1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING Address/Telephone number Emergency telephone number Use Croda Europe Ltd, Cowick Hall, Snaith, Goole, East Yorkshire, DN14 9AA, ENGLAND Tel +44 (0) 1405 860551 sdscompiler@croda.com 0032 3575 5555 Lubricant base fluid 2. HAZARDS IDENTIFICATION Eye contact Skin contact Inhalation Ingestion May cause eye irritation in man. Unlikely to cause skin irritation in man. This material may cause irritation following inhalation. Low oral toxicity, but ingestion may cause irritation of the gastrointestinal tract. 3. COMPOSITION/INFORMATION ON INGREDIENTS Product description. Lubricant base fluid Hazardous Ingredients Chemical name EINECS Number % Symbol R-Phrases Page 1 of 6
Contains no Hazardous Ingredients (2001/58/EC) 4 FIRST AID MEASURES Eye contact Skin contact Inhalation Ingestion Further Medical Treatment Irrigate with eyewash solution or clean water, holding the eyelids apart, for at least 10 minutes. Obtain medical attention. Remove contaminated clothing. Wash skin with soap and water. If symptoms develop, obtain medical attention. Remove patient from exposure. Obtain medical attention if ill effects occur. Do not induce vomiting. Wash out mouth with water and give 200-300 ml (half a pint) of water to drink. Obtain medical attention if ill effects occur. Symptomatic treatment and supportive therapy as indicated. 5 FIRE-FIGHTING MEASURES Extinguishing Media Water fog, alcohol foam, carbon dioxide, dry chemical. Unsuitable Extinguishing Media None known Special fire-fighting protective equipment A self contained breathing apparatus and suitable protective clothing must be worn in fire conditions. Fire and explosion hazards Combustible but not readily ignited. Explosion data Sensitivity to mechanical impact: Sensitivity to static discharge: 6. ACCIDENTAL RELEASE MEASURES Personal precautions Environmental precautions Methods for cleaning up Other information Refer to section 8 for proper personal protective equipment Do not allow to enter drains, sewers or watercourses. Contain spillages with sand, earth or any suitable adsorbent material. Transfer to a container for disposal. Wash the spillage area clean with water and detergent. Spillages or uncontrolled discharges into watercourses must be alerted to the appropriate regulatory body. Page 2 of 6
7. HANDLING AND STORAGE Handling Storage Prevent eye contact. Avoid breathing this material. Provide adequate ventilation. Do not swallow. Store in original containers. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Exposure limit values Chemical name Exposure limit values Notes No Workplace Exposure Limit Assigned. Engineering measures Eye protection Skin protection Respiratory protection Other Provide adequate ventilation. Good working practice suggests goggles should be worn. Good working practice suggests gloves should be worn. Respiratory protection is not required if good ventilation is maintained Eyewash and safety shower easily accessible to the work area. 9. PHYSICAL AND CHEMICAL PROPERTIES Values are not product specifications. Colour yellow Form liquid Odour faint ph Not applicable. Boiling point/boiling range ( C) > 200 Flash Point (ºC) > 265(open cup) Autoignition Temperature (ºC) 405 Flammable Limits Explosive Properties Oxidising Properties Not to be expected Vapour Pressure (hpa) < 1@ 20 C Page 3 of 6
Solubility in water Insoluble Solubility in other ingredients Partition Coefficient > 3Estimated Kinematic viscosity (mm²/s) 13 mm2/s (100 C) Density (g/ml) 0.9@ 25 C Melting point/melting range ( C) < -39 Freezing point ( C) < -39 Pour Point (ºC) < -39 10. STABILITY AND REACTIVITY Stability Materials to avoid Conditions to avoid Hazardous decomposition products Hazardous polymerisation Stable under normal conditions. Strong oxidising agents. None known None known Will not occur 11. TOXICOLOGICAL INFORMATION Eye contact Skin contact Ingestion Non-irritant to rabbit eyes. Non-irritant to rabbit skin. Low acute toxicity. LD50 rat > 2000mg/kg 12. ECOLOGICAL INFORMATION Persistence and degradability (CEC-L-33-A-93) (21 days) approx 40% Ecotoxicity Expected to be low Page 4 of 6
13. DISPOSAL CONSIDERATIONS Methods of Disposal Contaminated packaging Disposal should be in accordance with local, state or national legislation. Empty container retains product residue. Observe all hazard precautions. Do not distribute, make available, furnish or reuse empty container except for storage and shipment of original product. Remove all product residue from container before disposal. 14. TRANSPORT INFORMATION Not classified in RID/ADR - ADNR - IMDG - ICAO/IATA-DGR. 15. REGULATORY INFORMATION Not Classified as Dangerous for Supply/Use. WGK 1 Inventory Status EU (EINECS/ELINCS/NLP) USA (TSCA) Canada (DSL) Australia (AICS) China (IECSC) Korea (ECL) Philippines (PICCS) 16. OTHER INFORMATION Dimer acids and their esters: Safety evaluation. Uniqema, D96/015 (1996). This data sheet was prepared in accordance with Directive (EC) 1907/2006 Page 5 of 6
The following sections contain revisions or new statements: 1,2,3,4,5,6,7,8,9,10,13,15 The information in this publication is believed to be accurate and is given in good faith but no representation or warranty as to its completeness or accuracy is made. Suggestions for uses or applications are only opinions. Users are responsible for determining the suitability of these products for their own particular purpose. No representation or warranty, express or implied, is made with respect to information or products including without limitation warranties of merchantability or fitness for a particular purpose or non-infringement of any third party patent or other intellectual property rights including without limit copyright, trademark and designs. Any trademarks identified herein are trademarks of the Croda group of companies. See also www.croda.com Page 6 of 6