SENTINEL SEN-NO-FREEZE

Transcription

1 SEN-NO-FREEZE (PIN# 02120) Page 1 of 5 MATERIAL SAFETY DATA SHEET G MSDS FORMAT MEETS ANSI Z AND OSHA SENTINEL SEN-NO-FREEZE REVISION# 1 MSDS # REVISION DATE: January 2, CHEMICAL PRODUCT AND COMPANY IDENTIFICATION Sentinel SEN-NO-FREEZE PRODUCT NUMBER (S): SYNONYM: Sentinel s SEN-NO-FREEZE COMPANY IDENTIFICATION EMERGENCY TELEPHONE NUMBERS Sentinel Lubricants Corp. HEALTH (24 hr) : (800) or (305) N.W. 15 th Ave. TRANSPORTATION (24 hr) : (800) Miami, FL or (305) Int l collect calls accepted PRODUCT INFORMATION: MSDS Requests: (800) Environmental, Safety, & Health Info: (800) Product Information: (800) COMPOSITION/INFORMATION ON INGREDIENTS 100% SENTINEL S SEN-NO-FREEZE COMPONENTS OSHA PEL ACGIH TLV IDLH Hazardous Materials Identification Systems (HMIS) Acute Health Fire Reactivity HMIS NFPA Severe 4 Extreme Serious 3 High Moderate 2 Moderate Slight 1 Slight Minimal 0 Insignificant -1-

2 Continue SEN-NO-FREEZE (PIN# 02120) Page 2 of 5 3. HAZARD IDENTIFICATION AND EMERGENCY AND FIRST AID PROCEDURES POTENTIAL HEALTH EFFECTS EYE: If splashed into the eyes, flush with clear water for 15 minutes or until irritation subsides. If irritation persists, call a physician. SKIN Thoroughly wash exposed area with soap and water. Remove contaminated clothing. Launder contaminated clothing before re-use. Remove contaminated shoes promptly. Discard shoes saturated with this product. INGESTION Do Not induce vomiting. Immediately drink two glasses of water. Never give anything by mouth to an unconscious person. Call physician or transport to an emergency facility. INHALATION Vapor pressure is very low. Vapor inhalation under ambient conditions is normally not a problem. If overcome by vapors from hot product, immediately remove from exposure and call a physician. If breathing is irregular or has stopped, start resuscitation; administer oxygen, if available. If overexposed to oil mist, remove from further exposure until excessive oil mist condition subsides. 4. FIRE AND EXPLOSION HAZARD INFORMATION Flash Point (Minimum) Auto ignition Temperature 218 F (103 C) Greater Than, Not Determined National Fire Protection Association (NFPA) Hazard Identification Health Flammability Reactivity Handling Precautions Use product with caution around heat, sparks, pilot lights, static electricity and open flame. Flammable or Explosive Limits (Approximately Percent by Volume in Air) Lower Flammable Limit: 2.6 % Upper Flammable Limit: 12.5 % Extinguishing Media Water Fog, Alcohol Foam, CO2, Dry Chemical Firefighting Procedures N/A Empty Container Warning Empty containers retain residue (liquid and/or vapor) and can be dangerous. Do Not pressurize, cut, weld, braze, solder, drill, grind or expose such containers to heat, flame, sparks, static electricity, or other sources of ignition; they may explode and cause injury or death. Do not attempt to clean since residue is difficult to remove. Empty drums should be completely drained, properly bunged and promptly returned to a drum re-conditioner. All other containers should be disposed of in an environmental safe manner and in accordance with governmental regulations. For work on tanks refer to Occupational Safety and Health Administration regulations. ANSI Z49.1, and other governmental and industrial references pertaining to cleaning, repairing, welding, or other contemplated operations. Special Fire and Explosion Hazards Can react with chemically reactive metals such as aluminum, zinc, magnesium, copper, etc. to release hydrogen gas, which can form explosive mixtures with air. -2-

3 Continue SEN-NO-FREEZE (PIN# 02120) Page 3 of 5 5. HEALTH AND HAZARD INFORMATION Variability Among Individuals As a precaution, exposure to liquids, vapors, mists, or fumes should be minimized. Effects of Overexposure (Sings and Symptoms of exposure) Eyes- causes severe irritation and damage, which is likely to lead to impairment or loss of vision. Skin- can cause severe irritation and excessive or prolonged contact can result in blisters and burns. Inhalation- due to the physical nature of this product. Inhalation is unlikely. Ingestion- may cause gastrointestinal irritation. Oral toxicity is low. Pre-Existing Medical Conditions which may be Aggravated by Exposure None recognized 6. PHYSICAL DATA The following data are approximate or typical values and should not be used for precise design purposes. ph: Neutral 7 VAPOR PRESSURE: 0.8 mm C, 68 F VAPOR DENSITY (AIR = 1): 2.62 BOILING RANGE: 370 F (188 C) MOLECULAR WEIGHT: Not Determined SPECIFIC GRAVITY: (H20 = 1) EVAPORATION RATE: < 0.01 PERCENT VOLATILE BY VOLUME: Negligible from open container in 4 38 C (100 F) SOLUBILITY IN 1 ATM and 25 C (77 F) Complete POUR CONGEALING Not Determined (MELTING POINT) Pour Point by ASTM D 97-3-

4 Continue SEN-NO-FREEZE (PIN# 02120) Page 4 of 5 7. REACTIVITY Stability ( ) Unstable ( X) Stable Incompatibility (materials to avoid): Oxidizing materials Hazardous Polymerization: ( ) May occur (X) Will not occur Hazardous Decomposition Products: Propionaldehyde, CO in the presence of limited oxygen in a fire situation. 8. PROTECTION AND PRECAUTIONS VENTILATION Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below TLV (s). PROTECTIVE GLOVES: Use chemical-resistant gloves such as: neoprene, nitrile rubber RESPIRATORY PROTECTION If work place exposure limit (s) of product or any component is exceeded. A NIOSH/MSHA approved air supplied respirator is advised in absence of proper environmental control. OSHA regulations also permit other NIOSH/MSHA respirators (negative pressure type) under specified conditions (see your safety equipment supplier). Engineering or administrative controls should be implemented to reduce exposure. OTHER PROTECTIVE EQUIPMENT To prevent skin contact, wear impervious clothing and boots. -4-

5 Continue SEN-NO-FREEZE (PIN# 02120) Page 5 of 5 9. ENVIRONMENTAL INFORMATION STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED Small Spill: Absorb liquid on paper, vermiculite, floor absorbent, or other absorbent material and transfer to hood. Flush area with water. Large Spill: Persons not wearing protective equipment should be excluded from area of spill until clean up has been completed. Stop spill at source, dike area of spill to prevent spreading, pump liquid to salvage tank. Remaining liquid may be taken up on sand, clay, earth, floor absorbent material and shoveled into containers. WASTE DISPOSAL METHOD Small Spill: Dispose of in accordance with all local, state and federal regulations. Large Spill: Dispose of in accordance with all local, state and federal regulations. EPA Hazard Classification Code: ACUTE CHRONIC FIRE PRESSURE REACTIVE Hazard Hazard Hazard Hazard Not Applicable XXXXX 10. TRANSPORTATION INFORMATION TRANSPORTATION INCIDENT INFORMATION For further information relative to spills resulting from transportation, refer to latest Department of Transportation Emergency Guidebook for Hazardous Materials Incidents, DOT P DOT IDENTIFICATION NUMBER Not Applicable The information and recommendations contained herein are, to the best of Sentinel s knowledge and belief, accurate and reliable as of the date issued. Sentinel does not warrant or guarantee their accuracy or reliability and Sentinel s shall not be liable for any loss or damage arising out of the use thereof. The information and recommendations are offered for the user s consideration and examination, and it is the user s responsibility to satisfy itself that they are suitable and complete for its particular use. The Environmental Information included under Section 9 hereof as well as the Hazardous Materials Identification System (HMIS) and National Fire Protection Association (NFPA) ratings have been included by Sentinel Lubricants in order to provide additional health and hazard classification information. The ratings recommended are based upon the criteria supplied by the developers of these rating systems, together with Sentinel s interpretation of the available data. FOR ADDITIONAL INFORMATION ON HEALTH EFFECTS CONTACT: Director of Industrial Hygiene SENTINEL LUBRICANTS CORP P.O. BOX MIAMI, FL