RAILWAY LEVEL CROSSING CHECKLIST Road Safety Review of Railway Crossings

Similar documents
CHECKLIST 6: EXISTING ROADS: ROAD SAFETY AUDIT

CHECKLIST 5: ROADWORK TRAFFIC SCHEME AUDIT

CHECKLIST 4: PRE-OPENING STAGE AUDIT

CHECKLIST 2: PRELIMINARY DESIGN STAGE AUDIT

11 CHECKLISTS Master Checklists All Stages CHECKLIST 1 FEASIBILITY STAGE AUDIT

CHECKLIST 3: DETAILED DESIGN STAGE AUDIT

Traffic Control Inspection Checklist Segment:

Introduction Methodology Study area and data collection Results and recommendation Conclusion References

IMPLEMENTATION. PEDESTRIAN USERS (Continued /) A: Class 2 Pedestrian / Cycle Ways. Pedestrian and Cycle Ways:

Table of Contents. Introduction. Prompt List Arterials and Streets. Prompt List Interchange. Prompt List Intersections. Prompt List Limited Access

INDEX. Geometric Design Guide for Canadian Roads INDEX

ROAD SAFETY AUDIT REPORT STAGE 3 DETAILED DESIGN STAGE ROAD SAFETY AUDIT ROAD NETWORK FOR THE PROPOSED FIRST ESTATE SUBDIVISION

Appendix Work Zone Traffic Control

CHAPTER 1 STANDARD PRACTICES

Alberta Infrastructure HIGHWAY GEOMETRIC DESIGN GUIDE AUGUST 1999

2017 Temporary traffic control guidelines for pedestrians. v.2

ROAD SAFETY AROUND SCHOOLS Audit Checklists. Prepared for the Road Safety Council s

2004 Traffic and Safety Notes. Cross Reference between the Old Note Number and the New Note Number

Vermont Permit Test Flash Cards

Supplementary Appendix to ARTC Track & Civil Code of Practice. Establishing Minimum Protective Measures at Level Crossings ETF-16-01

The Ins and Outs of Roundabouts

IMPLEMENTATION. PEDESTRIAN USERS (Continued /) Building Frontages: A: Stair Applications. Geometry (Accessed from the Sidewalk) Refer to A:

CONSTRUCTION SPECIFICATION

Intersection Safety 6/7/2015 INTERSECTIONS. Five basic elements should be considered in intersection design. Intersection Safety (continued)

SECTION 12 ROAD MARKINGS AND DELINEATION

Road Safety Facilities Implemented in Japan

Considerations in the Review and Approval of a Driveway in Your Jurisdiction

11.2 Detailed Checklists CHECKLIST 1: FEASIBILITY STAGE AUDIT. 1.1 General topics Scope of project; function; traffic mix

MUTCD Part 6D: Pedestrian and Worker Safety

(This page left intentionally blank)

Engineering Countermeasures for Transportation Safety. Adam Larsen Safety Engineer Federal Highway Administration

MUTCD Part 6: Temporary Traffic Control

Traffic Signs and Markings. Instructor: Dr. Yahya Sarraj Associate Prof. Of Transportation

Guide to Road Design Part 3: Geometric Design Session I 18 October 2016

SECTION 12 ROAD MARKINGS AND DELINEATION

Designing and Benchmarking Mine Roads for Safe and Efficient Haulage. Roger Thompson Alex Visser

Review of Guidelines for Cycleway Safety Fencing

CHAPTER 6H. TYPICAL APPLICATIONS

ADA on Construction. Guidance for Section C Plan Preparers

Policy Statement. Objective. Context. References and Supporting Documentation

Accommodating Pedestrians in the Work Zone

2009 Manual on Uniform Traffic Control Devices

City of Vallejo Traffic Calming Toolbox

CHAPTER 3A. GENERAL PAGE CHAPTER 3B. PAVEMENT AND CURB MARKINGS PAGE

City of Albert Lea Policy and Procedure Manual 4.10 ALBERT LEA CROSSWALK POLICY

Design Overview. Section 4 Standard Plans for Design. Pedestrian Access Routes. Pedestrian Access Routes. Overview. Cross Slope

157 Chapter 6: Bicycles

Unit Six: Driving Faster with More Risk URBAN, SUBURBAN, AND RURAL DRIVING

TRAFFIC LINE MANUAL. June 2011 TRAFFIC-ROADWAY SECTION

TRAFFIC CONTROL DEVICES FOR LOW VOLUME ROADS

(HIGHWAY GEOMETRIC DESIGN -1)

Geometric designs for Safe Highways. Dr. Manoj M. Asst. Professor Department of Civil Engineering IIT Delhi

SECTION 5 DELINEATION AND HAZARD MARKERS

Alternative Traffic Calming Methods

18.1 Introduction Maintaining pedestrian-related Problems arising in the long term. infrastructure

Road Markings. Lecture Notes in Transportation Systems Engineering. Prof. Tom V. Mathew. 1 Overview 1. 2 Classification 2

Appendix C. TRAFFIC CALMING PROGRAM TOOLBOX

Road Safety Audit training course. Motorways - safety issues of the motorway design

Cycle Track Design Best Practices Cycle Track Sections

Chapter 8 (2009) - Summary of key changes

Signs. signs, signals and road markings. in this chapter

ROUNDABOUTS/TRAFFIC CIRCLES

TRAFFIC LINE MANUAL Edition Revision 1 June 2012 TRAFFIC-ROADWAY SECTION

Road Markings. Lecture Notes in Transportation Systems Engineering. Prof. Tom V. Mathew

PART 5. TRAFFIC CONTROL DEVICES FOR LOW-VOLUME ROADS TABLE OF CONTENTS

Copenhagen Cycling Map. Red Lines Cycling facilities

PEDESTRIAN ACCOMMODATIONS DPS 201 AT ROUNDABOUTS

Guidelines for flush medians RTS 4

Operations and Maintenance of Pedestrian Facilities Chapter 4. Operations and Maintenance of Pedestrian Facilities

Designing with the Railroad

Figure 1: Graphical definitions of superelevation in terms for a two lane roadway.

COMPLETE STREETS DURING CONSTRUCTION

American Railway Engineering and Maintenance of Way Association Letter Ballot. Draft

BICYCLE RULES OF THE ROAD

CIRCULAR NO. O-13. Recommended Practices for Manual Protection of Highway/Railway Grade Crossings

Chapter V TRAFFIC CONTROLS. Tewodros N.

Developed by: The American Traffic Safety Services Association (ATSSA) 15 Riverside Parkway, Suite 100 Fredericksburg, VA

CHAPTER 6H. TYPICAL APPLICATIONS

Chapter 5: Crossing the Street

SECTION TRAFFIC REGULATIONS

What Engineering Can Do for You! Low Cost Countermeasures for Transportation Safety

Designing for Pedestrian Safety. Alabama Department of Transportation Pre-Construction Conference May 2016

700 Multi-Modal Considerations

Attachment No. 4 Approved by National Committee Council

October 2004 REVISIONS (2) SUPERELEVATION DEVELOPMENT 11.3(2)

Toward Zero Deaths Maintaining a Safer Roadway Workshop

Parental Responsibilities

DEFINITIONS Activity Area - Advance Warning Area Advance Warning Sign Spacing Advisory Speed Approach Sight Distance Attended Work Space

Footpath design. A guide to creating footpaths that are safe, comfortable, and easy to use

PLACEMENT OF SIGNS RECOMMENDED PRACTICES SUB-SECTION

Traffic Control Devices

INTER- AND INTRA-CONNECTIVITY INTERPRETIVE GUIDELINES

Section 9A.07 Meaning of Standard, Guidance, Option, and Support

INTERSECTIONS AT GRADE INTERSECTIONS

3-13 UFC - GENERAL PROVISIONS AND GEOMETRIC DESIGN FOR ROADS, STREETS, WALKS, AND OPEN

Land Transport Rule: Traffic Control Devices 2004

Section 3A.04 Colors. Section 3B.10 Approach Markings for Obstructions

DRAFT OPERATIONAL RESPONSIBILITY FOR PUBLIC ROADS IN WESTERN AUSTRALIA DRAFT VERSION 2

We will also cover topics including sharing the road with: Emergency vehicles; Pedestrians; and Animals.

PROCEDURE FOR ACCOMMODATING PEDESTRIANS IN WORK ZONES FOR CONSTRUCTION AND MAINTENANCE

Transcription:

RAILWAY LEVEL CROSSING CHECKLIST Road Safety Review of Railway Crossings Location: Crossing No. Date of On-Site Inspection: (Day) / / (Night) / / Weather: CHECKLIST 5. - GENERAL TOPICS Level of control Is the level of control (eg Give Way Signs, Stop Signs, Flashing Lights, Boom Barriers) in accordance with guidelines? Sight distances Variations in Train Activity Are required sight distances likely to be restricted by future vegetation growth? Is it possible for sight distances to be obstructed by temporary events such as parked wagons and vehicles, stockpiles, etc? Has the railway operator been contacted to check for any changes or seasonal variation in train activity? Is the railway still in use? Railway Operations 5 Emergency Access 6 Temporary Works Has the railway operator/s been contacted to determine whether any special operational conditions apply to the train (e.g. sound horn, display headlights, reduce speed, flag person control, etc.)? Is there adequate provision for emergency vehicle access to the crossing? Are all locations free of construction or maintenance equipment, and any signing or temporary traffic control devices that are no longer required? MAIN ROADS Western Australia Page of 8

CHECKLIST 5. - ALIGNMENT AND CROSS SECTION Visibility, Sight Distances Is sight distance to other vehicles adequate for the speed of traffic approaching the crossing? Is adequate sight distance provided for intersections, driveways, pedestrian crossings etc? Design Speed Is the horizontal and vertical geometry (including the longitudinal profile of the road over the rails) suitable for the (85th %ile) traffic speed? Does the road superelevation conflict with the rail profile, or vice versa? Readability by Drivers Are there any sections of roadway or railway which may cause confusion, eg: (a) Have disused pavement or rail tracks been removed? (b) (c) (d) Have disused signs, pavement markings or signalling equipment been removed properly? Do streetlight and tree lines conform with the road and/or rail alignment? Are all railway tracks in use clearly obvious? Widths Are all traffic lane and carriageway widths, adequate? Are shoulder or verge widths appropriate (eg for broken down or emergency vehicles)? 5 Drainage Structures Are drainage structures in the vicinity of the crossing safe for run off vehicles to traverse? MAIN ROADS Western Australia Page of 8

CHECKLIST 5. - LAYOUT AND CONTROLS Location Is the crossing located safely with respect to horizontal and vertical alignment? Warning Where the crossing is located near the end of high-speed road sections (eg on the terminating approach to a T- junction), are there traffic control devices to alert drivers? Controls Do signs and/or pavement markings conform with actual vehicle movements at the crossing satisfactorily? Layout Is the alignment of kerbs, traffic islands and medians satisfactory? 5 Access Tracks Is the crossing layout obvious to all users? Are turning radii and tapers at nearby intersections and driveways appropriate? Are adequate approach and departure stacking distances available for long vehicles? Can queuing over the rails suddenly occur due to unexpected downstream events (eg right turn vehicle giving way to opposing traffic, pedestrian crosswalk, guard crossing, etc)? Do pedestrian mazes, fences or other structures restrict visibility from side roads or driveways? If provided, can vehicles safely enter and leave nearby railway maintenance track/s? MAIN ROADS Western Australia Page of 8

CHECKLIST 5. NON-MOTORISED TRAFFIC Paths Are there appropriate travel paths and crossing points for pedestrians, cyclists and the disabled (wheel chairs/ gophers )? Barriers and Fencing Where necessary, are pedestrian maze treatments and/or gates installed for pedestrians and cyclists? Is the pedestrian maze in accordance with AS77-7, 99? are associated signing and/or warning lights and audible warning devices installed? Is fencing installed to guide pedestrian movements and is fencing of appropriate design (eg avoids solid horizontal rails)? Where necessary, is crash barrier installed to controll pedestrian and cyclist flows? Surface Are rail tracks flush with the road and/or path surface to avoid tripping by pedestrians and dislodgement of cyclists? Elderly and Disabled Are there adequate provisions for the elderly, the disabled, children, wheelchairs and baby carriages (eg holding rails, kerb and median crossings, ramps)? Where necessary, are handrails provided and are they adequate? 5 Cyclists Is the pavement width adequate for the number of cyclists using the crossing? Where designated dual-use-paths adjoin pedestrian mazes, are END DUP signs installed? Are bicycle safe grates provided at drainage pits where necessary? MAIN ROADS Western Australia Page of 8

CHECKLIST 5.5 SIGNS AND LIGHTING Street Lighting Is appropriate lighting installed? Is all lighting operating satisfactorily? Are the appropriate types of poles used for all locations and correctly installed (eg slip-base at correct height, rigid poles controlled if within clear zone)? Conflicting Signals Are all locations free of any lighting or other signalling which may conflict visually with railway crossing signals or railway train signals? Signs Are all necessary signs in place? Are they conspicuous and in accordance with AS7-7, 99? Are there any redundant signs? Are traffic signs in their correct locations, and properly positioned with respect to lateral clearance and height? Are signs placed so as not to restrict sight distance, particularly for turning vehicles? Are all signs effective for all likely conditions (eg day, night, rain, fog, rising or setting sun, oncoming headlights, poor lighting)? Do sign supports conform to guidelines? Where applicable, are overhead electric warning signs installed? Where appropriate, are the numbers of tracks signed? MAIN ROADS Western Australia Page 5 of 8

CHECKLIST 5.6 PAVEMENT MARKING AND DELINEATION Pavement Marking Is all necessary pavement marking installed? Are pavement markings (centre lines, edge lines, transverse lines, cross hatching) clearly visible and effective for all likely conditions (eg day, night, rain, fog, rising or setting sun, oncoming headlights, light coloured pavement surface, poor lighting)? Particularly at skewed crossings, does longitudinal pavement marking provide adequate guidance through the crossing? Are stop or holding lines positioned correctly? Delineation Have delineation devices (eg width markers, RAILWAY CROSSING boards, guide posts, chevron alignment markers, etc) been installed where required? Are they correctly placed? Is delineation effective for all likely conditions (eg day, night, rain, fog, rising or setting sun, oncoming headlights)? Can dust from unsealed surfaces adversely effect delineation? On truck routes, are reflective devices appropriate to driver's eye height? Raised Pavement Markers Where coloured raised pavement markers are used, have they been installed correctly? On light coloured pavement surfaces (eg concrete) are RPMs used to simulate traffic lanes? Are RPMs in good order? MAIN ROADS Western Australia Page 6 of 8

CHECKLIST 5.7 - SIGNALS AND BOOM BARRIERS Operation Are signals, boom barriers and bells operating correctly? Are pre-warning times and sequences prior to the arrival of the train in accordance with appropriate codes of practice? Is the number and location of signal displays appropriate? Where appropriate, are the railway crossing signals co-ordinated with nearby traffic control signals? Are the delays to vehicles due to train activity excessive, (ie > 50% of cycle time)? Where appropriate, are the railway crossing signals co-ordinated with the train signalling system? Visibility Are signals clearly visible to approaching motorists, (as per guidelines)? Have correct focal alignments (for both cars and trucks) been used? Can visibility to signals be obscured by temporary events such as high vehicles stopped in side roads? Is the end of likely vehicle queues visible to motorists so that they may stop safely? Have any visibility problems caused by the rising or setting sun been addressed (eg target boards)? Are signal displays focused and aligned so that they can be seen only by the motorists for whom they are intended? Where signal displays are not visible from an adequate distance, are supplementary signals or advance flashing warning signs installed? Is appropriate warning provided to vehicles entering from side roads and driveways? Is there possible driver distraction from roadside advertising signs and hoardings? MAIN ROADS Western Australia Page 7 of 8

CHECKLIST 5.8 - PAVEMENT Pavement Defects Is the pavement free of defects (eg excessive roughness or rutting, corrugations, potholes etc), which could result in safety problems (eg loss of steering control)? Skid Resistance Does the pavement appear to have adequate skid resistance? Has skid resistance testing been carried out where necessary? Are the rail tracks located on vehicle turning paths and when wet, pose potential skidding hazards to turning vehicles, particularly motorcycles? Ponding Is the pavement free of areas where ponding or sheet flow of water may occur, with resultant safety problems? Loose Screenings Is the pavement free of loose screenings? MAIN ROADS Western Australia Page 8 of 8