SECTION 1: Identification of the substance/mixture and of the company/undertaking 1.1. Product identifier Name of product 1.2. Relevant identified uses of the substance or mixture and uses advised against Recommended intended purpose(s) Lubricating grease 1.3. Details of the supplier of the safety data sheet Manufacturer/distributor Advice 1.4. Emergency telephone number FUCHS LUBRITECH GMBH Werner-Heisenberg-Straße 1, D-67661 Kaiserslautern/Germany Phone +49 (0) 6301 3206-0, Fax +49 (0) 6301 3206-940 E-Mail reach@fuchs-lubritech.de Internet www.fuchs-lubritech.com Product Safety Management Phone +49 (0) 6301 3206-0 Fax +49 (0) 6301 3206-940 E-mail (competent person): reach@fuchs-lubritech.de Emergency advice +49 (0)171 / 4632154 Phone 06301/3206-808 This number is only available at office times. US Distributor Fuchs Lubricants Co. 17050 Lathrop Avenue Harvey, IL 60426 (708) 333-8900 (800) 225-3924 (24 hrs Emergency SECTION 2: Hazards identification 2.1. Classification of the substance or mixture Classification according to 67/548/EEC or 1999/45/EC Additional hints The product does not require a hazard warning label in accordance with EC directives/german regulations on dangerous substances. 2.2. Label elements Labelling according to Regulation (EC) No 1272/2008 [CLP/GHS] Additional information Remark This mixture is not classified as hazardous according to Regulation (EC) 1272/2008 2.3. Other hazards Information pertaining to special dangers for human and environment none at appropriate handling and storage SECTION 3: Composition/ information on ingredients 3.1. Substances not applicable 3.2. Mixtures Description Thickening system and additives in synthetic oil Hazardous ingredients CAS No EC No Name [% weight] Classification according to 67/548/EEC 203-749-3 Ölsäure-Derivat <= 0,1 Xn;R20-38-41, N;R50/53 80939-62-4 Aminphosphat-Gemisch 0,1 < 1 Xi, N,R36/38-51/53 CAS No EC No Name [% weight] Classification according to Regulation (EC) No 1272/2008 [CLP/GHS] 203-749-3 Ölsäure-Derivat <= 0,1 Eye Dam. 1, H318 / Aquatic Acute 1, H400 / Aquatic Chronic 1, H410 / Acute Tox.4, H332 / Skin Irrit.2, H315 80939-62-4 Aminphosphat-Gemisch 0,1 < 1 Aquatic Chronic 2, H411 / Skin Irrit. 2, H315 / Eye Irrit. 2, H319 Page 1/7
Additional advice none at appropriate handling and storage SECTION 4: First aid measures 4.1. Description of first aid measures General information Remove contaminated soaked clothing immediately, don`t leave to dry. In case of inhalation Ensure of fresh air. In the event of symptoms refer for medical treatment. (may be relevant for vapours of superheated product) In case of skin contact In case of contact with skin wash off with soap and water. Don't use organic solvents Consult a doctor if skin irritation persists. In case of eye contact In case of contact with eyes rinse with plenty of water carefully. In the event of persistent symptoms seek medical treatment. In case of ingestion Do not induce vomiting. Refer to medical treatment. 4.2. Most important symptoms and effects, both acute and delayed Physician's information / possible symptoms No symptoms known so far. 4.3. Indication of any immediate medical attention and special treatment needed Treatment (Advice to doctor) Treat symptoms. SECTION 5: Firefighting measures 5.1. Extinguishing media Suitable extinguishing media Foam Dry fire-extinguishing substance Carbon dioxide water mist Unsuitable extinguishing media Strong water jet 5.2. Special hazards arising from the substance or mixture Fire gas of organic material has to be classed invariably as respiratory poison. 5.3. Advice for firefighters Special protective equipment for fire-fighters Use breathing apparatus with independent air supply. Wear suitable personal protective equipment for fire extinguishing measures. Additional information Apply foam in large quantities because some of it is destroyed by the product. Fire residues and contaminated firefighting water must be disposed of in accordance with the local regulations. SECTION 6: Accidental release measures 6.1. Personal precautions, protective equipment and emergency procedures For non-emergency personnel Ensure adequate ventilation. Avoid contact with skin and eyes High risk of slipping due to leakage/spillage of product. For emergency responders no special dangers known Page 2/7
6.2. Environmental precautions Collect contaminated water / firefighting water separately. Do not discharge into the drains/surface waters/groundwater. 6.3. Methods and material for containment and cleaning up Send in suitable containers for recovery or disposal. Take up residues with absorbent material (e.g. sand, sawdust, general-purpose binder). Take up mechanically. Additional Information no special dangers known 6.4. Reference to other sections Safe handling: see section 7 Disposal: see section 13 Personal protection equipment: see section 8 Emergency telephone number: see section 1! SECTION 7: Handling and storage 7.1. Precautions for safe handling Advice on safe handling Avoid formation of oil dust. Care for thoroughly room ventilation, if necessary use in well ventilated area with local exhaust ventilation at workplace. General protective measures Avoid contact with eyes and skin Do not inhale gases/vapours/aerosols. Hygiene measures Cloths contaminated with product should not be kept in trouser pockets. Follow general rules of industrial hygiene for safe handling of chemical products Remove soaked clothing immediately. Wash skin thoroughly and immediately after handling the product. Use barrier skin cream. Advice on protection against fire and explosion The product is combustible. Pay attention to general rules of internal fire prevention. 7.2. Conditions for safe storage, including any incompatibilities Requirements for storage rooms and vessels Prevent penetration into the ground. Advice on storage compatibility Do not store together with oxidising and self-inflammable materials. Further information on storage conditions Keep container tightly closed, store at cool and aired place, open and handle carefully. Protect from heat and direct solar radiation. Storage temperature may not exceed 40 C (=104 F). Store in a dry place. Do not keep at temperatures below 0 C. Recommended storage temperature: room temperature. Information on storage stability See technical information about storage of lubricants Storage group 11 Fire class B 7.3. Specific end use(s) Page 3/7
SECTION 8: Exposure controls/personal protection 8.1. Control parameters Additional advice As basis for this information served the valid references. 8.2. Exposure controls Respiratory protection Not required at determined application Hand protection As the product is a preparation of several substances, the actual resistance of the materials used for gloves cannot be scientifically calculated; it is therefore mandatory to check this before using the product. The break through time depends on the mechanical stress imposed and must therefore be checked individually. PVC gloves nitrile gloves Neoprene gloves Eye protection tightly fitting goggles, in case of splashing Other protection measures Usual working clothes for chemical industries Appropriate engineering controls Care for good room ventilation, exhaust system at workshop place if necessary SECTION 9: Physical and chemical properties 9.1. Information on basic physical and chemical properties Appearance Colour pasty white Odour threshold Important health, safety and environmental information ph value boiling range > 280 C drop point > 240 C Flash point > 200 C Odour odourless Value Temperature at Method Remark not applicable Vapourisation rate Flammable (solid) Flammability (gas) Ignition temperature > 320 C Self ignition temperature Lower explosion limit 1 Vol-% information refer to base oil Upper explosion limit 10 Vol-% information refer to base oil Vapour pressure < 0,5 Pa 20 C Relative density ca. 0,87-0,88 g/cm3 25 C Vapour density Solubility in water more or less insoluble Solubility/other Page 4/7
Partition coefficient n- octanol/water (log P O/W) Decomposition temperature Value Temperature at Method Remark > 6 Viscosity consistency NLGI 1 Viscosity kinematic 135-165 mm2/s 40 C refers to base oil Oxidising properties no Explosive properties 9.2. Other information SECTION 10: Stability and reactivity 10.1. Reactivity 10.2. Chemical stability 10.3. Possibility of hazardous reactions 10.4. Conditions to avoid Heating, unshielded flame, ignition source, electrostatic charge 10.5. Incompatible materials Materials to avoid Reactions with oxidising agents. 10.6. Hazardous decomposition products none at appropriate handling and storage Thermal decomposition Remark No decomposition if used as directed. SECTION 11: Toxicological information 11.1. Information on toxicological effects Acute toxicity/irritability/sensitization LD50 acute oral Irritability skin Value/Validation Species Method Remark frequent and/or persistent contact may cause skin irritation Irritability eye may have irritating effect if splash reaches eye Skin sensitization No sensitizing effect known Experiences made from practice Has a degreasing effect on the skin. no harmful effects at appropriate handling and determined usage Additional information No toxical dates available. The product was classified on the basis of the calculation procedure of the directive 67/548/EEC (conventional method). Page 5/7
SECTION 12: Ecological information 12.1. Toxicity Ecotoxicological effects Value Species Method Validation Fish 12.2. Persistence and degradability Biological degradability 12.3. Bioaccumulative potential Because of its consistency the product cannot be dispersed in the environment. Adverse ecological effects are therefore unlikely on the basis of current knowledge. preparation is water insoluble and does not formate emulsion 12.4. Mobility in soil 12.5. Results of PBT and vpvb assessment 12.6. Other adverse effects Behaviour in sewage plant The viscous consistency of the product can cause trouble in transport lines and purification plants. General regulation Ecological dates are not available. Do not allow uncontrolled leakage of product into the environment. SECTION 13: Disposal considerations 13.1. Waste treatment methods Recommendations for the product Waste disposal in accordance with the relevant regulations. Recommendations for packaging Totally emptied packaging may be taken for recycling. Dispose one-trip container according to local authority prescriptions EAK 15 01 10: packing material with harmful contamination General information Ultimately responsible for correct classification is the waste producer, as the EWC names different codes for different origins of same waste SECTION 14: Transport information ADR/RID IMDG IATA-DGR 14.1. UN number - - - 14.2. UN proper shipping name - - - 14.3. Transport hazard class(es) - - - 14.4. Packing group - - - 14.5. Environmental hazards - - - 14.6. Special precautions for user unknown 14.7. Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code not applicable Land and inland navigation transport ADR/RID No dangerous goods as defined by these transport regulations. Marine transport IMDG No dangerous goods as defined by these transport regulations. Page 6/7
Air transport ICAO/IATA-DGR No dangerous goods as defined by these transport regulations. Transport/further information No hazardous goods as defined by prescriptions SECTION 15: Regulatory information 15.1. Safety, health and environmental regulations/legislation specific for the substance or mixture VOC standard VOC content 0 % National regulations Water hazard class 1 Mixture-WGK according to VwVwS (GER) 15.2. Chemical Safety Assessment SECTION 16: Other information Training advice Use information in this MSDS Recommended uses and restrictions usage only according to instructions for use and observance of warning notes National and local regulations concerning chemicals shall be observed. Further information The information given in this MSDS is based on the present state of knowledge and is intended to describe our products from the point of view of safety requirements only. Substantial changes to the former version are marked by "!" on the left margin of the paper. All the raw materials in this product are listed in TSCA. All the raw materials in this product are listed in DSL. Refer to product information paper. Indication of changes: "!" = Data changed compared with the previous version. Previous version: 2.1 Sources of key data used Material Safety Data Sheets of raw materials Wording of the R/H-phrases specified in chapter 3 (not the classification of the mixture!) R 20 Harmful by inhalation. R 36/38 Irritating to eyes and skin. R 38 Irritating to skin. R 41 Risk of serious damage to eyes. R 50/53 Very toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. R 51/53 Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. H315 H318 H319 H332 H400 H410 H411 Causes skin irritation. Causes serious eye damage. Causes serious eye irritation. Harmful if inhaled. Very toxic to aquatic life. Very toxic to aquatic life with long lasting effects. Toxic to aquatic life with long lasting effects. Page 7/7