RelaTECH Concrete Form Release Oil Safety Data Sheet

Transcription

1 SECTION 1: Identification of the substance/mixture and of the company/undertaking 1.1. Product identifier Product form; Product # Product name SDS # : Mixture; CFR00 : Concrete Form Release Oil : Relevant identified uses of the substance or mixture and uses advised against Use of the substance/mixture 1.3. Details of the supplier of the safety data sheet RelaDyne, LLC 8280 Montgomery Road, Suite 101 Cincinnati, OH Emergency telephone number : General purpose oil. Brick mould release. Emergency number INFOTRAC SECTION 2: Hazards identification 2.1. Classification of the substance or mixture GHS-US classification Not classified 2.2. Label elements GHS-US labelling No labelling applicable 2.3. Other hazards 2.4. Unknown acute toxicity (GHS US) SECTION 3: Composition/information on ingredients 3.1. Substance 3.2. Mixture *Chemical name, CAS number and/or exact concentration have been withheld as a trade secret SECTION 4: First aid measures 4.1. Description of first aid measures First-aid measures general First-aid measures after inhalation First-aid measures after skin contact First-aid measures after eye contact First-aid measures after ingestion : Never give anything by mouth to an unconscious person. IF exposed or concerned: Get medical advice/attention. : If inhaled and if breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing. : Remove affected clothing and wash all exposed skin area with mild soap and water, followed by warm water rinse. : IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. : Do NOT induce vomiting unless directed to do so by medical personnel. Call a poison center or a doctor if you feel unwell Most important symptoms and effects, both acute and delayed Symptoms/injuries after inhalation : Inhalation may cause: irritation, coughing, shortness of breath. Symptoms/injuries after eye contact : Direct contact with the eyes is likely to be irritating. Symptoms/injuries after ingestion : May damage lungs if swallowed and aspirated. 02/06/2019 EN (English) SDS: 477 Page 1

2 4.3. Indication of any immediate medical attention and special treatment needed All treatments should be based on observed signs and symptoms of distress in the patient. SECTION 5: Firefighting measures 5.1. Extinguishing media Suitable extinguishing media Unsuitable extinguishing media : Carbon dioxide. Dry powder. Foam. Water spray. Water fog. : Do not use a heavy water stream Special hazards arising from the substance or mixture Fire hazard : No specific fire or explosion hazard. Explosion hazard : Product is not explosive. Reactivity : No dangerous reactions known Advice for firefighters Firefighting instructions Protection during firefighting : Exercise caution when fighting any chemical fire. Do not allow run-off from fire fighting to enter drains or water courses. : Do not enter fire area without proper protective equipment, including respiratory protection. Wear fire/flame resistant/retardant clothing. Wear a self contained breathing apparatus. SECTION 6: Accidental release measures 6.1. Personal precautions, protective equipment and emergency procedures General measures : Avoid all eye and skin contact and do not breathe vapour and mist For non-emergency personnel Protective equipment Emergency procedures For emergency responders Protective equipment Emergency procedures : Wear suitable protective clothing and gloves. neoprene. Nitrile gloves. Chemical goggles or safety glasses. : Evacuate unnecessary personnel. : Wear suitable protective clothing and gloves. Neoprene or nitrile rubber gloves. Chemical goggles or safety glasses. : Ventilate area Environmental precautions Avoid release to the environment Methods and material for containment and cleaning up For containment : Absorb and/or contain spill with inert material, then place in suitable container. Methods for cleaning up : Soak up spills with inert solids, such as clay or diatomaceous earth as soon as possible Reference to other sections Section 13: disposal information. Section 7: safe handling. Section 8: personal protective equipment. SECTION 7: Handling and storage 7.1. Precautions for safe handling Precautions for safe handling Hygiene measures : Avoid all eye and skin contact and do not breathe vapour and mist. Handle in a well-ventilated area. : Wash hands and other exposed areas with mild soap and water before eating, drinking or smoking and when leaving work Conditions for safe storage, including any incompatibilities Storage conditions Incompatible products Incompatible materials 7.3. Specific end use(s) : Keep only in the original container in a cool well ventilated place. Keep container closed when not in use. : Strong acids. Strong bases. : Sources of ignition. SECTION 8: Exposure controls/personal protection 8.1. Control parameters Concrete Form Release Oil ACGIH ACGIH TWA (mg/m³) 5 mg/m³ oil mist 02/06/2019 EN (English) SDS: 477 Page 2

3 Concrete Form Release Oil ACGIH ACGIH STEL (mg/m³) 10 mg/m³ oil mist OSHA 8.2. Exposure controls Appropriate engineering controls Personal protective equipment Hand protection Eye protection Respiratory protection : Avoid creating mist or spray. Avoid splashing. Provide local exhaust ventilation of closed transfer systems to minimize exposures. : Avoid all unnecessary exposure. : Wear suitable gloves. neoprene gloves. : In case of splashing or aerosol production: protective goggles. Chemical goggles or safety glasses. : Where exposure through inhalation may occur from use, respiratory protection equipment is recommended. Use an approved respirator equipped with oil/mist cartridges. SECTION 9: Physical and chemical properties 9.1. Information on basic physical and chemical properties Physical state : Liquid Colour Odour Odour threshold ph Melting point Freezing point Boiling point Flash point Relative evaporation rate (butyl acetate=1) Flammability (solid, gas) Explosive limits Explosive properties : Product is not explosive. Oxidising properties : No oxidizing properties. Vapour pressure Relative density Relative vapour density at 20 C Solubility Log Pow Log Kow Auto-ignition temperature Decomposition temperature Viscosity Viscosity, kinematic Viscosity, dynamic 9.2. Other information SECTION 10: Stability and reactivity Reactivity No dangerous reactions known Chemical stability Stable under normal conditions Possibility of hazardous reactions Hazardous polymerization will not occur Conditions to avoid Extremely high or low temperatures. Keep away from sources of ignition. 02/06/2019 EN (English) SDS: 477 Page 3

4 10.5. Incompatible materials Strong bases. Strong acids Hazardous decomposition products Carbon dioxide. Carbon monoxide. SECTION 11: Toxicological information Information on toxicological effects Likely routes of exposure Acute toxicity Skin corrosion/irritation Serious eye damage/irritation Respiratory or skin sensitisation Germ cell mutagenicity Carcinogenicity Reproductive toxicity Specific target organ toxicity (single exposure) Specific target organ toxicity (repeated exposure) Aspiration hazard Symptoms/injuries after inhalation Symptoms/injuries after eye contact Symptoms/injuries after ingestion SECTION 12: Ecological information Toxicity Persistence and degradability Bioaccumulative potential Mobility in soil Other adverse effects SECTION 13: Disposal considerations Waste treatment methods Sewage disposal recommendations Waste disposal recommendations SECTION 14: Transport information Department of Transportation (DOT) In accordance with DOT : inhalation; Skin and eye contact Not considered a dangerous good for transport regulations Additional information Other information : Inhalation may cause: irritation, coughing, shortness of breath. : Direct contact with the eyes is likely to be irritating. : May damage lungs if swallowed and aspirated. : Do not dispose of waste into sewer. : Dispose in a safe manner in accordance with local/national regulations. : No supplementary information available. ADR Transport by sea Air transport 02/06/2019 EN (English) SDS: 477 Page 4

5 SECTION 15: Regulatory information US Federal regulations International regulations CANADA EU-Regulations Classification according to Regulation (EC) No. 1272/2008 [CLP] Not classified National regulations US State regulations SECTION 16: Other information Indication of changes : GHS classification information. Revision date : 07/08/2015 Data sources : European Chemicals Agency (ECHA) Registered Substances list. Accessed at Krister Forsberg and S.Z. Mansdorf, "Quick Selection Guide to Chemical Protective Clothing", Fifth Edition. National Fire Protection Association; Fire Protection Guide to Hazardous Materials; 10th edition. TSCA Chemical Substance Inventory. Accessed at Abbreviations and acronyms : ACGIH (American Conference of Governement Industrial Hygienists). ATE: Acute Toxicity Estimate. CAS (Chemical Abstracts Service) number. EC50: Environmental Concentration associated with a response by 50% of the test population. GHS: Globally Harmonized System (of Classification and Labeling of Chemicals). LD50: Lethal Dose for 50% of the test population. OSHA: Occupational Safety & Health Administration. STEL: Short Term Exposure Limits. TWA: Time Weight Average. TSCA: Toxic Substances Control Act. Other information : None. NFPA health hazard NFPA fire hazard NFPA reactivity : 1 - Exposure could cause irritation but only minor residual injury even if no treatment is given. : 1 - Must be preheated before ignition can occur. : 0 - Normally stable, even under fire exposure conditions, and not reactive with water. This is prepared according to the Hazard Communication Standard (CFR ) HazCom The information is based on our current knowledge and is intended to describe the product for the purposes of health, safety and environmental requirements only. It should not therefore be construed as guaranteeing any specific property of the product. 02/06/2019 EN (English) SDS: 477 Page 5