Health: 2 Fire: 3 Reactivity: 0 PPI: B

Similar documents
MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Page Number: 1 of

Section 3 Physical Data

Page Number: 1 of

SECTION 2 - HAZARDOUS INGREDIENTS Ingredient Name CAS Number Percent TSCA

Safety Data Sheet. Section I Product Identification. Section II Hazard Identification

Material Safety Data Sheet For: Die Set Lube MSDS I.D. #135 P/N Quart Size. MSDS I.D. #136 P/N Gallon Size

Safety Data Sheet. Section I Product Identification. Section II Hazard Identification

Kardol Quality Products 285 S. West Street Lebanon, Ohio Fax:

Page Number: 1 of

CAS Number Health: 1 Fire: 2 Reactivity: 1 PPI:

Air Tool Lubricant MSDS. Air Tool Lubricant. (800) (Poison Control USA) 24 Hours (800) (CHEMTREC) 24 Hours. Not Applicable - Mixture

=========================================================================== Section 1 PRODUCT AND COMPANY IDENTIFICATION

Page Number: 1 of

Material Safety Data Sheet

14 FORTUNE DRIVE PRODUCT NAME: EPO-TEK OM125, Part A BILLERICA, MA 01821

MATERIAL SAFETY DATA SHEET. Page Number:

Carcinogen: NTP (No) IARC (No) OSHA (No) DATE REVISED: 11/8/11 REV: E * HMIS CODE ratings are estimated by Epoxy Technology.

Material Safety Data Sheet

14 FORTUNE DRIVE PRODUCT NAME: EPO-TEK H20E, Part A BILLERICA, MA 01821

MATERIAL SAFETY DATA SHEET General Finishes Corporation. SECTION 2: Composition/Information on Ingredients

Health Flammability 4 Reactivity 0 PRODUCT NAME MAGIC COMPLETE COUNTERTOP AEROSOL MANUFACTURER'S NAME

MATERIAL SAFETY DATA SHEET

=========================================================================== Section 1 PRODUCT AND COMPANY IDENTIFICATION

MATERIAL SAFETY DATA SHEET

Emergency Telephone Primary Contact Technical Services

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet. Product Name: Synlube 531 Bulk. Chemical Type: EHS. Non-Hazardous Release Blend 4-8

RAZE DR 8810 MATERIAL SAFETY DATA SHEET ESSENTIALLY SIMILAR TO OSHA FORM 174

SAFETY DATA SHEET SECTION I PRODUCT IDENTIFICATION INGREDIANTS SECTION III HAZARDS IDENTIFICATION

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Southern Lithoplate, Inc. P.O. Box 9400 Wake Forest, NC Phone: Fax: Website:

M A T E R I A L S A F E T Y D A T A S H E E T

MATERIAL SAFETY DATA SHEET. Page Number:

14 FORTUNE DRIVE PRODUCT NAME: EPO-TEK H74 UNF, Part A BILLERICA, MA 01821

Safety Data Sheet. This SDS has been prepared for the purposes of Hazard Communication, under 29 CFR Hazards Identification

FLP-Q, FLP-32, FLP-G FITZGERALD'S LEATHER PREP

MATERIAL SAFETY DATA SHEET

SECTION I - PRODUCT AND COMPANY INFORMATION Product Name: A INVISIBLE BLUE PIGMENT

MATERIAL SAFETY DATA SHEET

Safety Data Sheet Bulldog Durex EPDM Rinseable Primer #115

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET. Page Number:

MATERIAL SAFETY DATA SHEET PIR

Carcinogen: NTP (No) IARC (No) OSHA (No) DATE REVISED: 6/5/01 REV: A * HMIS CODE ratings are estimated by Epoxy Technology.

MATERIAL SAFETY DATA SHEET

SAFETY DATA SHEET. Inhalation of vapor or spray mist. Eye contact with the product, vapor or spray mist.

Health Flammability 2 Reactivity 0 PRODUCT NAME FORMBY S* Build-Up Remover

TESCO Products Inc. Crystal Seal II

* HMIS CODE ratings are estimated by Epoxy Technology. II. HAZARDOUS INGREDIENTS CAS# WT % TOXICITY DATA

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET Complies with OSHA Hazard Communication Standard 29 CFR

MATERIAL SAFETY DATA SHEET Complies with OSHA Hazard Communication Standard 29 CFR

=========================================================================== Section 1 PRODUCT AND COMPANY IDENTIFICATION

7031 SW 22 Court, Davie, FL (866) 637-ROOF (7663) Fax: (941) Final Flat Roof MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET A

Safety Data Sheet. AK Page 1 of 6 January 01, Appearance/Odor: Thick, viscous, white to off-white liquid with a mild ammonia odor

MATERIAL SAFETY DATA SHEET. HMIS Hazard Rating: Health: 1 Fire: 1 Reactivity: 0 PPI: C

EverGuard 2331 PVC Bonding Adhesive

=========================================================================== Section 1 PRODUCT AND COMPANY IDENTIFICATION

MATERIAL SAFETY DATA SHEET. Quick Identifier (In Plant Common Name): SP-101

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET PAGE 1

MATERIAL SAFTEY DATA SHEET

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

The Valvoline Company Date Prepared: 01/14/02. MSDS No: I

=========================================================================== Section 1 PRODUCT AND COMPANY IDENTIFICATION

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET Date Revised: 7/18/2013 Page: 1 Mold Release MSDS Number: SECTION 1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

Cen-Pe-Co Hy-Torque Gear Lube Red With Temp Tac Page 1 of 5 05/01/08 MATERIAL SAFETY DATA SHEET

Page Number: 1 of Health: 3 Fire: 2 Reactivity: 0 PPI:

SAFETY DATA SHEET Lead Stop

********************* SECTION I, IDENTIFICATION OF PRODUCT *********************

MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Material Safety Data Sheet

Material Safety Data Sheet Fiebing Company, Inc., Milwaukee, WI Phone #: (414) Emergency Phone:

Safety Data Sheet SUREPREP NO-STING SKIN PROTECTANT

MATERIAL SAFETY DATA SHEET CS

COMPONENT/EXPOSURE LIMITS

MATERIAL SAFETY DATA SHEET 1 OF

MATERIAL SAFETY DATA SHEET

WHITE SEMI-GLOSS CONVERSION VARNISH

Ingredient CAS Number Weight % ACGIH TLV PEL STEL Acetone < 33 % 750 ppm 750 ppm 1000 ppm. n-hexane < 22 % 50 ppm 50 ppm 1000 ppm

MATERIAL SAFETY DATA SHEET. Elecro Static Dissapative WATER EMULSION FINISH PART A

Safety Data Sheet. This SDS has been prepared for the purposes of Hazard Communication, under 29 CFR

Issue Date: 23-Jan-2013 Revision Date: 19-Nov-2015 Version 2 1. PRODUCT AND COMPANY IDENTIFICATION. United 317 Cooling Tower Anti-Freeze

MATERIAL SAFTEY DATA SHEET

Safety Data Sheet. AB Page 1 of 6 January 01, Relevant routes of exposure: Eye contact, skin contact, inhalation, ingestion

14 FORTUNE DRIVE PRODUCT NAME: Epo Tek 320-3, Part A BILLERICA, MA 01821

The Valvoline Company Date Prepared: 01/14/02. MSDS No: I

Safety Data Sheet. Tuxton Select Full Synthetic 0W20 API SN/GF-5

View NSN Online:

Transcription:

Page Number: 1 SECTION I PRODUCT AND COMPANY INFORMATION Product Name: AGM TACTOO GPA 72 CAS Number: MIXTURE Hazard Rating: Health: 2 Fire: 3 Reactivity: 0 PPI: B Company Identification: Telephone/Fax: Chemtrec (24 Hour): ITW TACC AIR STATION INDUSTRIAL PARK ROCKLAND MA 02370 (781) 878 7015 (781) 871 6727 (800) 424 9300 Trade Name: AGM TACTOO GPA 72 Product Code: 116 DOT Hazard Class 3 UN Number: 1133 Shipping Name: ADHESIVES Packing Group: II Miracle is a registered trademark of Illinois Tool Works, Inc. SECTION II HAZARDOUS INFORMATION Ingredient Name CAS Number Percent TSCA TOLUENE 108 88 3 55 75 Y SILICA, QUARTZ 14808 60 7 < 0.5 Y Respirable crystalline silica (quartz) can cause silicosis, a fibrosis (scarring) of the lungs. Silicosis may be progressive; it many lead to disability and death. Crystalline silica (quartz) inhaled from occupational sources is classified as carcinogenic to humans. SECTION III PHYSICAL DATA

Page Number: 2 Appearance/Color: Boiling Range: Evaporation Rate: % Volatile Weight: 60.75% % Volatile Volume: Not Available Specific Gravity: 1.018 Weight/Volume Measure: 8.47691 EPA Method 24 VOC: 616.6 g/l Photo Chem Reactive Only VOC: 616.6 OLIVE GREEN 232.øF Faster than n Butyl Acetate SECTION IV FIRE AND EXPLOSION HAZARD DANGER Flammability Class: Flash Range: Explosive Range: 0.9% 7.% IB 45.øF Tag Closed Cup EXTINGUISHING MEDIA: Foam, dry chemical, carbon dioxide, water spray or fog. SPECIAL FIREFIGHTING PROCEDURES: Avoid breathing smoke. Use air supplied rescue equipment for enclosed area. Water tends to spread burning liquid if large amounts used. UNUSUAL FIRE & EXPLOSION HAZARDS: Flammable. Vapors may ignite explosively and/or cause flash fires. Eliminate sources of ignition. No smoking. Use adequate cross ventilation sufficient to remove odor of solvent and vapors. Electrically ground all containers during transfer. SECTION V HEALTH HAZARD DATA PERMISSIBLE EXPOSURE LEVEL: SEE SECTION VIII. EFFECTS OF OVEREXPOSURE: INHALATION: May cause dizziness, nausea, upper respiratory irritation, drowsiness, mental depression or narcosis, difficulty in breathing, irregular heartbeats. Chronic effects of overexposure to solvent vapors could lead to permanent effects to the nervous system, body organs and slight liver damage on excessive exposure. Use with adequate ventilation.

Page Number: 3 Can cause cardiac arrest and irregular heartbeats when inhaled in massive amounts as for euphoria. EYES: Irritation. SKIN: Removal of skin oils, irritation, dermatitis, sensitization. INGESTION: May be harmful if swallowed; can cause gastro intestinal tract effects. FIRST AID: INHALATION: Get fresh air, if necessary call physician. SKIN: Wash with mild soap and water, apply a mild cream. EYES: Flush with water for at least 15 minutes. INGESTION: Call Poison Center immediately. SECTION VI REACTIVITY DATA Stability: This product is stable Hazardous Polymerization: Hazardous polymerization will not occur INCOMPATIBILITY: Strong oxidizing agents, strong acids and bases. CONDITIONS TO AVOID: Fire, sparks, static electricity. HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide. SECTION VII SPILL OR LEAK PROCEDURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Keep spectators away. Eliminate all ignition sources (flames, hot surfaces and sources of electrical, static or frictional sparks). Dike and contain spill with inert material (e.g. sand, earth). Transfer liquids to covered metal containers for recovery or disposal, or remove with inert absorbent. Use only non sparking tools. Place absorbent diking materials in covered metal containers for disposal. Prevent contamination of sewers, streams and groundwater with spilled material or used absorbent. WASTE DISPOSAL METHOD: Dispose in accordance with federal, state and local regulations. SECTION VIII EXPOSURE CONTROLS/PERSONAL PROTECTION

Page Number: 4 Occupational Exposure Limits: ACGIH TLV ACGIH TLV C ACGIH STEL OSHA STEL OSHA PEL TOLUENE 50.00 PPM N/est N/est N/est 200.00 PPM SILICA, QUARTZ 0.10 mg/m3 N/est N/est N/est 0.10 mg/m3 RESPIRATORY PROTECTION: If workplace exposure limit of product is exceeded, a NIOSH/MSHA approved air supplied respirator must be used in absence of proper environmental control. Engineering or administrative controls should be implemented to reduce exposure. VENTILATION: Provide sufficent mechanical (general and/or local exhaust) ventilation to maintain exposure below PEL. PROTECTIVE GLOVES: Chemical resistant gloves. EYE PROTECTION: Chemical splash goggles in compliance with OSHA regulations are advised. OTHER PROTECTIVE EQUIPMENT: To prevent repeated, prolonged skin contact, wear impervious clothing and boots. SECTION IX SPECIAL PRECAUTIONS PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Keep container closed when not in use. Store at 60 95 degrees F and out of the sun. Use adequate ventilation to avoid breath ing vapors when cover is removed. Ground all equipment when handling flammable solventborne materials. OTHER PRECAUTIONS: For professional or industrial use only. Follow label instructions. Keep out of the reach of children. Not for consumpion. No smoking. Do not breathe fumes. Avoid contact with body. Turn off all pilot lights, flames, stoves, heaters, electric motors, welding equipment and other sources of ignition. Close all containers when not in use. Empty containers must not be washed and re used for any purpose. Contact lens wearers take appropriate precautions. Wash hands throughly after handling. For spray applications, use only with approved spray equipment.

Page Number: 5 For flammable products, vapors may cause flash fire or ignite explosively. To prevent buildup of vapors, use adequate ventilations (e.g. open all windows and doors to achieve cross ventilation). Containers may be hazardous when empty. Never use welding or cutting torch on or near container. SECTION X ADDITIONAL REGULATORY INFORMATION SARA TITLE III SECTION 313: This product contains the following toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right to Know Act of 1986 and of 40 CFR 372: Ingredient Name CAS Number Percent TOLUENE 108 88 3 55 75 PROP 65 (CARCINOGEN) WARNING: This product contains a chemical known to the state of California to cause cancer. Ingredient Name CAS Number Percent SILICA, QUARTZ 14808 60 7 < 0.5 PROP 65 (TERATOGEN) WARNING: This product contains a chemical known to the state of California to cause birth defects or other reproductive harm. Ingredient Name CAS Number Percent TOLUENE 108 88 3 55 75 DISCLAIMER ****** NOTICE ****** This information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of ITW TACC. The data on this sheet relates only to the specific material designated herein. ITW TACC assumes no legal responsibility for use or reliance upon these data.

Page Number: 6