SECTION 1: Identification 1.1. Identification Product form Product name Product code : Mixture : Aerospray Nozzle Cleaning Solution Concentrate : SS-029C or SS-029C-EU 1.2. Relevant identified uses of the substance or mixture and uses advised against Use of the substance/mixture 1.3. Details of the supplier of the safety data sheet ELITechGroup Inc. 370 West 1700 South Logan, UT 84321 - USA T +1 (435) 752-6011 - F +1 (435) 752-4127 qara_ebs@elitechgroup.com - www.elitechgroup.com 1.4. Emergency telephone number Emergency number SECTION 2: Hazard(s) identification 2.1. Classification of the substance or mixture GHS-US classification Skin Corr. 1A Eye Irrit. 2A : Laboratory chemical H314 - Causes severe skin burns and eye damage H319 - Causes serious eye irritation Full text of H-phrases: see section 16 2.2. Label elements GHS-US labeling Hazard pictograms (GHS-US) : : Contact your distributor or poison control center in your country. InfoTrac Emergency Response: Calls within the USA, phone: 1-800-535-5053. Calls outside the USA, phone: +1 352-323-3500 (call collect) Customer ID: #90104 (NOTE: this number is required when a customer calls into either phone number above). Signal word (GHS-US) Hazard statements (GHS-US) Precautionary statements (GHS-US) : Danger GHS05 : H314 - Causes severe skin burns and eye damage H319 - Causes serious eye irritation : P280 - Wear protective clothing, eye protection, face protection P303+P361+P353 - If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower P305+P351+P338 - If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing P315 - Get immediate medical advice/attention 2.3. Other hazards 2.4. Unknown acute toxicity (GHS US) Not applicable SECTION 3: Composition/Information on ingredients 3.1. Substance Not applicable SDS-00034C.docx Page 1 of 6 ELITechGroup Inc.
3.2. Mixture Name Product identifier % GHS-US classification oxalic acid, dihydrate (CAS No) 6153-56-6 1-5 Skin Corr. 1A, H314 Full text of H-phrases: see section 16 SECTION 4: First aid measures 4.1. Description of first aid measures First-aid measures general First-aid measures after inhalation First-aid measures after skin contact First-aid measures after eye contact First-aid measures after ingestion : Call a physician immediately. : Remove person to fresh air and keep comfortable for breathing. : Rinse skin with water/shower. Remove/Take off immediately all contaminated clothing. Call a physician immediately. : Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Call a physician immediately. : Rinse mouth. Do not induce vomiting. Call a physician immediately. 4.2. Most important symptoms and effects, both acute and delayed Symptoms/injuries after skin contact Symptoms/injuries after eye contact : Serious damage to eyes. Eye irritation. Symptoms/injuries after ingestion 4.3. Indication of any immediate medical attention and special treatment needed Treat symptomatically. SECTION 5: Firefighting measures 5.1. Extinguishing media Suitable extinguishing media : Water spray. Dry powder. Foam. Carbon dioxide. 5.2. Special hazards arising from the substance or mixture Reactivity : The product is non-reactive under normal conditions of use, storage and transport. 5.3. Advice for firefighters Protection during firefighting : Do not attempt to take action without suitable protective equipment. Self-contained breathing apparatus. Complete protective clothing. SECTION 6: Accidental release measures 6.1. Personal precautions, protective equipment and emergency procedures 6.1.1. For non-emergency personnel Emergency procedures : Ventilate spillage area. Avoid contact with skin and eyes. Do not breathe dust/fume/gas/mist/vapors/spray. 6.1.2. For emergency responders Protective equipment : Do not attempt to take action without suitable protective equipment. For further information refer to section 8: "Exposure controls/personal protection". 6.2. Environmental precautions Avoid release to the environment. 6.3. Methods and material for containment and cleaning up Methods for cleaning up : Take up liquid spill into absorbent material. Other information : Dispose of materials or solid residues at an authorized site. 6.4. Reference to other sections For further information refer to section 13. SECTION 7: Handling and storage 7.1. Precautions for safe handling Precautions for safe handling : Ensure good ventilation of the work station. Avoid contact with skin and eyes. Do not breathe dust/fume/gas/mist/vapors/spray. Wear personal protective equipment. SDS-00034C.docx Page 2 of 6 ELITechGroup Inc.
Hygiene measures : Wash contaminated clothing before reuse. Do not eat, drink or smoke when using this product. Always wash hands after handling the product. 7.2. Conditions for safe storage, including any incompatibilities Storage conditions : Store locked up. Store in a well-ventilated place. Keep cool. SECTION 8: Exposure controls/personal protection 8.1. Control parameters ACGIH ACGIH TWA (mg/m³) 1 mg/m³ ACGIH ACGIH STEL (mg/m³) 2 mg/m³ 8.2. Exposure controls Appropriate engineering controls Hand protection Eye protection Skin and body protection Respiratory protection Environmental exposure controls : Ensure good ventilation of the work station. : Protective gloves. : Safety glasses. : Wear suitable protective clothing. : In case of insufficient ventilation, wear suitable respiratory equipment. : Avoid release to the environment. SECTION 9: Physical and chemical properties 9.1. Information on basic physical and chemical properties Physical state Color Odor Odor threshold : Liquid ph : 1.08 Melting point Freezing point Boiling point Flash point Relative evaporation rate (butyl acetate=1) Flammability (solid, gas) Explosion limits Explosive properties Oxidizing properties Vapor pressure Relative density Relative vapor density at 20 C Solubility Log Pow Auto-ignition temperature Decomposition temperature Viscosity Viscosity, kinematic Viscosity, dynamic : Mixture contains one or more component(s) which have the following colour(s): Colourless or white : There may be no odour warning properties, odour is subjective and inadequate to warn of overexposure. Mixture contains one or more component(s) which have the following odour(s): Odourless : Not applicable : Water SDS-00034C.docx Page 3 of 6 ELITechGroup Inc.
9.2. Other information SECTION 10: Stability and reactivity 10.1. Reactivity The product is non-reactive under normal conditions of use, storage and transport. 10.2. Chemical stability Stable under normal conditions. 10.3. Possibility of hazardous reactions No dangerous reactions known under normal conditions of use. 10.4. Conditions to avoid None under recommended storage and handling conditions (see section 7). 10.5. Incompatible materials 10.6. Hazardous decomposition products Under normal conditions of storage and use, hazardous decomposition products should not be produced. SECTION 11: Toxicological information 11.1. Information on toxicological effects Acute toxicity Skin corrosion/irritation Serious eye damage/irritation Respiratory or skin sensitization Germ cell mutagenicity Carcinogenicity Reproductive toxicity Specific target organ toxicity (single exposure) Specific target organ toxicity (repeated exposure) Aspiration hazard Symptoms/injuries after skin contact Symptoms/injuries after eye contact Symptoms/injuries after ingestion SECTION 12: Ecological information 12.1. Toxicity Ecology - general : Causes severe skin burns and eye damage. ph: 1.08 : Causes serious eye irritation. ph: 1.08 : Serious damage to eyes. Eye irritation. : Before neutralisation, the product may represent a danger to aquatic organisms. LC50 fish 1 LC50 other aquatic organisms 1 EC50 Daphnia 1 LC50 fish 2 TLM fish 1 Threshold limit other aquatic organisms 1 Threshold limit algae 1 Threshold limit algae 2 34.1 mg/l (96 h; Pimephales promelas; Anhydrous form) 100-1000 mg/l (96 h; Anhydrous form) 137 mg/l (48 h; Daphnia magna; Anhydrous form) 160 mg/l (48 h; Leuciscus idus; Anhydrous form) 4000 mg/l (24 h; Lepomis macrochirus; Anhydrous form) 100-1000,96 h; Anhydrous form 790 mg/l (168 h; Scenedesmus quadricauda; Anhydrous form) 80 mg/l (192 h; Microcystis aeruginosa; Anhydrous form) SDS-00034C.docx Page 4 of 6 ELITechGroup Inc.
12.2. Persistence and degradability Persistence and degradability Readily biodegradable in water. Readily biodegradable in water in anaerobic conditions. Photolysis in water. Biodegradable in the soil. Photolysis in the air. 12.3. Bioaccumulative potential Log Pow Bioaccumulative potential -1.74 (Estimated value) Bioaccumulation: not applicable. 12.4. Mobility in soil 12.5. Other adverse effects Effect on the global warming : No known ecological damage caused by this product. SECTION 13: Disposal considerations 13.1. Waste treatment methods Waste treatment methods : Dispose of contents/container in accordance with licensed collector s sorting instructions. SECTION 14: Transport information Department of Transportation (DOT) In accordance with DOT Not regulated for transport TDG Transport by sea Air transport SECTION 15: Regulatory information 15.1. US Federal regulations Not listed on the United States TSCA (Toxic Substances Control Act) inventory 15.2. International regulations CANADA EU-Regulations National regulations 15.3. US State regulations SECTION 16: Other information SDS-00034C.docx Page 5 of 6 ELITechGroup Inc.
Full text of H-phrases: ------ Eye Irrit. 2A Serious eye damage/eye irritation Category 2A ------ Skin Corr. 1A Skin corrosion/irritation Category 1A ------ H314 Causes severe skin burns and eye damage ------ H319 Causes serious eye irritation SDS US Custom - EBS This information is based on our current knowledge and is intended to describe the product for the purposes of health, safety and environmental requirements only. It should not therefore be construed as guaranteeing any specific property of the product. Reason for change: Changed labelling requirements to be indicate that the product could cause skin corrosion H314, and eye irritation H319. SDS-00034C.docx Page 6 of 6 ELITechGroup Inc.