Material Safety Data Sheet ZEP ENHANCE PRESOAK 1. Trade name of product Product use Code Date of issue Product and company identification ZEP ENHANCE PRESOAK Presoak Product dilution information.78 to 1.56% 1128-164 Supplier s Information Zep Vehicle Care 293 Waters Road Suite 23 Eagan, MN 55121 Phone 1-877-3269274 2. Physical state Emergency overview 93962 1/1/216 Hazards identification Routes of entry Skin contact, Eye contact, Inhalation, Ingestion Potential acute health effects Eyes Corrosive to eyes. Skin Corrosive to the skin. Inhalation Ingestion Liquid. DANGER! CAUSES DIGESTIVE TRACT, EYE AND SKIN BURNS. CAUSES RESPIRATORY TRACT IRRITATION. Do not ingest. Do not get in eyes, on skin or on clothing. Avoid breathing vapours, spray or mists. Keep away from heat, sparks and flame. Keep container closed. Use only with adequate ventilation. Wash thoroughly after handling. Severely irritating to the respiratory system. Causes burns to mouth, throat and stomach. See toxicological information (section 11) 3. Emergency Telephone Numbers For MSDS Information Technical Services 1-78-453-81 Business Hours 8am -5pm For Medical and Transportation Emergency CANUTEC (24 Hours) 613-996-6666 Call Collect Composition/information on ingredients Liquid. CAUTION! MAY CAUSE EYE IRRITATION. Avoid contact with eyes. Wash thoroughly after handling. Slightly irritating to the eyes. Name CAS number % by weight SODIUM HYDROXIDE 131-73-2 1-5 TETRASODIUM EDTA 64-2-8 1-5 1/6
ZEP ENHANCE PRESOAK 1/1/216 3. Composition/information on ingredients Within the present knowledge of the supplier, this product does not contain any hazardous ingredients in quantities requiring reporting, in accordance with local regulations. 4. Eye contact Skin contact Inhalation Ingestion 5. First-aid measures In case of contact, immediately flush eyes with cool running water. Remove contact lenses and continue flushing with plenty of water for at least 15 minutes. Get medical attention immediately. In case of contact, immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Get medical attention immediately. Wash clothing before reuse. Clean shoes thoroughly before reuse. If inhaled, remove to fresh air. If exposed person is not breathing, give artificial respiration or oxygen applied by trained personnel. Get medical attention. If material has been swallowed and the exposed person is conscious, give small quantities of water to drink. Do not induce vomiting. Never give anything by mouth to an unconscious person. Get medical attention immediately. Fire-fighting measures Auto-ignition temperature Flammable limits Hazardous thermal decomposition products Special remarks on fire hazards Special remarks on explosion hazards Fire-fighting media and instructions Special protective equipment for fire-fighters 6. Personal precautions Environmental precautions Rinse with water for a few minutes. No known effect after skin contact. Rinse with water for a few minutes. No special measures required. Treat symptomatically. Get medical attention if symptoms occur. Decomposition products may include the following materials carbon dioxide carbon monoxide nitrogen oxides metal oxide/oxides Accidental release measures Use an extinguishing agent suitable for the surrounding fire. Dyke area of fire to prevent runoff. In a fire or if heated, a pressure increase will occur and the container may burst. Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode. Initiate company's spill response procedures immediately. Keep people out of area. Put on appropriate personal protective equipment (see section 8). Do not touch or walk through spilt material. Avoid contact of spilt material and runoff with soil and surface waterways. Use personal protective equipment as required. Avoid contact of large amounts of spilt material and runoff with soil and surface waterways. 2/6
ZEP ENHANCE PRESOAK 1/1/216 6. Methods for cleaning up Accidental release measures Follow company's spill procedures. Keep people away from spill. Put on appropriate personal protective equipment (see section 8). Absorb/neutralise liquid material. Use a tool to scoop up solid or absorbed material and put into appropriate labelled container. Use a water rinse for final clean-up. Use a water rinse for final clean-up. 7. Handling Storage 8. Engineering measures Handling and storage Do not ingest. Do not get in eyes, on skin, or on clothing. Do not breathe vapour or spray. Keep container closed. Use only with adequate ventilation. Wash thoroughly after handling. Keep out of reach of children. Store in a closed container. Keep container tightly closed. Store between the following temperatures -1 and 5 C Exposure controls/personal protection Personal protection Eyes Use chemical splash goggles. For continued or severe exposure wear a face shield over the goggles. Hands Skin Respiratory Use only with adequate ventilation. If user operations generate dust, fumes, gas, vapour or mist, use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure to airborne contaminants below any recommended or statutory limits. Provide suitable facilities for quick drenching or flushing of the eyes and body in case of contact or splash hazard. Use chemical-resistant, impervious gloves. Use synthetic apron, other protective equipment as necessary to prevent skin contact. Wear appropriate respirator when ventilation is inadequate and occupational exposure limits are exceeded. Avoid contact with eyes. Wash thoroughly after handling. Keep out of reach of children. Store in a closed container. Good general ventilation should be sufficient to control worker exposure to airborne contaminants. No protective equipment is needed under normal use conditions. No protective equipment is needed under normal use conditions. No protective equipment is needed under normal use conditions. No special protection is required. Occupational exposure limits TWA (8 hours) STEL (15 mins) Ceiling Ingredient List name ppm mg/m³ Other ppm mg/m³ Other ppm mg/m³ Other Notations sodium hydroxide US ACGIH 1/29 - - - - - - - 2 - AB 4/29 - - - - - - - 2 - [3] BC 1/29 - - - - - - - 2 - ON 8/28 - - - - - - - 2 - QC 6/28 - - - - 2 - - - - [3]Skin sensitisation 3/6
ZEP ENHANCE PRESOAK 1/1/216 9. Physical and chemical properties Physical state Liquid. Flash point > 1 C Colour Colourless. Odour Faint odour. ph Boiling/condensation point Melting/freezing point 12.5 to 13.5 [Conc. (% w/w) 1%] >1 C (>212 F) Relative density 1.3 to 1.7 Vapour pressure Vapour density Odour threshold Evaporation rate Viscosity Dispersibility properties Solubility LogKow 1. Stability and reactivity Stability Conditions of instability Reactivity Hazardous decomposition products Liquid. > 1 C Colourless. Odourless. 11.6 to 12.3 The product is stable. Under normal conditions of storage and use, hazardous polymerisation will not occur. Slightly reactive or incompatible with the following materials metals and acids. Under normal conditions of storage and use, hazardous decomposition products should not be produced. Hazardous polymerisation Under normal conditions of storage and use, hazardous polymerisation will not occur. 11. Toxicological information Potential acute health effects Eyes Corrosive to eyes. Skin Inhalation Ingestion Corrosive to the skin. Severely irritating to the respiratory system. Causes burns to mouth, throat and stomach. Potential chronic health effects Carcinogenic effects Mutagenic effects Teratogenic effects Reproductive effects Sensitization to Product Synergistic products (toxicologically) Slightly irritating to the eyes. 4/6
ZEP ENHANCE PRESOAK 1/1/216 11. Toxicity data Toxicological information Product/ingredient name Test Route Result Species sodium hydroxide LD5 Dermal >2 mg/kg Rabbit LD5 Dermal 135 mg/kg Rabbit LD5 Oral 5 mg/kg Rabbit LD5 Oral 3 to 5 mg/kg Rat LDLo Oral 5 mg/kg Rabbit acetic acid, (ethylenedinitrilo)tetra-, LD5 Oral 1 g/kg Rat tetrasodium salt LD5 Oral 7 g/kg Rabbit Other adverse effects Target organs 12. Ecological information Ecotoxicity 13. Waste disposal 14. Contains material which may cause damage to the following organs lungs, upper respiratory tract. Not reported Disposal considerations Avoid disposal. Attempt to use product completely in accordance with intended use. Disposal should be in accordance with applicable regional, national and local laws and regulations. Transport information Diluted product can be flushed to sanitary sewer. Discard empty container in trash. Certain shipping modes or package sizes may have exceptions from the transport regulations. The classification provided may not reflect those exceptions and may not apply to all shipping modes or package sizes. IMO/IMDG Classification Not applicable. UN number Proper shipping name Class UN1824 SODIUM HYDROXIDE SOLUTION Packing group II See shipping documents for specific transportation information. Not intended for transport. 8 15. Regulatory information WHMIS Class E Corrosive material Not hazardous by WHMIS criteria. Canada inventory All components are listed or exempted. This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and the MSDS contains all the information required by the Controlled Products Regulations. 5/6
ZEP ENHANCE PRESOAK 1/1/216 16. Other information Hazardous Material Information System (U.S.A.) Health Physical hazards * 3 Health Physical hazards 1 National Fire Protection Association (U.S.A.) Health 3 Instability/Reactivity Health 1 Instability/Reactivity Special Special Date of issue Date of previous issue Notice to reader 1/1/216 No previous validation Responsible name Compliance Services 1-877-428-9937, menu option #6, then option #2 Indicates information that has changed from previously issued version. The above information is believed to be correct with respect to the formula used to manufacture the product in the country of origin. As data, standards, and regulations change, and conditions of use and handling are beyond our control, NO WARRANTY, EXPRESS OR IMPLIED, IS MADE AS TO THE COMPLETENESS OR CONTINUING ACCURACY OF THIS INFORMATION. 6/6