Conforms to ANSI Z4.1-24 Standard (United States, Canada). Material Safety Data Sheet R Synthetic Diester Compressor Oil ISO-1, Section 1. Product and company identification Date Version 4/3/212 3 Product name Synthetic Diester Compressor Oil ISO-1, Material uses Lubricating Fluid. Not to be misted. Supplier/Manufacturer AMSOIL INC. 925 Tower Avenue Superior, WI 5488 Code MSDS authored by AMSOIL INC. In case of emergency CHEMTREC, U.S. 1-8-424-93 International +1-73-527-3887 Section 2. Hazards identification Emergency overview Color Physical state Odor Hazard statements Precautions OSHA/HCS status Amber. Liquid. [Fluid.] Mild hydrocarbon. NOT EXPECTED TO PRODUCE SIGNIFICANT ADVERSE HEALTH EFFECTS WHEN THE RECOMMENDED INSTRUCTIONS FOR USE ARE FOLLOWED. No known significant effects or critical hazards. Avoid prolonged contact with eyes, skin and clothing. While this material is not considered hazardous by the OSHA Hazard Communication Standard (29 CFR 191.12), this MSDS contains valuable information critical to the safe handling and proper use of the product. This MSDS should be retained and available for employees and other users of this product. Routes of entry Potential acute health effects Dermal contact. Eye contact. Inhalation. Ingestion. Inhalation Ingestion No known significant effects or critical hazards. No known significant effects or critical hazards. No known significant effects or critical hazards. No known significant effects or critical hazards. Potential chronic health effects Chronic effects No known significant effects or critical hazards. Carcinogenicity No known significant effects or critical hazards. Mutagenicity No known significant effects or critical hazards. Teratogenicity No known significant effects or critical hazards. Developmental effects No known significant effects or critical hazards. Fertility effects No known significant effects or critical hazards. Over-exposure signs/symptoms Inhalation No specific data. Ingestion No specific data. No specific data. 1/6 Date of issue 4/3/212
Medical conditions aggravated by overexposure See toxicological information (Section 11) No specific data. None known. Section 3. Composition/information on ingredients There are no ingredients present which, within the current knowledge of the supplier and in the concentrations applicable, are classified as hazardous to health or the environment and hence require reporting in this section. Section 4. First aid measures Eye contact contact Inhalation Ingestion Notes to physician Immediately flush eyes with plenty of water for at least 2 minutes, occasionally lifting the upper and lower eyelids. Get medical attention if symptoms occur. After contact with skin, wash immediately with plenty of soap and water. Get medical attention if symptoms occur. Move exposed person to fresh air. Get medical attention if symptoms occur. Wash out mouth with water. Do not induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Get medical attention if symptoms occur. No specific treatment. Treat symptomatically. Contact poison treatment specialist immediately if large quantities have been ingested or inhaled. Section 5. Fire-fighting measures Flammability of the product Extinguishing media Suitable Not suitable Hazardous decomposition products Special protective equipment for fire-fighters No specific fire or explosion hazard. Use an extinguishing agent suitable for the surrounding fire. None known. Decomposition products may include the following materials carbon dioxide carbon monoxide No special protection is required. Section 6. Accidental release measures Personal precautions Put on appropriate personal protective equipment (see Section 8). Environmental precautions Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Inform the relevant authorities if the product has caused environmental pollution (sewers, waterways, soil or air). Methods for cleaning up Small spill Absorb with an inert dry material and place in an appropriate waste disposal container. Dispose via a licensed waste disposal contractor. 2/6 Date of issue 4/3/212
Large spill Prevent entry into sewers, water courses, basements or confined areas. Wash spillages into an effluent treatment plant or proceed as follows. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations (see section 13). Dispose via a licensed waste disposal contractor. Note see section 1 for emergency contact information and section 13 for waste disposal. Section 7. Handling and storage Handling Storage Put on appropriate personal protective equipment (see Section 8). Avoid contact with used product. Eating, drinking and smoking should be prohibited in areas where this material is handled, stored and processed. Workers should wash hands and face before eating, drinking and smoking. Do not reuse container. Store in accordance with local regulations. Store in original container protected from direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials (see section 1) and food and drink. Keep container tightly closed and sealed until ready for use. Containers that have been opened must be carefully resealed and kept upright to prevent leakage. Do not store in unlabeled containers. Use appropriate containment to avoid environmental contamination. Section 8. Exposure controls/personal protection Under conditions which may generate mists, the following exposure limits are recommended ACGIH TLV TWA 5 mg/m³ ; STEL 1 mg/m³. Consult local authorities for acceptable exposure limits. Recommended monitoring procedures Engineering measures Hygiene measures Respiratory Hands Environmental exposure controls Personal, workplace atmosphere or biological monitoring may be required to determine the effectiveness of the ventilation or other control measures and/or the necessity to use respiratory protective equipment. No special ventilation requirements. Good general ventilation should be sufficient to control worker exposure to airborne contaminants. Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. Not required under normal conditions of use. Not required under normal conditions of use. Use gloves appropriate for work or task being performed. Not required under normal conditions of use. Safety eyewear should be used when there is a likelihood of exposure. Recommended Safety glasses with side shields. No special protective clothing is required. Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation. Section 9. Physical and chemical properties Physical state Liquid. [Fluid.] Odor Mild hydrocarbon. Color Amber. ph Flash point Open cup 248 to 254 C (478.4 to 489.2 F) [Cleveland.] Auto-ignition temperature 3/6 Date of issue 4/3/212
Flammable limits Boiling point Relative density Melting point/ Pour point -4 to -31 C (-4 to -23.8 F) Vapor pressure.933 to.9427 Vapor density Volatility Viscosity Kinematic.113 to.139 cm 2 /s (11.3 to 13.9 cst) (1 o C) Kinematic.985 to 1.53 cm 2 /s (98.5 to 15.3 cst) (4 o C) Evaporation rate Solubility Section 1. Stability and reactivity Chemical stability Conditions to avoid Materials to avoid Hazardous decomposition products Possibility of hazardous reactions Hazardous polymerization The product is stable. No specific data. Reactive or incompatible with the following materials oxidizing materials. Under normal conditions of storage and use, hazardous decomposition products should not be produced. Under normal conditions of storage and use, hazardous reactions will not occur. Under normal conditions of storage and use, hazardous polymerization will not occur. Section 11. Toxicological information Acute toxicity Chronic toxicity Irritation/Corrosion Respiratory Sensitizer Respiratory Carcinogenicity Mutagenicity Teratogenicity Reproductive toxicity 4/6 Date of issue 4/3/212
Section 12. Ecological information Ecotoxicity Aquatic ecotoxicity No known significant effects or critical hazards. Persistence/degradability Section 13. Disposal considerations Waste disposal The generation of waste should be avoided or minimized wherever possible. Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Empty containers or liners may retain some product residues. Dispose of surplus and non-recyclable products via a licensed waste disposal contractor. Disposal should be in accordance with applicable regional, national and local laws and regulations. Refer to Section 7 HANDLING AND STORAGE and Section 8 EXPOSURE CONTROLS/PERSONAL PROTECTION for additional handling information and protection of employees. Section 14. Transport information DOT/TDG/IMDG/IATA Not regulated. Section 15. Regulatory information United States HCS Classification U.S. Federal regulations Not regulated. United States inventory (TSCA 8b) All components are listed or exempted. SARA 32/34/311/312 extremely hazardous substances No products were found. SARA 32/34 emergency planning and notification No products were found. SARA 32/34/311/312 hazardous chemicals No products were found. SARA 311/312 MSDS distribution - chemical inventory - hazard identification No products were found. Clean Air Act Section 112(b) Hazardous Air Pollutants (HAPs) Clean Air Act Section 62 Class I Substances Clean Air Act Section 62 Class II Substances DEA List I Chemicals (Precursor Chemicals) DEA List II Chemicals (Essential Chemicals) Not listed Not listed Not listed Not listed Not listed 5/6 Date of issue 4/3/212
State regulations Massachusetts None of the components are listed. New York None of the components are listed. New Jersey None of the components are listed. Pennsylvania None of the components are listed. California Prop. 65 No products were found. Canada WHMIS (Canada) Not controlled under WHMIS (Canada). Canadian lists Canadian NPRI None of the components are listed. CEPA Toxic substances None of the components are listed. Canada inventory All components are listed or exempted. This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and the MSDS contains all the information required by the Controlled Products Regulations. Section 16. Other information United States Label requirements NOT EXPECTED TO PRODUCE SIGNIFICANT ADVERSE HEALTH EFFECTS WHEN THE RECOMMENDED INSTRUCTIONS FOR USE ARE FOLLOWED. Hazardous Material Information System (U.S.A.) Health Flammability Physical hazards 1 Caution HMIS ratings are based on a -4 rating scale, with representing minimal hazards or risks, and 4 representing significant hazards or risks Although HMIS ratings are not required on MSDSs under 29 CFR 191.12, the preparer may choose to provide them. HMIS ratings are to be used with a fully implemented HMIS program. HMIS is a registered mark of the National Paint & Coatings Association (NPCA). HMIS materials may be purchased exclusively from J. J. Keller (8) 327-6868. The customer is responsible for determining the PPE code for this material. National Fire Protection Association (U.S.A.) Health 1 Flammability Instability Special Date of issue Date of previous issue Version 4/3/212 7/3/211 3 Notice to reader To the best of our knowledge, the information contained herein is accurate. However, neither the above-named supplier, nor any of its subsidiaries, assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist. 6/6 Date of issue 4/3/212