Chemtech CT20 Wash 'N' Wax

Transcription

1 ITW AAMTech Chemwatch Hazard Alert Code: 2 Chemwatch: Material Safety Data Sheet according to NOHSC and ADG requirements Initial Date: S.Local.AUS.EN SECTION 1 IDENTIFICATION OF THE SUBSTANCE / MIXTURE AND OF THE COMPAN / UNDERTAKING Product Identifier Product name Synonyms Other means of identification Relevant identified uses of the substance or mixture and uses advised against Relevant identified uses Vehicle cleansing and wax gel. Details of the supplier of the safety data sheet Registered company name ITW AAMTech ITW AAMTech Address Unit 2/38 Trugood Drive 2013 New Zealand 100 Hassall Street 2164 NSW Australia Telephone Fax Website info@aamtech.co.nz info@aamtech.com.au Emergency telephone number Association / Organisation Emergency telephone numbers Other emergency telephone numbers SECTION 2 HAZARDS IDENTIFICATION Classification of the substance or mixture NON-HAZARDOUS SUBSTANCE. NON-DANGEROUS GOODS. According to NOHSC Criteria, and ADG Code. Poisons Schedule Risk Phrases Legend: GHS Classification 1. Classified by Chemwatch; 2. Classification drawn from HSIS ; 3. Classification drawn from EC Directive 1272/ Annex VI Label elements GHS label elements SIGNAL WORD NOT APPLICABLE Hazard statement(s)

2 Page 2 of 7 Precautionary statement(s) Prevention Precautionary statement(s) Response Precautionary statement(s) Storage Precautionary statement(s) Disposal Label elements Relevant risk statements are found in section 2 Indication(s) of danger SAFET ADVICE Other hazards May produce discomfort of the eyes and skin*. SECTION 3 COMPOSITION / INFORMATION ON INGREDIENTS Substances See section below for composition of Mixtures Mixtures CAS No %[weight] Name surfactants 1-10 ingredients non-hazardous >60 water The specific chemical identity and/or exact percentage (concentration) of composition has been withheld as a trade secret. SECTION 4 FIRST AID MEASURES Description of first aid measures Eye Contact Skin Contact Inhalation Ingestion If this product comes in contact with the eyes: Wash out immediately with fresh running water. Ensure complete irrigation of the eye by keeping eyelids apart and away from eye and moving the eyelids by occasionally lifting the upper and lower lids. Seek medical attention without delay; if pain persists or recurs seek medical attention. Removal of contact lenses after an eye injury should only be undertaken by skilled personnel. Concentrate and diluted solution is readily removed with water. Abraded or broken skin should be washed carefully and thoroughly. Seek medical attention in event of irritation. If fumes or combustion products are inhaled remove from contaminated area. Lay patient down. Keep warm and rested. Prostheses such as false teeth, which may block airway, should be removed, where possible, prior to initiating first aid procedures. Apply artificial respiration if not breathing, preferably with a demand valve resuscitator, bag-valve mask device, or pocket mask as trained. Perform CPR if necessary. Transport to hospital, or doctor. If swallowed do NOT induce vomiting. If vomiting occurs, lean patient forward or place on left side (head-down position, if possible) to maintain open airway and prevent aspiration. Observe the patient carefully. Never give liquid to a person showing signs of being sleepy or with reduced awareness; i.e. becoming unconscious. Give water to rinse out mouth, then provide liquid slowly and as much as casualty can comfortably drink. Seek medical advice. Indication of any immediate medical attention and special treatment needed

3 Page 3 of 7 Treat symptomatically. SECTION 5 FIREFIGHTING MEASURES Extinguishing media There is no restriction on the type of extinguisher which may be used. Use extinguishing media suitable for surrounding area. Special hazards arising from the substrate or mixture Fire Incompatibility None known Advice for firefighters Fire Fighting Fire/Explosion Hazard Alert Fire Brigade and tell them location and nature of hazard. Wear breathing apparatus plus protective gloves in the event of a fire. Prevent, by any means available, spillage from entering drains or water courses. Use fire fighting procedures suitable for surrounding area. Non combustible. Not considered to be a significant fire risk. Expansion or decomposition on heating may lead to violent rupture of containers. Decomposes on heating and may produce toxic fumes of carbon monoxide (CO). SECTION 6 ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures Minor Spills Major Spills Clean up all spills immediately. Slippery when spilt. Wipe up. Place in clean drum then flush area with water. Slippery when spilt. Minor hazard. Clear area of personnel. Alert Fire Brigade and tell them location and nature of hazard. Personal Protective Equipment advice is contained in Section 8 of the SDS. SECTION 7 HANDLING AND STORAGE Precautions for safe handling Safe handling Other information Avoid contact with eyes. Avoid physical damage to containers. Use good occupational work practice. Observe manufacturer's storage and handling recommendations contained within this MSDS. Wash hands with water after handling. Store in original containers. Keep containers securely sealed. Store in a cool, dry, well ventilated area. DO NOT allow to freeze. Conditions for safe storage, including any incompatibilities Suitable container Storage incompatibility Plastic container Check that containers are clearly labelled Packaging as recommended by manufacturer. None known SECTION 8 EXPOSURE CONTROLS / PERSONAL PROTECTION Control parameters OCCUPATIONAL EXPOSURE LIMITS (OEL) INGREDIENT DATA

4 Page 4 of 7 EMERGENC LIMITS Ingredient Material name TEEL-1 TEEL-2 TEEL-3 Chemtech CT20 Wash 'N' Wax Ingredient Original IDLH Revised IDLH surfactants ingredients non-hazardous water Exposure controls Appropriate engineering controls None under normal operating conditions. Provide adequate ventilation in warehouse or closed storage areas. Personal protection Eye and face protection Skin protection Hands/feet protection Body protection Other protection Thermal hazards No special equipment for minor exposure i.e. when handling small quantities. OTHERWISE: Safety glasses with side shields. Contact lenses may pose a special hazard; soft contact lenses may absorb and concentrate irritants. A written policy document, describing the wearing of lenses or restrictions on use, should be created for each workplace or task. See Hand protection below No special equipment needed when handling small quantities. OTHERWISE: Wear chemical protective gloves, e.g. PVC. See Other protection below No special equipment needed when handling small quantities. OTHERWISE: Overalls. Barrier cream. Eyewash unit. Recommended material(s) GLOVE SELECTION INDEX Glove selection is based on a modified presentation of the: "Forsberg Clothing Performance Index". The effect(s) of the following substance(s) are taken into account in the computer-generated selection: Respiratory protection Material BUTL NEOPRENE VITON NATURAL RUBBER PVA CPI A A A C C * CPI - Chemwatch Performance Index A: Best Selection B: Satisfactory; may degrade after 4 hours continuous immersion C: Poor to Dangerous Choice for other than short term immersion NOTE: As a series of factors will influence the actual performance of the glove, a final selection must be based on detailed observation. - * Where the glove is to be used on a short term, casual or infrequent basis, factors such as "feel" or convenience (e.g. disposability), may dictate a choice of gloves which might otherwise be unsuitable following long-term or frequent use. A qualified practitioner should be consulted.

5 Page 5 of 7 SECTION 9 PHSICAL AND CHEMICAL PROPERTIES Information on basic physical and chemical properties Appearance ellow opaque viscous liquid; mixes with water. Physical state Odour Odour threshold Liquid ph (as supplied) Melting point / freezing point ( C) Initial boiling point and boiling range ( C) Relative density (Water = 1) Partition coefficient n-octanol / water Auto-ignition temperature ( C) Decomposition temperature Viscosity (cst) 100 Molecular weight (g/mol) Flash point ( C) Taste Evaporation rate Same as water. Explosive properties Flammability Oxidising properties Upper Explosive Limit (%) Lower Explosive Limit (%) Surface Tension (dyn/cm or mn/m) Volatile Component (%vol) Vapour pressure (kpa) 20 C Gas group Solubility in water (g/l) Vapour density (Air = 1) Miscible ph as a solution (1%) VOC g/l SECTION 10 STABILIT AND REACTIVIT Reactivity See section 7 Chemical stability Possibility of hazardous reactions Product is considered stable and hazardous polymerisation will not occur. See section 7 Conditions to avoid See section 7 Incompatible materials See section 7 Hazardous decomposition products See section 5 SECTION 11 TOXICOLOGICAL INFORMATION Information on toxicological effects Inhaled Ingestion Not normally a hazard due to non-volatile nature of product The material has NOT been classified by EC Directives or other classification systems as "harmful by ingestion". This is because of the lack of corroborating animal or human evidence. Skin Contact Eye Chronic The liquid may produce skin discomfort following prolonged contact. Defatting and/or drying of the skin may lead to dermatitis There is some evidence to suggest that this material can cause inflammation of the skin on contact in some persons. Long-term exposure to the product is not thought to produce chronic effects adverse to the health (as classified by EC Directives using animal models); nevertheless exposure by all routes should be minimised as a matter of course. Chemtech CT20 Wash 'N' Wax TOXICIT IRRITATION

6 Page 6 of 7 water TOXICIT Oral (rat) LD50: >90000 mg/kg [2] IRRITATION Legend: 1. Value obtained from Europe ECHA Registered Substances - Acute toxicity 2.* Value obtained from manufacturer's SDS. Unless otherwise specified data extracted from RTECS - Register of Toxic Effect of chemical Substances Chemtech CT20 Wash 'N' Wax WATER Not available. No significant acute toxicological data identified in literature search. Acute Toxicity Skin Irritation/Corrosion Serious Eye Damage/Irritation Respiratory or Skin sensitisation Mutagenicity Carcinogenicity Reproductivity STOT - Single Exposure STOT - Repeated Exposure Aspiration Hazard Legend: Data required to make classification available Data available but does not fill the criteria for classification Data to make classification SECTION 12 ECOLOGICAL INFORMATION Toxicity Contains readily biodegradable surfactants. Persistence and degradability Ingredient Persistence: Water/Soil Persistence: Air water LOW LOW Bioaccumulative potential Ingredient Bioaccumulation water LOW (LogKOW = -1.38) Mobility in soil Ingredient Mobility water LOW (KOC = 14.3) SECTION 13 DISPOSAL CONSIDERATIONS Waste treatment methods Product / Packaging disposal Recycle wherever possible or consult manufacturer for recycling options. Consult State Land Waste Management Authority for disposal. Bury residue in an authorised landfill. Recycle containers if possible, or dispose of in an authorised landfill. SECTION 14 TRANSPORT INFORMATION Labels Required Marine Pollutant HAZCHEM NO Land transport (ADG): NOT REGULATED FOR TRANSPORT OF DANGEROUS GOODS Air transport (ICAO-IATA / DGR): NOT REGULATED FOR TRANSPORT OF DANGEROUS GOODS Sea transport (IMDG-Code / GGVSee): NOT REGULATED FOR TRANSPORT OF DANGEROUS GOODS

7 Page 7 of 7 SECTION 15 REGULATOR INFORMATION Safety, health and environmental regulations / legislation specific for the substance or mixture WATER( ) IS FOUND ON THE FOLLOWING REGULATOR LISTS Australia Inventory of Chemical Substances (AICS) National Inventory Australia - AICS Canada - DSL Canada - NDSL China - IECSC Europe - EINEC / ELINCS / NLP Japan - ENCS Korea - KECI New Zealand - NZIoC Philippines - PICCS USA - TSCA Legend: Status N (water) N (water) = All ingredients are on the inventory N = Not determined or one or more ingredients are not on the inventory and are not exempt from listing(see specific ingredients in brackets) SECTION 16 OTHER INFORMATION Other information Classification of the preparation and its individual components has drawn on official and authoritative sources as well as independent review by the Chemwatch Classification committee using available literature references. A list of reference resources used to assist the committee may be found at: The (M)SDS is a Hazard Communication tool and should be used to assist in the Risk Assessment. Many factors determine whether the reported Hazards are Risks in the workplace or other settings. Risks may be determined by reference to Exposures Scenarios. Scale of use, frequency of use and current or available engineering controls must be considered. This document is copyright. Apart from any fair dealing for the purposes of private study, research, review or criticism, as permitted under the Copyright Act, no part may be reproduced by any process without written permission from CHEMWATCH. TEL (+61 3) end of SDS