Lazy Bag Installation Guide for Beneteau Yachts

Similar documents
Sail Trimming Guide for the Beneteau 373

Sail Trimming Guide for the Beneteau 343

Sail Trimming Guide for the Beneteau 40

Headsail Tuning Guide for the Beneteau 423

TOPAZ R2 Race+ TOPAZ R2 Race X Rigging Instructions

DOYLE Cradle Cover MANUAL

KNOTS. Overhand Knot. Page 12 of 32

Vanguard Sailboats 300 Highpoint Avenue Portsmouth, RI For the dealer nearest you call SAIL

Follow these easy steps to properly assemble your new Zim 420

Sail Trimming Guide for the Beneteau Oceanis 38

Neil Pryde Sails International Design and Technical Office. Beneteau U.S.A. Oceanis Series Overview

KNOTS. A very short guide to knotting terminology used on these pages.

The Forest School Training Co. OCN accredited training

Table of content Introduction 5 1. Part 1. Assembly Tools needed for Assembly Glossary Hulls Mounting the beams 7

Index 1. Trampoline 2. Main Foils 3. Spinnaker Pole 4. Mast Setup 5. Mast Rigging 6. Rig Tension 7. Trapeze Lines 8. Rudders 9. Boom 10. Main Sheet an

Topaz OMEGA Rigging Instructions

Weta Basic Rigging Guide

SECTION V. Terminology: Bight: Double Bight: Loop: Turn: Round Turn: Half Hitch: Girth Hitch: Running End: Standing End:

TUNE YOUR SAILS SPEED. Optimist Tuning Guide. Photo Wavelength

Pico rigging manual 2007.doc Page 1 of 28

Wing assemblyfinal Master 4/29/04 11:20 PM Page 1. Issued January 1, Sabre Aircraft. Assembly Manual. Sabre 16ss Wing

ESCONDIDO FIRE DEPT TRAINING MANUAL Section Truck Module Page 1 of 13 Ropes Equipment Aloft Revised

JMPI for the MODULAR AIRBORNE WEAPONS CASE (MAWC)

Bladerider X8 Assembly Help Notes

Performance Cruising

Troop 226. Knot Master Program

ESOCCI RIGGING MANUAL

Fitting Instructions For Slab Reefing Kit Part No For Yachts Up To 8.5m (2 Reefing Points)

Club 420 Class Rigging Manual

CII Rigging suggestions

Kayaking Bob s Tandem Island SpraySkirt Kit Installation Instructions

HOW TO RIG A CORMORANT

FDR CHRYSLER 16' CATAMARAN (MUSKETEER) The initial rigging of a sailboat is not difficult, but if the boat is strange

ASSEMBLY MANUAL HOBIE CATSY

1997 Transformer Bump & Jump

Highlander Specifications

Square Diagonal Tripod Japanese Square Filipino Diagonal Round Shear Ladder

Army Mountain Warfare School Ethan Allen Firing Range Jericho, VT Military Mountaineer Course Knot Guide

MAXIMUM SAIL POWER CHAPTER 7 MAINSAIL DETAILS FOR THE CRUISING SAILOR

Dolly wheels in slot #8 for Boat #10.

KNOTS OFTEN USED BY FIGHTER KITE MAKERS AND FLYERS.

Far East Boat Optimist Rigging Instructions

Rhodes 19 Tuning Guide

Knots for Cavers Knots, Hitches, Bends, and Splices Step By Step Instructions For tying knots for Caving

J/70 Tuning Guide. onedesign.com Follow North Sails on... For any question you may have on tuning your J/70 for speed, contact our experts:

Knots, Hitches and Bends

COASTAL IN-BOOM FURLING SYSTEM. Installation Manual

TUNE YOUR SAILS SPEED

Laser Rigging Basics St. Jamestown Sailing Club

Ref :MMHC14SR_GB Emetteur :MF Date :Dec 2014 Revision : 1 Page 1/18. ASSEMBLY MANUAL : HOBIE CAT 14 Std & Race HOBIE CAT 14 STD & RACE

RIGGING INSTRUCTIONS Let's assume that you have your boat on a trailer when you take delivery from your dealer.

LOOP KNOTS: A loop knot, like a hitch, fastens a rope to another object. A loop knot may be tied in the hand and then placed over the object, while a


The Basics of Victory Sailing II

2. Note that the ropes from the rigging board are secured in the cam cleats of the jib fairleads.

Butler Tactical Parachute Systems, LLC

Knot Tying for Scouts and Scouters

Neil Pryde Sails International Design and Technical Office. O Day Sailboats Sails Overview

TUNE YOUR SAILS SPEED. J/70 Tuning Guide Rev. Q10a. Photo Chris Howell

T 10 Tacking Ver

Daysailer Tuning Guide

2018 Osprey Yacht Club

How to tie a sling for SHE's prototype HotPot

A Basic Guide to Europe Dinghy Rigging

The Definite Guide to Optimist Trim

OPERATIONAL CHECK LIST

Tying Farm Knots. Working with Heifers

SailTrack Installation Instructions. External Track

KNOTS OFTEN USED BY FIGHTER KITE MAKERS AND FLYERS

J/70 Tuning Guide. For any question you may have on tuning your J/70 for speed, contact our experts:

Knots /2017. Camp and Outdoor Curriculum Manual

MAN-032 Rev 0. Performance Designs Zero Packing Manual

Hobie Island Spinnaker Instructions

Wysiwig - Wayfarer Rigging Guide

APPENDIX IV DEVELOPMENT AND MEASUREMENT RULES OF THE INTERNATIONAL TEN SQUARE METER SAILING CANOE

Alternate Sked Lashing Methods From Roco Rescue. Approved by Skedco.

TUNE YOUR SAILS SPEED

420 Rigging Guide.

PROFURL IN-BOOM REEFING SYSTEM MK 2 R SERIAL NUMBER :... INSTALLATION MANUAL

North Sails Seattle Thunderbird Tuning Guide

RESCUE TECHNICIAN KNOT GUIDE

A useful guide for anyone interested in Inshore or Offshore yacht racing

Butler Parachute Systems, Inc

INTERNATIONAL RS TERA CLASS RULES

12.9 Gennaker. February Setting up and sailing with the 12.9 Gennaker

Ropework. Stopper Knots. Overhand Knot ROPEWORK. Figure of Eight 3.

Ropework. Stopper knots. Overhand Knot ROPEWORK. Figure of Eight 3.

North Sails One Design Atlantic Tuning Guide

End. Standing Part. An underhand loop is made by crossing the end under the standing part.

Raider 16/Sport - Spinnaker Rigging. Rigging Spinnaker

Sails. Sails: extract from 'Super-detailing the Cutter Sherbourne' page 1 George Bandurek

PROFURL IN-BOOM REEFING SYSTEM MK 3 R SERIAL NUMBER :... INSTALLATION MANUAL

EQUIPMENT INFORMATION SYSTEM COMPONENTS OPERATOR INSTRUCTIONS

Parts of a Rope 1. Carrick Bend 2 Fisherman s Bend 4 Hunter s/rigger s Bend 5 Sheet Bend 7

Rigging Manual. 1 Parts of the Hull. 2 Parts of the Sail. 3 Sunfish Mast Kit. 4 Bailer Installation. 5 Ratchet Block Installation

IOM RIGS AND SAILS CERTIFICATION CONTROL - CHECK LIST FORM 2017

1.4 Lift up one of the distressed members legs and place it on your shoulder.

THE POWER IS ON RIGGING + TUNING GUIDE Specifications First Time Rigging 9.1. Rig Assembly. Tuning Tips.

INSTRUCTION NO

J/22 Dave Perry. Based on sailing the POW in the Ft Worth Boat Club (TX) boats in 2006 We sailed with three in the boat

Transcription:

INTERNATIONAL DESIGN AND TECHNICAL OFFICE Lazy Bag Installation Guide for Beneteau Yachts 8 August, 2001 Neil Pryde Sails Int. 354 Woodmont Road #18 Milford, CT 06460 Phone: 203-874-6984 Fax: 203-877-7014 Email: admin@neilprydesails.com Web: www.neilprydesails.com All material herein Copyright 2001-2002 Neil Pryde Sails Int.

OVERVIEW The Neil Pryde Sails Mainsail Lazy Bag (MLB) is designed to be easily used and modular in design. It can conveniently be fitted and removed independently of the sail. The MLB includes a zippered flap at the front of the bag that wraps around the mast to the opposite side of the bag and zippers closed. This is designed to reduce U.V. damage and keep birds from nesting inside the mainsail! The front flap can be left in place while sailing, or folded back inside the bag and secured with a hook & loop strip. The top zipper is also provided with a flap to help decrease water ingress. The MLB is attached to the boom using slug/slides. The bag is NOT sewn between each slide so that rain water AND reefing lines can be led from the sail through the bag to the boom attachment points. Two adjustable webbing straps provide Fore/aft tension; one strap is passed through the clew ring of the mainsail and the forward strap goes around the mast (and inside the halyards). The straps are inside the bag to reduce U.V. exposure and allow the bag to be pulled aft over the sail, covering it completely. A third strap at the front/top can be used to tighten up the forward girth of the bag. The battens are inserted from the forward end of the bag. The design is such, that the battens themselves become the attachment point for the lazy jacks. This reduces point loading and makes the bag smooth and taunt. The battens are locked in place with the internal Velcro closure system. (Identical to the mainsail batten pocket system) The following pictorial guide will outline the basic steps to installation. 2

Installation Procedure Getting Started: Assuming the sail is already in place, pull the entire sail to one side of the boom. This allows you to access the boom slot opening at the front of the boom, just behind the gooseneck. Starting with aft most end (short end) insert the furthest aft slug into the boom at the forward end of the boom just aft of the gooseneck and slide it aft. Add each succeeding slug until the cover is pulled aft completely. Both halves of the bag will be on the same side at this time. (Starboard in the photo) Pull one half of the bag underneath the sail and to the opposite side.

The aft webbing strap is led through the clew ring of the sail and back into the buckle. The webbing should be pulled tight enough so that the bag covers the aft end of the sail. In the photo at right you can see the sail clew slug is pull out to the black band on the boom. The bag itself extends aft, past the black band. With this preliminary adjustment made now insert each batten into the pocket. Make sure it is completely seated at the very aft end of the bag. At each opening along the sock mark the batten and remove the batten. We suggest that you make a 2 / 50mm wrap of white riggers tape at these locations as it will provide good friction and holding power for the lazy jack lines. Re-insert the battens. Pulling the bag tight and with a fair amount of tension on the battens, the battens should be just inside of the pocket fronts. If this is not the case, they are easily trimmed with a hacksaw. Now insert the webbing/velcro strap, holding the locking the battens in place. This is the very same system as used on the mainsail battens and will require the pusher stick that came with your mainsail for this operation. Jackline Setup: The jacklines are composed of three parts; the upper line that connects to the mast, the aft line that runs from the aft most connection point on the bag, to the upper ring and the forward line. Take your aft line and tie it around the rigging tape on the batten at the last most connection point on the bag. A double or triple clove hitch or fisherman s bend are both very good knots that will resist slipping and be quite permanent. Tie the forward line in a similar fashion to the midattachment point on the bag. Take one turn on the forward line around the batten and pull the entire jackline system tight. The bag side should be pulled up smoothly and tightly. Later should you want, you can tie a overhand shortening loop above the bag on the forward line and turn the rope end around the batten and back up to the loop, making a purchase system that can be secured with a couple of overhands. Do the opposite side in the same fashion. Aft Line Upper Line Forward Line 4

With both sides of the bag now pulled up and tight you need to check the fore/aft location of the bag. Do this by bringing the forward flap around the mast (inside the halyards) and zip it closed. If you cannot zip it or if it zips and is quite loose, the bag needs to be adjusted fore or aft depending on location. You will need to slide each slide backward or forward in small increments until the overall position is correct. Once achieved, readjust the webbing and the aft end and at the forward end take the lower strap around the mast (inside the halyards) and make it fast to the other side. The bag should be taut and smooth along the bottom as in photo at right. Both sets of reef lines can now be led down the inside of the bag and out the bottom and tied securely at the reef eye location. The forward upper webbing strap can now be fitted and is normally adjusted to be snug when the front flap is zipped closed. You can tighten it more to squeeze together the girth of the bag if you choose. This strap provides support should you choose to sail with the front flap tucked inside the bag. The aft eyelets can optionally be used to tidy up the trailing edge of the cover should you choose. Some like to tie a small line from the upper eyelets around the topping lift and back for an upward pull. In this photo we have utilized the eyelet on the rear of the boom to secure the lower eyelets. NOTE: In this picture you can clearly see that we have stretched the bag aft over the sail (which actually stops at the black band). 5

Last Look: These final photographs illustrate the bag from a few vantage points. Forward starboard view With forward flap folded back inside and secured to the hook and loop strip. Forward line with shortening loop and hitch. Clove hitch at batten Portside view with front flap closed and zipped. 6

Top view looking forward Close up view looking aft. 7