Operating Instructions for: 2.4GHz Radio Control Model Boat Please read the instruction manual carefully before operating. CAUTION: DESIGNED FOR FRESH WATER USE ONLY. FEATURES 2.4GHz radio included Radio range - 300ft/(100m) approx. Proportional steering and forward speed with slow reverse Fan cooled motor Safety feature - Boat will only operate when placed in water Capsized boat can be turned upright remotely using the transmitter Display stand included Bonus Protective Nose Piece Included SPECIFICATIONS Hull length: 13.8in/350mm Hull width: 3.46in/88mm Height: 2.76in/70mm Battery: 7.4V Li-ion 700mAh Charger: 2-Cell/2S 7.4V Li-Ion, 650mAh 110-240V AC Charger Functions: Forward, backward, left, right
Identifying the main components 2 Atomic Flash Instructions
Installing batteries in transmitter Remove retaining screw and slide open the battery cover on base of the transmitter. Insert six (included) 1.5V AA alkaline batteries into the base of the tranmitter. Safety Warning: Ensure correct polarity, + and -, when inserting batteries. Replace battery cover and retaining screw. Precautions for batteries in transmitter 1. AA alkaline batteries are recommended. 2. Rechargeable batteries may be used. 3. Non-rechargeable batteries cannot be recharged. 4. Do not short circuit or dismantle alkaline or rechargeable batteries and do not place used batteries into a fire. 5. Charge rechargeable batteries only with Adult supervision. 6. Take rechargeable batteries out of the boat and transmitter to recharge. 7. Ensure correct polarity when replacing batteries. 8. Do not mix battery types or brands and do not mix old and new batteries. 9. The boat may be cleaned in fresh water. You must remove the battery before cleaning. 10. Discharged batteries must not be left in the boat or the transmitter. 11. If you are not using the boat, remove the battery. 12. Regularly check the condition of the wiring, plugs, hull and other components incase of damage. If damage is found, do not use until repaired. Charging boat battery 1. Remove battery from the boat. 2. Connect the boat battery to the charger. 3. Plug the charger into a 120V power socket and turn on the power. 4. Charge time is approxiamately 1 hour. 5. Do not leave battery unattended. 6. When the charge time is complete, the surface of the battery may be warm. 7. Turn off the power, remove the charger from the socket and disconnect the battery. 8. During charging, if the battery becomes too hot to hold, disconnect from the power and charger immediately. 120V AC www.modelengines.com.au 3
Installing Li-Ion battery in the boat 1. Turn the latch on the boat hatch to the left or right and remove the hatch. 2. Place a fully charged Li-Ion battery in the battery holder of the boat hull. 3. Connect the JST plug on the battery to the JST plug from the ESC (electronic speed controller). Safety Warning 4. Hold the boat cover hatch upside down and ensure the silicon sealing ring is correctly in place. While continuing to hold the boat cover hatch upside down, attach the hull as per the diagram above in the following order, 1 first, 2 second and 3 last. Press the boat cover hatch firmly into place and turn the latch to secure. 1. Safety feature - Boat will only operate when placed in water. But to prevent possibility of injury from a spinning propeller do not even attempt to run the boat out of the water. 2. The boat should only be used when placed in water and controlled by the transmitter. 3. Adjust the rudder so that it is inline with the centreline of the boat so the boat will track in a straight line. 4. This product is suitable for persons over 14 years of age unless under adult supervision. 5. Make sure there is no one swimming nearby so as to avoid injury. 6. Do not use in water containing foreign bodies which may damage the boat and prevent smooth operation 7. The radio control will operate at distances up to 300ft/100m. Do not exceed this distance otherwise you may loose control of the boat. 8. When you are not using the boat, disconnect the battery and turn off the transmitter. 9. When the Li-Ion battery in the boat is running out of power, the boat will slow down. Return the boat to shore and recharge as soon as possible. 10. Always recharge the battery before storing it away to prevent damage to the battery. 11. Please be safety consious and keep the boat under control. 12. Do not enter the water to retreive the boat without safety protection, so as to avoid accidents. 4 Atomic Flash Instructions
How to operate your boat Place the boat into the water. (Boat will only operate when placed in water) Pull the trigger on the transmitter towards you to make the boat go forwards. Push the trigger on the transmitter away from you to make the boat go backwards. Pull the trigger on the transmitter towards you and rotate the direction knob counterclockwise to make the boat turn left. Pull the trigger on the transmitter towards you and rotate the direction knob clockwise to make the boat turn right. www.modelengines.com.au 5
How to right the boat if it turns over If the boat flips over and remains upside down, push the throttle trigger on the transmitter away from you and in quick succession pull the throttle trigger towards you. The torque effect produced will right the boat and allow you keep using the vehicle without having to manually retreive it. Fine tuning if the boat turns left If the boat turns slightly to the left when it should be going straight ahead, slowly rotate the fine adjustment knob on the tranmitter clockwise until it travels in a straight line. Fine tuning if the boat turns right If the boat turns slightly to the right when it should be going straight ahead, slowly rotate the fine adjustment knob on the tranmitter counter-clockwise until it travels in a straight line. Maintenance and Inspection 1. Check for excess water in the hull after every use. If you do find excess water in the hull, pay extra special attention to installing the top hatch, ensuring the silicon seal is correctly in place. 2. Always remove the Li-Ion battery from the boat after use. 3. After use, store the boat in the shade or inside to prevent the sun fading the paint. 4. Never use chemicals to clean the boat as this may also damage the paint. 5. The boat is designed for fresh water use only. If the boat comes into contact with brackish or salty water, remove battery and wash the boat throughly with fresh water as soon as possible to remove all the salty water. 6. After use, clean the boat using fresh water. Make sure you dry the boat inside and out using a dry cloth or paper towel. This will keep the hull and hatch of the boat looking clean and new. 7. When you are finished using the boat, make sure you have removed the batteries from the boat and the transmitter. This will prevent damage in the event of a battery leak. 6 *Boat can not be righted if battery is fully discharged* Atomic Flash Instructions
Binding Instructions * read all steps before attempting to bind 1. With the boat out of water and battery unplugged turn on radio (The green freq LED will start flashing). 2. Plug the battery into the boat and place it in water before the green freq led stops flashing 3. When the binding procedure is done the green freq led will stop flashing. Spare Parts A full range of spare parts available to keep your boating action alive. Please order the parts you require from your local Hobby Town retailer. www.hobbytown.com. Parts can also be purchsed from Helion RC s website: Helionrc.com Item Number HLNB0001 HLNB0002 HLNB0003 HLNB0004 HLNB0005 HLNB0006 HLNB0007 HLNB0008 HLNB0009 HLNB0010 HLNB0011 HLNB0012 HLNB0013 HLNB0014 HLNB0015 HLNB0016 HLNB0017 Description Lagos Sport boat Hull: Lagos Sport Cover with hardware: Lagos Sport Rudder assembly: Lagos Sport Replacement motor: Lagos Sport Receiver/ESC board: Lagos Sport Battery holder: Lagos Sport Drive shaft: Lagos Sport Propeller: Lagos Sport Cover seal: Lagos Sport Replacement servo: Lagos Sport 700mAh 7.4V 2S Li-Ion replacement battery: Lagos Sport Transmitter: Lagos Sport Front bumper protector: Lagos Sport 2-Cell/2S 7.4V Li-Ion, 650mAh 110-240V AC Charger 1100mAh 7.4V 2S Li-Ion upgrade battery: Lagos Sport Decal set: Lagos Sport www.modelengines.com.au 7
Atomic Flash Instructions 8 Notes
Exclusively Available at HobbyTown USA 90 Day Limited Warranty General Disclaimer: This item is to be free of manufacture defects at time of purchase. This warranty does not cover breakage due to abuse, improper break-in, improper setup, or improper operation. We at Helion have made every effort in component design, material selection and assembly to make our products as durable as possible. Helion products are covered under warranty only against manufacturer s defect in materials, workmanship or assembly when it is new (before being used). If you believe a defect in materials, workmanship or assembly was not apparent when the product was new and only became evident after the product was used, then please contact your local HobbyTown USA to apply for warranty service. You must provide your original sales receipt verifying the proof-of purchase and date thereof. Provided warranty conditions have been met, the components that are found to be defective, incorrectly made, or incorrectly assembled within the warranty coverage time period may be repaired or replaced under the sole discretion of HobbyTown USA. In the event that your product needs a repair or a replacement part that is not covered by this warranty, your local HobbyTown USA dealer can assist you with obtaining the genuine replacement parts and/or accessories to service your Helion product. If you purchased your Helion product from a HobbyTown USA internet site not affiliated with a local store, please consult that site for its service policies. 000046-001 (REV B) www.modelengines.com.au 9