Safety Data Sheet Page 1 of 5

Transcription

1 Safety Data Sheet Page 1 of 5 TEROSON VR 500 SDS No. : V001.4 Revision: printing date: Section 1. Identification of the substance/preparation and of the company/undertaking Product name: TEROSON VR 500 Other means of identification: TEROSON VR 500 BG5,5ML DE Product code: IDH Recommended use of the chemical and restrictions on use Intended use: High temperature grease Identification of manufacturer, importer or distributor Importer: Henkel Adhesive Technologies Vietnam Co., Ltd, No. 7, Road 9A Bien Hoa II Industrial Zone, Bien Hoa City, Dong Nai Province, Vietnam Phone: Fax: address of person responsible for Safety Data Sheet: Emergency information: ap-ua-psra.sea@henkel.com FOR EMERGENCIES ONLY (Spill, major leak, Fire, Exposure, or Accident). Call CHEMTREC: Section 2. Hazards identification GHS Classification: GHS label elements: Substance or mixture is not classified as hazardous according to Globally Harmonized System(GHS). Substance or mixture is not classified as hazardous according to Globally Harmonized System(GHS). Substance or Mixture: Mixture Declaration of hazardous chemical: Section 3. Composition / information on ingredients Does not contain ingredients or impurities which contribute to hazard classification.

2 Page 2 of 5 Section 4. First aid measures Inhalation: Skin contact: Eye contact: Ingestion: Move to fresh air, consult doctor if complaint persists. Rinse with running water and soap. Apply replenishing cream. Change all contaminated clothing. Rinse immediately with plenty of running water (for 10 minutes). Seek medical attention if necessary. Rinse mouth, drink 1-2 glasses of water, do not induce vomiting, consult a doctor. Indication of immediate medical attention and special treatment needed: See section: Description of first aid measures Section 5. Fire fighting measures Suitable extinguishing media: Improper extinguishing media: Specific hazards arising from the chemical: Special protection equipment and precautions for firefighters: All common extinguishing agents are suitable. High pressure waterjet In case of fire toxic gases can be released. Wear self-contained breathing apparatus. Section 6. Accidental release measures Personal precautions: Environmental precautions: Clean-up methods: Do not empty into drains / surface water / ground water. Remove mechanically. Dispose of contaminated material as waste according to Section 13. Section 7. Handling and storage Handling: Storage: Avoid contact with e, skin and clothing. Avoid breathing vapors or mists of this product. Remove all sources of ignition. Ensure good ventilation/extraction.store in a cool, dry place.

3 Page 3 of 5 Section 8. Exposure controls / personal protection Respiratory protection: Hand protection: Eye protection: Body protection: Engineering controls: General protection and hygiene measures: Hygienic measures: In case of aerosol formation, we recommend wearing of appropriate respiratory protection equipment with ABEK P2 filter (EN 14387). This recommendation should be matched to local conditions. Chemical-resistant protective gloves (EN 374). Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes permeation time as per EN 374): Polychloroprene (CR; >= 1 mm thickness) or natural rubber (NR; >=1 mm thickness) Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time as per EN 374): Polychloroprene (CR; >= 1 mm thickness) or natural rubber (NR; >=1 mm thickness) This information is based on literature references and on information provided by glove manufacturers, or is derived by analogy with similar substances. Please note that in practice the working life of chemical-resistant protective gloves may be considerably shorter than the permeation time determined in accordance with EN 374 as a result of the many influencing factors (e.g. temperature). If signs of wear and tear are noticed then the gloves should be replaced. Protective goggles Protective eye equipment should conform to EN166. Protective clothing should conform to EN for liquid splashes or to EN for dusts. Ensure good ventilation/extraction. Eyewash fountains and emergency showers are required. Wash hands before work breaks and after finishing work. Do not eat, drink or smoke while working. Section 9. Physical and chemical properties Appearance: brownish pasty, solid material Odor: characteristic Odor threshold (CA): ph: Melting point / freezing point: Specific gravity: Boiling point: Flash point: Not applicable Evaporation rate: Flammability (solid, gas): Lower explosive limit: Upper explosive limit: Vapor pressure: Vapor density: Density: 0.9 g/cm3 Solubility: Partition coefficient: n- octanol/water: Auto ignition: Decomposition temperature: Viscosity: 100, ,000 mpa.s

4 Page 4 of 5 (Physica Rheolab; 23 C (73.4 F); Method: ;; Viscosity Physica; HT-Method) VOC content: Section 10. Stability and reactivity Reactivity/Incompatible materials: Chemical stability: Conditions to avoid: Hazardous decomposition products: None if used for intended purpose. Stable under recommended storage conditions. None if used for intended purpose. No decomposition if used according to specifications. Section 11. Toxicological information General toxicological information: Symptoms of Overexposure: To the best of our knowledge no harmful effects are to be expected if the product is handled and used properly. Section 12. Ecological information General ecological information: Do not empty into drains, soil or bodies of water. Section 13. Disposal considerations Product Method of disposal: In consultation with the responsible local authority, must be subjected to special treatment. Packaging Disposal of uncleaned packages: Packaging that cannot be cleaned are to be disposed of in the same manner as the product. Section 14. Transport information General information: Not hazardous according to RID, ADR, ADN, IMDG, IATA-DGR.

5 Page 5 of 5 Section 15. Regulatory information Regulatory Information: Circular No 04/2012/TT-BCT, dtd 13Feb2012 (Regulations On The Classification And Labeling Of Chemicals) Global inventory status: Regulatory list EINECS TSCA AICS DSL ENCS (JP) KECI (KR) PICCS (PH) IECSC NZIOC Notification Section 16. Other information Disclaimer: This information is based on our current level of knowledge and relates to the product in the state in which it is delivered. It is intended to describe our products from the point of view of safety requirements and is not intended to guarantee any particular properties.