Vave eection Guide eection Guide for uti-port, nge and Ebow Diaphragm Vaves technoogica eadership by design an O 9 certified company eection Guide Customize a vave to meet your system requirements. Your choice of Vave ctuation, End Connections and Fow Path are described beow. The mode designation options start with seection of the actuator in Figure #. Fow Path Vave ctuation Figure # ctuator Pressure Range Description of ctuator tye Vacuum to ctuator Designator anua 5 psig ( bar) Round handwhee / Turn ever ndicator Hande hort / turn ever Pneumatic 5 psig (8.6 bar) Normay Cosed OP P NC (ow pressure Normay Open OP P NO system) Pneumatic 5 psig ( bar) Normay Cosed OP HP NC. For oxygen: psig (5 bar). ctuation pressure - 75 psig nomina (6- psig) eect a body configuration with the desired interna fow path in Figure #. The fow path is shown as viewed from the top of the body. The O next to the port number indicates a port above the vave seat; the indicates a port beow the vave seat. though the 9/95/955 wi operate in either fow direction, the O port is generay used as the outet or downstream port and the port is normay used as the inet or upstream port. The Fow Path Designator wi be used in the Vave Ordering or mode number. Figure # and # on the foowing page address port numbering sequence and end connection styes. Fow Path Designator - Figure # ( Port) ( Port) C ( Port) D ( Port) E ( Port) F ( Port) G ( Port) H ( Port Ebow) ( Port Ebow) J ( Port nge) K ( Port) ( Port) ( Port) 5 (bottom port)
Vave eection Guide End Connections eect the desired End Connection using the End Connection tye Chart (Figure #) for each port on the body starting with Port and continuing in numerica sequence with Ports,,, and 5 as necessary shown in Figure #. ways seect a designator for each port that wi be used, i.e. two designators for a two port body, three designators for a three port body, and so on, even if the connections are identica. Figure # Figure # Port Numbering equence End Connection ize/tye Designator Top View of ody 5 5 = bottom port / Tube tub (.5 x.5) / Face ea ae wive / Face ea Femae wive /8 Tube tub (.75 x.5) / Face ea ae wive 5 / Face ea Femae wive 6 / Tube tub (.5 x.9) 7 afe Vave eection When seecting a vave, the tota system design must be considered to ensure safe, troube-free performance. Vave function, materia compatibiity, adequate ratings, proper instaation, operation, and maintenance are the responsibiity of the system designer and user.
Vave eection Guide 955 Dimensions Overa height and actuator dimensions are shown in Figure #9. Centerine to port dimensions are shown in Figure #. Port to port dimensions are determined by adding the dimensions together. Note: dimensions are in inches for reference ony. Figure #9 955 eries Note: The mini-ever is.75 on center. ength.5. Ø.8 Ø.6.75. f.5.6.88 (7. mm).5..65 955 955 955 OP P NO 955 OP P NC 955 Port.5 Port Port #- UNF P.78 Port.. TOP VEW PORT 5 OTTO VEW Figure # End Connection Designator / Tube tub (.5 x.5)..9 / Face ea ae wive.8.6 / Face ea Femae wive.8.6 Dimension Toerance +. Designator /8 Tube tub (.75 x.5)..9 / Face ea ae wive..89 5 / Face ea Femae wive..89 6 / Tube tub (.5 x.9)..9 7 uid a Vave Ordering Number by combining the moduar designators in the sequence shown beow. 955 OP P NC C V C ERE 955 OP P NC OP P NO TER = tainess tee H = Hasteoy (Refer to Figure #) FOW PTH,, C, D, E, F, G, H,, J, K,, (Refer to Figure #) OPTON Vesp = Vespe END CONNECTON Port Port (Refer to Figure # and #) Port Port Hasteoy C- is a registered trademark of Haynes Vespe is a registered trademark of Du Pont. (Refer to Figure #9and # for 5
Vave eection Guide 9 Dimensions Overa height and actuator dimensions are shown in Figure #5. Centerine to port dimensions are shown in Figure #6. Port to port dimensions are determined by adding the dimensions together. Note: dimensions are in inches for reference ony. Figure #5 9 eries Note: The mini-ever is.75 on center. ength.5. Ø. Ø. Ø.9 n.5..75.5..7. (76. mm).5.75 OPEN 9 9 9 OP P NO 9 OP P NC 9 OP HP 9. (6.mm) Port.5 (89. mm) COED Port Port.5. (58.mm) #- UNF P.78 Port.. (. mm).5 Q (.8 mm) TOP VEW PORT 5 OTTO VEW. Figure #6 Dimension Toerance +. End Connection Designator / Tube tub (.5 x.5).875.69 / Face ea ae wive.9.6 / Face ea Femae wive.9.6 Designator /8 Tube tub (.75 x.5)..9 / Face ea ae wive.7.89 5 / Face ea Femae wive.7.89 6 uid a Vave Ordering Number by combining the moduar designators in the sequence shown beow. 9 OP P NC C TH C ERE 9 OP P NC OP P NO OP HP NC TER = tainess tee H = Hasteoy (Refer to Figure #) FOW PTH,, C, D, E, F, G, H,, J, K,, (Refer to Figure #) OPTON TH = Hasteoy C- Trim Vesp = Vespe END CONNECTON Port Port (Refer to Figure # and #) Port Port Hasteoy C- is a registered trademark of Haynes Vespe is a registered trademark of Du Pont. (Refer to Figure #5 and #6 for
Vave eection Guide 95 Dimensions Overa height and actuator dimensions are shown in Figure #7. Centerine to port dimensions are shown in Figure #8. Port to port dimensions are determined by adding the dimensions together. Note: dimensions are in inches for reference ony. Figure #7 95 eries Note: The mini-ever is.75 on center. ength.5.. Ø. f.5.97.5..56.8.58 95 95 95 OP P NO 95 OP P NC 95 OP HP Port 95 Port Port. Port. #- UNF P.78 TOP VEW PORT 5 OTTO VEW. Figure #8 End Connection Designator / Tube tub(.5 x.5).875.69 / Face ea ae wive.9.6 / Face ea Femae wive.9.6 Dimension Toerance +. Designator /8 Tube tub (.75 x.5)..9 / Face ea ae wive.7.89 5 / Face ea Femae wive.7.89 6 *Port # and # ony uid a Vave Ordering Number by combining the moduar designators in the sequence shown beow. 95 OP P NC C TH C ERE 95 OP P NC OP P NO OP HP NC TER = tainess tee H = Hasteoy (Refer to Figure #) FOW PTH,, C, D, E, F, G, H,, J, K,, (Refer to Figure #) OPTON TH = Hasteoy C- Trim Vesp = Vespe END CONNECTON Port Port (Refer to Figure # and #) Port Port Hasteoy C- is a registered trademark of Haynes Vespe is a registered trademark of Du Pont. (Refer to Figure #7 and #8 for