Product name Product use MSDS # Date of Preparation/ Revision In case of emergency Material Safety Data Sheet Section 1. Chemical product and company identification Supplier Synonym Emergency overview Oxygen Molecular oxygen; Oxygen molecule; Pure oxygen; O2; UN 172; Dioxygen; Oxygen USP, Aviator s Breathing Oxygen (ABO) 143 9/24/213. Oxygen AIRGAS INC., on behalf of its subsidiaries 259 North Radnor-Chester Road Suite 1 Radnor, PA 1987-5283 1-61-687-5253 Synthetic/Analytical chemistry. 1-866-734-3438 Section 2. Hazards identification Physical state Routes of entry Potential acute health effects Eyes Skin Inhalation Ingestion Medical conditions aggravated by overexposure Inhalation See toxicological information (Section 11) Gas. [Compressed gas.] DANGER! GAS CONTENTS UNDER PRESURE. Do not puncture or incinerate container. LIQUID Extremely cold liquid and gas under pressure. Do not puncture or incinerate container. Store in tightly-closed container. Avoid contact with combustible materials. Contact with rapidly expanding gases or liquids can cause frostbite. May cause eye irritation. Contact with rapidly expanding gas may cause burns or frostbite. Contact with cryogenic liquid can cause frostbite and cryogenic burns. May cause skin irritation. Contact with rapidly expanding gas may cause burns or frostbite. Contact with cryogenic liquid can cause frostbite and cryogenic burns. Respiratory system irritation after overexposure to high oxygen concentrations. Ingestion is not a normal route of exposure for gases. Contact with cryogenic liquid can cause frostbite and cryogenic burns. Acute or chronic respiratory conditions may be aggravated by overexposure to this gas. Page 1/7
Section 3. Composition, Information on Ingredients Name CAS number % Volume Exposure limits Oxygen 7782-44-7 1 Section 4. First aid measures No action shall be taken involving any personal risk or without suitable training.if it is suspected that fumes are still present, the rescuer should wear an appropriate mask or self-contained breathing apparatus.it may be dangerous to the person providing aid to give mouth-to-mouth resuscitation. Eye contact Skin contact Check for and remove any contact lenses. Immediately flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical attention immediately. None expected. Frostbite Inhalation Ingestion Section 5. Fire-fighting measures Flammability of the product Products of combustion Fire hazards in the presence of various substances Fire-fighting media and instructions protective equipment for fire-fighters Try to warm up the frozen tissues and seek medical attention. Move exposed person to fresh air. If not breathing, if breathing is irregular or if respiratory arrest occurs, provide artificial respiration or oxygen by trained personnel. Loosen tight clothing such as a collar, tie, belt or waistband. Get medical attention immediately. As this product is a gas, refer to the inhalation section. Non-flammable. No specific data. Extremely flammable in the presence of the following materials or conditions reducing materials, combustible materials and organic materials. Use an extinguishing agent suitable for the surrounding fire. Section 6. Accidental release measures Apply water from a safe distance to cool container and protect surrounding area. If involved in fire, shut off flow immediately if it can be done without risk. Contains gas under pressure. Contact with combustible material may cause fire. This material increases the risk of fire and may aid combustion. In a fire or if heated, a pressure increase will occur and the container may burst or explode. Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode. Personal precautions Immediately contact emergency personnel. Keep unnecessary personnel away. Use suitable protective equipment (section 8). Eliminate all ignition sources if safe to do so. Do not touch or walk through spilled material. Shut off gas supply if this can be done safely. Isolate area until gas has dispersed. Environmental precautions Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Methods for cleaning up Immediately contact emergency personnel. Stop leak if without risk. Use spark-proof tools and explosion-proof equipment. Note see Section 1 for emergency contact information and Section 13 for waste disposal. Section 7. Handling and storage Handling High pressure gas. Do not puncture or incinerate container. Use equipment rated for cylinder pressure. Close valve after each use and when empty. Store in tightly-closed container. Avoid contact with combustible materials. Protect cylinders from physical damage; do not drag, roll, slide, or drop. Use a suitable hand truck for cylinder movement. Never allow any unprotected part of the body to touch uninsulated pipes or vessels that contain cryogenic liquids. Prevent entrapment of liquid in closed systems or piping without pressure relief devices. Some materials may become brittle at low temperatures Page 2/7
Storage Oxygen and will easily fracture. Keep container tightly closed. Keep container in a cool, well-ventilated area. Separate from acids, alkalies, reducing agents and combustibles. Cylinders should be stored upright, with valve protection cap in place, and firmly secured to prevent falling or being knocked over. Cylinder temperatures should not exceed 52 C (125 F). Section 8. Exposure controls/personal protection Engineering controls Personal protection Eyes Skin Respiratory Hands Personal protection in case of a large spill Product name Consult local authorities for acceptable exposure limits. Use only with adequate ventilation. Use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure to airborne contaminants below any recommended or statutory limits. Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists or dusts. When working with cryogenic liquids, wear a full face shield. Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Use a properly fitted, air-purifying or air-fed respirator complying with an approved standard if a risk assessment indicates this is necessary. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. The applicable standards are (US) 29 CFR 191.134 and (Canada) Z94.4-93 Chemical-resistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical products if a risk assessment indicates this is necessary. Insulated gloves suitable for low temperatures Self-contained breathing apparatus (SCBA) should be used to avoid inhalation of the product. Section 9. Physical and chemical properties Molecular weight Molecular formula Boiling/condensation point Melting/freezing point Critical temperature Vapor density 32 g/mole O2-183 C (-297.4 F) -218.4 C (-361.1 F) -118.15 C (-18.7 F) 1.1 (Air = 1) Specific Volume (ft 3 /lb) 12.482 Gas Density (lb/ft 3 ).83 Section 1. Stability and reactivity Stability and reactivity Incompatibility with various substances Hazardous decomposition products Hazardous polymerization The product is stable. Extremely reactive or incompatible with the following materials oxidizing materials, reducing materials and combustible materials. Under normal conditions of storage and use, hazardous decomposition products should not be produced. Under normal conditions of storage and use, hazardous polymerization will not occur. Page 3/7
Section 11. Toxicological information Toxicity data Other toxic effects on humans Specific effects Carcinogenic effects Mutagenic effects Reproduction toxicity No specific information is available in our database regarding the other toxic effects of this material to humans. No known significant effects or critical hazards. No known significant effects or critical hazards. No known significant effects or critical hazards. Section 12. Ecological information Aquatic ecotoxicity Not available. Environmental fate Environmental hazards Toxicity to the environment Not available. This product shows a low bioaccumulation potential. Not available. Section 13. Disposal considerations Product removed from the cylinder must be disposed of in accordance with appropriate Federal, State, local regulation.return cylinders with residual product to Airgas, Inc.Do not dispose of locally. Section 14. Transport information Regulatory information UN number Proper shipping name Class Packing group Label Additional information DOT Classification UN172 OXYGEN, COMPRESSED 2.2 Not applicable (gas). Limited quantity Yes. UN173 Oxygen, refrigerated liquid Packaging instruction Passenger aircraft Quantity limitation 75 kg Cargo aircraft Quantity limitation 15 kg provisions A52 Page 4/7
TDG Classification UN172 OXYGEN, 2.2 COMPRESSED UN173 Oxygen, refrigerated liquid Not applicable (gas). Explosive Limit and Limited Quantity Index.125 ERAP Index 3 Passenger Carrying Ship Index 5 Passenger Carrying Road or Rail Index 75 provisions 42 Mexico Classification UN172 OXYGEN, COMPRESSED 2.2 Not applicable (gas). - UN173 Oxygen, refrigerated liquid Refer to CFR 49 (or authority having jurisdiction) to determine the information required for shipment of the product. Section 15. Regulatory information United States U.S. Federal regulations TSCA 8(a) CDR Exempt/Partial exemption This material is listed or exempted. United States inventory (TSCA 8b) This material is listed or exempted. SARA 32/34 No products were found. SARA 311/312 Hazards identification Fire hazard, Sudden release of pressure State regulations Connecticut Carcinogen Reporting This material is not listed. Connecticut Hazardous Material Survey This material is not listed. Florida substances This material is not listed. Illinois Chemical Safety Act This material is not listed. Illinois Toxic Substances Disclosure to Employee Act This material is not listed. Louisiana Reporting This material is not listed. Louisiana Spill This material is not listed. Massachusetts Spill This material is not listed. Massachusetts Substances This material is listed. Michigan Critical Material This material is not listed. Minnesota Hazardous Substances This material is not listed. New Jersey Hazardous Substances This material is listed. New Jersey Spill This material is not listed. New Jersey Toxic Catastrophe Prevention Act This material is not listed. New York Acutely Hazardous Substances This material is not listed. New York Toxic Chemical Release Reporting This material is not listed. Pennsylvania RTK Hazardous Substances This material is listed. Page 5/7
Canada WHMIS (Canada) Section 16. Other information Rhode Island Hazardous Substances This material is not listed. Class A Compressed gas. Class C Oxidizing material. CEPA Toxic substances This material is not listed. Canadian ARET This material is not listed. Canadian NPRI This material is not listed. Alberta Designated Substances This material is not listed. Ontario Designated Substances This material is not listed. Quebec Designated Substances This material is not listed. United States Label requirements GAS CONTENTS UNDER PRESURE. Do not puncture or incinerate container. LIQUID Extremely cold liquid and gas under pressure. Canada Label requirements Class A Compressed gas. Class C Oxidizing material. Hazardous Material Information System (U.S.A.) Flammability Physical hazards liquid Fire hazard Reactivity 3 Personal protection National Fire Protection Association (U.S.A.) Flammability Instability liquid Page 6/7
Flammability 3 Instability Notice to reader To the best of our knowledge, the information contained herein is accurate. However, neither the above-named supplier, nor any of its subsidiaries, assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist. Page 7/7