MATERIAL SAFETY DATA SHEET

Transcription

1 MATERIAL SAFETY DATA SHEET MEGA GUARD PLUS (03) 15W-40 MEGA POWER 8565A Somerset Drive Largo, FL Tel: MSDS on-line: National Fire Protection Association HMIS Rating MSDS No: 367 Ver. No: 2 Ver. Date: 1/2/ HOUR EMERGENCY NUMBERS: CUSTOMER SERVICE: Protective Equipment: 1 Health Health 1 1 Flammability Flammability 1 0 Reactivity Reactivity 0 0 Special Special 0 SECTION 1 CHEMICAL PRODUCT AND COMPANY IDENTIFICATION Product Name: MEGA GUARD PLUS (03) 15W-40 Product Description: Chemical Name: Chemical Family: Product Odor: Blend Mild Hydrocarbon Odor Product Code: 367 Product Appearance: Brown Transparent General Use: Manufacturer: MEGA POWER 8565A Somerset Drive Largo, FL SECTION 2 COMPOSITION / INFORMATION ON INGREDIENTS EXPOSURE GUIDELINES OSHA ACGIH Component/CAS Number LO% HI% TWA STEL TWA STEL UNIT Limits for the Product 5 5 MG/M3 Additional Exposure Limits Government Regulation OTHER LIMIT OIL MIST: 5MG'M3 OSHA PEL'ACGIH TLV. SECTION 3 HAZARDOUS IDENTIFICATION (HMIS) FOR DISCLAIMER OF LIABILITY SEE FINAL PAGE Page 1 of 5

2 Route(s) of Entry Inhalation: Skin: Ingestion: Eyes: Target Organs: Effects of overexposure: Effects of overexposure: Acute:. Chronic:. Medical Conditions Generally Aggravated by Long-Term Exposure: None expected. Chronic Effects: Carcinogenicity NTP: IARC Monographs: OSHA Regulations: ACGIH No effects expected. Practically non-toxic if absorbed. May cause moderate irritation with prolonged or repeated contact. Obtain emergency medical attention. Small amounts which accidentally enter mouth should be rinsed out until taste of substance is no longer detected. Expected to be a minor eye irritant.. Contact with the eyes may damage delicate eye tissue. Ingestion may cause mouth, throat and gastrointestinal irritation. Inhalation of harmful levels of vapors is unlikely due to the relatively low vapor pressure. SECTION 4 FIRST AID MEASURES Emergency and First Aid Procedures: Eye contact: Flush eyes with large amounts of water for at least 15 minutes. If irritation persists, obtain medical attention. Skin contact: Ingestion: Inhalation: Note to Physicians: Treat symptomatically Special Precautions/Procedures: SECTION 5 FIRE-FIGHTING MEASURES Wash affected area thoroughly with soap and water until no odor remains. If redness or swelling develops, obtain medical assistance. Wash clothing before reuse. Practically non-toxic. Induction of vomiting not required. Obtain medical emergency medical attention. Small amounts which accidentally enter mouth should be rinsed out until taste of substance is no longer detected. Move to fresh air. Extinguishing Media: Flash Point: Flash Point Method: Auto Ignition Temperature: Flammable (Explosive) Limits (% by volume in air): Flammability Classification: Fire-Fighting Instructions; Fire-Fighting Equipment: Water spray, dry chemical, carbon dioxide (CO2), foam. 421 ºF Minimum, 216 ºC Minimum Cleveland Open Cup 675 ºF (Estimated) 359 ºC (Estimated) Lower: Not Applicable Upper: Not Applicable Not Flammable NFPA This material will burn although it is not easily ignited. For fires involving this material, do not enter any confined space without proper PPE, including an SCBA. Fire may produce toxic thermal decomposition products; wear an (SCBA) FOR DISCLAIMER OF LIABILITY SEE FINAL PAGE Page 2 of 5

3 Hazardous Combustion Products: Highly dependent on combustion conditions. A complex mixture forms when this material undergoes combustion. Examples: carbon dioxide, water vapor, unidentified organic compounds. SECTION 6 ACCIDENTAL RELEASE MEASURES Spill/Leak Procedures: Small Spills: Large Spills: Containment: Regulatory Requirements: Precautionary Measures: Static Hazard: Storage Requirements: Ventilation: Recover usable material by convenient method; residual may be removed by wipe or wet mop Small spills should be absorbed with a suitable inert material (sand, earth, clay, etc.). Remove the absorbed material and place in an appropriate chemical waste container for disposal. For large spills, dike and pump into suitable containers. Clean up residual with suitable inert material.. For large spills, dike far ahead of liquid spill for later disposal. Follow applicable Federal, State and Local regulations. SECTION 7 HANDLING AND STORAGE Keep out of reach of children. Electrostatic charge may accumulate and create a hazardous condition when handling this material. To minimize this hazard, bonding and grounding may be necessary but may not, by themselves, be sufficient. NFPA Class IIIB Storage. SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION Ventilate as needed to comply with exposure limit. General dilution ventilation acceptable. Personal Protective Equipment Eye: Gloves: Splash proof chemical goggles recommended to protect against splash of product. Protective gloves recommended when prolonged skin contact cannot be avoided. The following glove materials are acceptable: polyvinyl chloride (PVC); neoprene; nitrile; polyvinyl alcohol; viton. Respirator: Concentration in air determines protection needed. Use only NIOSH certified respiratory protection. Respiratory protection usually not needed unless product is heated or misted. Half-mask air purifying respirator with dust/mist filters or HEPA filter cartridges is acceptable to 10 times the exposure limit. Full face air purifying respirator with dust/mist filters of HEPA filter cartridges is acceptable to 50 times the exposure limit. Protection by air purifying respirators is limited. Use a positive pressure demand full face supplied air respirator or SCBA for exposures above 50X the exposure limit. If exposure is above IDLH (immediately dangerous to life and health) or there is the possibility of an uncontrolled release or exposure levels are unknown then use a positive pressure demand full face supplied air respirator with escape bottle or SCBA. Other: If contact is unavoidable, wear chemical resistant clothing. The following materials are acceptable as protective clothing materials: polyvinyl alcohol (PVA); polyvinyl chloride (PVC); neoprene; nitrile; viton; polyurethane; launder soiled clothes. Protective Clothing/Equipment: Safety Stations: Appearance and odor: Pour Point, ºC: Make emergency eyewash stations, safety/quick-drench showers, and washing facilities available in work area. SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES Amber Fluid, Motor Oil Odor -34 (Estimated) FOR DISCLAIMER OF LIABILITY SEE FINAL PAGE Page 3 of 5

4 Specific Gravity (water =1): (Estimated) API Gravity: 31.0 (Estimated) 25 ºC, cst: Negligible Vapor Density (Air =1): >1 Solubility: Soluble in hydrocarbons; almost completely insoluble in water Boiling Point: >315 ºC (599 ºF) SECTION 10 STABILITY AND REACTIVITY Stability: Hazardous Polymerization: Materials to Avoid: Conditions to Avoid: Hazardous Decomposition: Stable Will not occur. Strong oxidizing agents. Strong oxidizing agents. Combustion will produce carbon monoxide and asphyxiants. SECTION 7 - REACTIVITY DATA This product is stable and will not react violently with water. Hazardous polymerization will not occur. Avoid contact with strong oxidants such as liquid chlorine, concentrated oxygen, sodium hypochlorite or calcium hypochlorite. The Alkyl Nitrate in this product may undergo a self - accelerating exothermic reaction if heated abov e 150 C. (302 F.) SECTION 11 TOXICOLOGICAL INFORMATION Eye Effects: Skin Effects: Acute Inhalation Effects: Acute Oral Effects: Chronic Effects: Mutagenicity: Teratogenicity: Ecotoxicity: Environmental Fate: Waste disposal method: Container Cleaning and Disposal: DOT Shipping Name: Shipping Symbols: Hazard Class: DOT Identification No.: Packing Group: Label: Packaging Authorizations: Mildly irritating on contact. Expected to be acutely non-toxic if absorbed. Expected to have low acute toxicity. Expected to be practically non-toxic... SECTION 12 ECOLOGICAL INFORMATION No Data Available. This material is not expected to be readily biodegradable. SECTION 13 DISPOSAL CONSIDERATIONS Do not flush to drain/sewer. Contact an authorized disposal service. Disposal should be in accordance with all applicable federal, state and local laws and regulations. Containers should be cleaned of residual product before disposal, and disposed of in accordance with all applicable laws and regulations. SECTION 14 TRANSPORT INFORMATION Non-Hazardous Petroleum Lubricating Oil FOR DISCLAIMER OF LIABILITY SEE FINAL PAGE Page 4 of 5

5 Quantity Limitations: None SECTION 15 REGULATORY INFORMATION EPCRA 311/312 Categories: 1. Immediate (Acute) Health Effects: NO Regulatory Lists Searched: 01-1=IARC Group A=IARC Group 2A 01-2B=IARC Group 2B 02=NTP Carcinogen 03=EPCRA =CA Proposition 65 05=MA RTK 06=NJ RTK 07=PA RTK The following components of this material are found on the above regulatory lists. Zinc dialkyldithiophosphate 03, 06 Chemical Inventories: All components comply with TSCA (United States). New Jersey RTK Classification: Under the New Jersey Right-to-Know Act L Chapter 315 N.J.S.A. 34:5A-1 et. Seq., the product is to be identified as follows: Petroleum Oil (Motor Oil). WHMIS Classification: This product is not considered a controlled product according to the criteria of the Canadian Controlled Products Regulations. OSHA Regulations: Must comply with OSHA standard 29 CFR (employee right to know) SECTION 16 OTHER INFORMATION Prepared By: MEGA POWER Disclaimer: THE INFORMATION GIVEN HEREIN IS GIVEN IN GOOD FAITH AND FROM SOURCES WE BELIEVE RELIABLE. BUT NO WARRANTY, EXPRESS OR IMPLIED, REGARDING ITS CORRECTNESS IS MADE. The conditions or methods of handling, storage, use and disposal of this product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of this product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not apply. CONSULT MEGA POWER FOR FURTHER INFORMATION FOR DISCLAIMER OF LIABILITY SEE FINAL PAGE Page 5 of 5