Page 1 of 8 MATERIAL SAFETY DATA SHEET SECTION 1 PRODUCT AND COMPANY IDENTIFICATION Not classified as hazardous according to criteria of National Occupational Health and Safety Commission. PRODUCT Product Name: PETROLEUM JELLY Product Description: Soft offwhite odourless paste Product Code: 1309 Intended Use: Ointment base, lubricant COMPANY IDENTIFICATION Supplier: Lidomont Pty Ltd ACN 010 867 428 trading as PROLUBE 15 Pinacle Street PO Box 5435 Brendale Queensland Australia 4500 Telephone: Australia Fax Internet Email 07 38811733 International +61738811733 07 38811708 International +61738811708 www.prolube.com.au admin@prolube.com.au SECTION 2 HAZARDS IDENTIFICATION Hazard Classification: NON-HAZARDOUS SUBSTANCE. NON-DANGEROUS GOOD. Refer to Section 15, Regulatory Information, for hazard classification criteria. POISON SCHEDULE NUMBER: None Allocated. HEALTH HAZARDS Low order of toxicity. Excessive exposure may result in eye, skin or respiratory irritation. Note: This material should not be used for any other purpose than the intended use in Section 1 without expert advice. Health studies have shown that chemical exposure may cause potential human health risks which may vary from person to person.
Page 2 of 8 SECTION 3 COMPOSITION / INFORMATION ON INGREDIENTS Reportable Hazardous Substance(s) or Complex Substance(s) Name CAS# Concentration* Symbols/Risk Phrases Petrolatum 8009-06-8 >60% Hydrocarbon Waxes 30-40% Other additives non hazardous <10% Stabiliser Additive 7695-91-2 0-20 ppm * All concentrations are percent by weight unless ingredient is a gas. Gas concentrations are in percent by volume. Other ingredients determined not to be hazardous up to 100%. SECTION 4 FIRST AID MEASURES INHALATION Should not normally cause irritation. Remove from further exposure. For those providing assistance, avoid exposure to yourself or others. Use adequate respiratory protection. If respiratory irritation, dizziness, nausea, or unconsciousness occurs, seek immediate medical assistance. If breathing has stopped, assist ventilation with a mechanical device or use mouth-to-mouth resuscitation. ADVICE TO DOCTOR: This product may present as an aspiration hazard. If spontaneous vomiting has occurred after ingestion, the patient should be monitored for difficult breathing, as adverse effects of aspiration into the lungs may be delayed for up to 48 hours. SKIN CONTACT Wash contact areas with soap and water. Remove contaminated clothing. Launder contaminated clothing before reuse. If product is injected into or under the skin, or into any part of the body, regardless of the appearance of the wound or its size, the individual should be evaluated immediately by a physician as a surgical emergency. Even though initial symptoms from high pressure injection may be minimal or absent, early surgical treatment within the first few hours may significantly reduce the ultimate extent of injury. EYE CONTACT Flush thoroughly with water. If irritation occurs, get medical assistance. INGESTION Do not induce vomiting aspiration of this product can cause serious lung injury pnuemonitis, Seek medical attention if discomfort occurs.
Page 3 of 8 SECTION 5 FIRE FIGHTING MEASURES EXTINGUISHING MEDIA Appropriate Extinguishing Media: Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish flames. FIRE FIGHTING Fire Fighting Instructions: Evacuate area. Prevent run-off from fire control or dilution from entering streams, sewers or drinking water supply. Fire-fighters should use standard protective equipment and in enclosed spaces, self-contained breathing apparatus (SCBA). Use water spray to cool fire exposed surfaces and to protect personnel. Hazardous Combustion Products: Oxides of carbon, Incomplete combustion products, Smoke, Fume. FLAMMABILITY PROPERTIES Flash Point [Method]: N/A Autoignition Temperature: N/D. Combustible Paste, will not burn unless preheated. Refer AS1940 SECTION 6 ACCIDENTAL RELEASE MEASURES NOTIFICATION PROCEDURES In the event of a spill or accidental release, notify relevant authorities in accordance with all applicable regulations. SPILL MANAGEMENT Product is easily contained. May be slippery. Dispose in approved disposal containers. ENVIRONMENTAL PRECAUTIONS Large Spills: Dyke around spill for later recovery and disposal. Prevent entry into waterways, sewers, basements or confined areas. SECTION 7 HANDLING AND STORAGE HANDLING Keep containers closed. Avoid personal contact. Prevent small spills to avoid slip hazards. STORAGE Do not store in open or unlabelled containers. Store in original containers. Store away from incompatible materials and foodstuff containers. Check regularly for leaks and physical damage.
Page 4 of 8 SECTION 8 EXPOSURE CONTROLS / PERSONAL PROTECTION Exposure limits/standards for materials that can be formed when handling this product: NOTE: Limits/standards shown for guidance only. Follow applicable regulations. Biological limits No biological limits allocated. ENGINEERING CONTROLS Use and with adequate ventilation. PERSONAL PROTECTION Personal protective equipment selections vary based on potential exposure conditions such as applications, handling practices, concentration and ventilation. Information on the selection of protective equipment for use with this material, as provided below, is based upon intended, normal usage. Respiratory Protection: No special requirements under ordinary conditions of use and with adequate ventilation. Hand Protection: Any specific glove information provided is based on published literature and glove manufacturer data. Glove suitability and breakthrough time will differ depending on the specific use conditions. Contact the glove manufacturer for specific advice on glove selection and breakthrough times for your use conditions. Inspect and replace worn or damaged gloves. The types of gloves to be considered for this material include: Chemical resistant, Nitrile, Viton Eye Protection: If contact is likely, safety glasses with side shields are recommended. Skin and Body Protection: Any specific clothing information provided is based on published literature or manufacturer data. The types of clothing to be considered for this material include: Long sleeve and long pants will provide protection. Specific Hygiene Measures: Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. Discard contaminated clothing and footwear that cannot be cleaned. Practise good housekeeping.
Page 5 of 8 SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES Typical physical and chemical properties are given below. Consult the Supplier in Section 1 for additional data. GENERAL INFORMATION Physical State: White translucent paste Colour: White Odour: Practically Odourless Odour Threshold: N/D IMPORTANT HEALTH, SAFETY, AND ENVIRONMENTAL INFORMATION Relative Density (at 15 C): 0.86 0.92 Flash Point [Method]: >170 o C Flammable Limits (Approximate volume % in air): N/A Autoignition Temperature: N/A Melting Point: 30-62 o C Boiling Point / Range: 343 o C Vapour Density (Air = 1): > 1.0 Vapour Pressure: < 0.1 mmhg Evaporation Rate (N-Butyl Acetate = 1): N/A ph: N/A Solubility in Water: Negligible Viscosity: N/A SECTION 10 STABILITY AND REACTIVITY STABILITY: Material is stable under normal conditions. CONDITIONS TO AVOID: Excessive heat. High energy sources of ignition. INCOMPATIBLE MATERIALS: Strong oxidisers HAZARDOUS DECOMPOSITION PRODUCTS: Material does not decompose at ambient temperatures. HAZARDOUS REACTIONS: Will not occur
Page 6 of 8 SECTION 11 TOXICOLOGICAL INFORMATION Acute Toxicity Route of Exposure INHALATION Toxicity (Rat): LC50 > 5000 mg/m³ Irritation: INGESTION Toxicity (Rat): LD50 > 2000 mg/kg Skin Toxicity (Rabbit): LD50 > 3600 mg/kg Irritation (Rabbit): Eye Irritation (Rabbit): Conclusion / Remarks Practically non toxic, based on test data of similar materials N/A Practically non toxic, based on test data of similar materials Practically non toxic, based on test data of similar materials N/A. N/A CHRONIC/OTHER EFFECTS For the product itself: Not expected to cause dermal sensitisation. Not carcinogenic in animal tests based on data from similar materials. Contains: Refined base oil SECTION 12 ECOLOGICAL INFORMATION The information given is based on data available for the material, the components of the material, and similar materials. ECOTOXICITY Material -- Expected to be harmful to aquatic organisms. MOBILITY Stable, non mobile. Floats on water. Expected to migrate from water to land. PERSISTENCE AND DEGRADABILITY Biodegradation: Expected to be inherently biodegradable. BIOACCUMULATION POTENTIAL Limited potential for bioaccumulation
Page 7 of 8 SECTION 13 DISPOSAL CONSIDERATIONS Disposal recommendations based on material as supplied. Disposal must be in accordance with current applicable laws and regulations, and material characteristics at time of disposal. DISPOSAL RECOMMENDATIONS Product is suitable for burning in an enclosed controlled burner for fuel value or disposal by incineration at very high temperatures. Empty Container Warning Empty Container Warning (where applicable): Empty containers may contain residue and can be dangerous. Do not attempt to refill or clean containers without proper instructions. Empty drums should be completely drained and safely stored until appropriately reconditioned or disposed. Empty containers should be taken for recycling, recovery, or disposal through suitably qualified or licensed contractor and in accordance with governmental regulations. DO NOT PRESSURISE, CUT, WELD, BRAZE, SOLDER, DRILL, GRIND, OR EXPOSE SUCH CONTAINERS TO HEAT, FLAME, SPARKS, STATIC ELECTRICITY, OR OTHER SOURCES OF IGNITION. THEY MAY EXPLODE AND CAUSE INJURY OR DEATH. SECTION 14 LAND (ADG) : Not Regulated for Land Transport TRANSPORT INFORMATION SEA (IMDG) : Not Regulated for Sea Transport according to IMDG-Code AIR (IATA) : Not Regulated for Air Transport SECTION 15 REGULATORY INFORMATION Material is not hazardous as defined by the Approved Criteria for Classifying Hazardous Substances NOHSC:1008. Product is not regulated according to Australian Dangerous Goods Code. No Poison Schedule number allocated by the Standard for the Uniform Scheduling of Drugs and Poisons (SUSDP) established under the Therapeutic Goods Act. SECTION 16 OTHER INFORMATION KEY TO ABBREVIATIONS AND ACRONYMS: N/D = Not determined, N/A = Not applicable, STEL = Short-Term Exposure Limit, TWA = Time-Weighted Average THIS SAFETY DATA SHEET CONTAINS THE FOLLOWING REVISIONS: Original Version 20/10/10 Update Ingredients and Physical Characteristics 17/2/11 12/1/12 Address change -------------------------------------------------------------------------------------------------------------------------------------------------- ---
Page 8 of 8 The information and recommendations contained herein are, to the best of Prolube s knowledge and belief, accurate and reliable as of the date issued. You can contact Prolube to insure that this document is the most current available from Prolube. The information and recommendations are offered for the user's consideration and examination. It is the user's responsibility to satisfy itself that the product is suitable for the intended use. If buyer repackages this product, it is the user's responsibility to insure proper health, safety and other necessary information is included with and/or on the container. Appropriate warnings and safe-handling procedures should be provided to handlers and users. Prepared By: Contact Point: Lidomont Pty Ltd 15 Pinacle Street Brendale Queensland Australia 4500 See Section 1 for Local Contact number End of MSDS