up on absorbent material and place into container for disposal. Clean walking surfaces thoroughly to reduce slipping hazard. Trim-Tex Mud-Max 2 of 6
SECTION VII HANDLING AND STORAGE Handling: Storage: Containers of this material may be hazardous when emptied, since containers retain product resides (vapor, liquid, and/or solid). All hazard precautions given must be observed. Do not flame cut, braze or use welding torch on containers. Intentional misuse may be harmful. Avoid freezing. Store at temperatures of 60ºF to 90ºF to preserve product stability. SECTION VIII EXPOSURE CONTROL AND PERSONAL PROTECTION Engineering Controls: Provide sufficient mechanical ventilation (general and/or local exhaust) ventilation to maintain exposure below TLV(s). Personal Protective Equipment: Eye Protection: Skin and Body Protection: Respiratory Protection: Hygiene Measures: Wear safety glasses at minimum, more extensive protection may be necessary depending on how the product is to be used. Wear impervious gloves if method of use involves skin contact with product. Consult your safety supply vendor for glove recommendations. No information. Wash hands after handling and before eating or smoking. Smoke in designated areas only. Remove and launder clothing if contaminated. Other Protective Equipment: Wear impervious clothing if bodily exposure is anticipated. Consult your safety supply vendor for recommendations. Trim-Tex Mud-Max 3 of 6
SECTION IX PHYSICAL AND CHEMICAL PROPERTIES Physical Form: Liquid Appearance: White Liquid Odor: Slight Ammonia Odor Threshold: Boiling Range: 212ºF - 212ºF Freezing Point: Vapor Pressure (at 100ºF): Vapor Density: Is heavier than air Viscosity: Solubility in Water (%): Dilutable Specific Gravity (at 77ºF / 25ºC): 1.0327 ph @ 0.0%: : Evaporation Rate: Is slower than Butyl Acetate Coefficient of Water/Oil Distribution: (See Section 16 for abbreviation legend.) SECTION X STABILITY AND REACTIVITY Conditions to Avoid: Incompatibility: None known None known Hazardous Decomposition Products: None known Hazardous Polymerization: Stability: Will not occur under normal conditions. This product is stable under normal storage conditions. SECTION XI TOXICOLOGICAL INFORMATION No product or component toxicological information is available. SECTION XII ECOLOGICAL INFORMATION Ecological Information: No information Trim-Tex Mud-Max 4 of 6
SECTION XIII DISPOSAL INFORMATION Product Disposal: Dispose of in accordance with all local, state and federal regulations. SECTION XIV TRANSPORT INFORMATION DOT Information (49CFR 172.101) Proper Shipping Name: Technical Name: Hazard Class: Hazard Subclass: UN / NA Number: Packing Group: Resp. Guide Page: Additional Information: Not Regulated No Information. SECTION XV REGULATORY INFORMATION US FEDERAL REGULATIONS: OSHA: Non-hazardous by definition of Hazard Communication Standard (29 CFR 1910.1200) SARA Section 313: This product contains the following substances subject to the reporting requirements of Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372: CAS No. CHEMICAL NAME WT. % No SARA Section 313 component exists in this product. Toxic Substance Control Act (TSCA): This product contains the following chemical substances subject to the reporting requirement of TSCA 12(B) if exported from the United States: CAS No. CHEMICAL NAME WT. % No information is available. Trim-Tex Mud-Max 5 of 6
SECTION XV REGULATORY INFORMATION INTERNATIONAL REGULATIONS AS FOLLOWS: CANADIAN WHMIS: This MSDS has been prepared in compliance with controlled Product Regulations except for use of the 16 headings. CANADIAN WHMIS CLASS: No information available TSCA INVENTORY: All components of this product are on the US TSCA Inventory. SECTION XVI OTHER INFORMATION HMIS Ratings: Health: 1 Flammability: 0 Reactivity: 0 Previous MSDS Revision Date: 03/07/11 Reason for Revision: Scheduled Update. Volatile by Weight: 45.0% Volatile by Volume: 45.0% VOC Content: 0.0% by weight, 0 grams/liter total product, 0 grams/liter less water and exempt, 0.00 lbs/can Legend: N/A Not Applicable N/E Not Established N/D The information contained on this MSDS has been checked and should be accurate. However, it is the responsibility of the user to comply with all Federal, State, and Local laws and regulations. The environmental information and hazardous materials identification system have been included by Trim-Tex, Inc. in order to provide additional health and hazard classification information. The ratings recommended are based upon the criteria supplied by the developers of these rating systems, together with Trim-Tex, Inc. s interpretation of the available data. Proper personal protective equipment varies widely with conditions of use and anticipated exposure. We recommend that a supervisor or other qualified person determine proper PPE for intended use. Trim-Tex Mud-Max 6 of 6