Material Safety Data Sheet Revision Date: 10/24/2006 Issue date: 10/25/2006 1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION Product name: LOCTITE GASKET MAKER HIGH Item No. : 30558 / IDH No. 226654 TEMPERATURE Product type: Sealant Region: United States Company address: Henkel Corporation 1001 Trout Brook Crossing Rocky Hill, Connecticut 06067 Contact Information: Telephone: 860.571.5100 Emergency telephone: 860.571.5100 Internet: www.loctite.com 2. COMPOSITION/INFORMATION ON INGREDIENTS Hazardous components % ACGIH TLV OSHA PEL OTHER 30-60 200 ppm TWA 200 ppm TWA 250 ppm STEL 610 mg/m³ TWA 10-30 2 mg/m 3 TWA = 20 mppcf TWA 50 ppm 10-30 10-30 5-10 2 mg/m 3 TWA all forms except graphite fibers 15 mg/m³ (total), 5 mg/m³ (respirable) 0.1-1 200 ppm TWA 250 ppm STEL (skin) 0.1-1 0.025 mg/m³ TWA respirable fraction 200 ppm TWA 260 mg/m³ TWA 0.1mg/m³ TWA (respirable) 3. HAZARDS IDENTIFICATION EMERGENCY OVERVIEW HMIS: Physical state: Liquid HEALTH: 2* Color: Grey FLAMMABILITY: 3 Odor: Ester-like PHYSICAL HAZARD: 0 Personal Protection: See Section 8 WARNING: FLAMMABLE LIQUID AND VAPOR. CAUSES EYE AND RESPIRATORY TRACT IRRITATION. MAY CAUSE SKIN IRRITATION. Relevant routes of exposure: Eye contact, Inhalation, Ingestion, Skin Potential Health Effects Inhalation: Skin contact: Eye contact: Ingestion: May cause respiratory tract irritation. Exposure to vapors above the established exposure limit results in respiratory irritation which may lead to difficulty in breathing and tightness in the chest. Central nervous system depression, including dizziness, drowsiness, fatigue, nausea, headache, unconsciousness. May cause skin irritation. Redness. Pain and discomfort. Causes eye irritation. May be harmful if swallowed. Existing conditions aggravated by Pre-existing skin, respiratory, central nervous system, liver and kidney conditions may be susceptible. exposure: 1 of 5
See Section 11 for additional toxicological information. 4. FIRST AID MEASURES Inhalation: Skin contact: Eye contact: Ingestion: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention. Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and shoes. If skin irritation persists, call a physician. Wash clothing before reuse. Thoroughly clean shoes before reuse. Immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention. Immediately give large quantities of water to drink. DO NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Obtain medical attention. 5. FIRE-FIGHTING MEASURES Flash point: 30 C (86 F) Pensky Martens closed cup Autoignition temperature: Not available Flammable/Explosive limits-lower %: 2.3 % Flammable/Explosive limits-upper %: 12.7 % Extinguishing media: Special fire fighting procedures: Unusual fire or explosion hazards: Hazardous combustion products: Foam, dry chemical or carbon dioxide. Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear. Butyraldehyde. Butyric acid. Irritating organic vapors. Oxides of carbon. 6. ACCIDENTAL RELEASE MEASURES Environmental precautions: Clean-up methods: Prevent product from entering drains or open waters. Remove all ignition sources. Soak up with inert absorbent. Ventilate area. Scrape up spilled material and place in a closed container for disposal. Contain the spill in a closed container until disposal. 7. HANDLING AND STORAGE Handling: Storage: Incompatible products: Avoid contact with eyes, skin and clothing. Avoid breathing vapor and mist. Wash thoroughly after handling. Keep container closed. Use only with adequate ventilation. Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use. Oxidizing agents. For information on product shelf life contact Henkel Customer Service at (800) 243-4874. 8. EXPOSURE CONTROLS / PERSONAL PROTECTION Engineering controls: Respiratory protection: Skin protection: Local exhaust ventilation is recommended when general ventilation is not sufficient to control airborne contamination. Use NIOSH approved respirator if there is potential to exceed exposure limit(s). Use impermeable gloves and protective clothing as necessary to prevent skin contact. Neoprene gloves. Nitrile gloves. 2 of 5
Eye/face protection: Safety goggles or safety glasses with side shields. Physical state: Liquid Color: Grey Odor: Ester-like Vapor pressure: 33 mmhg @20 C (68 F) ph: Boiling point/range: 82.2 C (180 F) Melting point/range: Specific gravity: 1.17 at 25ºC (77ºF) Vapor density: 2.07 Evaporation rate: 7.7 (Ether = 1) Solubility in water: Partial Partition coefficient (n-octanol/water): Not available VOC content: 0.00%; 0.00 grams/liter See Section 2 for exposure limits. 9. PHYSICAL AND CHEMICAL PROPERTIES 10. STABILITY AND REACTIVITY Stability: Hazardous polymerization: Hazardous decomposition products: Incompatability: Conditions to avoid: Stable. Will not occur. Oxides of carbon. Acrolein. Acrid smoke and fumes. Strong oxidizing agents. Heat, flames and sparks. 11. TOXICOLOGICAL INFORMATION Carcinogen Status Hazardous components NTP Carcinogen IARC Carcinogen OSHA Carcinogen Known Carcinogen Group 1 Yes Literature Referenced Target Organ & Other Health Effects 3 of 5
Hazardous components Health Effects/Target Organs Irritant, Central nervous system, Eyes, Blood Some evidence of carcinogenicity, Lung, Irritant Irritant No data Lung Eyes, Heart, Irritant, Kidney, Liver, Metabolic, Nervous System, Reproductive Some evidence of carcinogenicity, Lung, Immune system 12. ECOLOGICAL INFORMATION Ecological information: Not available 13. DISPOSAL CONSIDERATIONS Information provided is for unused product only. Recommended method of disposal: EPA hazardous waste number: Dispose of in accordance with Federal, State and local regulations. D001: Ignitable. 14. TRANSPORT INFORMATION The shipping classifications in this section are for non-bulk packaging only (unless otherwise specified). Shipping classification may be different for bulk packaging. U.S. Department of Transportation Ground (49 CFR): Hazard class or division: 3 (Not more than 1 Liter) Consumer Commodity ORM-D International Air Transportation (ICAO/IATA): Hazard class or division: 3 (Not more than 500 ml) Consumer Commodity ORM-D, ID8000 WaterTransportation (IMO/IMDG): Hazard class or division: 3.2 Limited quantity (Not more than 500 ml) Marine pollutant: 4 of 5
15. REGULATORY INFORMATION United States Regulatory Information TSCA 8 (b) Inventory Status: All components are listed or are exempt from listing on the Toxic Substances Control Act Inventory. TSCA 12 (b) Export Notification: (CAS # ). CERCLA/SARA Section 302 EHS: CERCLA/SARA Section 311/312: CERCLA/SARA 313: California Proposition 65:. Immediate Health Hazard, Delayed Health Hazard, Fire. This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Canada Regulatory Information CEPA DSL/NDSL Status: WHMIS hazard class: Contains one or more components listed on the Non-Domestic Substances list. All other components are listed on or are exempt from listing on the Domestic Substances List. B.2, D.2.A, D.2.B 16. OTHER INFORMATION This material safety data sheet contains changes from the previous version in sections: First issue. Prepared by: Kyra Kozak Woods, Product Safety and Regulatory Affairs Specialist DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel Corporation does not assume responsibility for any results obtained by persons over whose methods Henkel Corporation has no control. It is the user's responsibility to determine the suitability of Henkel's products or any production methods mentioned herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and persons against any hazards that may be involved in the handling and use of any of Henkel Corporation's products. In light of the foregoing, Henkel Corporation specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular purpose, arising from sale or use of Henkel Corporation's products. Henkel Corporation further disclaims any liability for consequential or incidental damages of any kind, including lost profits. 5 of 5