BLUESIL V-240 A Version: 6.0 Revision date: 02/12/2014 SAFETY DATA SHEET. No adverse effects due to ingestion are expected.

Transcription

1 1 PRODUCT AND COMPANY IDENTIFICATION Product identifier: Product name: BLUESIL V-240 A Synonyms, Trade Names: RHODORSIL V-240 A SAFETY DATA SHEET Manufacturer: Bluestar Silicones USA Corp Park Place Road York, SC Supplier: Bluestar Silicones USA Corp. Two Tower Blvd, Suite East Brunswick, NJ Telephone: +1 (803) Fax: +1 (803) Telephone: +1 (732) Fax: +1 (732) Emergency telephone number: +1 (800) CHEMTREC 2 HAZARDS IDENTIFICATION Emergency Overview: Appearance: Color: Form : Physical State : Odor: Potential Health Effects: General Potential Physical / Chemical Effects: Inhalation: Skin: Eye: Ingestion: Environment: Beige. Viscous. Liquid Odorless This material is not considered hazardous by the OSHA Hazard Communication Standard, OSHA 29 CFR None known. No adverse effects due to inhalation are expected. Quartz : When encapsulated in a polymer, is not expected to pose a health hazard when processed under normal conditions of use. : When encapsulated in polymer, it is not expected to pose a health hazard when processed under normal conditions Non-irritating. Non-irritating. No adverse effects due to ingestion are expected. Not regarded as dangerous for the environment. MSDS_US 1/6

2 OTHER INFORMATION No other information noted. 3 COMPOSITION / INFORMATION ON INGREDIENTS Mixture General information: Mixture of Polyorganosiloxanes, fillers, additives. Hazardous Component(s): Chemical name CAS-No. Concentration % % * All concentrations are percent by weight unless ingredient is a gas. Gas concentrations are in percent by volume. 4 FIRST AID MEASURES General: Inhalation: Skin contact: Eye contact: Ingestion: Notes to the physician: Hazards: Treatment: For further information refer to section 8 "Exposure-controls/personal protection". Under normal conditions of intended use, this material is not expected to be an inhalation hazard. Remove contaminated clothing and shoes. Immediately wipe excess material off skin with a dry cloth; then wash skin with plenty of soap and water. Seek medical attention if irritation develops or persists. In case of contact, immediately absorb excess with clean absorbent cloth or cotton. Then, hold eyelids open and flush with a steady, gentle stream of water for at least 15 minutes. Seek medical attention if irritation develops or persists or if visual changes occur. Do not induce vomiting. Rinse mouth thoroughly. Get medical attention if symptoms occur. No specific recommendations. No specific recommendations. 5 FIRE-FIGHTING MEASURES Extinguishing media: Unsuitable extinguishing media: Unusual Fire & Explosion Hazards: Special fire fighting procedures: Protective Measures: Water spray, fog, CO2, dry chemical, or alcohol resistant foam. None known. Product will burn under fire conditions. Hazardous decomposition products : formaldehyde, oxides of carbon and silica. No specific recommendations. Firefighters should wear NIOSH/MSHA approved self-contained breathing apparatus and full protective clothing. Use water to keep fire exposed containers cool and disperse vapors. 6 ACCIDENTAL RELEASE MEASURES Personal precautions: Use personal protective equipment. See Section 8 of the MSDS for Personal MSDS_US 2/6

3 Protective Equipment. Environmental precautions: Spill Cleanup Methods: Notification Procedures: Do not allow to enter drains, sewers or watercourses. Absorb with inert material. Scrape up and place in appropriate closed container see Section 7 of the MSDS. Caution: Contaminated surfaces may be slippery. For waste disposal, see section 13 of the MSDS. 7 HANDLING AND STORAGE Handling: Storage: See Section 8 of the MSDS for Personal Protective Equipment. Store in original container. Store in a cool and well-ventilated place. 8 EXPOSURE CONTROLS / PERSONAL PROTECTION Exposure limits Protective Measures: Respiratory Protection: Eye protection: Skin and Body Protection: Hygiene measures: Quartz : When encapsulated in a polymer, is not expected to pose a health hazard when processed under normal conditions of use. : When encapsulated in polymer, it is not expected to pose a health hazard when processed under normal conditions No specific precautions. No protection is ordinarily required under normal conditions of use and with adequate ventilation. This product can form formaldehyde vapors when heated to temperatures above 150 degrees C in the presence of air. Wear approved chemical safety glasses with side shields or goggles. It is a good industrial hygiene practice to minimize skin contact. Wear suitable protective clothing and gloves. Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. 9 PHYSICAL AND CHEMICAL PROPERTIES Appearance Physical State: Form: Color: Odor: Odor Threshold: ph: Freezing point: Boiling Point: Flash Point: Evaporation Rate: Flammability (solid, gas): Flammability Limit - Upper (%) : Flammability Limit - Lower (%) : Liquid Viscous. Beige. Odorless Not applicable > 500 F (260 C) > 399 F (204 C) (Pensky-Martens Closed Cup) MSDS_US 3/6

4 Vapor pressure: Vapor density (air=1): Relative density: Solubility(ies) Solubility in Water: Solubility (other): Partition coefficient (n-octanol/water): Autoignition Temperature: Decomposition Temperature: Viscosity: Explosive properties: Oxidizing properties: Insoluble in water 10 STABILITY AND REACTIVITY Stability: Possibility of hazardous reactions: Conditions to avoid: Incompatible materials: Hazardous decomposition products: Stable Will not occur. No other information noted. Strong oxidizers, strong acids, and strong bases. Thermal decomposition may liberate dimethylcyclosiloxanes and methylphenylcyclosiloxanes. This product can form formaldehyde vapors when heated to temperatures above 150 degrees C in the presence of air. 11 TOXICOLOGICAL INFORMATION Specified substance(s): Acute Toxicity (Oral); Name Test results LD 50 (Rat): 6,450 mg/kg Inhalation: Ingestion: Skin corrosion/irritation: Serious eye damage/eye irritation: Respiratory sensitizer/skin sensitizer: Carcinogenicity: The following components have been identified as having carcinogenic properties Name CAS-No. Concentration % Mutagenesis: MSDS_US 4/6

5 Reproductive toxicity: 12 ECOLOGICAL INFORMATION Ecotoxicity: Specified substance(s): Acute toxicity(fish): Name Persistence and degradability: Bioaccumulative potential: Mobility: Test results LC 50 (Western mosquitofish (Gambusia affinis), 96 h): > 56,000 mg/l Mortality 13 DISPOSAL CONSIDERATIONS Disposal methods: Dispose of waste at an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal. 14 TRANSPORT INFORMATION This material is not subject to transport regulations. Environmental hazards: Special precautions for user: Not regulated. No special precautions. 15 REGULATORY INFORMATION Inventory Status: Australia AICS: Canada DSL Inventory List: EU EINECS List: Japan (ENCS) List: China Inv. Existing Chemical Substances: Korea Existing Chemicals Inv. (KECI): Philippines PICCS: US TSCA Inventory: New Zealand Inventory of Chemicals: Not in compliance with the inventory. US Regulations CERCLA Hazardous Substance List (40 CFR 302.4): Clean Water Act Section 311 Hazardous Substances (40 CFR 117.3): Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR ): SARA Title III Section 302 Extremely Hazardous Substance (40 CFR 355, Appendix A): MSDS_US 5/6

6 Section 311/312 (40 CFR 370): Acute (Immediate) Chronic (Delayed) Fire Reactive Pressure Generating Section 313 Toxic Release Inventory (40 CFR 372): State Regulations California Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65): Carcinogenic. Massachusetts Right-To-Know List: New Jersey Right-To-Know List: Pennsylvania Right-To-Know List: 16 OTHER INFORMATION HMIS Hazard ID HEALTH 1 B - Safety Glasses & Gloves FLAMMABILITY 1 PHYSICAL HAZARDS 0 PERSONAL PROTECTION B NFPA Hazard ID Hazard rating: 0 - Minimal; 1 - Slight; 2 - Moderate; 3 - Serious; 4 - Severe; *Chronic health effect Flammability Health Reactivity Special hazard. Hazard rating: 0 - Minimal; 1 - Slight; 2 - Moderate; 3 - Serious; 4 - Severe Revision Information: Issue date: 02/12/2014 SDS No.: Disclaimer: The information given is based on data available for the material, the components of the material, and similar materials. The information is believed to be correct. It is given in good faith. This information should be used to make an independent determination of the methods to safeguard workers and the environment. MSDS_US 6/6