ALDI STORES MATERIAL SAFETY DATA SHEET

Transcription

1 Page 1 of 8 Issue Number: 1 Issue Date: 23th June IDENTIFICATION OF THE MATERIAL AND SUPPLIER Product Name: Other Names: Recommended Use: Tricare Soothing Aloe Vera & Chamomile Liquid Hand Wash To be used for cleansing hand with water. Supplier: Fortune Laboratories Sdn Bhd Address: Wisma Fortune, Lot 4, Jalan 16/12, Section 16, Shah Alam, Selangor Telephone Number: Facsimile Number: Emergency Telephone No: HAZARDS IDENTIFICATION Based on available information, the material is: Based on available information, the material is: HAZARDOUS SUBSTANCE ACCORDING TO CRITERIA OF THE AUSTRALIAN SAFETY AND COMPENSATION COUNCIL (NOHSC) NOT CLASSIFIED AS DANGEROUS GOODS ACCORDING TO AUSTRALIAN DANGEROUS GOODS (ADG) CODE Hazard category: Risk Phrases: Risk Phrase Number R43 Risk Phrase May cause SENSITISATION by skin contact. Safety Phrases: Safety Phrase Number Safety Phrase S23 Do not breathe gas/fumes/vapour/spray. S24. Avoid contact with skin S37 Wear suitable gloves. S40 To clean the floor and all objects contaminated by this material, use water and detergent. S46 If swallowed, seek medical advice immediately and show this container or label. S56 Dispose of this material and its container at hazardous or special waste collection point. S64 If swallowed, rinse mouth with water (only if the person is conscious).

2 Page 2 of 8 Issue Number: 1 Issue Date: 23th June COMPOSITION/ INFORMATION ON INGREDIENTS COMPONENTS CAS No. Proportion Non Hazardous Ingredients - To 100% Fragrance mixture Tetrasodium EDTA Propylene Glycol (32.5% active) Mixture of Methylchloroisothiazolinone and Methylisothiazolinone (1.5% active) FIRST AID MEASURES For advice, contact Poisons Information Centre (phone Australia ) or a doctor. (For each route of exposure provide indication of medical attention and special treatment needed including description of most important symptoms, acute and delayed) Inhalation: Remove from site of exposure into fresh air. Obtain medical attention immediately if breathing shows signs of failing or deliberate abuse is suspected. Skin Contact: Eye Contact: Ingestion: Wash the skin with soap and running water. Contact a doctor in the event of skin irritation occurs. In case of contact with eyes, rinse immediately with plenty of water and contact a doctor or Poisons Information Centre. Wash out the mouth with water. Do not induce vomiting. Contact a doctor or Poisons Information Centre.

3 Page 3 of 8 Issue Number: 1 Issue Date: 23th June FIRE FIGHTING MEASURES Hazards from combustion products: Precautions for firefighters and special protective equipment: Suitable extinguishing material Combustible. Slight fire hazard when exposed to heat or flame. Heating may cause expansion or decomposition leading to violent rupture of containers. On combustion, may emit toxic fumes of carbon monoxide (CO). Alert Fire Brigade and tell them location and nature of hazard. Wear full body protective clothing with breathing apparatus. Prevent, by any means available, spillage from entering drains or water course. Use water delivered as a fine spray to control fire and cool adjacent area. The product contains a substantial proportion of water, therefore there are no restrictions on the type of extinguishing media which may be used. Though the material is non-combustible, evaporation of water from the mixture, caused by the heat of nearby fire, may produce floating layers of combustible substances. In such an event consider: foam 6. ACCIDENTAL RELEASE MEASURES Emergency procedures: Avoid breathing vapours and contact with skin and eyes Methods and materials for containment and clean up: Minor Spills Environmental hazard - contain spillage. Remove all ignition sources. Clean up all spills immediately. Major Spills Environmental hazard - contain spillage. Moderate hazard. Clear area of personnel and move upwind. Alert Fire Brigade and tell them location and nature of hazard. 7. HANDLING AND STORAGE Precautions for safe handling: (including any incompatibilities) Conditions for safe storage: Do not allow clothing wet with material to stay in contact with skin Avoid all personal contact, including inhalation. Wear protective clothing when risk of exposure occurs. Use in a well-ventilated area. Prevent concentration in hollows and sumps. Store in original containers. Keep containers securely sealed. No smoking, naked lights or ignition sources. Store in a cool, dry, well-ventilated area.

4 Page 4 of 8 Issue Number: 1 Issue Date: 23th June EXPOSURE CONTROLS / PERSONAL PROTECTION National Exposure Standards: Biological Limit Values: Name UN No CAS No Range % [ai] TWA (ppm) TWA (mg/m3) Glycerin N/A N/A 10 Propylene Glycol N/A N/A 10 N/A Engineering Controls: Personal Protective Equipment: The basic types of engineering controls are: Process controls which involve changing the way a job activity or process is done to reduce the risk. Enclosure and/or isolation of emission source which keeps a selected hazard "physically" away from the worker and ventilation that strategically "adds" and "removes" air in the work environment Eye and face protection Safety glasses with side Shields. Chemical goggles. Contact lenses may pose a special hazard; soft contact lenses may absorb and concentrate irritants. A written policy document, describing the wearing of lenses or restrictions on use, should be created for each workplace or task. Hand Protection Wear chemical protective gloves, e.g. PVC. Wear safety footwear or safety gumboots, e.g. Rubber The material may produce skin sensitisation in predisposed individuals. Care must be taken, when removing gloves and other protective equipment, to avoid all possible skin contact. Contaminated leather items, such as shoes, belts and watch-bands should be removed and destroyed. Other Protection Overalls. P.V.C. apron. Barrier cream. 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance: Pearlized white to off white viscous liquid Odour: Not relevant ph: Specific Gravity or Density: g/ml Vapour Pressure: Not relevant Vapour Density: Not relevant Percent Volatiles: Not relevant Boiling Point Range: Not tested Freezing/ Melting Point: Not tested Solubility: Miscible in water Flash Point (include method detection): >60 C Flammability Limits: Ignition Temperature: Not tested Shelf Life: 2 years from date of manufacture (when stored as directed) Other: N/A

5 Page 5 of 8 Issue Number: 1 Issue Date: 23th June STABILITY AND REACTIVITY Chemical Stability: The material is stable under normal ambient and anticipated storage and handling conditions of temperature and pressure. Refer section 7 on condition of safe storage. Conditions to avoid: Refer section 7 Incompatible Materials: Refer section 7 Hazardous Decomposition Products: Refer section 7 Hazardous Reactions: Refer section TOXICOLOGICAL INFORMATION No adverse health effects expected if the product is handled in accordance with this Safety Data Sheet and the product label. Symptoms or effects that may arise if the product is mishandled and overexposure occurs are: HEALTH EFFECTS Ingestion: Eye Contact: Skin Contact: Inhalation: Long term effects: Acute Toxicity/ Chronic Toxicity: (ie LD 50) Not classified Although the liquid is not thought to be an irritant (as classified by EC Directives), direct contact with the eye may produce transient is comfort characterised by tearing or conjunctival redness (as with windburn). The liquid may be miscible with fats or oils and may degrease the skin, producing a skin reaction described as non-allergic contact dermatitis. The material is unlikely to produce an irritant dermatitis as described in EC Directives. Open cuts, abraded or irritated skin should not be exposed to this material Entry into the blood-stream through, for example, cuts, abrasions, puncture wounds or lesions, may produce systemic injury with harmful effects. Examine the skin prior to the use of the material and ensure that any external damage is suitably protected. The material is not thought to produce adverse health effects or irritation of the respiratory tract (as classified by EC Directives using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable control measures be used in an occupational setting. Not normally a hazard due to non-volatile nature of product Not classified Not classified

6 Page 6 of 8 Issue Number: 1 Issue Date: 23th June ECOLOGICAL INFORMATION Ecotoxicity: During normal use mixture is not anticipated to present a significant risk to the environment. Persistence and N/A Degradability: Mobility: N/A Other: DISPOSAL CONSIDERATIONS Under conditions of expected use the mixture will be disposed of at the end of its life into normal domestic waste Disposal methods: (including container disposal) Special precautions for landfill or incineration: Completely emptied packages can be recycled Completely emptied packages can be recycled.

7 Page 7 of 8 Issue Number: 1 Issue Date: 23th June TRANSPORT INFORMATION ROAD & RAIL TRANSPORT: UN Number: UN Proper Shipping Name: D.G. Class: Subsidiary Risk: Packaging Group: HAZCHEM Code: Segregation: Special Precautions For User: MARINE TRANSPORT: UN Number: UN Proper Shipping Name: D.G. Class: Subsidiary Risk: Packaging Group: Stowage & Segregation: Special Precautions For User: AIR TRANSPORT: UN Number: UN Proper Shipping Name: D.G. Class: Subsidiary Risk: Packaging Group: Special Precautions For User: DG ERG Code: Not classified as Dangerous Goods by the criteria of the Australian Dangerous Goods Code (ADG Code) for transport by road and rail. Not classified as Dangerous Goods by the criteria of the International Maritime Dangerous Goods Code (IMDG Code) for transport by sea. Classified/Not classified as Dangerous Goods by the criteria of the International Air Transport Association (IATA) for transport by air.

8 Page 8 of 8 Issue Number: 1 Issue Date: 23th June REGULATORY INFORMATION Poisons Schedule: APVMA Status: TGA Status: AICS Status: AQIS Status: ADG Status: NOHSC Status: Other: No constituents of this product are regulated by Poisons Standard All the constituents of this product are listed on AICS 16. OTHER INFORMATION. MSDS Issue date: 23th June 2014 Issue Number: 1.0 Reason for issue: New Product In any event, the review and, if necessary, the re-issue of this MSDS shall be no longer than 5 years after the last date of issue. Key/Legend to Abbreviations and Acronyms used in the MSDS: Abbreviation Meaning /Acronym AICS Australian Inventory of Chemical Substances APVMA Australian Pesticides and Veterinary Medicines Authority AQIS Australian Quarantine and Inspection Service AS Australian Standard (as issued by Standards Australia) ASCC Australian Safety and Compensation Council DG ERG Code Dangerous Goods Emergency Response Guidebook Code. The Emergency Response Guidebook is used by first responders (eg firefighters, police officers and ambulance personnel) when responding to a transportation emergency involving hazardous materials. LD 50 The median lethal toxicological dose, LD 50 is an abbreviation for Lethal Dose, 50%. of a toxic substance. This is the dose required to kill half the members of a tested population. MSDS STEL TGA TLV TWA UN Number Literature References: Material Safety Data Sheet Short Term Exposure Limit - A 15 minute TWA exposure which should not be exceeded at any time during a working day even if the eight-hour TWA average is within the TWA exposure standard. Exposures at the STEL should not be longer than 15 minutes and should not be repeated more than four times per day. There should be at least 60 minutes between successive exposures at the STEL. Therapeutic Goods Administration Threshold Limit Value - TLV is a proprietary name registered by the American Conference of Governmental Industrial Hygienists (ACGIH) and refers to airborne concentrations of substances or levels of physical agents to which it is believed that nearly all workers may be repeatedly exposed day after day without adverse effect. Time Weighted Average - The average airborne concentration of a particular substance when calculated over a normal eight-hour working day, for a five-day working week. UN numbers are four-digit numbers that identify hazardous substances, and articles (such as explosives, flammable liquids, toxic substances, etc.) in the framework of international transport.

9 Page 9 of 8 Issue Number: 1 Issue Date: 23th June 2014 National Industrial Chemicals Notification and Assessment Scheme (NICNAS) Australian Inventory of Chemical Substances (AICS): Industrial Chemicals (Notification and Assessment) Act 1989 (the ICNA Act), including Cosmetics Standard 2007 Standard for the Uniform Scheduling of Drugs and Poisons (SUSDP) established under the Therapeutic Goods Act (1989) (The Poisons Standard) Therapeutic Goods Regulations 1990 established under the Therapeutic Goods Act (1989) Australian Code for the Transport of Dangerous Goods by Road And Rail (ADG Code) Endorsed by the Australian Transport Council Approved Criteria for Classifying Hazardous Substances [NOHSC:1008] Hazardous Substances Information System: National Code of Practice for the Preparation of Material Safety Data Sheets 2nd Edition [NOHSC:2011(2003)] National Code of Practice for the Labelling of Workplace Substances [NOHSC:2012(1994)] Adopted National Exposure Standards for Atmospheric Contaminants in the Occupational Environment [NOHSC:1003(1995)] AS Aerosol containers - Metal aerosol dispensers of capacity 50 ml to 1000 ml inclusive Sources of Data: As above This MSDS has been prepared by using current technical data and summarises to their best knowledge of the health and safety information of the product, and in particular how to safely handle and use the product in the workplace. If clarification or further information is needed to ensure that an appropriate assessment can be made, the user should contact relevant contact personnel as per listed above or on label. This MSDS may only be reproduced in full. Summaries or excerpts from this MSDS may not contain all the relevant information and thus are not permitted. This MSDS gives no warranty and makes no representation as to the accuracy, reliability or completeness of the information contained. Please be aware that the information in this MSDS may be subject to change and may no longer be current. The user should make their own determination in light of their own circumstances as to the suitability of this information and the safe conditions for the use of this product. To the extent permitted by law, ALDI Stores will not be liable for any loss, damage or expense arising from the use of this MSDS, whether caused by the negligent act or omission.. End of MSDS