Page 1 of 9 1. IDENTIFICATION OF THE SUBSTANCE / PREPARATION AND THE COMPANY / UNDERTAKING 920 Alumina, 906 Magnesia, 944 Silica PRODUCT APPLICATION: Ceramic Adhesives COMPANY / UNDERTAKING IDENTIFICATION: IS Rayfast Limited 2 Westmead Swindon Wiltshire SN5 7SY 2. COMPOSITION / INFORMATION ON INGREDIENTS CHEMICAL DESCRIPTION: Alumina, Quartz, Magnesia, Zirconia, or Silica. Part A immediately below for powder and Part B, from page 5, for liquid binder or water. HAZARDOUS INGREDIENTS: Substance % Symbol S No s CAS No. Label Index EC No Refractory Ceramic Powder (See 100 type above) 3. HAZARDS IDENTIFICATION 1. This preparation is not considered hazardous. 4. FIRST AID MEASURES Eyes Flush eyes with copious quantities of water Get immediate medical attention for eyes Skin Contact: Flush skin with copious quantities of water Ingestion If swallowed, consult physician immediately Inhalation Not applicable 5. FIRE-FIGHTING MEASURES Extinguishing Media: Fire and Explosion Hazards Protective Measures Foam Dry Chemical Powder. Carbon Dioxide Water jets. None identified Full protective equipment, including self-contained breathing apparatus is recommended and protective clothing. Avoid contact with substance.
Page 2 of 9 6. ACCIDENTAL RELEASE MEASURES (SPILLAGE) Personal Precautions: Environmental Precautions Decontamination Procedures Wear protective overalls, safety goggles and gloves. Note liquid is mild acid Prevent spillage from entering drains, groundwater or sewage. Sweep up spilled powder and dispose in approved industrial waste container. Hose spilled wet cement paste with water, immediately. (Cement is not water soluble after setting up) 7. HANDLING AND STORAGE Storage Keep containers sealed and clearly labeled. Avoid getting wet until ready to use. Ventilation Vacuuming with the vacuum exhaust passing through a high efficiency particulate arresting (HEPA) filter if the exhaust is discharged into the work-place. Handling Keep container closed when not in use. Note liquid is mild acid Avoid getting powder in Body Openings, Including Cuts, Sores, Mouth, etc. Wash Hands Thoroughly Before Eating or Smoking. 8. EXPOSURE CONTROLS / PERSONAL PROTECTION WORKPLACE EXPOSURE LIMITS: Substance Workplace Exposure Limits 8 hour T.W.A 15 minute STEL Other Information Refractory Ceramic Powder 5 mg/ Cu M Dust levels Refractory Ceramic Colloid 5 mg/ Cu M Dust levels PERSONAL PROTECTION: Respirator: Approved respirator should be used for spray applications Skin Protection: Overalls, chemical resistant safety boots and gloves recommended. Do not wear contaminated clothing. Eye Protection: Chemical safety goggles/glasses
Page 3 of 9 9. PHYSICAL AND CHEMICAL PROPERTIES As supplied Cured Appearance Creamy Paste Solid Odour No Odour Specific Gravity 1.5-3 1 2-2.5 Boiling Point 100 C N/A Vapour Pressure (mm Hg.) 0.2-1.2 N/A Vapour Density >1 N/A Solubility in water Soluble Insoluble % Volatile by Volume 20-50 N/A Evaporation rate (H 2 O=1) 1 N/A 10. STABILITY AND REACTIVITY: Stability Stable, hazardous polymerisation will not occur. Conditions to Avoid None identified Materials to be Avoided None identified. Hazardous Decomposition Products None identified. 11. TOXICOLOGICAL INFORMATION ACUTE EFFECTS: Eyes: Skin: Will produce irritation to the conjunction, cornea and eyelids. Slight dermatological irritation after prolonged skin contact. By Ingestion: May produce gastric discomfort, nausea, vomiting and diarrhoea. By Inhalation: May produce nose and throat irritation CHRONIC EFFECTS: No long term effects known about. OTHER POTENTIAL HAZARDS INCLUDE: None identified
Page 4 of 9 12. ECOLOGICAL INFORMATION Mobility: Persistence and Degradability: Bio-accumulative Potential: 13. DISPOSABLE CONSIDERATIONS Unused Product and Containers Used/Contaminated Product Dispose of in accordance with Local Regulations through an authorised Contractor. Dispose of in accordance with Local Regulations through an authorised Contractor. Do not dispose of down drains or anywhere that will enter the ground water system. 14. TRANSPORT INFORMATION Packaging (Size and Description) Transport Classification Substance Identification Number Conveyance classification Not classified N/A 15. REGULATORY INFORMATION Supply Classification o Not classified Hazard Pictogram o Not applicable Risk Phrases None specified. Safety Phrases None specified 16. OTHER INFORMATION When used in a mixture, read the labels and safety data sheets of all components. END USE connection sealant. The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty of quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text.
Page 5 of 9 PART B 1. IDENTIFICATION OF THE SUBSTANCE / PREPARATION AND THE COMPANY / UNDERTAKING 920 Alumina, 906 Magnesia, 944 Silica PRODUCT APPLICATION: Ceramic Adhesives COMPANY / UNDERTAKING IDENTIFICATION: IS Rayfast Limited 2 Westmead Swindon Wiltshire SN5 7SY 2. COMPOSITION / INFORMATION ON INGREDIENTS CHEMICAL DESCRIPTION: Alumina, Quartz, Magnesia, Zirconia, or Silica. Part A immediately above for powder and Part B, from this page, for liquid binder or water. HAZARDOUS INGREDIENTS: Substance % Symbol S No s CAS No. Label Index EC No Liquid Binder or Thinner Refractory Ceramic Colloid Water 20-50 3. HAZARDS IDENTIFICATION 2. This preparation is not considered hazardous. 4. FIRST AID MEASURES Eyes Flush eyes with copious quantities of water Get immediate medical attention for eyes Skin Contact: Flush skin with copious quantities of water Ingestion If swallowed, consult doctor immediately Inhalation Not applicable
Page 6 of 9 5. FIRE-FIGHTING MEASURES Extinguishing Media: Fire and Explosion Hazards Protective Measures Foam Dry Chemical Powder. Carbon Dioxide Water Fog Do not use water jets. The vapour is heavier than air and may travel along the ground, instant ignition possible. Vapour and air mixtures are explosive. Keep drums cool in a fire by spraying with water. Full protective equipment, including self-contained breathing apparatus is recommended and protective clothing. Avoid contact with substance. 6. ACCIDENTAL RELEASE MEASURES (SPILLAGE) Personal Precautions: Environmental Precautions Decontamination Procedures Wear protective overalls, safety goggles and gloves. Note liquid is mild acid Prevent spillage from entering drains, groundwater or sewage. Sweep up spilled powder and dispose in approved industrial waste container. Hose spilled wet cement paste with water, immediately. (Cement is not water soluble after setting up) 7. HANDLING AND STORAGE Storage Keep containers sealed and clearly labeled. Avoid getting wet until ready to use. Ventilation Vacuuming with the vacuum exhaust passing through a high efficiency particulate arresting (HEPA) filter if the exhaust is discharged into the work-place. Handling Keep container closed when not in use. Note liquid is mild acid Avoid getting powder in Body Openings, Including Cuts, Sores, Mouth, etc. Wash Hands Thoroughly Before Eating or Smoking. Precautions To Be Taken After Use And Upon Removal: This product as manufactured contains Silicate which could transform upon heating to mullet and crystobalite (a form of crystalline silica). Removal of this product after use may result in the generation of dust. Repeated inhalation of respirable free crystalline silica dust may cause delayed lung injury (silicosis). The recommended TLV/PEL for free crystalline silica is derived from the formula: 10 mg/cu m ½(----------)# % Respirable quartz + 2
Page 7 of 9 8. EXPOSURE CONTROLS / PERSONAL PROTECTION OCCUPATIONAL EXPOSURE LIMITED: Substance Occupational Exposure Limits 8 hour T.W.A 10 minute STEL Other Information Refractory Ceramic Colloid 5 mg/ Cu M Dust levels Mist or Dried dust from spraying 10 mg/m Not formed in normal use PERSONAL PROTECTION: Respirator: Approved respirator should be used for spray applications Skin Protection: Overalls, chemical resistant safety boots and gloves recommended. Do not wear contaminated clothing. Eye Protection: Chemical safety goggles/glasses 9. PHYSICAL AND CHEMICAL PROPERTIES As supplied Cured Appearance Clear or Opalescent liquid Solid Odour No Odor Specific Gravity 1.2-1.4 1.2-2.5 Boiling Point 100 C N/A Vapour Pressure (mm Hg.) 0.2-1.2 N/A Vapour Density (Air = 1) >1 N/A Solubility in water Soluble Insoluble % Volatile by Volume 20-50 N/A Evaporation rate (H 2 O = 1) 1 N/A 10. STABILITY AND REACTIVITY: Stability Stable, hazardous polymerisation will not occur. Conditions to Avoid None identified Materials to be Avoided None identified. Hazardous Decomposition Products None identified.
Page 8 of 9 11. TOXICOLOGICAL INFORMATION ACUTE EFFECTS: Eyes: Skin: Will produce irritation to the conjunction, cornea and eyelids. Slight dermatological irritation after prolonged skin contact. By Ingestion: May produce gastric discomfort, nausea, vomiting and diarrhoea. By Inhalation: May produce nose and throat irritation CHRONIC EFFECTS: Long-term overexposure to inhalation of mists or dust of dried down particles may cause tissue response in the lung (Pneumoconiosis). OTHER POTENTIAL HAZARDS INCLUDE: None identified 12. ECOLOGICAL INFORMATION Mobility: Persistence and Degradability: Bio-accumulative Potential: 13. DISPOSABLE CONSIDERATIONS Unused Product and Containers Used/Contaminated Product Dispose of in accordance with Local Regulations through an authorised Contractor. Dispose of in accordance with Local Regulations through an authorised Contractor. Do not dispose of down drains or anywhere that will enter the ground water system. 14. TRANSPORT INFORMATION Packaging (Size and Description) Transport Classification Substance Identification Number Conveyance classification Not classified N/A
Page 9 of 9 15. REGULATORY INFORMATION Supply Classification o Not classified Hazard Pictogram o Not applicable Risk Phrases None specified. Safety Phrases None specified 16. OTHER INFORMATION When used in a mixture, read the labels and safety data sheets of all components. END USE connection sealant. The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty of quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text.